• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.43 no.12
• /
• pp.1097-1107
• /
• 2015

General VTOL aircraft uses gas turbine engine which has high power to weight ratio. However, in the VTOL UAV in small sector, the gas turbine as a prime mover is not adequate because of the limitation of the high fuel consumption ratio of the gas turbine. In this research, The Series Hybrid-Electric Propulsion System(SHEPS) has been proposed and technology survey & comparison analysis has conducted to constitute propulsion system for engine, electric motor and battery. To achieve this object a 65kg-class P-UAV from "Company I" was used. And to estimate the validity of power control algorithm and developed power management control, Matlab/simulink$^{(R)}$ has been used for the simulation. As a result, the developed algorithm worked comparatively well and the research has predicted that SHEPS was satisfied enough for 7 hour of endurance for mission profile.

• Journal of Aerospace System Engineering
• /
• v.15 no.5
• /
• pp.43-49
• /
• 2021

This research shows how is designed, and its performance is evaluated on the ground for the VTOL drone before the flight test initiates. The targeted drone weight is approximately 45 kg including battery packs, and 4 motors are utilized to produce thrust and control directions. 30 min flight schedules were simulated to estimate the total power consumptions which result in 2.4 kWh. Then, two packs of 13-cells lithium-polymer battery with operating voltage ranging between 54 V and 44 V with up to 4 C-rate were fabricated to safely operate a VTOL drone. Moreover, the battery management system was installed to prevent over and under-voltage and over-current while running a battery system. To finally verify battery's performance, we conducted a ground evaluation for discharging battery tests at -10 ℃, 25 ℃ and 40 ℃, resulting in satisfying simulated power consumption conditions for flight schedules.

• Journal of the Korea Society of Computer and Information
• /
• v.25 no.6
• /
• pp.9-15
• /
• 2020

In this paper, we propose a case that drone (unmanned aerial vehicle), one of the representative technologies of the 4th Industrial Revolution, threatens airport safety and privacy infringement, and describes a drone control system proposal to solve the problem. Unmanned aerial vehicle (Drone) is creating a serious problem recently, In Korea, on May 21, 19, according to the Jeju Regional Aviation Administration, drones flew over Jeju Jeongseok Airfield twice in the same month, causing problems in aircraft operation. In overseas cases, two drones near the runway of Gatwick International Airport in the UK There has been a disturbance in which the takeoff and landing of the aircraft flies for a while, and various problems have occurred, such as voyeuring the private life of an individual using a drone. This paper is equipped with an Acess Point transponder mounted on a drone (unmanned aerial vehicle), and unspecified many who want to receive flight information (coordinates, altitude, and obstacles) of the drone access the drone AP, receive and receive the flight information of the drone, and receive unspecified multiple Drone AP flight information is collected and collected to provide the information of the drone currently floating on one user interface screen. In addition, an AP transponder is proposed to operate a safe drone (unmanned aerial vehicle) and the drone's flight information is transmitted., To receive and collect and collect data.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.1
• /
• pp.597-604
• /
• 2016

The aim of this study was to prevent the decrease in crop output by disease and insect pests and excessive spraying of agricultural pesticides by application uniformity. A 3m height and 15km/h speed is difficult to maintain with an unmanned helicopter for aerial application, which has been affected by the controlling habits and methods or environmental factors, such as changes in the wind. Therefore, in this study, an aerial application system was design to be attached to an unmanned helicopter, which can allow a controlled application width and spray rate automatically and verified experimentally using Rmax of MS-AVIATION. The size of agricultural land was 50 m2 and nine water sensitive cards were arranged at 1.25m intervals in 5 rows with each row having a 10m interval from the position of 5m. The unmanned helicopter was flying at speeds ranging from 7.2km/h to 17.6km/h and heights ranging from 2.32m to 3.47m. The proposed aerial application system allowed application uniformity by making a valid spraying area of 7.5 m2 with 46423 particles distributed on average.

• Journal of Advanced Navigation Technology
• /
• v.28 no.1
• /
• pp.95-101
• /
• 2024

This paper aims to establish a reconfigurable flight simulation environment to conduct safety evaluation of various electric vertical take-off and landing (eVTOL) aircraft. Since the inceptor, aircraft dynamics model, and controller applied to each eVTOL aircraft are different, it was configured to be variable so that a simulation can be executed for each eVTOL aircraft. Test elements and performance indicators were set to perform safety evaluation of eVTOL aircraft. Ground auxiliary equipments were designed and implemented in a simulation environment according to test procedures for each test element. In addition, to analyze safety performance, a simulation flight data collection environment based on MATLAB/Simulink and a tool for safety performance analysis were implemented. Test flight and analysis were conducted in the implemented simulation environment in this paper. Finally, this study shows the environment was verified by confirming that it was performed normally.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.1
• /
• pp.39-47
• /
• 2008

Automatic landing performance of UAV can be enhanced by adding Pseudolite(PL) to GPS. However, it is very hard to install and operate PL with confidence because GPS satellites are moving and the landing zone are usually changeable. The coverage and accuracy of combined GPS and PL can be estimated by using simulator and the correct information is very crucial to UAV operation. In this paper, design, implementation and evaluation of GPS/PL simulator for UAV landing are given. A very realistic coverage estimation is obtained using GIS data and ray launching method with considerations of the transmitter power level, altitude of UAV, number and location of PL. The expected accuracy is estimated using DOP and NSP computed using both GPS and PL. The performance of simulator is evaluated by comparing with the results of a real GPS receiver, and the certified simulator shows the required accuracy for UAV landing can be easily met by proper installation of at least 2 PLs.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.2
• /
• pp.140-147
• /
• 2017

This paper describes the design and implementation of previously developed PMU (Power Monitoring Unit) for LiPB (Lithium-ion Polymer Battery) that is electric propulsion used as unmanned aerial vehicle's power source. Improved PMU provides stable voltage and current to various sensors and elctric motors necessary during flight. Voltage and current monitoring function that is measured by improved PMU more precisely be enhanced and the monitoring channel and temperature sensor is added. To verify the improved performance of the equipment, it is integrated to electric propulsion system of unmanned aerial vehicle. PMU is calibrated through the ground test. And PMU's performance is checked through the flight test.

• Journal of the Geological Society of Korea
• /
• v.54 no.5
• /
• pp.501-511
• /
• 2018

Geoparks are worth preserving in an environmentally and heritage. Monitoring and public attention are essential for the conservation and protection of geoparks. The use of Unmanned Aerial Vehicles and the Structure from Motion algorithm enables effective monitoring of geoparks that are difficult to manage due to their wide range of manpower, and various spatial data derived from SfM can be utilized to improve awareness of geoparks that have been lacking. In order to prove this, firstly, we created the 3D spatial data by using the UAV and the SfM algorithm, which is one of the National geoparks of the Hantan-Imjin River area. Using this 3D data for Virtual Reality and 3D printing. After that, we verified the possibility of promoting the geopark through a simple online survey. Finally, we propose a method to utilize all the generated data from each step to promote and research for geoparks.

• Journal of Advanced Navigation Technology
• /
• v.26 no.5
• /
• pp.312-318
• /
• 2022

Currently, the Republic of Korea is facing the problem of a decrease in military service resources due to the demographic cliff, and is pursuing military restructuring and changes in the military force structure in order to respond to this. In this situation, the Army is pushing forward the deployment of a drone-bot combat system that will lead the future battlefield. The battlefield of the future will be changed into an integrated battlefield concept that combines command and control, surveillance and reconnaissance, and precision strike. According to these changes, unmanned combat system, including dronebots, will be widely applied to combat situations that are high risk and difficult for humans to perform in actual combat. In this paper, as one of the countermeasures to these changes, autonomous behavior software with a BDI architecture-based decision-making system was developed. The autonomous behavior software applied a framework structure to improve applicability to multiple models. Its function was verified in a PC-based environment by assuming that the target UAV is a battalion-level surveillance and reconnaissance UAV.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.38 no.8
• /
• pp.781-789
• /
• 2010

In the GPS/INS integrated system fault detection, algorithm based on a chi-square distribution is commonly used. In this paper, it has been proposed simplified GPS/INS fault detection algorithm that is combined conventional RAIM (Receiver Autonomous Integrity Monitor) and algorithm based on chi-square distribution for UAV using row-grade processor. It use a fault model to verify the proposed algorithm and produced the result.