• Journal of the Korea institute for structural maintenance and inspection
• /
• v.10 no.5
• /
• pp.106-114
• /
• 2006

This paper investigates the fundamental properties and shrinkage characteristics of low shrinkage high performance concrete(LSHPC), using mock-up specimens. According to the test results, the most suitable mix proportions of LSHPC need a higher dosage of SP agent and AE agent, in order to obtain the target of slump flow and air content. This is due to reduce fluidity and air content respectively. It also presented earlier setting time than control concrete by 6 hours and exhibited compressive strength of 60MPa at age 28 days. Autogenous shrinkage of LSHPC was the half of the value of control concrete. Drying shrinkage of center section of LSHPC showed similar tendency with autogenous shrinkage, because of no internal moisture movement, while surface section had larger drying shrinkage. The specimen with embedded reinforcing bar had smaller deformation owing to confinement of reinforcing bar.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.937-940
• /
• 2008

Recently, the recycling and reusing of construction and demolition waste concrete is urgently required because generation quantity of construction and demolition waste concrete is greatly increased according to the rapid increasing of urban redevelopment project. On the other hand, the problem solution for demand and supply unbalance of fine aggregate is urgently required because of the restriction of collecting sea fine aggregate by intensification of environment influence evaluation and the shortage of river fine aggregate. but a quality of aggregate as building structure is not demonstrated. Therefore it is the objective of this study to estimate plastic and early dry shrink crack of fiber reinforced concrete using a recycled aggregate by plat-ring test and mock-up test of exposure to the air. as a result, in case of plat- ring test, developing crack is wider using recycled aggregate concrete than natural aggregate concrete, is wider using fiber reinforced concrete than non fiber. in case of mock-up test of exposure to the air, it is similar to plat-ring test.

• Journal of the Korea Institute of Building Construction
• /
• v.14 no.3
• /
• pp.223-229
• /
• 2014

In this study, the fire resistance of high strength concrete with organic fibers and polymer powder (PW) was investigated. Two types of the specimens of ${\phi}100{\times}200mm$ and $300{\times}300{\times}600mm$ sizes were prepared. As a result of the test, it was found that the fiber-to-PW mixing ratio of 1:1 achieved the highest fluidity. Further, it was found that the mixing ratios of PP 0.05% + PW 0.05%, PNY 0.05% + PW 0.05% was sufficient to protect the high strength concrete from spalling. For the mock-up specimens of $300{\times}300{\times}600mm$ size, if the required amounts of fibers were added in the concrete. the concrete spalling was resisted. Likewise, in the case of the polymix (PM) together with PW, all the tested specimens were satisfactory for fire resistance performance.

• Journal of the Korea Institute of Building Construction
• /
• v.19 no.3
• /
• pp.229-237
• /
• 2019

This study examines the estimation of strength through a ultra-high strength concrete mock-up specimen using the rock compressive strength test hammer. According to the test result, the commonly used strength estimation formulae showed differences among them when the data of this test were applied. In additional, it show that these formulae underestimated the actual measurements further when the compressive strength was 30MPa or greater and deviated the distribution range of actual measurements in all strength ranges. The rock test hammer showed a higher correlation than type N Schmidt hammer regardless of the direction of hit for each type of W/B and the inclusion of coarse aggregate, and mortar showed a little higher correlation than concrete. As a result, it can be suggested that the coefficient of variation and the standard deviation of the mortar(2.26%/1.36) are lower than those of the concrete(4.06%/2.5), and the smaller the size of the coarse aggregate, the smaller the coefficient of variation and the more accurate the value.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.15 no.5
• /
• pp.218-226
• /
• 2011

Low heat concrete using strontium hydroxide based latent heat material was manufactured in ready-mixed concrete batcher plant and its fundamental properties were tested. As a result of B/P test, its applicability to the construction site was verified. After B/P test, low heat concrete using strontium hydroxide based latent heat material was applied to the real construction site of bridge footing. Through the analysis and the actual measurement of the hydration heat of the concrete footing, the reduction effect of hydration heat and thermal crack was confirmed.

• Proceedings of the KIEE Conference
• /
• 2001.05a
• /
• pp.180-182
• /
• 2001

기존의 디지털 계전기 교육/훈련 방법은 적절한 교육용 소프트웨어 및 기기의 부재로 인해 교육을 받는 훈련생들을 단기간 내에 이해시키는데 어려움이 있었다. 본 연구의 목적은 GUI 환경에서 다양한 모의 고장 발생, 모의 고장 시나리오의 입력, 편집 수정, 삭제가 가능하고 디지털 계전기의 교육/훈련 기능과 함께 훈련 결과의 평가와 훈련일지의 작성 기능을 포함하는 디지털 계전기 시뮬레이터의 개발이다. 본 논문에서는 고장종류, 고장발생 각, 고장거리, 데이터의 샘플수에 따라 EMTP를 이용하여 모의한 후, 디지털 신호 처리를 이용하여 직류 성분과 고조파 성분을 제거하고, 기본파 성분을 추출한다. 그리고 추출된 데이터를 사용하여 임피던스 궤적을 도시하고. 그 결과를 사용자에게 보여주도록 하였다. 특히, GUI 환경으로 구성하여 알고리즘의 수행과정을 보다 쉽게 이해하고. 사용할 수 있도록 함으로써, 교육/훈련의 효과가 극대화되도록 하였다.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.308-308
• /
• 2016

기후변화는 하천 수문특성을 변화시켰으며, 이로 인해 홍수와 가뭄과 같은 자연재해로 인한 피해와 발생빈도가 점차 증가하고 있다. 이에 따라 기후변화에 대비한 유역관리를 위해 유역특성을 고려한 정확한 수문예측이 요구되고 있다. 다양한 유역특성 중에서 수문곡선의 감수부는 유역의 토성, 경사, 대수층 특성 등에 영향을 받는다. 하지만 대부분 유출 모의 모형에서는 이를 고려하지 않고 유역 전체가 동일한 감수특성을 가지고 있다고 가정하여 모의를 한다. 이에 본 연구에서는 미계측 유역에서의 유출 모의가 가능한 Soil and Water Assessement Tool(SWAT) 모형을 활용하여 소유역 별 수문곡선의 감수부 특성이 기저유출 모의 결과에 대한 영향을 분석하였다. alpha factor는 SWAT 모형의 다양한 매개변수 중 한가지로 수문곡선의 감수부 특성을 나타내는 매개변수이다. 이에 본 연구에서는 소유역 중에서 실측 유량자료가 활용 가능한 소유역에 대하여 Web-based RECESS를 통해 alpha factor를 직접 산정하였다. 이렇게 산정한 alpha factor를 SWAT 모형에 적용하여 유출 모의를 한 뒤 모의 결과로부터 기저유출을 분리하였다. SWAT 모형의 기본 입력값(default value)을 적용에 따른 기저유출 분리결과와 실측 유량자료로부터 산정된 alpha factor 적용에 따른 기저유출 분리결과를 비교한 결과 실측 유량자료로부터 산정된 alpha factor를 적용 시 기저유출 모의 결과가 실제 기저유출에 더 가까운 값을 나타내었다. 하지만 alpha factor의 산정 방법 특성 상 실측 유량자료 부재시 이를 산정할 수 없다는 한계점이 있다. 이에 실측 유량자료를 이용한 기존의 alpha factor 산정 방법을 대체할 수 있는 alpha factor 산정 방법을 개발한다면 정확한 기저유출 모의가 가능할 것으로 기대된다.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2005.05a
• /
• pp.9-12
• /
• 2005

This paper investigated the temperature history of mass concrete mock up structure considering different heat generation by varying with mixture proportion. Setting time difference between high early strength mixture (E-P) and retarding mixture (R-F30) was 14.5hours. Incorporation of $30\%$ of fly ash contributed to $10^{\circ}C$ of hydration heat reduction. In generally used C and D combination, bottom concrete shows earlier hydration, while E-J combination showed reverse tendency and thus, this method can reduce the crack occurrence. Therefore, heat generation difference method has beneficial effect on reducing crack induced by hydration heat resulting from heat generation difference between surface and center section.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 2011.04a
• /
• pp.521-524
• /
• 2011

본 논문에서는 순환골재에 대하여 구조용 적용성 검증을 목표로 하였으며, 천연골재와 순환골재 치환율에 따른 압축파괴강도와 압축강도증가에 따른 파속도의 상관관계를 비교 분석하였다. 설계기준강도 21, 27, 35MPa에 순환굵은골재 치환율 0, 30, 50, 100%를 적용하여 설계기준강도에 따른 순환굵은골재 치환율의 배합을 총 12가지로 설정하였다. 재령160일까지의 압축파괴강도의 변화를 대기양생 공시체, 수중 양생공시체 그리고 코어공시체를 이용하여 비교하였고, 모의부재(800${\times}$800${\times}$200mm)를 통하여 재령160일까지의 초음파속도를 측정하였다. 압축파괴실험을 통하여 취득한 데이터를 비교해 본 결과 순환굵은골재 치환율에 따른 강도저하현상은 나타나지 않았다. 또한, 재령일에 따른 강도 증가와 함께 파속도도 같이 증가함을 알 수 있었다.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2006.11a
• /
• pp.33-36
• /
• 2006

This Study is based on manufacture non-sintering cement(NSC) by adding phosphogysum and waste lime to GBFS as sulfate and alkali activators. This study also investigates the basic physical properties and duality of NSC, and evaluates its reusing possibility as construction materials. Therefore, we design 40MPa and 60MPa for compressive strength using OPC and NSC by binder. And There is a purpose to present fundamental data, applying in field and analyzing quality control of concrete using NSC according to rate of replace between OPC and NSC.