• Journal of the Korean Chemical Society
• /
• v.22 no.5
• /
• pp.340-355
• /
• 1978

Model reactions were often applied in the measuring of the mass transfer coefficient and interfacial area between gas and liquid, which are the most important factors in the design of equipment for gas absorption accompanied with chemical reaction this study, wetted wall column was applied to the sulfite-system among the known model reactions. It was found that one could not ignore the effect of contact time on the determination of mass transfer coefficient and interfacial area. When the reaction rate is very high or very low, the differences of absorption rate would be very large in according to the length of column, that is to the contact time. But the effect of contact time was free about the rate constant $k_2=5.5{\times}10^6m^3/kmol{\cdot}s$, that means the rate of gas absorption become independent upon the hydrodynamics of the equipment. It has shown that instead of steel column could be applied the fine grain-graphite column.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.18 no.4 s.70
• /
• pp.335-345
• /
• 2005

This paper concentrates on the nonlinear analysis of prestressed concrete (PSC) containment structures. Unlike a commercialized program which adopts the perfect bond assumption between concrete and tendon in the analysis of PSC structures, a numerical algorithm to consider the slip effect, simultaneously with the use of commercialized programs such as DIANA and ABAQUS, is introduced in this paper For bonded tendons, the apparent yield stress of an embedded tendon is determined from the bond slip relationship. And for unbonded tendons, Correction for the strength and stiffness of unbonded internal tendons is achieved on the basis of an iteration scheme derived from the slip behavior of tendon along the entire length. Finally, the developed algorithm is applied to two PSC containment structures of PWR and CANDU to verify its efficiency and applicability in simulating the structural behavior of large complex structures, and the obtained result shows that both containment structures represent the ultimate pressure capacity larger than about 3 times of the design pressure.

• Journal of the Society of Naval Architects of Korea
• /
• v.39 no.2
• /
• pp.11-18
• /
• 2002

In this paper, the method calculating hydroelastic responses of very large floating structure close to a breakwater in waves is presented. The source-dipole distribution method is used to calculate the generalized radiation problem considering breakwater effects and the diffraction problem is analyzed by using the source-dipole distribution andvelocity potential continuation method. The response of a VLFS is approximated by anexpansion in terms of a free-free beam. Calculated model is a VLFS with 1000m in length in a sea with a straight breakwater. The vertical displacements and bonding moments around a VLFS are calculated by variations for distance between a VLFS and a breakwater and incident wave angle to know the effect of a breakwater.

• Journal of Internet Computing and Services
• /
• v.8 no.3
• /
• pp.75-83
• /
• 2007

Multithreaded model is an effective parallel system in that it can reduce the long memory reference latency time and solve the synchronization problems. When compiling the non-strict functional programs for the multithreaded parallel machine, the most important thing is to find an set of sequentially executable instructions and to partitions them into threads. The existing partitioning algorithm partitions the condition of conditional expression, true expression and false expression into the basic blocks and apply local partitioning to these basic blocks. We can do the better partitioning if we modify the definition of the thread and allow the branching within the thread. The branching within the thread do not reduce the parallelism, do not increase the number of synchronization and do not violate the basic rule of the thread partitioning. On the contrary, it can lengthen the thread and reduce the number of synchronization. In the paper, we enhance the method of the partition of threads by combining the three basic blocks into one of two blocks.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.30 no.1
• /
• pp.40-46
• /
• 2016

Many medicinal plants have been used for the treatment of edema, jaundice, and gonorrhea in traditional Oriental medicine. This screening study was designed to search the positive inotropic effects of herbal extracts in beating rabbit atria. Aquarius extracts of twenty six herbs were examined in atrial mechanical dynamics such as pulse pressure and stroke volume and atrial natriuretic peptide (ANP), one of the main hormones involved in the regulation of the body fluid and blood pressure homeostasis in perfused beating rabbit atria. Sophora flavescens Ait., Rheum officinale Baill., Acorus gramineus Sol., Chelidonium majus L., Pulsatilla koreana Nakai., Reynoutria japonica Houtt., Euphorbia lathyris L., Pyrrosia lingua (Thunb.) Farwell, Poncirus trifoliata Rafin., Anemarrhena asphodeloides Bunge, Kochia scoparia Schrad. significantly increased stroke volume and pulse pressure. However, those herbal extracts were not induced ANP secretion. We clarified the eleven herbal extracts for the positive inotropic effect independent of ANP secretion in beating rabbit atria. Thus these results provide a beneficial data for the treatment of the impairment of body fluid and blood pressure in traditional Oriental medicine.

• Fire Science and Engineering
• /
• v.23 no.4
• /
• pp.13-18
• /
• 2009

The main objective of the present study is to investigate smoke propagation in railway tunnels with rescue stations. In particular, based on measurement of HRR (heat release rate) for pool fires formed at different locations, the influence of fire source location on smoke behavior is examined. The fuel is n-heptane and pool fires are generated with a square length 4cm. With the use of MVHS (Modified Volumetric Heat Source) model for fire source, extensive numerical simulations are performed by using the commercial code FLUENT (Ver.6.3) Predicted smoke temperatures and smoke propagation are discussed. From numerical predictions, it is found that ventilation systems may be necessary in the railway tunnels because the smoke moves along the tunnel, and consequently it enters the non-accident tunnel. It is also confirmed that the cross-passage and fire protection wall systems contribute to control the smoke.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.37 no.2
• /
• pp.54-61
• /
• 2000

This paper presents the performance evaluation of channel estimation algorithm using RLS algorithm lot W-CDMA reverse link over Rayleigh fading channels. By obtaining BER(Bit Error Rate) performance through computer simulations, the RLS(Recursive Least Square) algorithm is compared with the existing WMSA(Weighted Averaging)(K=1,3) and constant gain algorithm. The channel structure, modulation and pilot patterns are applied to the ARIB (Association of Radio Industries and Business) and 3GPP (3rd Generation Partnership Project) ITU-R proposal for the IMT-2000. The BER performance of RLS algorithm with linear interpolation is similar to that of WMSA(K=1) and slightly superior to that of constant gain algorithm at low Doppler frequencies. Also, RLS algorithm performance is better than that of the WMSA(K=1,3) and constant gain algorithms about 4dB at BER=2.0$\times$$10^{-2}$ and Doppler frequencies $F_D$=320Hz. With increasing Doppler frequency, therefore, the BER performance of RLS algorithm with linear interpolation is superior to WMSA(K=L.3) and constant rain algorithms.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.5
• /
• pp.123-131
• /
• 2016

To capture color and near-infrared images simultaneously, a multi-spectral filter array(MSFA) sensor is used. This is because an NIR band gives additional invisible information to human eyes to see subject under extremely low light level. However, because lenses have different refractive indices for different wavelengths, lenses may fail to focus widely different rays to the same convergence point. This is why a chromatic aberration(CA) problem occurs and images are degraded. In this paper, the image restoration algorithm for an MSFA image, which removes the CA problem, is presented. The obtained MSFA image is filtered by the estimated low-pass kernel to generate a base image. This base image is used to remove CA problem in multi-spectral(MS) images. By modeling the image degradation process and by using the least squares approach of the difference between the high-frequencies of the base and MS images, the desired high-resolution MS images are reconstructed. The experimental results show that the proposed algorithm performs well in estimating the high-quality MS images and reducing the chromatic aberration problem.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.45 no.6
• /
• pp.33-44
• /
• 2008

Multipath routing protocols with load balance, fault tolerance, aggregated bandwidth in Ad-hoc Networks provide improved throughput and reliable route as compared with singlepath routing protocols. However, multipath routing protocols have not been explored thoroughly in the domain of overhead in Ad-hoc Networks. In this paper, we analyze and compare on-demand singlepath and multipath routing with IEEE 802.11 DCF in terms of Routing overhead and MAC overhead. The results reveals that in comparison with singlepath routing protocol, multipath routing mechanism creates more overheads but provides better performance in congestion and capacity provided that the route length is within a certain upper bound which is derivable. The analytical results are further confirmed by simulation.

• 대한공업교육학회지
• /
• v.33 no.2
• /
• pp.273-286
• /
• 2008

Underwater acoustic sensor array can detect acoustic signal in underwater and the sensor array can be mounted in each left, right or front side of the UUV(Unmanned Underwater Vehicle). The sensor array could be conformal array and effected turbulent boundary layer flow noise. Therefore, in this paper numerical simulations were performed to know the how the outer flow noise affect the hydrophone which embedded in the elastomer. Corcos wall pressure model was used as turbulent boundary layer flow noise and this model was applied to the frequency density function. Characteristics of transfer function according the kx wave number were simulated and design parameters were thickness of elastomer, density, and modulus of elasticity. Based on the simulation results when increasing the thickness of elastomer noise reduction was increased. This results can be applied to the design of conformal array of UUV.