• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.12
• /
• pp.3-9
• /
• 2015

In this paper, we propose the operation procedures of the 1-channel monopulse receiver which achieves the new configuration. Also, we analyzed the monopulse ratio and the target angle accuracy of the fabricated receiver by using the monopulse signal generator developed for verifying the proposal equipment. As a result, it is apparent that the monopulse ratio of the proposal receiver is equal to that of the 3-channel monopulse receiver. Also, the fabricated receiver exhibits the target angle accuracy with fewer than 0.1 RMS. The proposal receiver achieves the simple receiver configuration and the simple tracking procedures, as contrasted with the 3-channel monopulse receiver. Also, the proposal receiver has advantages in terms of size, weight, cost and power. Because the proposal monopulse receiver requires 1-channel receiver and needs not the signal processor in comparison with 3-channel monopulse receiver which requires 3-channel receiver and need the signal processor.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.11
• /
• pp.1299-1308
• /
• 2007

In this paper, we propose the calibration method of monopulse slope to minimize the variation of angle estimate in frequency agile noncoherent monopulse system. We analyze the monopulse slope characteristics of antenna and RF receiver including the phase and gain imbalances of each receiving channel and present the calibration method to minimize the phase and gain imbalances of RF receiver channels including antenna. In addition, we present the calibration method using channel switching to minimize the gain imbalance of IF receiver channels. The measured average monopulse slope within the frequency bandwidth is -0.96, the maximum variation of angle estimate is similar to theoretical value, $0.15^{\circ}$ at ${\pm}2^{\circ}$ azimuth and $0.03^{\circ}$ at $0^{\circ}$ azimuth.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.5
• /
• pp.528-536
• /
• 2010

A monopulse feeder gives the most important impact upon the radiation pattern characteristics of a multi-function radar or a tracking radar which uses the space feed. It is described that the triple-mode type monopulse feeder which possesses the optimum aperture illumination for three monopulse channels is designed and measured in this paper. The measured results show that the designed feeder has not only the characteristics of the optimum aperture illimination in each channel and also very low return loss over the 10 % of fractional bandwidth at X-band. This means that the feeder provides the antenna system with low sidelobe level and high monopulse slope characteristics.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.1
• /
• pp.71-76
• /
• 2014

In this paper, we proposed the 1-channel monopulse receiver which has the new configuration and described the operation procedures. Also, we compared and analyzed the proposal receiver and the general 3-channel monopulse receiver. As a result, it is apparent that the monopulse ratio of the proposal receiver is equal to that of the 3-channel monopulse receiver. The proposal receiver achieve the simple receiver configuration and the simple tracking procedures, as contrasted with the 3-channel monopulse receiver. Also, the proposal receiver has advantages in terms of size, weight, cost and power. Because the proposal monopulse receiver require 1-channel receiver and need not the signal processor in comparison with 3-channel monopulse receiver which require 3-channel receiver and need the signal processor.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.4 no.1
• /
• pp.83-92
• /
• 2001

In this paper, the monopulse channel receiver which can be matched between channels through a wide bandwidth has been proposed. The effects of the gain and phase imbalance between channels on the slope of monopulse error signal were analyzed. Also, the matching method between channels in a wide bandwidth was proposed, by which monopulse slope could be stabilized. Using the implemented monopulse radar system the monopulse slope was measured in the anechoic chamber which include the moving horn antenna and the target signal generator. The results show that the wide band matching method is useful and applicable to various channel receivers

• Journal of the Korea Institute of Military Science and Technology
• /
• v.20 no.2
• /
• pp.272-278
• /
• 2017

In this paper, we consider a single-channel amplitude comparison monopulse system(SCACMS). The monopulse ratio curve(MR-C) of the SCACMS can be controlled by an amplitude difference between sum and different signal, a phase difference and the coefficient of the signal processor. We first propose the SCACMS with multiple variables, and then apply a genetic algorithm to optimize the multiple variables in terms of minimizing a root mean square error. The simulation results show that when three variables of the SCACMS are jointly optimized, the linear region of the MR-C can be extended approximately 187 % compared to that of two variables.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.12
• /
• pp.1036-1043
• /
• 2016

In this paper, an analysis about the elevation angle accuracy degradation of an APAR(Airport Precision Approach Radar) due to the multi-path effect using a phased array antenna was performed. An APAR installed around a runway of airport will be continuously affected in a runway surface of the fixed environment. In this paper, an analysis about the elevation angle accuracy degradation of APAR due to the multi-path effect of runway surface was conducted through a calculation of monopluse slope and sum/difference beam pattern analysis of array antenna. Also, a difference pattern for monopulse to minimize this degradation was optimized in an appropriate configuration to improve a elevation angle accuracy. Finally, a degree of improvement of elevation angle accuracy was confirmed by calculating a monopulse slope including the ground reflection after applying optimized difference patterns of array antenna.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.5
• /
• pp.35-43
• /
• 2014

In this paper, we propose a performance enhancement method of the target tracking system for communication signal using the monopulse and the ${\alpha}{\beta}$ filter to keep the connection of the communication system between the airplane and the ground. We suggest the minimum distance measurement method for tracking error angle of the monopulse signal instead of the generally used method of MR(Monopulse Ratio) curve, and the ${\alpha}{\beta}$ filter with variable gain for enhancement of the tracking accuracy and the probability of re-tracking the monopulse signal under the disconnection of link. We show the performance enhancement of the proposed method of monopulse system using the measured MR Curve results of the prototype system. And also, the comparison of simulation results between the ${\alpha}{\beta}$ filter with variable gain and the ${\alpha}{\beta}$ filter with fixed gain shows the performance enhancement of the proposed ${\alpha}{\beta}$ filter. Using the proposed methods, we expect the enhanced performance of the existing target tracking system for communication signal only by changing the algorithm without hardware changes.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.2
• /
• pp.235-244
• /
• 2014

This paper describes the subarray channel configuration and calibration method for airborne AESA radar antenna. AESA radar demonstrator was designed and implemented for the digital beam-forming performance test of the 12 channel subarray structure. Magnitude and phase difference can be exist between the manufactured subarray channel. In this paper, calibration method for the subarray difference error was suggested. We measured digital monopulse slope in the subarray channel and verified the channel calibration effect. To verify the subarray channel operation, digital monopulse channel was compared with analog monopulse channel performance. AESA radar demonstrator was tested in the ground far field test range. Emulated single target was generated to test the detection and tracking performance of the demonstrator with the same waveform and search pattern. We verified that the detection and tracking performance of the 12 subarray digital monopulse channel was similar with the conventional analog monopulse channel. Also, ABF(Adaptive Beam-Forming) function for the sidelobe jammer was tested and effective operation was verified.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.9
• /
• pp.735-738
• /
• 2018

The accuracy of extracting the azimuth angle of a target is significantly affected by the error in the mono-pulse ratio of the air-borne antenna hybrid mono-pulse Radar system. This error is strongly induced by the phase imbalance between the channels of the system. In this paper, a method is proposed for effectively calibrating the phase imbalance caused by physical differences between the RF channels from the antenna to the $180^{\circ}$ hybrid. Through a flight test, it was confirmed that the accuracy of the azimuth angle of the target is improved by using the proposed method.