• Journal of the Microelectronics and Packaging Society
• /
• v.19 no.1
• /
• pp.75-80
• /
• 2012

$InSb$ films were fabricated by DC magnetron sputtering and the effects of deposition temperature, heat treatment, passivation from evaporation and multi-layered structure were investigated. Electron mobility and electron concentration were linearly increased with deposition temperature for as-deposited specimens. It was found that the mobilities depend on the grain size rather than the stoichiometry for the samples with very low mobilities. The mobilities largely increased for the specimens with evaporation passivation compared with those without passivation layer. The mobility also increased with the amount of indium deposition in the multi-layer structured $InSb$ films. It was found that the mobility increments in both cases are due to the matching of the stoichiometry in $InSb$ films. For the heat treated and passivated specimens, the mobilities increased with annealing time and the maximum mobility was measured as 1612 $cm^2$/Vs.

• The KIPS Transactions:PartC
• /
• v.9C no.5
• /
• pp.733-742
• /
• 2002

It has been known that the host mobility feature has very significant impact on the QoS (Quality of Service), which is usually required to a real-time multimedia application. The existing QoS support mechanisms to provide the real-time services to fixed network environment, like as RSVP, are inadequate to accommodate the mobile hosts which can frequently change their point of attachments to the fixed network. So, MRSVP (Mobile RSVP) protocol has been proposed to reduce the impacts of host mobility on QoS guarantees, in which a mobile host needs to make advance resource reservations at multiple locations it may possibly visit during the lifetime of the connection. This paper proposes a dynamic dual anchor node (DDAN) architecture which integrates the MRSVP and RSVP tunnel, in addition to the Mobile IP Regional Registration protocol. By limiting the resource reserved in local area, it preserves the lower level of resource reservation, but provides approximately the same degree of QoS support as the existing MRSVP.

• Korean Journal of Optics and Photonics
• /
• v.32 no.5
• /
• pp.230-234
• /
• 2021

Relief of thermal stress has received great attention, to improve the beam quality and stability of high-power laser diodes. In this paper, we investigate a microtrench structure engraved around a laser-diode chip-on-submount (CoS) to relieve the thermal stress on a laser-diode bar (LD-bar), using the SolidWorks® software. First, we systematically analyze the thermal stress on the LD-bar CoS with a metal heat-sink holder, and then derive an optimal design for thermal stress relief according to the change in microtrench depth. The thermal stress of the front part of the LD-bar CoS, which is the main cause of the "smile effect", is reduced to about 1/5 of that without the microtrench structure, while maintaining the thermal resistance.

• Proceedings of the Korean Information Science Society Conference
• /
• 2001.10c
• /
• pp.391-393
• /
• 2001

이동컴퓨팅 환경에서 호스트의 이동성으로 야기되는 멀티미디어 데이터전송 문제 해결에 관한 연구가 활발히 진행되고 있다 . 멀티캐스트는 멀티미디어 데이터가 차지하는 많은 네트워크 트래픽을 수신자에게 효율적으로 분배함으로써 네트워크 트래픽을 줄일수 있다. 그러나 이동 호스트를 대상으로 하는 멀티캐스트는 무선자원의 효율적 사용을 위해 셀 반경이 작아짐에 따라 빈번하게 그룹의 멤버와 위치를 변화시키기 때문에 라우팅 경로의 최적화, 투명성 제공, 잦은 핸드오프로 인한 등록지연에 따른 서비스 단절과 패킷손실의 증가에 대한 명확한 대책이 제시되지 못하고 있다. 또한 멀티캐스트를 지원하지 않는 영역으로 이동했을 때의 데이터전송에 관한 문제점도 내포하고 있다. 본 논문에서는 이러한 문제의 해결방안으로 이동컴퓨팅환경에서 Hop Counter로 정의된 서비스 범위를 하나의 그룹이라 정의하고 그룹기반의 멀티캐스트 라우팅 방법을 제안한다. 제안 방법은 셀이 마이크로화됨에 따라 나타나는 Hop 증가에 따른 전송 오버로드와 터널링 문제를 해결하고, 광역 네트워크에서의 멀티캐스팅을 담당하는 에이전트의 부하를 감소시킴으로써 성능 향상을 기대할 수 있다. 또한 호스트가 이동한 FA가 멀티캐스트를 지원하지 않을 때 MA가 그룹의 특정 호스트로부터 보낸 데이터를 받기 위해서 주변에 인접해 있는 MA중 멀티캐스트를 지원하고 가장 작은 Hop을 갖은 MA를 터널의 대리자로 등록해 놓음으로써 멀티캐스팅이 지원되지 않은 환경에서의 멀티캐스팅이 이루어질 수 있다.

• 유체기계공업학회:학술대회논문집
• /
• 2006.08a
• /
• pp.297-300
• /
• 2006

This article discusses about the droplet movement on the super-hydrophobic surface by the electro-wetting on dielectric and the effect of particles on the contact angle as well as the movement is investigated. The movement of droplet, driven by the principle of electro-wetting on dielectric, and the effect of particles are experimentally verified according to the driving voltage and different particles concentrations (fluorescent, charged particles). To increase the contact angle, the super-hydrophobic surface is fabricated and applied to the dielectric layer for the EWOD device. Then its performance is verified and discussed.

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.8
• /
• pp.79-87
• /
• 2010

It is widely accepted that the coverage with high user densities in mobile multimedia environments can only be achieved with small cell such as micro- and pico-cell. If handover events occur during the transmission of multimedia, the efficient resource reservation and handover methods are necessary in order to maintain the same QoS of transmitted multimedia traffic because the QoS may be defected by some delay and information loss. In this paper, we propose a resource allocation method in the next generation mobile communication systems, in which the resource allocation process has a tight relation with call admission, call load, and packet scheduling. The simulation results show that our proposed method provides a excellent performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.7A
• /
• pp.770-777
• /
• 2007

Smaller cell size in the micro-cell or pico-cell structure brings about more frequent hand-overs between cells, and higher speed movement of the mobile terminal makes short the permissible time interval for executing these hand-over procedures. In this situation the hand-over failure may occur or some packets may be lost during the hand-over. Moreover a rapid degradation of throughput is triggered by packet re-transmission for compensating such errors. The QoS (Quality of Services) of mobile multimedia applications with higher bits rate requirements and higher speed mobility are severely affected by even shot service interruption. This paper proposes a new hand-over scheme to provide seamless services in the next generation mobile communication systems. Simulation is done to evaluate the performance of the proposed scheme based on its hand-over failure rate and packet loss rate.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.20 no.2
• /
• pp.195-201
• /
• 2010

Recently, the necessity of the autonomous mobile robot is emphasized in order to enlarge the scope of activity and actively cope with the change of work environment. This paper proposes the algorithm which enables the mobile robot to avoid obstacles and lead it to the destination by the shortest path. And we verify the usability by a simulation. We made the algorithm with micro-GA and $\lambda$-geometry MRA. The area of simulation is limited to 320(width)$\times$200(length) pixels and one pixel is one centimeter. When we planned the path with only $\lambda$-geometry MRA, we could find the direction for path planning but could not find the shortest path. But when we planned the path with $\lambda$-geometry MRA and micro-GA, we could find the shortest path. So the algorithm enables us to find the direction for path planning and the shortest path.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2010.04a
• /
• pp.75-78
• /
• 2010

고발포 소화약제의 발포력은 화재시 포소화약제의 성능을 검증하는데에 중요한 요소이다. 이러한 발포력 검증은 한국소방산업기술원의 "포소화약제의 형식승인 및 검정기술기준(KOFEIS 0103)"에서 제시하고 있는 표준발포기를 이용한 측정법을 통해 검증한다. 본 연구에서는 기존 방법의 제작 비용 및 측정의 번거로움을 보완하기 위한 약제 개발단계에서의 포소화약제 발포력 검증을 위한 실험실적인 측정법을 고안하여 적용성을 분석한다. 측정은 1000ml 시험관내에 3%의 수용액 $100m{\ell}$를 첨가하여 수용액 내부에 정량펌프를 통해 일정한 기포량 및 기포크기로 분사하여 발포시켰으며, 기포의 노즐은 거품의 정확도를 향상시키기 위해 마이크로 피펫팁 $0.2m{\ell}$ 용량을 사용하여 적용성을 분석하였다.

• Proceedings of the Korean Information Science Society Conference
• /
• 2002.10e
• /
• pp.52-54
• /
• 2002

최근 하루가 다르게 증가하는 이동전화 가입자의 통화 품질을 보장하기 위해CDMA중계기의 중요도가 증가하고 있으며 자동화된 모니터링 시스템의 필요성이 대두되었다. Embedded Internet하에 CDMA중계기를 임베디드 리눅스 시스템과 연동하여 리눅스 커널 레벨에서의 모니터링 방안으로 EKMM(Embedded internet based Kernel level Monitoring Modules)시스템을 제시한다. 본 시스템은 SA-1110 마이크로 프로세스로 구현된 하드웨어에 시리얼 디바이스 드라이브와 네트웍 디바이스 드라이브를 설계하였다. 또한 리눅스 커널을 재구성하며 동적 로딩 방식으로 EKMM이 탑재되어 기존의 중계기 임베디드 시스템 보다 기능 확장성이 뛰어나고 성능이 향상된 중계기 모니터링 시스템을 설계 구현하였다.