• Transactions of the Korean Society of Automotive Engineers
• /
• v.19 no.4
• /
• pp.130-136
• /
• 2011

This study describes the effect of EGR rate on the combustion and emissions characteristics of a four cylinder CRDI diesel engine using biodiesel (soybean oil) blended diesel fuel. The test fuel is composed of 30% biodiesel and 70% ULSD (ultra low sulfur diesel) by volumetric ratio. The experiment of engine emissions and performance characteristics were performed under the various EGR rates. The experimental results showed that ignition delay was extended, the maximum combustion pressure and heat release gradually were decreased with increasing EGR rate. Comparing biodiesel blended fuel to ULSD, the injection quantity of biodiesel blended fuel was further increased than ULSD. The emission results showed that $NO_x$ emission of biodiesel blended fuel becomes higher according to the increase of EGR rate. However, in the case of biodiesel blended fuel, HC, CO and soot emissions were decreased compared to ULSD.

• Korean Chemical Engineering Research
• /
• v.48 no.3
• /
• pp.375-381
• /
• 2010

Cetane number of diesel fuel for compression ignition engine is one of main properties for fuel ignition quality. Recently the cetane index has been replaced the cetane number in order to resolve the disadvantage of CFR engine test, but these two value have slightly difference values due to addition of various additives. In this study, we analyzed the cetane number, derived cetane number and cetane index for diesel fuel which was blended with various ratios of biodiesel, kerosene and cetane improver as additives. As a result, Cetane number showed the similar value with derived cetane number, but cetane index showed quite different value with cetane number when biodiesel and cetane improver were used as additives.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.7
• /
• pp.1648-1653
• /
• 2009

Fossil fuel causes the greenhouse effect by emitting $CO_2$, and an estimated amount of oil deposits are also limited. Therefore, people have been interested in alternative energies. Vegetable oil which is one of the alternative energies is eco-friendly renewable energy source and has similar properties like diesel oil with high efficiency. Also, vegetable oil has been well recognized as one of solutions to reduce the greenhouse effect caused by $CO_2$release. In this study, we chose Waste vegetable oil(WVO) to solve the problems of high price of grain and lack of food. Impurities and sediments from WVO were removed by separation process using sieves of $15{\mu}m$pore size. Blending was performed in Homo-mixer by 5000 rpm for 10 min. We investigated viscosities and Iodine values in different compositions of WVO and diesel oil blends. Finally, we could find out blended oils have some possibility to be used in the diesel engine.

• Journal of the korean Society of Automotive Engineers
• /
• v.7 no.4
• /
• pp.49-56
• /
• 1985

This study consists of instrumenting and running tests on variable compression engines and measuring the following combustion characterics: (a)flame speed, (b) emission and (c)performance parameter such as power and economy. The results were as follows: 1) The phase separation diagram of substitute fuels were obtained from phase separation experiment. 2) The flame propagation speed of substitute fuels were higher than gasoline and increased with increasing methanol weight percent of substitute fuels. 3) BEMP of substitute fuels was slightly less than that of gasoline but in the range of small weight percent, BEMP was compatible to gasoline. 4) Concentration of NOx decreased significantly with delaying spark advancing time. Also, it decreased for rich equivalence ratio but increased with high compression ratio. In general, NOx concentration was much lower than that of gasoline. 5) Concentration of HC and CO increased for rich equivalence ratio. Also it was lower than that of gasoline.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.3
• /
• pp.1-6
• /
• 2003

Natural gas is one of the promising alternative fuels because of the abundant deposits and the cleanness of emission gas. CNG has a lot of merits except lower burning speed has a slow disadvantage. One way to overcome the disadvantage is to raise a turbulence intensity. We give various intake for changing turbulence intensity in the cylinder by three kinds of swirl control valve with a way to raise a turbulence intensity. In the present study, a $1.8\ell$ conventional gasoline engine is modified to use a CNG as a fuel instead of gasoline. We try to virify combustion and emission characteristics in each engine parameters. Parameters of experimentation are equivalence ratio, spark timing and intake flow change. The results of this study are as swirl flows. In the case of adding swirl flow, burning speed and torque are increased. But NOx and THC concentration are increased a little respectively.

• Electronics and Telecommunications Trends
• /
• v.24 no.5
• /
• pp.52-61
• /
• 2009

교토 의정서에 의한 지구 온난화의 규제 및 방지를 위하여 자동차에 환경 관련 규제가 강화되고 있으나 재생에너지가 전체 에너지에서 차지하는 부분은 2020년에 약 1%(현재는 약 0.4%) 정도로 예측되어 대체에너지 개발 이전에 에너지 저감 기술에 대한 필요성이 대두되어 차량의 공회전 상태시 엔진 구동을 정지시키는 Stop-Start 시스템에 대한 연구가 자동차 제조사 중심으로 연구되어 왔으며 불필요한 공회전으로 소모되는 연료 손실 중 $5{\sim}8%$ 이상 회수 가능함이 입증되고 있다. 본 고에서는 Stop-Start 시스템 기술에 대하여 소개하고, 국/내외 시장동향을 분석하여 그 필요성에 대하여 고찰하며, 한국전자통신연구원에서 개발중인 IT 융합 Stop-Start 시스템 개발 현황에 대하여 기술한 후 결론을 맺는다.

• Journal of ILASS-Korea
• /
• v.16 no.2
• /
• pp.97-103
• /
• 2011

The electronically controlled diesel engine was converted to dual fuel engine system. Test engine was set up for investigating the power output, thermal efficiency and emissions. ND 13-mode tests were employed for the engine test cycle. The emission result of dual fuel mode meets Euro-4 (K2006) regulation and the engine performance of dual fuel engine was comparable to the performance of diesel engine. To estimate economical efficiency, test vehicles have been operated on a certain driving route repeatedly. Fuel economy, maximum driving distance per refueling and driveability were examined on the road including free ways. Developed vehicle can be operated over 500 km with dual fuel mode and shows 80% of diesel substitution ratio. Driveability of dual fuel mode is similar with that of diesel mode.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2004.05a
• /
• pp.90-90
• /
• 2004

반도체 집적회로 제작 기술을 기반으로 하여 각종 물리량 감지를 위한 미세기계구조물과 각종 물리량의 전기신호로의 변화, 증폭, 보정을 위한 전자회로를 동시에 제작하여 하나의 칩 상에 집적화시킬 수 있는 MEMS 기술이 등장하게 됨에 따라 센서의 소형화, 경량화, 다기능화, 고성능화와 함께 비용을 최소화할 수 있는 장점을 가진 반도체 센서가 급격하게 개발되어 자동차 산업에 상용화되고 있다. 특히 반도체 압력센서는 엔진 제어용 MAP센서에서 가장 먼저 상품화되었으며, 현재 타이어압 센서 그리고 탱크 연료압력센서가 상품화되었고, 에어콘 압력 센서등도 실리콘 센서로 대체하기 위한 단계에와 있다.(중략)

• Applied Chemistry for Engineering
• /
• v.28 no.6
• /
• pp.632-637
• /
• 2017

The vehicle lubricant occupies upto 35% in a total lubricant market and engine oil occupies upto 77% in the vehicle lubricant market in Korea. A suitable quality management of the circulating engine oil is necessary for driver and engine protection. But, KS and synthetic engine oil products (involved over 30% synthetic oil) are exempt to any quality management under Petroleum and Alternative Fuel Business Act. It is also known that synthetic oils such as PAO (poly alpha olefin) have excellent properties and performance like anti-wear, varnish control and oxidation stability than those of mineral oils. For this reason, PAO has been used for an engine oil, rotary screw and reciprocating compressor in addition to heavy duty and other extreme service applications. In this study, our research group analyzed the chromatogram pattern for the mineral oil, PAO and mineral oil involved a typical ratio of PAO using SIMDIST (simulated distillation). In the SIMDIST chromatogram, the mineral oil showed a broad peak, while PAO showed a sharp typical peak. Also the oil with a large viscosity grade exhibited a long retention time due to the heavy molecular weight and high boiling point. In particular, the blended mineral oil with 20% PAO sample showed a distinctly different pattern compared to that of using the conventional mineral oil. For monitoring PAO contents in distributing engine oils, we analyzed the SIMDIST for 27 kinds of engine oils which were popularly sold in Korea. The analytic results indicate that all kinds of engine oils showed that PAO contents were below 20% in engine oil products. Moreover, the PAO titled product was found to have a small amount of PAO. Thus, we conclude that the related laws for the proper quality management of synthetic oils are needed to be established.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.11
• /
• pp.634-640
• /
• 2020

Failure analysis and heat-resistant were performed for an electric fuel pump that is installed in the fuel tank to transfer fuel to the engine of combat vehicles. The fuel pump with a DC motor was disassembled and inspected to determine the cause of failure. The failure phenomenon was classified into three categories based on observations of the inside of the housing: burnt winding, quick brush abrasion, and fuel leak into the pump. Based on the inspection results, it was estimated that overheating was the main cause of failure. The thermal test was conducted under the no-load condition in 24 hours, and the thermal sensor was installed on the stator surface and the brush holder to check the possibility of damage to the winding due to overheating. When the ambient temperature of the fuel pump was set to 68 ℃, the stator temperature increased to 135.9 ℃, and the winding of the motor was almost damaged. The test results confirmed the lack of heat resistance of fuel pump windings, and suggested that the type F of insulation class (below 155 ℃) of the windings and varnish should be replaced with type C or higher that can be used above 180 ℃.