• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.7
• /
• pp.1459-1467
• /
• 1997

The current on the thin planar structure as an element of the transversely fed electromagnetically coupled(EMC) microstrip dipole array antenna is obtained by using the integral forms of the finite difference time domain(FDTD) method. This method was applied to calculating the optimum current distribution (Doplh-Tchebyscheff distribution) of each dipole element on the feed line as a function of their offset positions for the narrow main beam width and the side beam level below -20 dB. The current on each dipole substitutes for the electric and magnetic current densities on the virtual surface of the FDTD calculation to express the far field intensity, the calculation time and the computer memeory can be reduced to about 80% and 1.3 Mbyte, respectively. The calculated radiation patterns are compared to the measured values and these are in good agreement.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.219-220
• /
• 2006

In this paper, we designed and implemented the Dual Band Dipole Antenna with Tapered Microstrip Balun for WLAN Access Point. Two dipole antennas with different resonant frequency and the antenna structure combined additional line were implemented for dual band performance. In order to feed the balun current, the tapered microstrip balun was used. Produced the Dual Band Antenna shows a special quality. The quality is that all VSWR is less than 1.5 in the 2.4GHz and 5GHz frequency bands in 802.11 standards, and it profits not less than 1.7dBi having typical Dipole Antenna pattern the very "a form of 8"pattern and Omni-directional pattern.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.2
• /
• pp.164-169
• /
• 2002

This paper reports on design and fabrication of near field probe operating at 300~3000 MHz. Design parameters are extracted by equivalent circuit of E-field probe and simulation using S parameter is performed to predict probes performance. The probe consists of a dipole antenna with 3.25 mm length, a zero bias Schottky diode and a highly resistive transmission line. A TEM cell was used for performance evaluation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.10
• /
• pp.2703-2709
• /
• 1996

This paper proposes an exact numerical method for analyzing a dipole antenna attached on a dielectric slab. A Green's function for an infinitesimal current filament on a dielectric slab is derived and a field integral equation is formulated using a boundary condition. The moment Method is used to solve the field integral equation to otain current distribution on the antenna. Since an asymptotic function is used to compute the impedance matrix elements, the computataion time is significantly reduced. Using the computed current distributions, the input impedances, the resonance lengths and the resonant resistances of the antennas for various values of the thichnessandthe dielectric constant of the slab are obtained. It was found that the resonant length and the resonant resistance are decrease monotonically as the dielectric constant increases, however, those are changed up-and-down as the substrate thickness increases.

• Proceedings of the KIEE Conference
• /
• 2006.10a
• /
• pp.131-132
• /
• 2006

무선전력송신은 로봇, 우주 항공, 정보통신, MEMS 등 디바이스 경량화 및 운동성 향상 등의 요소가 중요하게 작용하는 분야에 도움을 줄 수 있다. 특히 정찰 및 탐사에 쓰일 초경량의 로봇을 위해서는 무선전력송신 기술은 상당히 중요한 개념이 된다. 본 논문에서는 유연 박막 기판과 다이폴 안테나, 그리고 쇼트키다이오드를 이용하여 전송된 마이크로파를 직류전력으로 변환시키는 렉테나(rectenna)에 대해서 소개하고 제조방과 성능평가를 통하여서 응용 개발의 가능성에 대해서 논한다.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2005.11a
• /
• pp.405-408
• /
• 2005

This paper presents the characteristics of antenna factors for sleeve dipole antennas with a broad bandwidth. The coupled integral equations for the unknown current distributions on each elements are derived and solved by applying Galerkin's method of moments. The flatness of antenna factor is considered by variation of the length and number of sleeve elements.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.11a
• /
• pp.120-123
• /
• 1999

This paper presents the design method of EMC(Electromagnetic Coupling) microstrip array antenna for CS(Communication Satellite) system. Microstrip dipole antennas are attractive elements owing to the desirable properties such as simplicity, small size and linear polarization. From the optimum simulation results by the FDTD method[1], design parameters such as EMC dipole length, width, height and offset are discussed at 12CHz. The array characteristics of 5-elements and 10-elements array are also presented. By adjusting geometry of model antenna, we can design dual polarization EMC microstrip dipole antenna for CS system. Direction of nam beam is easily tilted by the control of distance between dipole elements.

• Proceedings of the KIEE Conference
• /
• 2004.11a
• /
• pp.104-106
• /
• 2004

GIS의 금속으로 차폐된 폐쇄형 스페이서(barrier)의 에폭시 주입구를 통해 방사되는 극초단파 부분방전 신호를 검출할 수 있는 외장형 UHF PD 센서를 제작하였다. 센서에 내장되는 패치안테나는 모노폴(monopole)과 다이폴(dipole) 형태로 설계하여 고주파 전자기장 해석 툴을 이용하여 각각의 특성을 계산하고 분석하였다. 제작된 센서는 362kV GIS의 차폐형 스페이서의 에폭시 주입구에 장착하고 각 센서의 PD 검출 감도와 주파수 특성을 측정하고 비교하였다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.11
• /
• pp.1294-1302
• /
• 2008

A design approach for a radiation element of dual polarization, which can be implemented in the waveguide structure, is proposed. For minimization of the radiating element, the ridged waveguide type is used and for dual polarization, the microstrip type of printed dipole structure is additionally installed inside the waveguide. In order to validate the design approach, $1{\times}4$ array antenna is fabricated and its performances such as return loss, co-polarization coupling between adjacent channels, and radiation patterns are investigated. Theory and experiment are observed to be in good agreement. The radiating structure is thought to be a useful one in an application to the phased array antenna system, in particular, requiring dual polarization characteristics.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.4
• /
• pp.473-478
• /
• 2011

The extent of a rectangular conducting plane for measuring electromagnetic interference is discussed. Mutual coupling between the transmit and receive antennas is negligible, the effects of the ground plane on the normalized site attenuation(NSA) are considered by applying GTD(Geometric theory of diffraction). The calculation was done for the case that measuring distance(d) was 3 m for both horizontal and vertical polarizations. As the result, the size of the rectangular ground plane almost never affects upon NSA for horizontal polarization, but for vertical case, when both width and length of the rectangular plane are several times as long as distance, the effects of the edges are reduced under 1 dB.