• 한국인쇄학회지
• /
• 제16권3호
• /
• pp.15-27
• /
• 1998

Several aspects of polymer dispersed liquid crystal(PDLC) film properties make them interesting for display application. Most versions of PDLC materials are able to modulate light without the use of polarizers, which offers advantages in optical throughput(brightness) and viewing angle compared to polarizer-based display. In this papers, we attemped to doe minimum of remaining liquid crystals at polymer network for the liquid crystal-polymer composite (LCPC) films. In results, best phase separation behaviors turned out liquid crystal/monomer/oligomer mixture system.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1996년도 춘계학술대회 논문집
• /
• pp.232-234
• /
• 1996

We have investigated the effect of molecular structure of polymer of rubbed polyimide (PI) films for surface liquid crystal alignment. To obtain surface alignment effect of Polymer molecular structure, we measured the polar (out of plane-tilt) anchoring strength and surface ordering of 5CB on rubbed PI surfaces. We have found that the polar anchoring strength of 5CB is depend on the polymer molecular structure of these unidirectionally rubbed PI surfaces.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 C
• /
• pp.1577-1578
• /
• 1997

We have studied the effect of the rubbing fabric for liquid crystal alignment and pretilt angle generation in nematic liquid crystals (NLC), 4-cyano-4-n-penthylbiphenyl (5CB), on rubbed polyimide (PI) surfaces. The pretilt angle of 5CB for nylon and rayon fabric is larger than that of cotton fabric in weak rubbing on rubbed PI surfaces. We conclude that the pretilt angle of 5CB is strongly related to the rubbing fabrics on rubbed PI surfaces.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2001년도 제12회 정기총회 및 01년도 동계학술발표회
• /
• pp.206-207
• /
• 2001

The photorefractive (PR) effect in liquid crystals sandwiched between photoconductive polymer layers was first studied by Ono et al. They reported that the PR effect vanished at steady state If there were not insulating layers because no charge trapping occurred in the photoconductive poly(N-vinylcarbazole) (PVK) layers. However we observed a significant PR effect in the polymer layered liquid crystal (PLLC) system where a liquid crystal layer doped with fullerene is sandwiched between two photoconductive PVK layers. (omitted)

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.133-136
• /
• 2000

We investigated the improvement of viewing angle using a patterned double twisted (PDT) vertical-alignment (VA) cell mode on a homeotropic alignment layer. Good voltage-transmittance curves for negative dielectric anisotropic nematic liquid crystal (NLC) using the PDT-VA cell without a negative compensation film were obtained. The viewing angle of the PDT-VA cell without a negative compensation film was wider than that of a conventional VA cell.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 춘계학술대회 논문집 디스플레이 광소자 분야
• /
• pp.177-180
• /
• 2000

In this study, we investigated the pretilt angle generation and liquid crystal (LC) alignment by ultraviolet (UV) exposure during imidization of polyimide on the polymer with side chain. The generated pretilt angle of nematic (N) LC using in-situ photo-alignment method was smaller than that of the conventional UV photo-alignment method. Also, the generated pretilt angle of NLC tends to increase by annealing.

• 한국전기전자재료학회논문지
• /
• 제11권6호
• /
• pp.481-485
• /
• 1998

We investigated the generation of high pretilt angle for nematic liquid crystal (NLC) in a cell with obilique non-polarized ultraviolet (UV) light irradiation on mixtured polyimide surface. It was found that the monodomain alignment of NLC is obtained with an angle of incidence of 75∼85 degrees on PI surface. We consider that the monodomain alignment of NLC is attributed to anisotropic dispersion force effect to photo-depolymerization of polymer. We successfully observed that the pretilt angle of NLC is generated above 5 degree with an angle of incidence of 75∼85 degrees. It is considered that the pretilt angle generation NLC is attributed to interaction between the LC molecules and the polymer surfaces.

• 한국전기전자재료학회논문지
• /
• 제11권6호
• /
• pp.477-480
• /
• 1998

In this paper, we investigated the liquid crystal(LC) alignment and generation of pretilt angle by using photo-alignment techniques on two kinds of polyimide(PI) surface, It was found that the uniform alignment for nematic(N) LC is obtained in a cell with slanted UV light irradiation on PI surface without side chain. We successfully observed that the pretilt angle of NLC is generated about $3^{\circ}$ with an incident angle of 70 degree on the PI surface without side chain. It is considered that the pretilt angle generation in NLC is attributed to interaction between the LC molecules and the polymer surfaces.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.53-54
• /
• 2006

We have studied the viewing angle control of a twist nematic liquid crystal display (TN-LCD). The TN-LCD exhibits a bad image quality along vertical direction, due to characteristics such as low contrast ratio and grey scale inversion. The proposed new TN-LCD has the function of switching between the wide viewing mode and narrow viewing angle mode using two tilted LC layers at both sides of a TN-cell Tilt angles of the two LC layers, $14^{\circ}$ and $60^{\circ}$ were required in both wide viewing angle and narrow viewing angle modes, respectively.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 춘계학술대회 논문집 디스플레이 광소자분야
• /
• pp.150-152
• /
• 2004

We have studied contrast ratio of a homogeneously aligned nematic liquid crystal (LC) display as a function of the angle between the polarizer axis and LC director. The results show that a cell configuration in which a polarizer axis facing a light source coincides with a short LC axis has a better process margin in terms of high contrast ratio than that of the cell coinciding with a long LC axis.