• Journal of Korea Soil Environment Society
• /
• v.4 no.2
• /
• pp.163-174
• /
• 1999

This paper presents a case history of remedial action adopted for contaminated groundwater in a landfill. The objectives of the projects are : (1) to effectively confine contaminated groundwater with an economically reasonable means, (2) to prevent further contamination of soil by collecting and treat the contaminant. and (3) to assure the environmental safety of the landfill during its operating period. Reported are the process from site investigation, through design and construction of an appropriate remedial action, to the monitoring of the selected confinement system. In view of the results of site investigation, deep soil mixing cutoff wall using the DMW(deep soil mixing cutoff wall) method and specially produced HEC soil stabilizer were used for the construction of deep soil mixing cutoff wall. For rock foundation with sever fractures, chemical grout curtain with urethane was installed. The monitoring results to date indicate that the selected vertical barrier performed satisfactorily.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.39 no.5
• /
• pp.474-480
• /
• 2011

Space Imaging Sensor operated on LEO is affected from the Earth IR and Albedo as well as the Sun Radiation. The Imaging Sensor exposed to extreme environment needs thermal control subsystem to be maintained in operating/non-operating allowable temperature. Generally, units are periodically dissipated on spacecraft panel, which is designed as radiator. Because thermal design of the imaging sensor inside a spacecraft is isolated, heat pipes connected to radiators on the panel efficiently transfer dissipation of the units. First of all, preliminary thermal design of radiating area and heater power is performed through steady energy balance equation. Based on preliminary thermal design, on-orbit thermal analysis is calculated by SINDA, so calculation for thermal design could be easy and rapid. Radiators are designed to rib-type in order to maintain radiating performance and reduce mass. After on-orbit thermal analysis, thermal requirements for Space Imaging Sensor are verified.

• Journal of Digital Convergence
• /
• v.14 no.2
• /
• pp.41-48
• /
• 2016

This paper identifies the factors affecting user satisfaction for the successful application of Smart-education in national defense recently at the national level and suggests the political implications through the empirical research to nurture creative talents globally. The study model was designed by setting the influencing factors on the user satisfaction of smart education. In order to verify the reliability of the measurement item, it was calculating the coefficient Cronbach's ${\alpha}$ and validity was verified by carrying out factor analysis. The empirical results of this doctoral dissertation as a Smart-education, factors affecting user satisfaction, content, management, internal organization, user characteristics, such as classified into five areas detailed factors as independent variables correlation analyzes were carried out factors influencing the most effective impact on training and user satisfactions were tested.

• Convergence Security Journal
• /
• v.7 no.2
• /
• pp.81-89
• /
• 2007

Mobile computing environment that support so that can offer employees inside information that enterprise has always improves business productivity and fetches efficiency enlargement. In this paper, limit model that can process ERP information by real-time as easy and convenient always utilizing radio network and PDA, Mobile camera based on Mobile vision concept. Calculable information between seller and customer is supplied supplying real-time brand image and information by practical use of Enterprise Resource Planning doing based on Mobile. Technical development and commercialization that utilize mobility, enforcement stronghold, portability etc. that is advantage of Mobile communication are required. In this paper, mobility of precious metals.jewel field that use portable terminal equipment taking advantage of a Mobile technology is secured. Constructed Mobile vision system that satisfy photography and bar-code scan at the same time from Mobile camera.

• Korean Journal of Social Welfare
• /
• v.66 no.4
• /
• pp.281-306
• /
• 2014

This paper explores the how the disability type, severeness and economic activeness affects marital satisfaction, and seeks to improve marital satisfaction among disabled by clarifying mediating effects of discriminatory experiences in everyday experiences. This research was done with 3,463 married disabled who were prone to everyday discrimination, among whom were enrolled in research database of Employment Development Institute of Korea Employment Promotion Agency for the Disabled. The research showed positive effects between marital satisfaction and everyday discriminatory experience except for unemployed people and severe among all the disabled type (external disability, sensory disability, mental disability, internal disability), disability severeness (severe and light), and economic activeness (paid workers, self-employed, home-worker, unemployed, not economically active). Also, relationship between disability type, severeness, economical activeness and marital satisfaction was partly mediated through everyday discriminatory experiences. Therefore, active movements to reduce everyday discrimination are strongly advised.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.3B
• /
• pp.493-502
• /
• 2010

In this paper we propose a scalable sensor network system that makes mesh network among the sink nodes to solve the scalability problem of existing sensor network which is caused by multi-hop networking between the sensor nodes. In the proposed system, the sink nodes have the wireless networking ability to communicate with another sink nodes in mesh fashion, and with the monitoring nodes which is located in the local area or internet area. Especially, the system includes L4(Application Layer) routing mechanism that provides subscribe/publish service to serve selective transmission of sensor data to the specific monitoring nodes. The collected sensor data is transmitted to the monitoring nodes when the sensor data is matched with the monitoring node's interesting value.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.3
• /
• pp.569-577
• /
• 1999

A wideband RF receiver for satellite mobile communications system was fabricated and evaluated of performance in low noise amplifier and high gain amplifier. The low noise amplifier used to the resistive decoupling and self-bias circuits. The low noise amplifier is fabricated with both the RF circuits and the self-bias circuits. Using a INA-03184, the high gain amplifier consists of matched amplifier type. The active bias circuitry can be used to provide temperature stability without requiring the large voltage drop or relatively high-dissipated power needed with a bias stabilized resistor. The bandpass filter was used to reduce a spurious level. As a result, the characteristics of the receiver implemented here show more than 55 dB in gain, 50.83 dBc in a spurious level and less than 1.8 : 1 in input and output voltage standing wave ratio(VSWR), especially the carrier to noise ratio is a 43.15 dB/Hz at a 1 KHz from 1537.5 MHz.

• Journal of Digital Convergence
• /
• v.8 no.1
• /
• pp.1-10
• /
• 2010

Since 2004, the Korean government has been engaged in u-IT new technology verification projects in an effort to level up the industries. Recently, cases are reported that RFID/USN technology has been adopted and applied to business processes, mainly by large enterprises. However, further policies and support for the industries have been restrained because of unavailability of essential data for policy making. Therefore, the study examined the level of satisfaction among the actual recipient organizations from the 27 pilot projects to draw implications from the study result. Accordingly, the level of satisfaction was assessed in four project phases from RFID/USN building, utilization (technical quality), utilization (business quality), to maintenance. The study result showed that the technical stability reached a significant level but the level of satisfaction in the maintenance phase for the utilization and proliferation of the technology remained at the lowest. It suggested that a more specified policy support is needed in the maintenance phase to include inexpensive supply of tags and devices, a maintenance establishment of consortium to maintain reliability and continuity of service, strengthening internal competence of the beneficiary organizations for utilization of RFID/USN.

• Journal of Applied Tourism Food and Beverage Management and Research
• /
• v.12 no.2
• /
• pp.59-78
• /
• 2001

The domestic food service industry has established its industrial basis since the overseas brands were introduced and international events were held in Korea. It also has showed a prominent growth rate as consumers began to show more interests in leisure and quality of working life(QWL) At this, the employees, constituting Points of contacts with consumers of the food service industry, have emerged as a Primarily critical concern in order for the food service industry, which can affect people in various ways, to adopt our own food culture and develop its business quality. In the food service industry, as a relatively labour-intensive industry, the manpower service is considered very important. Whether the industry succeeds or not depends on the role of employees as the quality of service of employees can decide the quality of the industry itself. In spite of the importance of employees in the food service industry, not many researches have been Performed on the personnel management of the industry, as Koreans traditionally have hold a prejudiced view on the food service industry and it is only a short time since the food business began to be considered as an industry. This thesis aims at research on the factors affecting job satisfaction of the employees by dealing with the importance and characteristics of the role of employees of the food service industry and theoretical background of the job satisfaction. The presumable factors affecting the job satisfaction are divided into several groups ; characteristics of organization, working condition, human relationship, psychological factors, and its reputation in the labour market. Hypotheses and models, where those factors affect the employees, are formed. Statistical methods such as correlation analysis and multiple regression are used in order to verify those hypotheses. Alternatives to improve job satisfaction of employees are suggested based on the analysis. It is expected that there will be more active researches on employees of the food service industry, as this thesis has selected employees of the food service industry as its subjects while subjects of similar researches have been mainly hotel employees so far.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.1-4
• /
• 2008

Flat plate slab has been widely used in high rise building for its remarkable advantages. However, Flat plate structures under lateral load are susceptible to punching shear of the slab-column connection. Exterior slab-column connections has an unsymmetrical critical section for eccentric shear of which perimeter is less than that of interior connection, and hence, around the connection, unbalanced moment and eccentric shear are developed by both gravity load and lateral loads. Therefore, exterior connections is susceptible to punching shear failure. For that reason, this study compare ACI 318-05 to CEB-FIP MC 90 that is based on experiment results and existing data of flat plate exterior connections. This study shows that compared to CEB-FIP MC 90 is more exact about eccentric shear stress, unbalanced moment and Both of all are not suitable in large column aspect ratio. Considering gravity shear ratio, These are suitable but design condition only consider gravity shear ratio. So these should be considered differences from change of design condition