• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11a
• /
• pp.312-315
• /
• 2001

Recently organic electroluminescent devices have been intensively investigated for using in full-color flat-panel display. Since the quantum efficiency of electrophosphorescent device decrease rapidly as the luminance increase, it is desirable to operate the electrophosphorescent display with active matrix rather than passive matrix. Here we report the study of driving electrophosphorescent diode with all organic thin film transistor(OTFT). The structure of electrophosphorescent diode is ITO/TPD/BCP:Ir(ppy)$_3$/BCP/Alq$_3$/Li:Al/Al. In OTFT, Polymer is used as an insulator and pentacene as an active layer. Detailed performance of the integrated device will be discussed.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1994.05a
• /
• pp.79-82
• /
• 1994

We have manufacture Copper-tetra-tert-butylphalocyanine (CuTBP)Langmuir-Blodgett(LB) films, which is known be sensitive to NO$_2$ gab. A response of these films to the NO$_2$ gab was studied. A surface pleasure of 25mN/m was obtained as a proper one for a film deposition. A deposited film status was identified with Uv/visible absorption spectra, ellipsometry measurements, and current-voltage(I-Y) characteristics. The NO$_2$ gas response experiments under 200ppm conducentration show that there are increment of electrical conductivity by 12 times, 5 seconds of response time, and 5 seconds of response time, and 90 seconds of recovery time.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1994.05a
• /
• pp.75-78
• /
• 1994

Organic ultra thin films about 500${\AA}$ in thickness are fabricated by LB(Langmuir-Blodgett) technique and their gas detect properties are investigated. The LB films deposited are made of the specimen named as N-docosyl pyridinium(TCNQ) and the deposition is verified by capacitance conductivity measurement. From the study of gas detect properties with I-V characteristics and UV spectrum we have found that their conductivities were increased about 3 times of magnitude and peaks of UV spectrum were decreased.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2011.05a
• /
• pp.133-134
• /
• 2011

전기도금을 이용하여 $TiO_2$ 입자들을 니켈 도금층에 넣은 Ni-$TiO_2$ 복합체를 만들때 pH, 전류형태에 따른 열적안정성에 대한 영향을 평가하였다. pH 범위는 1, 2, 3.4 였으며, 전류형태는 직류, duty cycle 50%의 펄스를 사용하였다. pH가 낮으면 도금속도는 낮아졌으나 $TiO_2$의 부피분율은 증가하였고, 펄스를 이용하면 도금속도는 증가하였으나 $TiO_2$ 부피분율은 감소하였다. 경도는 pH가 낮으면 상온에서는 낮았으나 고온에서는 상대적으로 경도값이 높았다.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.11
• /
• pp.1112-1117
• /
• 2006

• 한국방재학회:학술대회논문집
• /
• 2008.02a
• /
• pp.605-608
• /
• 2008

Storm and flood damage management systems in national disaster management system(NDMS) were organized into three operation systems. They are prevention, preparation, response, and recovery systems. Disaster resources in each system must be promptly and exactly applied to minimize casualties and loss of properties. However, the disaster resources in current management system can not be immediately used in calamity situation due to the lack of efficiency in statistical data. Therefore, it is necessary to classify the emergency restoration equipment for efficient management and mobilization of disaster resources in disaster situation. In this study, field survey was executed to appropriately classify the emergency restoration equipment. Problems and reformation points of the disaster resources system were also presented to improve the classification technique and to construct the data base.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2006.05a
• /
• pp.20-24
• /
• 2006

In this paper we investigated the method of examining the accelerated life test on LED traffic signal module by the temperature. The longevity presumption of the LED type signal light by a general heat cycle test used and executed cycle when it was done to longevity by the heat cycle test number and the acceleration factor of a real system requirements of this heat cycle test. Therefore, it reports on the introduction of the acceleration type from which the LED traffic signal module is done here to clarify the above-mentioned acceleration factor with the object and the acceleration factor is requested the test atmosphere actually in the system requirements.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2015.05a
• /
• pp.157-158
• /
• 2015

$Ni-TiO_2$ 복합체를 전기도금법으로 제조할 때, pH, 전류밀도 변화에 따른 $TiO_2$ 부피분율을 측정하였다. 산화물의 부피분율은 pH가 높아질수록 낮아지고, 전류밀도가 증가하면, $100mA/cm^2$에서 최댓값을 가진 뒤에 감소하였다. 기존의 산화물 공석량 예측식 모델에 수소발생반응을 고려하여 적용한 결과, 기존 모델보다 실험값과 예측값의 정확도가 더 높았다. 따라서, 산화물이 전기도금층에 공석될 때에는 수소이온의 환원반응과 니켈이온의 환원반응을 종합적으로 고려하여야 한다.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2009.10a
• /
• pp.153-154
• /
• 2009

원자력발전소 증기발생기 전열관 보수 기술의 하나로 니켈 합금 전기 도금이 연구되고 있다. 여러 도금 공정변수 중 peak current density를 달리하여 Ni-P-Fe 전기도금층을 제조한 뒤, 열처리 온도 $325^{\circ}C$에서 10, 30일간 열처리를 한 후, 인장강도와 연신율을 측정하고, 그 파단면을 관찰하였다. 50mA/$cm^2$로 제조된 도금층은 100mA/$cm^2$로 제조된 도금층에 비해 우수한 열적안정성을 가짐을 알 수 있었다.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2012.05a
• /
• pp.315-316
• /
• 2012

전기도금법으로 제조한 $Ni-TiO_2$ 복합체에 교반 속도가 전류효율에 미치는 영향을 연구하였다. 교반은 공기를 불어넣은 공기교반과 자석막대를 회전시킨 자석교반으로 나누어 실시하였다. 교반 속도는 공기교반의 경우에는 0.5, 1.0, 1.5 L/min, 자석교반의 경우에는 100, 200, 300, 400, 500 rpm으로 변화시켜 $Ni-TiO_2$ 복합체의 전류효율과 순수 니켈의 전류효율 변화를 관찰하였다. 순수 니켈의 경우 전류효율이 두 종류의 교반 방식 모두, 속도가 높아질수록 다소 감소하였으나, 그 폭이 크지 않았다. 반면, $Ni-TiO_2$ 복합체의 경우에는 교반 속도가 높아지면, 전류효율이 급격히 감소하였다. 특히, 공기교반의 경우에는 1.0L/min에서 1.5L/min으로 교반속도가 증가하면 전류효율이 크게 감소하였다.