• Resources Recycling
• /
• v.15 no.2 s.70
• /
• pp.45-49
• /
• 2006

The removal of copper ion from aqueous solution by adsorption with bone char that made from spent pig bone has been studied. This paper was studied the effects of bone char dosage and pH. The optimal results show that bone char adsorbs about 96.5 percent of copper ion in aqueous solution containing 50 mg/L as initial concentration at pH 5.0 when the bone char of 5g/L is used for 30 hours. Increase in the initial pH of the copper solution resulted in an increase in the copper ion uptake per weight of the sorbent Freundlich isotherm model was found to be applicable for the experimental data of $Cu^{2+}$.

• Journal of the Korean Chemical Society
• /
• v.36 no.5
• /
• pp.632-637
• /
• 1992

Standard transfer free energies of sodium and cupric perchlorates in water-acetylacetone solvent system have been determined by electromotive force measurements of galvanic cell and these energies of sodium and cupric ions in this solvent system have been evaluated by the tetrabutylammonium tetraphenylborate assumption as the extrathermodynamic procedure. Standard transfer free energy values of sodium and cupric ions from water to acetylacetone solvent were 5.09 and 4.16 kcal/mol at 25${\circ}C$, respectively. These values mean that acetylacetone is much weaker donor solvent to sodium and cupric ions than water. The standard transfer free energy value of cupric ion from water to mixture solvents which contain small amount of acetylacetone is changed by an unusual form. This is because of the chelate formation effect of acetylacetone to cupric ion.

• Journal of the Korean Electrochemical Society
• /
• v.15 no.1
• /
• pp.41-47
• /
• 2012

An annular flow type of copper electrolysis reactor was setup in order to generate the copper ions to remove algae in water. The operating characteristics of the reactor and the effect of copper ion on algae have been considered. By controling the applied current, the copper ion concentration could be obtained as desired level and the faradaic efficiency was above 90%. When the flow rate was increased, the copper ion concentration was linearly decreased due to the dilution effect and the effect of concentration overpotential was insignificant. With the increase of pH in water, the copper ion concentration was linearly decreased and not affected by the conductivity of the water. The concentration of chlorophyll-a was sharply decreased with the increase of copper ion concentration. The algae was effectively removed as the copper ion concentration was above 0.2 ppm. There was no difference between the copper ions obtained by dissolving copper sulfate and those produced by copper electrolysis. The algae removal efficiency was above 90% after 5 days as the copper ion concentration was above 0.4 ppm.

• Korean Chemical Engineering Research
• /
• v.52 no.2
• /
• pp.272-277
• /
• 2014

In this study the nanofiltration (NF) membrane treatment of a sulfuric acid waste solutions containing copper ion ($Cu^{+2}$) discharging from the etching processes of the printed circuit board (PCB) manufacturing industry has been studied for the recycling of acid etching solution. SelRO MPS-34 4040 NF membrane from Koch company was tested to obtain the basic NF data for recycling of etching solution and separation efficiency (total rejection) of copper ion. NF experiments were carried out with a cross-flow membrane filtration laboratory system. The permeate flux was decreased with the increasing copper ion concentration in sulfuric acid solution and lowering pH of acid solution, and its value was the range of $4.5{\sim}23L/m^2{\cdot}h$. Total rejection of copper ion was decreased with the increasing copper ion concentration, lowering pH of acid solution and decreasing cross-flow rate. The total rejection of copper ion was more than 70% at the experimental condition. The SelRO MPS-34 4040 NF membrane was represented the stable flux and rejection for 1 year operation.

• Membrane Journal
• /
• v.23 no.1
• /
• pp.92-99
• /
• 2013

In this study the nanofiltration (NF) membrane treatment of a sulfuric acid waste solutions containing copper ion ($Cu^{+2}$) discharging from the etching processes of the printed circuit board (PCB) manufacturing industry has been studied for the recycling of acid etching solution. SelRO MPS-34 4040 NF membrane from Koch company was tested to obtain the basic NF data for recycling of etching solution and separation efficiency (total rejection) of copper ion. NF experiments were carried out with a dead-end membrane filtration laboratory system. The pure water flux was increased with the increasing storage time in sulfuric acid solution and lowering pH of acid solution because of the enhancement of NF membrane damage by sulfuric acid. The permeate flux of acid solution was decreased with the increasing copper ion concentration. Total rejection of copper ion was decreased with the increasing storage time in sulfuric acid solution and copper ion concentration, and lowering the pH of acid solution. The total rejection of copper ion was decreased from initial 37% to 15% minimum value.

• Polymer(Korea)
• /
• v.38 no.6
• /
• pp.801-808
• /
• 2014

Ion diffusion and chemical binding to acrylic polymer were investigated in a solid film. The composition of acrylic monomers containing amino group and carboxylic acid was adjusted for rapid ion migration in the film. p-Methylred (PMR) and phenolphthalein derivatives were optically sensitive to the concentration of proton and hydroxyl anion, respectively and verified the ion migration through the film layers. A rapid proton migration was observed in the film of a high amino content. On the other hand, $OH^-$ migration occurred rapidly in a high content of carboxylic acid group. The proton migration occurred through the internal layer as well as surface layer of a film and was reversible during 50 repetition examination. Copper(II) ion migration was examined with a Rhodamine-containing polymer film. The light absorption and emission spectra of a Rhodamine-Cu complex showed the key contribution of carboxylic acid group to the Cu(II) migration in a film.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2007.11a
• /
• pp.83-84
• /
• 2007

Damascene 공정을 이용하여 80nm급의 trench 패턴 내에 구리 배선 형성을 위해 무전해 구리 도금법을 이용하였다. 화학 반응으로 진행되는 무전해 도금법에 의한 구리이온의 초미세 패턴 내 환원 과정에 구리 이온의 물질 전달과정이 구리 도금층의 표면 특성과 superconformality에 미치는 영향을 살펴보았다. 회전 전극에 고정된 칩의 회전 속도가 증가함에 따라 구리 도금층의 비저항이 감소하고, trench 내 균일 도금성이 향상되는 것으로 나타났다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.12
• /
• pp.100-105
• /
• 2017

An 8-hydroxyquinoline compound that was synthesized with 8-hydroxyquinoline-2-carboxaldehyde and 4-aminoantipyrine was investigated for use as the sensing material of a fiber-optic copper ion sensor in an aqueous environment. The experiment was conducted with a fiber-optic measurement system, in order to evaluate the relationship between the absorbance peak and copper ion concentration. The synthesized derivative exhibited a (highly selective) chromogenic phenomenon for copper ions among various metal ions in an aqueous environment and showed a specific absorbance peak at a wavelength of 530 nm for copper ions. The effect of mercury ions was investigated to evaluate the selectivity of the prepared synthesized derivatives toward Cu ions. The absorbance was measured at various concentration ratios of Cu and Hg ions (Cu:Hg ratios from 0.05 to 20), and it was found that the absorbance at 530 nm tended to increase with increasing Cu ion concentration. The experimental results also showed the linear relationship between the logarithmic concentration of copper ions and the specific absorbance peak at a wavelength of 530 nm. These results indicate that the synthesized 8-hydroxyquinoline compound has selectivity for copper ions and can be used as a sensing material for fiber-optic copper ion sensors.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.237-237
• /
• 2009

전도 특성을 가지는 나노선 제작의 연구가 활발하게 진행되고 있다. 본 실험에서는 높은 전도성을 가지는 구리 이온을 이용하여 나노선을 제작하는 실험을 진행하였으며 제작된 구리-나노선의 전도특성을 분석하여 구리 이온 치환 정도에 따른 DNA 전도성 개선 여부를 확인하였다. DNA를 기반으로 구리 Metalization 횟수가 늘어날수록 나노선이 연속적으로 형성되며 선형적이고 높은 전도특성을 가지게 되는 것을 확인할 수 있었다. 이 결과로부터 본 연구에서 사용한 방법을 이용하여 제작된 구리 나노선이 향후 나노소자 제작에 크기 기여할 것으로 기대한다.

• Journal of the Korean Chemical Society
• /
• v.51 no.2
• /
• pp.141-146
• /
• 2007

The present paper describes a procedure for separation, preconcentration and determination of trace amount of copper in natural water samples by using 2-mercaptobenzimidazol as the complexing agent. The proposed method is based on the surfactant aggregation formed on γ-alumina by mixing sodium dodecyl sulfate and γ-alumina in water; 2-mercaptobenzimidazol was incorporated into inner hydrophobic part of produced ad-micelles in acidic media to produce an assemble suitable for preconcentration and determination of copper ion. Optimum experimental conditions for adsorption of μg/ml levels of copper ions from aqueous solution by the adsorbent have been reported. The copper ions were quantitively adsorbed by the sorbent over the pH range of 7.1-8.0 and were quantitatively desorbed afterward by using sulfosalycilic acid as the eluent. The determination of copper was not interfered in the presence of common metal ions. The procedure was applied for analysis of river water sample. Relative standard deviation was found to be 4.91%.