• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 1993.04a
• /
• pp.80-84
• /
• 1993

공기베어링은 기체으 압축성에 의한 평균화 효과로 운전정밀도가 우수하고 기체의 낮은 점도에 의한 효과로 마찰력과 열발생량이 매우 적으며, 사용가능 온도구간이 저온에서 고온까지 넓고 프로세스 계통내의 기체를 윤활제로 사용할 수 있기 때문에 그 경우 불순물에 의한 오염이 문제되지 않는 장점등이 있다. 이와 같은 특성과 더불어 공기베어링은 지지 물체를 완전히 부상시켜 운전하므로써 마찰$\cdot$마모와 온도변화에 다른 열변형이 문제되지 않는다. 이러한 장점으로 인해서 공기베어링은 현재 정밀기기의 미끄럼면, 각종 측정장치의 테이블지지 기구로 많이 사용되고 있다. 반면 공기베어링의 단점으로는 기체의 낮은 점성계수로 인해서 부하능력이 적고 강성, 감쇄계수 또한 적다. 그리고 기체의 압축성으로 인해 뉴메틱 헤머라는 불안정 현상이 생기기도 한다. 본 연구에서는 스퀴즈 효과를 이용한 능동 공기베어링을 설계, 제작하여 실험하였다. 본 연구의 목적은 강성과 감쇄 계수가 작은 공기 베어링의 단점을 보완하기 위해 드러스트베어링을 대상으로 능동베어링을 설계, 제작하여 그 특성을 연구하고 기초 설계자료를 축적하는데 있다.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.25 no.9
• /
• pp.1391-1399
• /
• 2001

The AE measurement is one of the most convenient methods for detecting contacts between the slider and the disk. The AE method has been widely used in the investigation of the tribology of sliding interfaces due to its convenience. We examined the relationship between the AE signal and the flying height of a slider. We investigated the influence of the disk linear velocity on the AE rms signal by using the AE measurement system. The experiment also gives the relationship between the take-off velocity and the disk surface conditions. To investigate the behavior of the slider further, the variances of the AE signals are analyzed. The experimental results indicate that the increase in the magnitude of the AE rms signal does not necessarily mean the slider/disk contacts.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.11a
• /
• pp.97-101
• /
• 2000

The AE measurement is one of the most convenient methods for detecting contacts between slider disk. The AE method has been widely used in the investigation of the tribology of sliding interfaces due to the convenience of using AE sensor. In this study, we examined the relationship between the AE signal and the flying height of a slider. We tried to know the influence of the disk velocity on the AE rms signal by using the AE measurement system. The experiment also gives the relationship between the take-off velocity and the disk surface state. To investigate the behavior of the slider further, the variances of the AE signal are analyzed. The results about a subambient pressure slider indicate that the increase in the magnitude of AE rms signal does not necessarily mean the slider/disk contacts.

• Proceedings of the SAREK Conference
• /
• 2004.06a
• /
• pp.54-54
• /
• 2004

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.6
• /
• pp.639-646
• /
• 2012

The characteristics of autoignited lifted flames in laminar jets of carbon monoxide/hydrogen fuels have been investigated experimentally in heated coflow air. In result, as the jet velocity increased, the blowoff was directly occurred from the nozzle-attached flame without experiencing a stabilized lifted flame, in the non-autoignited regime. In the autoignited regime, the autoignited lifted flame of carbon monoxide diluted by nitrogen was affected by the water vapor content in the compressed air oxidizer, as evidenced by the variation of the ignition delay time estimated by numerical calculation. In particular, in the autoignition regime at low temperatures with added hydrogen, the liftoff height of the autoignited lifted flames decreased and then increased as the jet velocity increased. Based on the mechanism in which the autoignited laminar lifted flame is stabilized by ignition delay time, the liftoff height can be influenced not only by the heat loss, but also by the preferential diffusion between momentum and mass diffusion in fuel jets during the autoignition process.

• Economic and Environmental Geology
• /
• v.35 no.6
• /
• pp.581-588
• /
• 2002

• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.3
• /
• pp.329-336
• /
• 2008

The pilot study was conducted to evaluate the applicability of air flotation(AF) processes combined with biological nutrient removal(BNR) for the retrofitting of conventional wastewater treatment facilities. The BNR system was operated in pre-denitrification and intermittent aeration; developed ceramic membrane diffusers were installed to separate the solid-liquid of activated sludge at the bottom of a flotation tank. Before performing a pilot scale study, the size distribution of microbubbles generated by silica or alumina-based ceramic membrane diffusers was tested to identify the ability of solid-liquid separation. According to the experimental results, the separation and thickening efficiency of the alumina-based ceramic membrane diffuser was higher than the silica-based ceramic membrane diffuser. In a $100m^3/d$ pilot plant, thickened and return sludge concentration was measured to be higher than 15,000mg SS/L, therefore, the MLSS in the bioreactor was maintained at over 3,000mg SS/L. The effluent quality of the AF-BNR process was 4.2mg/L, 3.7mg/L, 10.6mg/L and 1.6mg/L for $BOD_5$, SS, T-N and T-P, respectively. Lastly, it was revealed that the unit treatment cost by flotation process is lower than about $1won/m^3$ compared to a gravity sedimentation process.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.57-60
• /
• 2008

Maglev is a system that a train runs levitated above a rail. Therefore it is very important to maintain a constant levitation gap for achieving serviceability and ride comfort. This study is a cooperation research subject of the 3-1 subject, performance improvement of maglev track structures, of the Center for Urban Maglev Program in Korea, started in 2006. The aim of this study is development of rapid constructions of bridge superstructure for maglev. At present, precast deck is widely used because of its superiority to cast-in-place concrete on quality and the term of works. The research group suggested basic systems of maglev guideway with PSC-U type and trapezoidal open steel box type girder, and precast deck, cooperating with Korea Railroad Research Institute, the managing institute of the 3-1 subject. In this study, a mock-up consisted of girders, decks and rail was fabricated and test was performed for constructability, serviceability and maintenance evaluation of PSC U-type girder, precast deck, and new guide rail system.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.6
• /
• pp.1886-1896
• /
• 1991

This paper presents a method to predict the flying height of the head slider in a hard disk drive. Quantitative predicts of the flying height according to the variations of the external load and the disk velocity have been done by numerical computation. In addition, the magnitude of the external load to keep flying height constant were also suggested. The Modified Reynolds' equation driven from hydrodynamic lubrication theory under slip flow condition was used to describe air-bearing system under the slider. To solve the equation, a Finite Volume Method (FVM) has been applied. To determine the final minimum flying height and pitch angle of the head slider, the Secant iteration method is used which update initial guess of the minimum flying height and pitch angle of the slider. In this study, the model head slider has been selected from a real hard disk drive which is equipped in many commercial personal computers. As a result, as the disk velocity increases at constant external load, the minimum flying height and the pitch angle increase due to the in crease of the air-bearing force at the bottom of slider.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.11a
• /
• pp.393-396
• /
• 2008

The study of nitrogen dilution effect on flame stability was experimentally investigated in non-premixed turbulent lifted hydrogen jet with coaxial air. hydrogen gas was used as a fuel and coaxial air was injected to make flame liftoff. And both of the fuel jet and coaxial air velocity were fixed as $u_F$=200 m/s and $u_A$=16 m/s, while nitrogen diluents mole fraction was varied from 0 to 0.2. For the analysis of flame structure and flame stabilization mechanism, the simultaneous measurement of PIV/OH PLIF had been performed. It was found that the turbulent flame propagation velocity increased as decreasing of nitrogen mole fraction. We concluded that the turbulent flame propagation velocity was expressed as a function of turbulent intensity, even though the mole fraction of nitrogen diluents gas was changed.