• The Transactions of the Korean Institute of Power Electronics
• /
• v.6 no.2
• /
• pp.173-179
• /
• 2001

This paper represents the control algorithm of the instantaneous voltage sag corrector for the power quality enhancement in distribution line. Especially, a novel detection technique of the symmetrical components is proposed for the analysis of the three-phase unbalanced and asymmetrical problems caused by the single line ground fault which is he most frequent event. This proposed method is based on the simple calculation and the control references of the symmetrical components for voltage compensation can be described as dc value without any other phase detection procedure. And also, for the generation of the reference voltages, the UF and MF defined by IEC is considered. Using this proposed control algorithm, the compensator has the fast dynamic characteristics and the THD of the compensated voltage waveform is very low. Finally, the validity of the proposed algorithm is proved by the PSCAD/EMTDC simulation and experimental results.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.3 s.118
• /
• pp.241-247
• /
• 2007

This paper introduces a new type push-push harmonic dielectric resonator oscillator. Proposed oscillators are utilized by HDRO(Harmonic Dielectric Resonator Oscillator) which are combined in push-push structure. As a result, fundamental signal suppression ratio and output power of harmonic signal has been improved. The increase of phase noise is compensated by improving coupling characteristic between resonator and parallel microstrip line. The proposed push-push HDRO shows the output power of 9.32 dBm, the fundamental signal suppression of -47.2 dBc and phase noise of -99.86 dBc at 100 kHz offset frequency and 18.7 GHz center frequency.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.20 no.1
• /
• pp.71-77
• /
• 2014

According to the increasement of demand for energy around globe, the concern degree of advanced countries for ocean energy including offshore wind power becomes excited. In domestic case, the government set up a goal that jumps up to the third ranked powerful nation of offshore wind in the world until 2020 and announced "The plan for 2.5-gigawatt wind farm off the south-west coast by 2019". Also the legal basis was created in order to support development of offshore wind power as 'A law on development, use, supply and promotion for New energy and renewable energy' was established by law. However to promote offshore wind power projects, there are much difficulties that developers should be applied by permitting use of public water surface and regulations of several domestic public institution. Therefore in this paper, we suggested an alternative to promote efficient offshore wind power projects by comparative analysis between domestic and foreign on regulatory pathways for siting and permitting offshore wind facilities.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.5
• /
• pp.145-151
• /
• 2010

Voltage unbalance is regarded as a power quality problem of significant at the user application. Although the voltages are quite well balanced at the transmission system, the voltage level of utilization can be unbalanced due to the unequal system impedances and the unequal distribution of single phase loads. Capacitor is generally used for power-factor compensation and reducing harmonics of non linear load with reactor. If voltage unbalance exists, current unbalance is generated and it will be reflected in the capacity variance. When the reactor and condenser are used at the same location, generally its trouble rate is high. And it is very important checking out that how the variance of voltage, current and capacity of condenser is proceeded by the voltage unbalance. In this paper, we calculated that voltage, current and capacity of condenser are within the tolerance limit of official regulations in the event of voltage unbalance with/without reactor.

• Superconductivity and Cryogenics
• /
• v.1 no.2
• /
• pp.14-20
• /
• 1999

초전도 재료는 선재의 형태로 가공하면 송전선이나 변압기, 발전기 그리고 전력 저장장치 등에 사용되어 전력계통의 효율을 극대화시킬 수 있는 재료로서 실제 응용 기기의 개발을 위해 많은 연구가 수행되고 있다. 더우기 1980년대 후반에 개발된 고온초전도 산화물 재료는 액체질수의 비등점인 77K 이상에서 초전도현상을 나타내어 초전도 현상의 응용에 대한 기대를 고조시켜 이에 대한 연구를 더욱 활성화시키고 있다. 초전도선재 연구는 그간 PIT(Powder in Tube) 공정을 이용한 Ag/Bi-2223(Ag/$Bi_2Sr_2Ca_2Cu_3O$) 선재가 높은 전기적 성질과 장선 가공상의 잇점으로 인해 많은 연구와 성과가 있었다. 그러나 Ag/Bi-2223선재는 강한 자기장 하에서 통전 능력이 현저하게 저하되는 성질 때문에 높은 자기장하에서 사용하기 위해서는 사용온도를 액체질소온도보다 상당히 낮은 20K 부근까지 낮추어야 한다는 점 때문에 전력기기 개발에 제한이 따르는 단점이 있다. 이에 반해 최근에 개발된 금속/YBCO 박막 복합선재는 높은 전기적 특성 이외에 특히 높은 자장에서도 통전 능력의 저하가 적어 제한 없이 전력기기의 모든 분야에 사용할 수 있는 특징이 있다. 따라서 1993년에 일본에서 Ni 금속기판에 물리적 증착방법으로 YBCO($YiBa_2Cu_3O$) 박막을 증착시킨 선재제조에 성공하고 있어 1996년에 Oak Ridge National Laboratories (ORNL)에서 Rolling Assisted Biaxially Textured Substrate (RaBiTS) 라는 집합조직을 형성시킨 금속기판이 개발되어 연속적인 가공의 가능성이 확인된 후 이의 특성향상 및 가공기술 개발을 위한 많은 연구가 수행되고 이다. 이 글에서는 이제 까지 개발된 금속기판을 사용한 YBCO계 초전도 박막형 선재의 제조기술 중에서 최근 가장 가능성 있는 것으로 평가되는 RABiTS 방법을 위주로 그 외에 IBAD와 ISD 방법에 관하여 소개하고 현재까지의 개발현황 및 앞으로의 전망에 대하여 간략하게 기술하고자 한다.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.2
• /
• pp.247-254
• /
• 2003

While the interests in the environmental problem during the construction are increasing, the use of low noise-vibration auger-drilled pilling is increasing to solve noise and vibration problem in pilling. Therefore, in Korea, SIP (Soil-Cement Injected Precast Pile) method is mainly used as auger-drilled pilling. However, there is no proper design criteria compatible with the ground condition of Korea, so which is most wanted. To improve and supplement this situation, direct shear tests for the friction between SIP pile skin interface and soil were executed on various conditions. Through the analysis of test results, skin friction characteristics of SIP were investigated thoroughly Also, hyperbolic model parameter fomulas which describe the friction behavior and the new non-linear unit skin friction capacity model with SM, SC soil were suggested.

• Proceedings of the Korean Institute Of Construction Engineering and Management
• /
• 2007.11a
• /
• pp.844-847
• /
• 2007

As the interest of environment is increasing all over the world, the effort to protect environment in many industries is also being made. In the case of Construction, the effort keeps being made in effect as well. Therefore, this paper suggests the environmental-friendly smart component system which contains multiple performances such as Environmental-friendly, high-durability, variability, renovation and comfort and could be the basic factor of future building. As the enquired performances for the development of environmentally-friendly intelligent component system are grasped, the key technology to be embodied are analyzed. In the result of the analysis, SI(Skeleton & Infill) housing and Home automation are deduced as the key technology. Furthermore, it look through concept and development tendency of the main factors. Finally environmental-friendly smart component system is suggested with conversing the factors deduced.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.5 s.120
• /
• pp.486-495
• /
• 2007

In this paper, we present the design procedure of BPF(Band Pass Filter) for the suppression of LO(Local Oscillator) harmonics. The required suppression at given harmonics is the key issues in such a filter design, while the bandwidth and the suppression of the unwanted signals are more important in the conventional RF filter design. In LO filter design the bandwidth is used for the minimization of the insertion loss for the desired signal. In addition, we propose the novel tuning procedure based on Momentum to consider the unknown parasitic effects, which usually are not included in the circuit design step and results in undesirable and frustrating tuning after fabrication.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.9
• /
• pp.2253-2260
• /
• 2009

The typical distribution systems have the power flow from distribution substations (sources) to customers (load) only as one direction. However, in the case where new energy power sources are connected to distribution systems, the output variations of new energy sources to distribution systems, which is so called reverse power flow, may cause the bi-directional power flow. So, the reverse power flow has severe impacts on typical power system, for example power quality problems, protection coordination problems, and so on. Therefore, this paper proposes the algorithm for Multi-functional protection devices in distribution systems in the case where new energy sources are interconnected. The proposed algorithm is verified to show the effectiveness by simulating and experimenting the prototype systems.

• Korean Journal of Remote Sensing
• /
• v.12 no.2
• /
• pp.155-168
• /
• 1996

Speckle noise has been a primary concern to many applications of synthetic aperture radar (SAR) imagery. In recent years, several satellites with radar imaging systems were launched and the use of SAR data are expected to be increased rapidly The objectives of this study are to provide introductory understanding on radar speckle filtering and to compare the effects of several filtering methods that are relatively unknown to user community. Two study sites were extracted from the RADARSAT SAR data obtained over the suburban areas near Seoul. The study sites include relatively homogeneous cover types, such as reservoir, parking lot, rice pad, and deciduous forest. Five filters (mean filter, median filter, sigma filter, local statistics filter, and autocorrelation filter) were applied to the SAR imagery and their effects were evaluated from the aspects of both image smoothing and edge preservation. In overall, the evaluation results indicate that the local statistics filter and autocorrelation filter, that are based on a speckle model, are more effective to suppress speckle within homogeneous cover type while maintaining the edge sharpness between cover types.