• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.7 no.3
• /
• pp.359-365
• /
• 1995

The drag reduction phenomenon with an additives of surfactant(STAC, stearlytrimethyl ammonium chloride) and polymer(PEO, polyethlene oxide) was investigated in fully developed turbulent pipe and channel flows at various low Reynolds numbers as well as very low additives concentration. A maximum of 70% drag reduction compared with plain water flow was found. This maximum drag reduction percentage obtained with surfactant solution was slightly higher than that of the Virk's asymptote in polymer solution.

• Journal of the Korean Applied Science and Technology
• /
• v.12 no.1
• /
• pp.101-107
• /
• 1995

As the surfactants that were used in micellar reaction, emulsion polymerization and phase-transfer reaction etc. have the problems, the cleavable surfactant was converted to inactive compound after such as the reaction in the condition. Because 1, 3-dioxolane ring by ketal or acetal reactioc is lack of stability in acid condition, it is easily made to acid-hydrolysis. And cmc value of the surfactant is assumed $1.0{\times}10^{-5}mol/L$ and surface tension in cmc is 31 dyne/cm. Compared with other surfactant, this surfactant foam property is not better. But emulsion property was relatively good. According as acid-hydrolysis property was observed the interface tension change between aqueous solution and benzene by the variation of pH and time, this surfactant was made to hydrolysis within about 300minutes in pH 1${\sims}$4. Therefore this surfactant is expected to be a good emulsifier that has the bad foam property and the acid-hydrolysis property in acid condition.

• Applied Chemistry for Engineering
• /
• v.20 no.1
• /
• pp.15-20
• /
• 2009

In this study, solubilization experiments of n-octane oil were performed by micellar solutions of polymeric nonionic surfactant Pluronic L64 ($EO_{13}PO_{30}EO_{13}$) at room temperature. A single spherical drop of n-octane was injected into aqueous surfactant solution using an oil drop contacting technique and solubilization rate of n-octane was measured by observing the size of oil drop with time. It was found that solubilization rate was independent of initial oil drop size but inversely proportional to the initial surfactant concentration. These results revealed that solubilization of n-octane oil by L64 micellar solution is controlled by interface-controlled mechanism rather than diffusion-controlled mechanism. Dynamic interfacial tension measurements showed that interfacial tension decreases such as from $2.59{\times}10^{-2}$ to $2.45{\times}10^{-2}$, and further to $2.13{\times}10^{-2}mN/m$ as surfactant concentration increases from 8 to 9 and further to 10 wt% respectively. The equilibration time was also found to decrease slightly with an increase in surfactant concentration. All three systems reached an equilibrium within 7 minutes.

• Korean Chemical Engineering Research
• /
• v.47 no.1
• /
• pp.24-30
• /
• 2009

In this study, solubilization experiments of n-decane, n-undecane and n-dodecane oil were performed by micellar solutions of polymeric nonionic surfactant Pluronic L64($EO_{13}PO_{30}EO_{13}$) at room temperature. A single spherical drop of hydrocarbon oil was injected into aqueous surfactant solution using an oil drop contacting technique and solubilization rate of hydrocarbon oil was measured by observing the size of oil drop with time. It was shown that solubilization rate decreased with the alkane carbon number(ACN) of the hydrocarbon oil. The solubilization rate was also found to be independent of initial oil dorp size and almost linearly proportional to the initial surfactant concentration. These results revealed that solubilization of n-decane, n-undecane and n-dodecane oils by L64 micellar solution is controlled by interface-controlled mechanism but not by diffusion-controlled mechanism. The equilibrium solubilization capacity(ESC) was measured by a turbidimeter and the result showed that EAC decreased with an increase in ACN but increased with both increases in surfactant concentration and solubilization rate. Dynamic interfacial tension measurements showed that interfacial tension and equilibrium time increased with an increase in ACN of hydrocarbon oil but decreased with an increase in surfactant concentration.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.2
• /
• pp.153-164
• /
• 1999

The solubilization of BTEX was evaluated in aqueous surfactant solutions with and without several additives. Anionic surfactant(Sodium Dodecyl Sulfate, SDS) and nonionic surfactants (NEODOL(equation omitted)25-3 and $SOFTANOL\circledR-90$ were used as test surfactants. The effects of surfactant HLB(Hydrophile-Lipophile Balance) Number and hydrocarbon molar volume and polarity of BTEX on the MSR(Molar Solubilization Ratio), micelle-water partition coefficient of BTEX, and CMC(C,itical Micelle Concentration) were investigated. Optimizing treatment conditions applicable to enhanced solubilization was also studied by manupulating salinity or electrolyte control with additives of ethyl alcohol, hydrotrope, and electrolyte solution. The most effective surfactant for solubilization was found $SOFTANOL\circledR-90$, since HLB number of 13.6 is similar to those values of BTEX ranging between 11.4 and 12.2, which was also proved experimentally. Ethyl alchohol of 3% was the most effective additives in reducing CMC and improving solubilization among the conditions using SDS, NEODOL(equation omitted)25-3, and $SOFTANOL\circledR-90$ with three additives. The partitioning of BTEX between surfactant micelles and aqueous solutions was characterized by a mole fraction micelle-phase/aqueous phase partion coefficient, $K_m$. Values of log $K_m$. for BTEX compounds in surfactant solutions of this study range from 2.95 to 3.76(100mM SDS) and 2.95 to 3.49(117mM $SOFTANOL\circledR-90$. Log $K_m$ appears to be a linear function of log $K_{ow}$ for SDS and $SOFTANOL\circledR-90$. A knowledge of partitioning of BTEX in aqueous surfactant system can be a prerequisite for the understanding of the behavior of hydrophobic organic compounds in soil-water systems in which surfactants play a role in remediation of contaminated soil and facilitated transport.

• Analytical Science and Technology
• /
• v.18 no.1
• /
• pp.35-42
• /
• 2005

This study reports the effect of $Mg^{2+}$ ions on the behavior of the anionic surfactant in electrophoresis. Intractions of $Mg^{2+}$ ions with carboxylates and sulfonates resulted large changes in their apparent mobilities. A comprehensive analysis of the electroosmotic and electrophoretic mobilities reveals that major cause for the variation of the apparent mobilities of anions arises from the electroosmotic mobilities.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.3
• /
• pp.428-434
• /
• 2016

In this study, benzyltrialkylammonium chlorides with different alkyl chain length were synthesized and applied to liposome. Prepared cationic surfactant embedded liposomes were measured particle size, zetapotential, release property and antibacterial activity. The average particle size of liposomes was 120~140 nm. As alkyl chain length was increased, the liposome size was increased. Zetapotential for the solution of liposomes added cationic surfactants were in the range of +80~90 mV. In release test, collagen release rate could be controlled by alkyl chain length. liposome embedded long alkyl chain surfactant had enhanced sustained release property. Entrapment efficiency of hydrophilic collagen were 25.9~27.5%.

• Korean Journal of Materials Research
• /
• v.4 no.2
• /
• pp.187-193
• /
• 1994

무전해 동도금액에서의 각종 안정제, 촉진제등의 첨가제에 따른 영향을 고찰하였다. 욕의 기본성분은 황산구리 10g/1, EDTA-2Na 40g/1, 포르말린 3ml/1, pH조절용 수산화나트륨 용액으로 조성하였고, 안정제, 도금촉진제 및 계면활성제의 첨가에 따른 분극곡선을 검토하여 도금욕의 경향을 검토한뒤 농도변화에 따른 도금속도를 측정하여 최적조건을 구하였다. 안정제는 $\alpha$, $\alpha$'-dipyridy1과 NaSCN을 혼합 사용하는 것이 좋았으며 촉진제로는 pyridine이 계면활성제로는 PEG 4000이 좋았다. 첨가량은 5mg/1이하의 미량이었으며 이후 첨가량이 증가함에 따라 증가함에 따라 도금속도는 직선적으로 감소하였다.

• Korean Chemical Engineering Research
• /
• v.51 no.4
• /
• pp.426-431
• /
• 2013

Nanosized $TiO_2$ particles were prepared from titanium (IV) sulfate solution using base solutions at low reaction temperature ($95^{\circ}C$) and atmospheric pressure by hydrothermal precipitation method without calcination. The effects of preparation conditions, such as kind of base solutions (NaOH, $NH_4OH$, Monoethanolamine, Diethanolamine, Triethanolamine) and surfactants (CTAB, Span 20, SDBS), concentration of surfactants, temperature and pH, on the physical properties of $TiO_2$ particles have been investigated by XRD, SEM and Zeta-potential meter. Absorption area was also investigated by DRS in order to confirm the photocatalytic activity of the nanosized $TiO_2$ particles. It was turned out that, among base solutions, NaOH provides the smallest $TiO_2$ particles with excellent crystallinity. And cationic surfactant (CTAB) prepared smaller $TiO_2$ particles than any other surfactants. When CTAB is added in the concentration ratio of $Ti(SO_4)_2$:CTAB=10:1, $TiO_2$ particles with particle diameter of 5.8 nm were prepared. This is approximately 1/10 of that prepared without CTAB.

• Journal of the Korean Chemical Society
• /
• v.42 no.4
• /
• pp.383-390
• /
• 1998

The interaction of phenoxide anion with several cationic surfactant micelles (DTAB, TTAB, CTAB, CDEAB, and CTAC) was studied by UV/Vis spectrophotometric method. The solubilization constants of phenoxide anion into the cationic micellar phase and the critical micelle concentration of these surfactants in the presence of the phenoxide anion could be determined from the absorbance changes. The measured solubilization constants were changed according to the following order: $K_s(CTAC)>K_s(CDEAB)>K_s(CTAB)>K_s(TTAB)>K_s(DTAB).$ Effects of salts(NaCl and NaBr) and n-alcohols(butanol, pentanol, and hexanol) on the solubilization of phenoxide anion by the TTAB system have been also measured and analyzed. There was a great decrease of solubilization constant and CMC with these additives. The standard Gibbs free energy, enthalpy, and entropy changes for the solubilization of phenoxide anion by the TTAB system were calculated from the temperature dependence of $K_s$ values.