• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.8
• /
• pp.5342-5348
• /
• 2014

Slope stability analyses were conducted to investigate the limitations of application of the standard inclination of slope and the effects of the berm width on the slope stability. The standard slope inclination could be applied to the basic slope sections that were considered for the analyses, whereas additional slope stability analysis should be performed for the case of considering ground water. A comparison of the factors of safety between the case of installing a berm and the case of letting the grading have an equivalent section area with the case of installing the berm, the factors of safety in the case of installing a berm were greater than those for the case of allowing grading, and the differences between the factors of safety increase with increasing berm width. For all the sections considered in the analyses, the increments of the safety factor were proportional to the width of the berm and those corresponding to the embankment slope and cut slope with a berm width of 7m were 34.5% and 48%, respectively.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.9 no.4
• /
• pp.45-59
• /
• 2006

In this study, the effects of the surface topographical characteristics on the meteorological fields are examined in a mesoscale meteorlolgical model. We calculated the direct solar radiation using the illumination angle considering the inclination of topography and tried to find out its effect on meteorological fields. In above experiments, we selected two cases for the clear day and the cloudy day to show the effect of weather and represented the results for two cases. In the correction of the direct solar radiation, the results of two cases indicate that there are obvious differences on the steep Taeback and Soback mountains. And on the time-series analysis the east-facing slope of these mountains receives the more direct solar radiation about $10-60W/m^2$ in the morning hours but lesser in the afternoon hours than the horizontal surface while it is opposite on the west-facing slope. And the results mentioned above are more obvious at clear day. With the same analysis method, at clear day, the surface skin temperature is higher at all hours than that on horizontal surface on the both of slope. At cloudy and rainy day, the surface skin temperature on the east-facing slope is higher in the morning hours but lower in the afternoon hours than that on horizontal surface. But on the west-facing slope, it is higher at all hours than that on horizontal surface. In the two cases, the temperature considering the slope of surface is almost higher than that on the horizontal surface. The wind is stronger than that on the horizontal surface with increasing pressure gradient force according as increasing temperature gradient around the Taeback and the Soback mountains.

• Water for future
• /
• v.26 no.2
• /
• pp.39-48
• /
• 1993

Since major reason of disaster in coastal area is wave action, prediction of wave deformation is one of the most important problems to ocean engineers. Wave deformations are due to physical factors such as shoaling effect, reflection, diffraction, refraction, scattering and radiation etc. Recently, numerical models are widely utilized to calculate wave deformation. In this study, the mild slope equation was used in calculatin gwave deformation which considers diffraction and refraction. In order to slove the governing equation, finite element method is introduced. Even though this method has some difficulties, it is proved to predict the wave deformation accurately even in complicated boundary conditions. To verify the validity of the numerical calculation, experiments were carried out in a model harbour of rectangular shape which has mild slope bottom. The results by F.E.M. are compared with those of both Lee's method and the experiment. The results of these three methods show reasonable agreement.

• Tunnel and Underground Space
• /
• v.18 no.5
• /
• pp.355-365
• /
• 2008

Displacement caused by tunneling is difficult to predict since it is affected by many factors such as ground condition, excavation method and supplementary method of reinforcement. In this study, horizontal inclinometer was employed to monitor ground settlements above a tunnel face before and after the excavation. Monitoring results were analyzed to predict the preceding displacement and settlement of the surface structures. The result of the analysis can be used to establish a proper counter measure which keeps the serviceability of the surface structures. Based on the analysis of the monitoring result, ground properties of the site were deduced and the influence of the tunnel excavation on the settlement of the foundation above the tunnel is analyzed.

• Asia-pacific Journal of Multimedia Services Convergent with Art, Humanities, and Sociology
• /
• v.5 no.2
• /
• pp.215-222
• /
• 2015

This paper presents the measurement of stress intensity factors of inclined cracks by use of photoelasticity. The distributions of isochromatics near a crack tip of the specimen loaded by uniaxially tensile load are used for analysis. Accuracy and reliability is enhanced by twice multiplying and sharpening the measured isochromatics using digital image processing. Photoelastic results are compared with those obtained by finite element method. Good agreement between them shows that the photoelastic analysis is reliable.

• Spatial Information Research
• /
• v.7 no.1
• /
• pp.1-12
• /
• 1999

The DTM(Digital Terrain Model) in GIS(Geographical Information System) shows the elevation from interpolation using data points surveyed. In panoramic flat landform, pixel size, resolution of source data may not be the problem in using DTM However, in mountainous landform like Korea, appropriate resolution accuracy of source data are important factors to represent the topography concerned. In this study, the difference in contour interval of source data, the resolution after interpolation, and different data structures were compared to figure out the accuracy of slope calculation using DTM from the topographic maps of Togyusan National Park Two types of GIS softwares, Idrisi(grid) ver. 2.0 using the altitude matrices and ArcView(TIN) ver. 3.0a using TIN were used for this purpose. After the analysis the conclusions are as follows: 1) The coarser resolution, the more smoothing effect inrepresenting the topography. 2) The coarser resolution the more difference between the grid-based Idrisi and the TIN-based ArcView. 3) Based on the comparison analysis of error for 30 points from clustering, there is not much difference among 10, 20, 30 m resolution in TIM-based Airview ranging from 4.9 to 6.2n However, the coarser resolution the more error for elevation and slope in the grid-based Idrisi. ranging from 6.3 to 10.9m. 4) Both Idrisi and ArcView could net consider breaklines of lanform like hilltops, valley bottoms.

• Proceedings of the Korean Association of Geographic Inforamtion Studies Conference
• /
• 2010.06a
• /
• pp.128-129
• /
• 2010

기존의 고도계는 레이더 특성에 의해 직하부의 높이 값을 정밀하게 관측할 수 없었다. 그러나 레이더 간섭 고도계는 SAR(Synthetic Aperture Radar) 영상의 칩 펄스(Chirp Pulse)를 이용한 고정밀 경사거리(Slant Range Distance)관측, 도플러 효과를 이용한 고정밀 경사각(Squint Angle)의 관측 및 레이더 간섭기법(SAR Interferometry)을 이용한 고정밀 관측각(Look Angle)의 관측을 가능하게 하였다. 이 연구의 목적은 레이더 간섭 고도계의 효율적인 신호처리 기법의 개발에 있다.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2003.11b
• /
• pp.106-111
• /
• 2003

본 연구에서는 수위-유량곡선식의 정도를 개선하는 방안으로 수위를 추정하는 과정에서 수면경사법을 이용하여 계산한 수위와 HEC-RAS 3.1.1 의 부정류 계산을 하여 얻어진 수위를 이용하여 유량을 계산한 값을 비교하였다. 그 결과 관측된 유량과 계산된 유량의 상대편차는 5.37%로 양호한 결과를 얻을 수 있었으며. 수면경사법을 이용하여 수위를 계산하여 수위-유량곡선식을 유도하는 것보다 HEC-RAS 3.1.1 부정류 모형을 이용한 수위자료를 이용하여 수위-유량곡선식을 유도하는 것이 정도를 높일 수 있을 것이라 판단된다.

• Bulletin of the Korean Space Science Society
• /
• 2003.10a
• /
• pp.22-22
• /
• 2003

1998년 12월부터 1999년 5월까지 총 10일간 소백산천문대의 61cm 망원경과 PM512 CCD 카메라를 이용하여 W UMa형 접촉 식쌍성 AM Cnc의 CCD 측광관측을 수행하여 BVI 광도곡선을 완성하였다. 새로운 광도곡선으로부터 주극심시각 2점, 부극심시각 3점을 얻었다. 이 관측치를 포함하여 AH Cnc의 관측된 모든 극심시각을 수집하여 분석한 결과, 영년 주기 증가를 보이고, 변화 원인을 질량이 큰 별에서 질량이 작은 별로의 보존적 질량이동에 의한 것으로 해석하였다. 영년주기 증가율은 3.18$\times$$10^{-7}$ day/year이다. 새로운 BVI 광도곡선을 WD 쌍성 모델의 접촉모드(Mode 3)로 분석하여 측광해를 산출하였고, 측광해의 결과는 질량비 0.159, 궤도경사각 86$^{\circ}$, 접촉도(fill-out factor) 49%등으로 계산되었다. 측광해를 Sandquist & Shetrone(2003)의 연구결과와 비교하면 질량비와 궤도경사각은 거의 같고, 접촉도는 약간 작은 값이다. 작은 값이다.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2014.11a
• /
• pp.216-217
• /
• 2014

고효율 비디오 부호화/복호화 표준인 HEVC(High Efficiency Video Coding)는 ITU-T(VCEG)와 ISO-IEC(MPEG)이 JCT-VC라는 팀을 이루어 공동으로 표준화를 진행 하였다. 이 표준화에서는 기존 표준기술 보다 다양한 예측 방향을 통한 인트라 예측 방법을 사용하며, 이로 인해 부호기의 계산량이 매우 높은 단점을 가진다. 제안하는 방법은 예측단위인 PU의 서브샘플링 값을 구하고 이의 경사도를 이용해 율-왜곡 최적화 방법(Rate-Distortion Optimization)의 계산에 사용되는 후보 모드를 줄이는 방법으로 부호기의 속도를 개선하는 방법이다. 이 방법은 기존 방법보다 적은 비트 손실에도 불구하고 약 19%의 부호화 속도 향상을 가진다.