• Proceedings of the KIEE Conference
• /
• 1999.07d
• /
• pp.1677-1679
• /
• 1999

Crosslinked LB films of p-HP (p-hexadecoxyphenol) were produced to insulation layers of electronic devices. The fabrication and the electrical properties of LB films according to crosslinking have investigated respectively to Brewster angle microscopy (BAM), Scanning Maxwell-stress microscopy (SMM), current-voltage (I-V) properties and frequency-capacitance (C-F) characteristics. According to crosslinking, conductivity of p-HP LB films have improved and relative dielectric constant have reduced.

• Applied Chemistry for Engineering
• /
• v.4 no.2
• /
• pp.416-422
• /
• 1993

In order to prepare high performance polymeric membrane, the crosslinked chitosan(C. Chitosan)membrane was prepared, the transport and the selective separation of the metal ions through the membrane were investigated. It was observed that the transport rates of the metal ions through the membrane increased according to the decreasing of the initial pH in downstream solution. Proton pump mechanism for this transport phenomenon was suggested. The transport selectivity is dependent on the selective adsorption resulting from the complex formation of chitosan with each metal ion. The separatin factor(${\alpha}_{Cu}{^{2+}}$) for the membrane was 9.5.

• Applied Chemistry for Engineering
• /
• v.5 no.4
• /
• pp.722-730
• /
• 1994

The effects of antioxidant and carbon black on weatherability of crosslinked polythylene(XLPE) for electrical insulation were investigated. 16 compositions were prepared in other to determine the weathering resistance. Samples were exposed in xenon-arc lamp Weather-Ometer for 500, 1000, 1500, 2000 hours respectively. Tensile strength, elongation at break, dielectric strength and tan ${\delta}$ were measured to evaluate the weatherability of XLPE. The results indicated that the effect of carbon black was more prominent than antioxidant and synergistic effect, was observed when two additives were mixed.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.4
• /
• pp.302-308
• /
• 2001

The polymers with various composition of 4-vinylpyridine (4-VP) with n-butyl acrylate (n-BA) and 2-hydroxypropyl methacrylate (HPMA) were synthesized as a humidity sensitive material and quaternized with 1.5-dibromopentane. Resistance versus relative humidity decreased with increase in the content of n-BA in the copolymer. The introduction of HPMA increased the resistance of the humidity sensor as well as enhanced the adherence to the alumina substrate. In the case of 4-VP/n-BA/HPMA=80/10.10, the hysteresis and temperature coefficient were $\pm$2%RH and -0.42∼0.46%RH/$\^{C}$. The average resistance at 30%RH, 60%RH and 90%RH are 3.1㏁, 155 ㏀ and 7.9 ㏀, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.05a
• /
• pp.146-149
• /
• 1999

Langmur-Blodgett (LB) method has a unique characteristic of making molecularly mutilayered aggregation structures. LB method makes the thickness of organic insulation layer controllable at molecular scale in various electronic devices. In this study, the organic materials applicable to crosslinked LB insulation layers of electronic devices have developed and the electrical properties of their LB films have examined such as Brewster angle microscopy(BAM), Scanning Maxwell-stress microscopy(SMM), and Current-voltage(1-V) properties.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.347-349
• /
• 1999

We have fabricated insulating thin films using p-hexadecoxyphenol(p-Hp) that was formed phenol-formaldehyde resin of crosslinked structure from reaction with formaldehyde by LB technique. For fabricated MIM device, the possibility for insulating layers of electronic were investigated by electrical properties of their LB films according to crosslinking of LB films current-voltage (I-V) properties and frequency-capacitance (C-F) characteristics. We have provided evidence for the high insulating performance of phenol-formaldehyde thin films by the LB method. Conductivity of their LB films was as follows: pure water > 1 % aq. Formaldehyde > heat treatment, in the current-voltage (I-V) characteristics. It is demonstrated that insulation properties of crosslinked p-HP LB films were improved. In capacitance-frequency properties, the heat-treated p-HP LB films for crosslinking showed a low relative dielectric constant.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.23 no.6
• /
• pp.21-27
• /
• 2019

Cellulose-based carbon fabrics are used in aerospace nozzles have low thermal conductivity and high ablation resistance. However, there is a disadvantage in that the weight is reduced by 70~90% in the pyrolysis process and graphitization process and the residual rate is low when the final carbon fabric is produced. In this study, phosphoric acid as a phosphorus flame retardant and Citric acid as a cross-linking agent were treated on the lyocell fabrics. After that the functional groups were identified and thermal properties were confirmed by FT-IR, XRD and TGA. The yields of the final carbon fabrics were also compared through the pyrolysis and graphitization process. The graphitized yield increased to 8.1% with increasing citric acid to 16 wt% added.

• Journal of Adhesion and Interface
• /
• v.3 no.4
• /
• pp.19-26
• /
• 2002

In order to study the toughening mechanism of rubber modified polycarbonate, the sequence of development of micro-voids was investigated by real-time small angle X-ray scattering with Synchrotron radiation (SR-SAXS). The used test method was wedge test. The scattering intensity increases with increasing penetration depth of wedge, i.e. applied strain. The increase is due to the micro-void formation during deformation. This micro-void was uniformly developed in matrix and was different from large-void due to internal cavitation of rubber particle and/or debonding between rubber particle and polycarbonate matrix. The micro-void was developed at the critical strain and the radius of micro-void is around $600{\AA}$. Above the critical strain the size of micro-void remains almost constant with increasing applied strain. However, the population of micro-void increased with applied strain.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.23 no.5
• /
• pp.36-42
• /
• 2019

In this study, the pre-treatment of lyocell fabrics was performed using phosphoric acid (PA) as a phosphorus flame retardant and melamine resin (MR) as a cross-linking agent to fabricate carbon fabrics using lyocell fibers. The physical and chemical changes were investigated by thermogravimetric analysis (TGA), Fourier transform infrared spectroscopy (FT-IR), X-ray diffractometry (XRD) and weight analysis. We confirmed that the weight yield of the carbon fabrics compared to the untreated fabrics increased by 14.7%, and width and length yield of the fabrics increased by 15% and 15.5%, respectively. This may be due to the effect of promoting the dehydration reaction of cellulose, forming char on the fiber surface, which induces a crosslinking reaction in the cellulose molecule and stabilizes the structure upon pyrolysis.

• 한국사회정책
• /
• v.25 no.2
• /
• pp.281-304
• /
• 2018

This paper aims at analysing what impacts the experience of self-employed business have had on the income mobility. Since 2000s, the flexibilization of labor market and the population aging led to the increase of the number of self-employed job as many retirees at the age of early 50s has set up the self-employed business as a bridge job. However, previous researches just have emphasized on the impoverishment of the self-employed, but not focused on what different effects the experience of self-employed had on the income class mobility by age group. This paper compares the difference in the income class mobility by age group and employment status, and analyses its longitudinal trends. According to the result, as a whole the experience of self-employed has positive effect on the upper mobility of income class, but it become disadvantageous for the upper mobility as the age goes up. When belonging to the age group over 60s, the experience of self-employed rather increases the risk of lowering income class. Just as the experience of self-employed has different effects on income class mobility by age group, so the differentiated measures for age groups are demanded.