• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.230-234
• /
• 2000

Bi$_2$Sr$_2$Ca$_{n}$Cu$_{n+1}$ O$_{y}$(n$\geq$0; BSCCO)thin film is fabricated via two different processes using an ion beam sputtering method i.e. co-deposition and layer-by-layer deposition. A single phase of Bi2212 can be fabricated via the co-deposition process. While it cannot be obtained by the layer-by-layer process. Ultra-law growth rate in our ion beam sputtering system brings out the difference in Bi element adsorption between the two processes and results in only 30% adsorption against total incident Bi amount by layer-by-layer deposition, in contrast to enough Bi adsorption by co-deposition.on.n.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.5C no.5
• /
• pp.204-210
• /
• 2005

Alternating current (AC) losses of two Bi-2223 ([Bi, Pb]: Sr: Ca: Cu: O = 2:2:2:3) tapes [(Tape I, un-twist-pitch) and the other with a twist-pitch of 10 mm (Tape II)] were measured and compared. These samples, produced by the powder-in-(Ag) tube (PIT) method, are multi-filamentary. Also, it's produced by non-twist and different twist pitch (8, 10, 13, 30, 50 and 70 mm). The critical current measurement was carried out under the environment in liquid Nitrogen and in zero-field by 4-probe method. Susceptibility measurements were conducted while cooling in a magnetic field. Flux loss measurements were conducted as a function of ramping rate, frequency and field direction. The AC flux loss increases as the twist-pitch of the tapes decreased, in agreement with the Norris Equation. Neutron-diffraction measurements have been carried out investigate the crystal structure, magnetic structures, and magnetic phase transitions in Bi-2223([Bi, Pb]:Sr:Ca:Cu:O)

• Journal of Radiation Protection and Research
• /
• v.23 no.4
• /
• pp.267-271
• /
• 1998

It is required to measure air density correction factor at the time of absorbed dose calibration or measurement. In general, thermometer and barometer are widely used for air density correction. However, this can be done using the radioactive check device with better accuracy. The measurements of air density correction were performed by using the radioactive check device, Unidos electrometer, and 0.6 cc Farmer-type ion chamber of PTW under the different environmental conditions. Above experiments were repeated with thermometer and barometer. By comparing the two methods, they were within the difference of 0.2 %. The overall uncertainty for the dose found in thermometer and barometer was 1.2 - 1.6 %, depending upon either one step or two, whereas the overall uncertainty for the radioactive check device was 1.02 %. This method may reduce the possible error which could occur when thermometer and barometer are not calibrated at regular basis.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.17 no.2
• /
• pp.549-552
• /
• 2003

To investigate the protective effect of Sophorae Radix (SR) on the damage by pulmonary vascular endothelial cells by xanthine oxidase (XO)/hypoxanthine (HX)-induced oxygen tree radical, Neutral Red (NR) and c-fos immunopositive cell assay were used. The results were obtained as follows ; The viability of vascular endothelial cells treated with XO/HX was decreased. And c-fos immunopositive cells represented a maximal increase in group treated with XO/HX for 2 hour in pulmonary vasvular endothelial cells. But pretreated groups with SR extracts were not inhibited the increase of c-fos immunopositive cells by XO/HX in a dose-dependent manner. These results show that XO/HX elicits toxic effects in cultured pulmonary vascular endothelial cells, and suggest that SR extract is very effective in the prevention of XO/HX-induced increase of c-fos immunopositive cells.

• Electrical & Electronic Materials
• /
• v.10 no.2
• /
• pp.97-104
• /
• 1997

In this paper, in order to investigate the behavior of charged particles on (Sr.Ca)TiO$_{3}$ ceramics with paraelectric properties, the characteristics of electrical conduction and thermally stimulated current was measured respectively. As a result, the conduction mechanism is divided into three regions having different mechanism as the current increased. The region I below 200[V/Cm] shows the ohmic conduction. The region B between 200[V/cm] and 2000[V/cm] can be explained by the Poole-Frenkel emission theory, and the region III above 2000[V/cm] is dominated by the tunneling effect. The three peaks of TSC were obtained at the temperature of -20[.deg. C], 20[.deg. C] and 80[.deg. C], respectively. The origins of these peaks are that the .alpha. peak observed at -20[.deg. C] looks like to be ascribed to the ionization excitation from donor level in the grain, and the .alpha.' peak observed at 20 [.deg. C] appears to show up by hopping conduction of the trapped carrier of border between the oxidation layer and the grain, and the .betha. peak observed at 80[.deg. C] seems to be resulted from hopping conduction of existing carrier in the trap site of the border between the oxidation and second phase.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.1 no.2
• /
• pp.221-237
• /
• 1991

This study was conducted to evaluate the accuracy and the precision of asbestos counting data produced by the Division of Industrial Health, School of Public Health, Seoul National Universitys (SNU). The study was performed from July 18 to October 4, 1991, and the results are summarized as follows. 1. Intracounter Relative Standard Deviations (Sr) in the category of 5-50.5 fibers as total fibers counted ranged from 0.27 to 0.37, which were greater than 0.10-0.17 which were reported by the NIOSH. The reasons are supposed to be as follows. First, inexperience of counters in asbestos fiber counting was considered to be a main reason. Second, poor quality of samples due to sampling and mounting error increased variation of counting. Third, fiber density of many samples were less than $100fibers/mm^2$. But Intracounter Relative Standard Deviations (Sr) in samples with >50.5 fibers ranged from 0.l6 to 0.20, approaching the value 01 NIOSH. 2. Intralaboratory Relative Standard Deviations (Sr) in categories of 5-20.5, >20.5-50.5 and >50.5 fibers were 0.54, 0.37 and 0.26, respectively. Intralaboratory Sr in samples with fiber density greater than $100fibers/mm^2$ was 0.26. This was similar to the values reported by other foreign experienced laboratories. 3. Comparing results of three counters, Counter C, a beginner, overestimated asbestos fiber concentrations. 4. Since our SNU laboratory has participated in two quality control programs, IOMA-F.R.I.C.A., U.K. and NIOSH PAT Program, U.S.A., this laboratory has been evaluated as " Rating 1" and "Proficient" laboratory, by IOM and NIOSH, respectively.

• Journal of the Korean Vacuum Society
• /
• v.11 no.3
• /
• pp.166-170
• /
• 2002

Artificial $BaTiO_3$(BTO)/$SrTiO_3$(STO) oxide superlattice have been deposited on MgO (100) single crystal substrate by pulsed laser deposition(PLD) method. The stacking periodicity of BTO/STO superlattice structure was varied from $BTO_{1\;unit\; cell}/STO_{1\;unit\; cell}$ to $BTO_{125\;unit\; cell}/STO_{125 \;unit \;cell}$ thickness with the total thickness of 100 nm. The result of X-ray diffraction showed the characteristics of superlattice in the BTO/STO multilayer structure. we have also confirmed that there was no interdiffusion at the interface between BTO and STO layers by high resolution transmission electron microscopy(HRTEM). The dielectric constant of superlattice increased with decreasing stacking periodicity of the BTO/STO superlattice within the critical thickness. The dielectric constant of the BTO/STO superlattice reached a maximum i.e., 1230 at a stacking perioicity of $BTO_{2\;unit\; cell}/STO_{2\;unit\; cell}$ .

• Journal of the Korean earth science society
• /
• v.34 no.4
• /
• pp.313-328
• /
• 2013

Jurassic granitoids in the northeastern part of the Yeongnam Massif are possibly the result of intensive magmatic activities that occurred in response to subduction of the proto-Pacific plate beneath the northeast portion of the Eurasian plate. Geochemical studies on the granitic rocks are carried out in order to constrain the petrogenesis of the granitic magma and to establish the paleotectonic environment of the area. Whole rock chemical data of the Uljin granitoids in the northeastern part of the Yeongnam Massif indicate that all of the rocks have the characteristics of calcalkaline series in subalkaline field. The overall major element trends show systematic variations in each granitic body, but the source materials of each granitoids seem to have different chemical composition. The Uljin granitoids are different from other granitic rocks, which distributed vicinity of the study area, in the contents of $Al_2O_3$ and trace elements such as Cr, Co, Ni, Sr, Y and Nb. The Uljin granitoids have geochemical features similar to slab-derived adakites such as high $Al_2O_3$, Sr contents and high Sr/Y, La/Yb ratios, but they have low Y and Yb contents. The major ($SiO_2$, $Al_2O_3$, MgO) and trace element (Sr, Y, La, Yb) contents of the Uljin granitoids fall well within the adakitic field. The Uljin granitoids have similar geochemical characteristics, paleotectonic environments and intrusion ages to those of the Yatsuo plutonic rocks of Hida belt located on northwestern part of Japan. Chondrite normalized REE patterns show generally enriched LREEs ($(La/Yb)_{CN}=10.6-103.4$) and are slight negative to flat Eu anomalies. On the ANK vs. A/CNK and tectonic discrimination diagrams, parental magma type of the granites corresponds to I-type and volcanic arc granite (VAG). Interpretations of the chemical characteristics of the granitic rocks favor their emplacement in a compressional tectonic regime at the continental margin during the subduction of Izanagi plate in Jurassic period.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.2
• /
• pp.212-216
• /
• 1999

SiC(3C) photodiodes (PDs) were fabricated on p-type Si(111) substrates using chemical vapor deposition (CVD) technique by pyrolyzing tetramethylsilane (TMS) with $H_{2}$ carrier gas. Electrical properties of SiC(3C) were investigated by Hall measurement and current-voltage (I-V) characteristics. SiC(3C) layers exhibited n-type conductivity. Ohmic contact was formed by thermal evaporation Al metal through a shadow-mask. The optical gain $(G_{op})$ of the SiC(3C)/Si PD was measured as a function of the incident wavelength. For the analysis of the photovoltaic detection of the Sic(3C) n/p PD, the spectral response (SR) has calculated by using the electrical parameters of the SiC(3C) layer and the geometric structure of the PD. The peak response calculated for properly chosen parameters was about 0.75 near 550 nm. We expect a good photoresponse in the SiC(3C) heterostructure for the wavelength range of 400~600 nm. The SiC(3C) photodiode can detect blue and near ultraviolet (UV) radiation.

• Journal of the Korean Ceramic Society
• /
• v.40 no.6
• /
• pp.530-538
• /
• 2003

Samples with the nominal composition, B $i_{1.84}$P $b_{0.34}$S $r_{1.91}$C $a_{2.03}$C $u_{3.06}$ $O_{10+}$$\delta$/ (110 K phase) high $T_{C}$ superconductors containing MgO as an additive were fabricated by a solid-state reaction method. Samples with 5~50 wt％ MgO were sintered at 820~86$0^{\circ}C$ for 24 h. The structural characteristics, critical temperature and grain size of the samples with different MgO contents were analyzed by XRD and SEM. As the MgO content increased, the intensity of MgO peaks and ratio of Bi-2212 phase in superconductors were intensified and the proportion of the phase transition from Bi-2223 to Bi-2212 was increased.d.creased.d.