• 전기화학회지
• /
• 제13권4호
• /
• pp.246-250
• /
• 2010

In this study, nano-crystallized $Al_2O_3$ was coated on the surface of $LiFePO_4$ powders via a novel dry coating method. The influence of coated $LiFePO_4$ upon electrochemical behavior was discussed. Surface morphology characterization was achieved by transmission electron microscopy (TEM), clearly showing nano-crystallized $Al_2O_3$ on $LiFePO_4$ surfaces. Furthermore, it revealed that the $Al_2O_3$-coated $LiFePO_4$ cathode exhibited a distinct surface morphology. It was also found that the $Al_2O_3$ coating reduces capacity fading especially at high charge/discharge rates. Results from the cyclic voltammogram measurements (2.5-4.2 V) showed a significant decrease in both interfacial resistance and cathode polarization. This behavior implies that $Al_2O_3$ can prevent structural change of $LiFePO_4$ or reaction with the electrolyte on cycling. In addition, the $Al_2O_3$ coated $LiFePO_4$ compound showed highly improved area-specific impedance (ASI), an important measure of battery performance. From the correlation between these characteristics of bare and coated $LiFePO_4$, the role of $Al_2O_3$ coating played on the electrochemical performance of $LiFePO_4$ was probed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 하계학술대회 논문집 Vol.7
• /
• pp.368-369
• /
• 2006

The pure $LiFePO_4$, carbon added $LiFePO_4(LiFePO_4/C$) and pyrene added $LiFePO_4(LiFePO_4/P$) are synthesized by using solid-state reaction. XRD patterns show no impurity phase in the three kinds of the cathode materials. The 10wt% pyrene added $LiFePO_4$ shows around 140mAh/g of discharge capacity at 3rd cycle compared to the pure $LiFePO_4$. The carbon added $LiFePO_4$ shows 145mAh/g of discharge capacity at 3rd cycle and stable cycle-life compared to the others.

• 전기화학회지
• /
• 제8권4호
• /
• pp.168-171
• /
• 2005

The electrochemical properties of $LiFePO_4$ as a cathode for Li-ion batteries were improved by incorporating conductive carbon into the $LiFePO_4$. X-ray diffraction analysis and SEM observations revealed that the carbon-coated $LiFePO_4$ consisted of fine single crystalline particles, which were smaller than the bare $LiFePO_4$. The electrochemical performance of the carbon-coated $LiFePO_4$ was tested under various conditions. The carbon-coated $LiFePO_4$ showed much better performance in terms of the discharge capacity and cycling stability than the bare $LiFePO_4$. The improved electrochemical performances were found to be attributed to the reduced particle size and enhanced electrical conductivity of the $LiFePO_4$ by the carbon.

• Bulletin of the Korean Chemical Society
• /
• 제32권3호
• /
• pp.836-840
• /
• 2011

This study examines the effects of a carbon coating on the electrochemical performances of $LiFePO_4$. The results show that the capacity of bare $LiFePO_4$ decreased sharply, whereas the $LiFePO_4$/C shows a well maintained initial capacity. The Li ion diffusivity of the bare and carbon coated $LiFePO_4$ is calculated using cyclic voltammetry (CV) to determine the correlation between the electrochemical performance of $LiFePO_4$ and Li diffusion. The diffusion constants for $LiFePO_4$ and $LiFePO_4$/C measured from CV are $6.56{\times}10^{-16}$ and $2.48{\times}10^{-15}\;cm^2\;s^{-1}$, respectively, indicating considerable increases in diffusivity after modifications. The Li ion diffusivity (DLi) values as a function of the lithium content in the cathode are estimated by electrochemical impedance spectroscopy (EIS). The effects of the carbon coating as well as the mechanisms for the improved electrochemical performances after modification are discussed based on the diffusivity data.

• 한국결정성장학회지
• /
• 제21권1호
• /
• pp.15-20
• /
• 2011

[ $^7Li$ ]Magic Angle Spinning(MAS) NMR Spectroscopy를 활용하여 $Li_4P_2O_7$와 $LiFePO_4$ 물질에서 $^7Li$ 핵의 NMR 특성 및 화합물 분자내의 국부적 구조 연구를 수행하였다. $Li_4P_2O_7$와 $LiFePO_4$ 물질 연구는 리튬이온전지에서 고체-전해질 경계상(SEI, solid-electrolyte interphase) 물질 연구를 위한 것이다. $Li_4P_2O_7$와 $LiFePO_4$ 분말은 고상합성법으로 제조하였다.$^7Li$MAS NMR 실험은 $27^{\circ}C$에서 $97^{\circ}C$의 영역에서 변온 실험을 수행하였으며 이는 주변 온도 변화 환경에서 $Li_4P_2O_7$ 물질 내의 Li 핵의 구조 변화를 관찰하기 위한 것이다. $^7Li$ MAS NMR 측정 결과 시료 온도가 $27^{\circ}C$에서 $97^{\circ}C$의 온도 분포 영역에서는 $Li_4P_2O_7$ 물질 내부의 Li 핵은 구조적으로 변화하지 않는 것이 확인되었다. 금번 실험을 통하여 $LiFePO_4$ 분말에 5.0 wt%이내로 포함되어있는 $Li_4P_2O_7$ 물질의 $^7Li$ MAS NMR 신호를 측정할 수 있는 측정 조건을 알았다.

• 한국결정성장학회지
• /
• 제18권6호
• /
• pp.248-252
• /
• 2008

전기전도성이 우수하면서 입자 크기가 작은 $LiFePO_4$ 분말을 얻기 위해서, 이종원소(Cr+B 또는 Cr+Al) 도핑이 $LiFePO_4$의 전기전도도에 미치는 영향과 열처리 조건이 입자 크기에 미치는 영향에 대해서 조사하였다. 조성이 $LiFe_{0.965}Cr_{0.03}B_{0.005}PO_4$ and $LiFe_{0.065}Cr_{0.03}Al_{0.005}PO_4$인 두 종류의 분말을 기계화학적 밀링법으로 혼합 후 $675{\sim}759^{\circ}C$에서 $5{\sim}10$시간 열처리하여 합성하였다. 이종원소 도핑은 입자성장을 촉진하였고 전기전도도를 높이는 효과가 있었다. $LiFe_{0.065}Cr_{0.03}Al_{0.005}PO_4$의 전기전도도는 $1{\times}10^{-8}S/cm$로 도핑하지 않은 것의 $5{\times}10^{-10}S/cm$보다 높았다.

• Bulletin of the Korean Chemical Society
• /
• 제34권3호
• /
• pp.851-855
• /
• 2013

This paper describes an environmentally friendly process for the recovery of $LiFePO_4$ cathode materials from scrap electrodes by a simple thermal treatment method. The active materials were easily separated from the aluminum substrate foil and polymeric binders were also decomposed at different temperatures ($400^{\circ}C$, $500^{\circ}C$, $600^{\circ}C$) for 30 min under nitrogen gas flow. The samples were characterized by X-ray diffraction (XRD), scanning electronic microscopy (SEM), Raman spectroscopy, Thermogravimetric analysis (TGA), and differential scanning calorimetry (DSC). The electrochemical properties of the recycled $LiFePO_4$ cathode were evaluated by galvanostatic charge and discharge modes. The specific charge/discharge capacities of the recycled $LiFePO_4$ cathode were similar to those of the original $LiFePO_4$ cathode. The $LiFePO_4$ cathode material recovered at $500^{\circ}C$ exhibits a somewhat higher capacity than those of other recovered materials at high current rates. The recycled $LiFePO_4$ cathode also showed a good cycling performance.

• Bulletin of the Korean Chemical Society
• /
• 제32권3호
• /
• pp.921-926
• /
• 2011

This study investigates a root cause of the improved rate performance of $LiFePO_4$ after metal doping to Fesites. This is because the metal doped $LiFePO_4$/C maintains its initial capacity at higher C-rates than undoped one. Using $LiFePO_4$/C and doped $LiFe_{0.97}M_{0.03}PO_4$/C (M=$Al^{3+}$, $Cr^{3+}$, $Zr^{4+}$), which are synthesized by a mechanochemical process followed by one-step heat treatment, the Li content before and after chemical delithiation in the $LiFePO_4$/C and the binding energy are compared using atomic absorption spectroscopy (AAS) and X-ray photoelectron spectroscopy (XPS). The results from AAS and XPS indicate that the low Li content of the metal doped $LiFePO_4$/C after chemical delithiation is attributed to the low binding energy induced by weak Li-O interactions. The improved capacity retention of the doped $LiFePO_4$/C at high discharge rates is, therefore, achieved by relatively low binding energy between Li and O ions, which leads to fast Li diffusivity.

• 전기화학회지
• /
• 제11권2호
• /
• pp.120-124
• /
• 2008

리튬이차전지의 양극 활물질로 카본 코팅된 $LiFePO_4$와 $LiMn_{0.4}Fe_{0.6}PO_4$를 졸-겔방법으로 합성하였다. 제조된 양극 활물질을 X-선 회절분석과 주사전자현미경을 통하여 불순물이 존재하지 않으며 기공이 잘 발달되어 있다는 것을 확인하였다. 액체전해질을 사용하여 0.1 C-rate의 전류밀도에서 충방전하였을 경우 $LiFePO_4$는 132 mAH/g, $LiMn_{0.4}Fe_{0.6}PO_4$는 145 mAh/g의 방전용량을 각각 나타내었다. 전기방사에 의해 만들어진 겔 고분자 전해질을 사용하였을 경우에 $LiFePO_4$와 $LiMn_{0.4}Fe_{0.6}PO_4$는 각각 114, 130 mAh/g의 우수한 방전용량을 나타내었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.424-425
• /
• 2005

The purpose of this study is to research and develop $LiFe_xMn_{1-x}PO_4$ cathode for lithium polymer batteries. $LiFe_xMn_{1-x}PO_4$ cathode active materials were prepared using a solid-state reaction by adding carbon black to the synthetic precursors. We investigated cyclic voltammetry and charge/discharge cycling of $LiFe_xMn_{1-x}PO_4$/SPE/Li cells. The discharge capacity of $LiFe_{0.5}Mn_{0.5}PO_4$ was l26mAh/g and 110mAh/g at 1st and 10th cycle.