• Journal of Korean Society of Water and Wastewater
• /
• v.30 no.1
• /
• pp.33-40
• /
• 2016

In this study, a fluorescent silica nano particle is used as the surrogate for challenging test of membrane surface integrity. The particles are functionalized by a fluorescent dying agent so that as an ultraviolet light is imposed a bright fluorescent image from the particles can be taken. If a membrane surface is damaged and has a compromised part larger than the size of surrogate the fluorescent particles would pass through and contained in the permeate. An operator can directly notice whether the membrane surface is damaged or not by detecting a fluorescent image taken from the permeate. Additionally, the size of compromised part is estimated through analysing the fluorescent image in which we surmise the mass of particles included in the permeate by calculating an average RGB value of the image. The pilot scale experiments showed that this method could be applied successfully to determine if a membrane surface had a damaged parts regardless of the test condition. In the testing on the actual damaged area of $4.712mm^2$, the lowest error of estimating the damaged area was -1.32% with the surrogate concentration of 80 mg/L, flux of $40L/m^2/hr$ for 25 minutes of detection. A further study is still going on to increase the lowest detection limit and thus decrease the error of estimation.

• Archives of Plastic Surgery
• /
• v.35 no.3
• /
• pp.267-272
• /
• 2008

Purpose: Donor site seroma is the most common complication of extended latissimus dorsi flap for breast reconstruction. One of preventive treatments is to use the fibrin sealant in donor site before closure. Experimentally, it has been used successfully in the prevention of latissimus donor site seroma, but its clinical efficacy and results were very controversial. Thus, the purpose of this study is to evaluate the clinical efficacy and to determine the optimal dose of fibrin sealant. Methods: A retrospective study was done of patients operated under same surgical conditions by one operator with variable doses of fibrin sealant. The study group consisted of 60 consecutive patients who underwent breast reconstruction with extended latissimus flap reconstructions from January 2005 to December 2006. Patients were divided into 4 group by applied fibrin sealant amount(group 1=0 mL, group 2=1 mL, group 3=2 mL, group 4=4 mL). Retrospective data were obtained from total postoperative drainage amount, time from surgery to drain removal, and incidence and quantity of seroma formation in matched patients group. Results: Total drainage amount decreased relative to the amount of fibrin sealant. The seroma formation rate of 30% in the study group 4 was significantly less than group 1 rate of 71%(p<0.05). It was an improvement over the rates of as much as 79% described previously in the literature. Also, time from surgery to drain removal was shortened significantly in group 4 patients(p<0.05). Conclusion: The use of fibrin sealant in the extended latissimus dorsi flap donor site appears effective in preventing seroma. However, important factors to obtain lower seroma formation rates are proper techniques and proper amounts such as the authors suggested amount: $0.01mL/cm^2$ with spray type fibrin sealant.

• The KIPS Transactions:PartB
• /
• v.18B no.2
• /
• pp.57-66
• /
• 2011

To prevent cardiac diseases, quantifying cardiac function is important in routine clinical practice by analyzing blood volume and ejection fraction. These works have been manually performed and hence it requires computational costs and varies depending on the operator. In this paper, an automatic left ventricle segmentation algorithm is presented to segment left ventricle on cardiac magnetic resonance images. After coil sensitivity of MRI images is compensated, a K-mean clustering scheme is applied to segment blood area. A graph searching scheme is employed to correct the segmentation error from coil distortions and noises. Using cardiac MRI images from 38 subjects, the presented algorithm is performed to calculate blood volume and ejection fraction and compared with those of manual contouring by experts and GE MASS software. Based on the results, the presented algorithm achieves the average accuracy of 6.2mL${\pm}$5.6, 2.9mL${\pm}$3.0 and 2.1%${\pm}$1.5 in diastolic phase, systolic phase and ejection fraction, respectively. Moreover, the presented algorithm minimizes user intervention rates which was critical to automatize algorithms in previous researches.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2017.11a
• /
• pp.236-237
• /
• 2017

In this research, experimental seakeeping results of Warped hull form 2 on the regular waves were compared with numerical results of strip method and CFD. In case of ship's speed, there are 3 cases (3.4m/s, 4.6m/s, 5.75m/s) for numerical simulation, and they are belong to semi-planing and planing condition. Consequently, in case of strip method, it is shown that the resonance phenomena occurred from around ${\lambda}/L_{OA}=2$ to 4 and RAO value were significantly higher than that of other. this is different from experimental results. In case of CFD, overall trends were similar with experimental values except there are somewhat excessive RAO values around ${\lambda}/L_{OA}=0.5$ to 2.5. these phenomena is confirmed that it became larger as the ship's speed increased, and it was considered that the error occurred because the number of mesh in vertical direction of wave height at ${\lambda}/L_{OA}=0.5$ to 2.5 were relatively less than those of wave height at ${\lambda}/L_{OA}=2.5$ to 5.2.

• The Korean Journal of Pain
• /
• v.26 no.2
• /
• pp.148-153
• /
• 2013

Background: C-arm fluoroscope has been widely used to promote more effective pain management; however, unwanted radiation exposure for operators is inevitable. We prospectively investigated the differences in radiation exposure related to collimation in Medial Branch Block (MBB). Methods: This study was a randomized controlled trial of 62 MBBs at L3, 4 and 5. After the patient was laid in the prone position on the operating table, MBB was conducted and only AP projections of the fluoroscope were used. Based on a concealed random number table, MBB was performed with (collimation group) and without (control group) collimation. The data on the patient's age, height, gender, laterality (right/left), radiation absorbed dose (RAD), exposure time, distance from the center of the field to the operator, and effective dose (ED) at the side of the table and at the operator's chest were collected. The brightness of the fluoroscopic image was evaluated with histogram in Photoshop. Results: There were no significant differences in age, height, weight, male to female ratio, laterality, time, distance and brightness of fluoroscopic image. The area of the fluoroscopic image with collimation was 67% of the conventional image. The RAD ($29.9{\pm}13.0$, P = 0.001) and the ED at the left chest of the operators ($0.53{\pm}0.71$, P = 0.042) and beside the table ($5.69{\pm}4.6$, P = 0.025) in collimation group were lower than that of the control group ($44.6{\pm}19.0$, $0.97{\pm}0.92$, and $9.53{\pm}8.16$), resepectively. Conclusions: Collimation reduced radiation exposure and maintained the image quality. Therefore, the proper use of collimation will be beneficial to both patients and operators.

• Journal of Navigation and Port Research
• /
• v.32 no.8
• /
• pp.569-576
• /
• 2008

By the development of international trade in last decades, Korean International Trade has been grown rapidly and Korean Port and Port facilities have been improved stimultaneously: finally volume of the marine traffic increased rapidly. Presently, 15 VTS centers have serving in Korean waters and since the introduction of the first VIS Center in Korea there is no quantitative analysis to find workload of VIS operator. After that Port-MIS and De-brief data have been gathered for 7 days and inbound-outbound vessels time-g/t table prepared and traffic volume examined for each V1S center. Hence $L^2$ conversion traffic volume and dangerous vessel ratio obtained Later on conversion controlled number obtained by denoting ratio 1.0 to directly controlled vessels by VTSO and denoting ratio 0.3 to indirectly controlled vessels by VTSO. Traffic volume, large vessel ratio, dangerous vessel ratio, dimension of VTS controlled area, marine accident occurrence frequency and communication volume of comm. log can be counted as a factor which influence to workload of VTSO. All those factors have been examined and analyzed. Finally, ship's size and dangerous vessel ratio have been chosen to derive the Number of composite conversion control for workload formula.

• Proceedings of the Korean Society of Computational and Applied Mathematics Conference
• /
• 2003.09a
• /
• pp.9-9
• /
• 2003

Let $\Omega$ be a bounded, open, and polygonal domain in $R^2$ with re-entrant corners. We consider the following Partial Differential Equations: $$(I-\nabla\nabla\cdot+\nabla^{\bot}\nabla\times)u\;=\;f\;in\;\Omega$$, $$n\cdotu\;0\;0\;on\;{\Gamma}_{N}$$, $${\nabla}{\times}u\;=\;0\;on\;{\Gamma}_{N}$$, $$\tau{\cdot}u\;=\;0\;on\;{\Gamma}_{D}$$, $$\nabla{\cdot}u\;=\;0\;on\;{\Gamma}_{D}$$ where the symbol $\nabla\cdot$ and $\nabla$ stand for the divergence and gradient operators, respectively; $f{\in}L^2(\Omega)^2$ is a given vector function, $\partial\Omega=\Gamma_{D}\cup\Gamma_{N}$ is the partition of the boundary of $\Omega$; nis the outward unit vector normal to the boundary and $\tau$represents the unit vector tangent to the boundary oriented counterclockwise. For simplicity, assume that both $\Gamma_{D}$ and $\Gamma_{N}$ are nonempty. Denote the curl operator in $R^2$ by $$\nabla\times\;=\;(-{\partial}_2,{\partial}_1$$ and its formal adjoint by $${\nabla}^{\bot}\;=\;({-{\partial}_1}^{{\partial}_2}$$ Consider a weak formulation(WF): Find $u\;\in\;V$ such that $$a(u,v):=(u,v)+(\nabla{\cdot}u,\nabla{\cdot}v)+(\nabla{\times}u,\nabla{\times}V)=(f,v),\;A\;v{\in}V$$. (2) We assume there is only one singular corner. There are many methods to deal with the domain singularities. We introduce them shortly and we suggest a new Finite Element Methods by using Singular representation for the solution.

• The Korean Journal of Air & Space Law and Policy
• /
• v.21 no.2
• /
• pp.71-96
• /
• 2006

This paper intends to describe the carrier's duty for the delivery of international air cargo and the carrier's liability for the illegal delivery of cargo under the Montreal Convention, lATA Conditions of Carriage for Cargo and judicial precedents. Under the Article 13 of Montreal Convention, the consignee is entitled, on arrival of the cargo at the place of destination, to require the carrier to deliver the cargo to it, on payment of the charge due and on complying with the conditions of carriage. And unless it is otherwise agreed, it is the duty of the carrier to give notice to the consignee as soon as the cargo arrives. Under the Article 18 of Montreal Convention, the carrier is liable for damage sustained in the event of the destruction or less of or damage to, cargo upon condition only that the event which caused the damage so sustained took place during the carriage by air. And the carriage by air comprises by the period during which the cargo is in the carriage of the carrier. Under the Article 11 of lATA Conditions of Carriage for Cargo, carrier is liable to shipper, consignee of any other person for damage sustained in the event of destruction of loss of, or damage to, or delay in the carriage of cargo only if the occurrence which caused to the damage so sustained took place during the carriage as defined under Article 1. According to the precedent of Korean Supreme Court sentenced on 22 July 2004, the freight forwarder as carrier was not liable for the illegal delivery of cargo to the notify party (actual importer) on the airway bill by the bonded warehouse operator because the freight forwarder did not designate the bonded warehouse and did not hold the position of employer to the bonded warehouse operator. In conclusion, the carrier or freight forwarder should pay always attention the movement and condition of the cargo not to be liable for the illegal delivery of cargo.

• The Journal of Advanced Prosthodontics
• /
• v.10 no.3
• /
• pp.252-258
• /
• 2018

PURPOSE. The purpose of this study was to evaluate the repeatability and matching accuracy between two identical intraoral spectrophotometers. MATERIALS AND METHODS. The maxillary right central incisor, canine, and mandibular left central incisor of each of 30 patients were measured using 2 identical intraoral spectrophotometers with different serial numbers (EasyShade V). The color of each shade tab from 3 shade guides (VITA 3D-Master) was also determined with both devices. All measurements were performed by a single operator. Statistical analyses were performed to verify the repeatability, accuracy, and the differences between the devices with paired t-tests, one-way ANOVA, and intra-class correlation coefficients (ICCs) (${\alpha}=.05$). RESULTS. A high level of measurement repeatability (ICC>0.90) among $L^*$, $a^*$, and $b^*$ color components was observed within and between devices (P<.001). Intra-device matching agreement rates were 80.00% and 81.11%, respectively, while inter-device matching agreement rate was 51.85%. ANOVA revealed no significant different color values within each device, while paired t-test provided significant different color values between both devices. The CIEDE2000 color differences between both devices were $2.28{\pm}1.61$ ${\Delta}E_{00}$ for in-vivo readings. Regarding the clinical matching accuracy of both devices, ${\Delta}E_{00}$ values between teeth and matching shade tabs were $3.05{\pm}1.19$ and $2.86{\pm}1.02$, respectively. CONCLUSION. Although two EasyShade V devices with different serial numbers show high repeatability of CIE $L^*$, $a^*$, and $b^*$ measurements, they could provide different color values and shade for the same tooth.

• The Korean Journal of Pesticide Science
• /
• v.11 no.4
• /
• pp.281-288
• /
• 2007

This research was carried out to propose the Korean method for estimating the agricultural occupational pesticide exposure level in orchard. The UK-POEM (UK-Predictive Operator Exposure Model) was proposed as a bench-marking model and analysed its performance properties. To extrapolate the Korean agricultural conditions, application equipment, application method, work rate per day, application volume and spraying time of pesticide was surveyed for Korean 204 orchard farmhouse. This survey indicate that the major application equipments are speed sprayer(64.9%) and motor sprayer(33.9%). When they spayed the pesticide with a speed sprayer, they worked for more than 4 hours on area of 4 ha per day. In case of using motor sprayer, they worked for more than 4 hours on area of 1 ha. Based on the above survey result, Korean method for estimating the pesticide exposure level of agricultural worker was proposed finally.