• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.12 s.354
• /
• pp.61-67
• /
• 2006

This paper proposes the algorithm for tracking of the residual phase errors incurred by carrier frequency offset and sampling frequency offset in the orthogonal frequency division multiplexing (OFDM) systems which are suitable for high data rate wireless communications. In the OFDM systems the subcarriers which are orthogonal to each other are modulated by digital data and transmitted simultaneously. The carrier frequency offset causes degradation of signal to noise ratio(SNR) performance and interference between the adjacent subcarriers. The errors in the sampling timing caused by the sampling frequency difference between the transmitter and the receiver sides also cause a major performance degradation in the OFDM systems. The residual error tracking and compensation mechanism is essential in the OFDM system since the carrier and the sampling frequency offset cause the loss of orthogonality resulting in the system performance loss. This paper proposes the scheme where the channel gain and the payload data information are reflected in the residual error tracking process which results in the reduction of the estimation error and the tracking performance improvements under the frequency selective fading wireless channels.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.6 s.360
• /
• pp.31-39
• /
• 2007

In this paper, a system for real-time or periodic measurement and analysis of RF parameters such as forward transmit power and pilot power in CDMA base station systems is proposed. Such RF characteristic parameter measurement can be prevented from system fault and used to achieve optimal service quality and maximum investment return through cell coverage expansion, subscriber capacity increase and so on. For forward power measurement, the local oscillator frequency for the detector is varied so that the transmit power for all channels can be measured. The channel power measurement can be used to analyze the variation in transmit power for changes in voice traffic. By comparing to forward $E_c/I_o$, the pilot channel power can be deducted, which can be used to determine uy degradation in transmit section modules such as the high dover amplifier. Since an accurate analysis of carefully measured data using the CDMA level detector must be made, the system is designed so that measurement errors due to changes in crest factor with modulation method can be overcome.

• Journal of IKEEE
• /
• v.17 no.2
• /
• pp.135-139
• /
• 2013

This paper presents the 8-channel active module operated in Ka-band. The module is designed for the mobile satellite communication antenna systems, and the module structure has the merit to minimize the size and weight of the antenna systems by 30% compared with the conventional systems using the active module composed of single channel. This module was designed to be optimally operated by prohibiting the electrical interference among the individual channels. From the test results of the fabricated 8-channel active module, it can be confirmed that the maximum channel gain error is ${\pm}1.3dB$, the minimum channel output power is 21.5dBm, and the maximum gain variation by phase control is ${\pm}1.0dB$.

• The Journal of the Acoustical Society of Korea
• /
• v.34 no.4
• /
• pp.295-302
• /
• 2015

Acoustic channels are characterized by long multipath spreads that cause inter-symbol interference. The way in which this fact influences the design of the receiver structure is considered. To satisfy performance and throughput, we presented consecutive iterative BCJR (Bahl, Cocke, Jelinek, Raviv) equalization to improve the performance and throughput. To achieve low error performance, we resort to powerful BCJR equalization algorithms that iteratively update probabilistic information between inner decoder and outer decoder. Also, to achieve high throughput, we divide long packet into consecutive small packets, and the estimate channel information of previous packets are compensated to next packets. Based on experimental channel response, we confirmed that the performance is improved for long length packet size.

• Convergence Security Journal
• /
• v.13 no.4
• /
• pp.19-25
• /
• 2013

The increasing demand for fast, flexible and guaranteed Quality of Service (QoS) in core networks has caused to deploy MultiProtocol Label Switching (MPLS) and Generalized MPLS (GMPLS) control plane. In GMPLS control plane, path computation and cooperation processes are one of the crucial element to maintain an acceptable level of service. The Internet Engineering Task Force (IETF) has proposed the Path Computation Element (PCE) architecture. The PCE is a dedicated network element devoted to path computation process and communications between Path Computation Clients (PCC) and PCEs is realized through the PCE Protocol (PCEP). This paper examines the PCE-based path computation architecture to include the design and implementation of PCEP. The functional modules including Finite State Machine (FSM) and related key design issues of each state are presented. In particular we also discuss internal/external protocol interfaces that efficiently control the communication channels.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.1A
• /
• pp.7-15
• /
• 2008

In this paper, it is investigated that the limitation due to the asymmetry of optical power with respect to optical phase conjugator(OPC) in mid-span spectral inversion(MSSI) for compensating optical signal distortion due to group velocity dispersion(GVD) and nonlinearities generated in fiber by combining with lumped dispersion management(DM) technique into MSSI. Two kinds of lumped DM configuration(configuration A and configuration B) are considered and compared each other in this research. Configuration A consists of two dispersion compensating fiber(DCF) span positioned after transmitter and before receiver, respectively. Configuration B consists of two dispersion compensating fiber(DCF) span positioned before and after OPC placed at middle of total transmission link, respectively. It is confirmed that the transmission performances are more improved by the configuration A combined with MSSI than configuration B. Also, it is confirmed that the best performance of overall channels are obtained by making net residual dispersion(NRD) to have positive value in self phase modulation(SPM)-limited WDM transmission systems, irrelevant to the configuration of DM.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10A
• /
• pp.839-846
• /
• 2011

Link Adaptation should select the best modulation and coding scheme (MCS) which gives the highest throughput as channel conditions vary. Several link adaptation algorithms for wireless local area network (WLAN) have been proposed but for the future WLAN systems such as 802.11n system, these algorithms do not guarantee the best performance. In this paper, we propose a new link adaptation algorithm in which an MCS level is chosen by the received SNR plus the offset value obtained from the transmission results. The performance of proposed algorithm is simulated by an IEEE 802.11n system. From the analysis, we conclude the proposed algorithm performs better than the well-known link adaptation algorithms such as auto rate fallback and general SNR-based techniques. Particularly, the proposed algorithm improves throughput when the packet error ratio (PER) is constrained for fast fading channels.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.8
• /
• pp.653-660
• /
• 2017

In this paper, the author analyzes direction finding accuracy based on phase comparisons to estimate elevation and azimuth angles of arrival signals. This paper considers the uniform array configurations using four and three elements. In that direction finding structures, I present the analytic expressions for estimated elevation and azimuth angles and then analyze the direction finding errors. And one presents the design guideline of direction finding system in comparison with aspects of accuracy, structure, the number of channels in that structures. The analysis result is similar with simulation one and has difference within $1.2^{\circ}RMS$. From the proposed analysis results, one knows that when SNR is 20 dB and the baseline is half of wavelength, the estimated elevation accuracy of the uniform array using four elements is 1.15 times better than the one of the uniform array using three elements and the estimated azimuth accuracy is same each other. In addition, one knows coning error is eliminated in 2-D direction finding structure.

• Journal of the Korean Data and Information Science Society
• /
• v.23 no.4
• /
• pp.665-675
• /
• 2012

The object of study is to compare the characteristics of IPTV (Internet protocol television) subscribers and digital CATV (Community antenna television) subscribers. We used the adjusted residuals. We did gang survey for 100 subscribers in Seoul, Kyeonggi or Incheon regions. Compared to digital CATV, IPTV seems to have appropriate contents for interactive services and high satisfaction level for cost, but high dissatisfaction level for channels. Digital CATV subscribers would know and subscribe passively, compared to IPTV subscribers. IPTV subscribers are more satisfied than digital CATV subscribers even though IPTV is higher cost. Main content of digital CATV is sports, which is not interactive contents. People think IPTV is an innovative service which let subscribers see wanted contents always, but digital CATV is an extension of CATV. So digital CATV cannot use advantages of interactive services. Even though two services are almost same, they are very different in recognition.

• The Journal of Information Technology
• /
• v.7 no.1
• /
• pp.69-86
• /
• 2004

In this paper, a conceptual framework describing the dynamics of click and mortar businesses is provided. It directs our attention to the many potential sources of synergy that are available to firms that choose to integrate e-commerce with their existing traditional forms of business. It further emphasizes the many actions that firms can take to minimize channel conflicts and help achieve the benefits of synergy. Finally, it describes four categories of synergy-related benefits from the integration of e-commerce with traditional businesses, including potential cost saving, gains due to enhanced differentiation, improved trust, and potential extensions into new markets. The utility of the framework was demonstrated using the case of an electronics retailer that has chosen to tightly integrate its large chain of retail stores with its Web-based electronic store. The framework was also used to develop a series of propositions that can guide future empirical research. The discussion points to the need to develop new types of metrics to better judge the contributions of e-commerce channels, and provides some guidance for future empirical research that can test whether, and under what conditions, integrated click and mortar business models work well. Thus, the purpose of this study is to present the combining physical and virtual presence in e-commerce.