• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제43회 하계 정기 학술대회 초록집
• /
• pp.332-332
• /
• 2012

프로그래밍 단자와 채널 단자가 게이트 산화 막으로 절연되는 플래시 스위치 및 SRAM 스위치와는 달리 상변화 스위치에서는 채널 단자를 통해 흐르는 전기신호가 프로그래밍 단자를 통해 그대로 누설되는 문제점이 발생한다. 이러한 문제점을 해결하기 위해서 지난 연구에서는 칼코겐화물로 구성되는 다층구조를 제안하고 $Ge_2Sb_2Te_5$의 특성을 보고하였다. 본 연구에서는 스퍼터링 방식을 이용하여 조성비가 다른 GeSbTe 박막을 증착하고 온도변화에 따른 면 저항 및 표면 형상 변화를 관찰한 후 이를 통해 다층구조에 적용하기에 적합한 조성비를 얻고자 하였다. GeSbTe 박막의 조성비에 따라 면 저항 및 표면형상이 크게 변화 하는 것을 확인 하였으며 이러한 결과로부터 프로그래머블 스위치에 적용되는 칼코겐화물 합금의 조성비는 스위치의 성능 좌우하는 중요한 파라미터임을 확인하였다.

• Transactions on Electrical and Electronic Materials
• /
• 제4권5호
• /
• pp.24-27
• /
• 2003

We have been investigated phase-change with temperature and electric field in chalcogenide Ge$_2$Sb$_2$Te$\sub$5/ thin film. T$\sub$c/(crystallization temperature) is confirmed by measuring the resistance with the varying temperature on the hotplate. We have measured I-V characteristics with Ge$_2$Sb$_2$Te$\sub$5/ chalcogenide thin film. It is compared with I-V characteristics after impress the variable pulse. The pulse has variable height and duration.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2015년도 제49회 하계 정기학술대회 초록집
• /
• pp.222.2-222.2
• /
• 2015

A $Ge_2Sb_2Te_5$ nanowire (GST NW) phase change memory device is investigated with Joule heating electrodes. GST is the most promising phase change materials, thus has been studied for decades but atomic structure transition in the phase-change area of single crystalline phase-change material has not been clearly investigated. We fabricated a phase change memory (PCM) device consisting of GST NWs connected with WN electrodes. The GST NW has switching performance with the reset/set resistance ratio above $10^3$. We directly observed the changes in atomic structure between the ordered hexagonal close packed (HCP) structure and disordered amorphous phase of a reset-stop GST NW with cross-sectional STEM analysis. Amorphous areas are detected at the center of NW and side areas adjacent to heating electrodes. Direct imaging of phase change area verified the atomic structure transition from the migration and disordering of Ge and Sb atoms. Even with the repeated phase transitions, periodic arrangement of Te atoms is not significantly changed, thus acting as a template for recrystallization. This result provides a novel understanding on the phase-change mechanism in single crystalline phase-change materials.

• 한국분말재료학회지
• /
• 제18권5호
• /
• pp.449-455
• /
• 2011

In this study, p-type $(AgSbTe_2)_{15}(GeTe)_{85}$: TAGS-85 compound powders were prepared by gas atomization process, and then their microstructures and mechanical properties were investigated. The fabricated powders were of spherical shape, had clean surface, and illustrated fine microstructure and homogeneous $AgSbTe_2$ + GeTe solid solution. Powder X-ray diffraction results revealed that the crystal structure of the TAGS-85 sample was single rhombohedral GeTe phase, which with a space group $R_{3m}$. The grain size of the powder particles increased while the micro Vickers hardness decreased with increasing annealing temperature within the range of 573 K and 723 K due to grain growth and loss of Te. In addition, the crystal structure of the powder went through a phase transformation from rhombohedral ($R_{3m}$) at low-temperature to cubic ($F_{m-3m}$) at high-temperature with increasing annealing temperature. The micro Vickers hardness of the as-atomized powder was around 165 Hv, while it decreased gradually to 130 Hv after annealing at 673K, which is still higher than most other fabrication processes.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 추계학술대회 논문집 Vol.17
• /
• pp.268-271
• /
• 2004

The phase transition from amorphous to crystalline states, and vice versa, of $Ge_2Sb_2Te_5$ films by applying electrical pulses have been studied. This material can be used as nonvolatile memory. The reversible phase transition between the amorphous and crystalline states, which is accompanied by a considerable change in electrical resistivity, is exploited as means to store bits of information. The nonvolatile memory cells are composed of a simple sandwich (metal/chalcogenide/metal). It was formed that the threshold voltage depends on thickness, electrode distance, annealing time and temperature, respectively.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.1
• /
• pp.416-419
• /
• 2003

There is a growing need for a nonvolatile memory technology with faster speed than existing nonvolatile memories. We studied of phase-change according to temperature and voltage in chalcogenide thin film base on $Ge_2Sb_2Te_5$. Searching for Tg(Glass transition temperature) temperature controlled on hotplate with RT quenching. We measure I-V characteristic through out bottom electrode(ITO) and top electrode(Al) between $Ge_2Sb_2Te_5$. And compared with I-V characteristics after impress the variable stress.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 추계학술대회 논문집 전기물성,응용부문
• /
• pp.32-33
• /
• 2006

As next generation nonvolatile memory, chalcogenide-based phase change memory can substitute for a conventional flash memory from its high performance. Also, fast writing speed, low writing voltage, high sensing margin, low power consumption and repetition reliability over $10^{15}$ cycle shows its possibility. At our laboratory, we invented ${Ge_1}{Se_1}{Te_2}$ material to alternate with conventional ${Ge_2}{Sb_2}{Te_5}$ for improve its ability. We respect the ${Ge_1}{Se_1}{Te_2}$ material can be a solution for high power consumption problem and long time at 'set' performance. A conductivity experiment from variable temperature was performed to see reliability of repetition at read and write performance. Compare with conventional ${Ge_2}{Sb_2}{Te_5}$ material, these two materials are used as complex compound to get the finest parameter.

• 한국전기전자재료학회논문지
• /
• 제32권5호
• /
• pp.376-381
• /
• 2019

In this work, we evaluated the structural, electrical and optical properties of $Ge_8Sb_2Te_{11}$ and Cu-doped $Ge_8Sb_2Te_{11}$ thin films prepared by rf-magnetron reactive sputtering. The 200-nm-thick deposited films were annealed in a range of $100{\sim}400^{\circ}C$ using a furnace in an $N_2$ atmosphere. The amorphous-to-crystalline phase changes of the thin films were investigated by X-ray diffraction (XRD), UV-Vis-IR spectrophotometry, a 4-point probe, and a source meter. A one-step phase transformation from amorphous to face-centered-cubic (fcc) and an increase of the crystallization temperature ($T_c$) was observed in the Cu-doped film, which indicates an enhanced thermal stability in the amorphous state. The difference in the optical energy band gap ($E_{op}$) between the amorphous and crystalline phases was relatively large, approximately 0.38~0.41 eV, which is beneficial for reducing the noise in the memory devices. The sheet resistance($R_s$) of the amorphous phase in the Cu-doped film was about 1.5 orders larger than that in undoped film. A large $R_s$ in the amorphous phase will reduce the programming current in the memory device. An increase of threshold voltage ($V_{th}$) was seen in the Cu-doped film, which implied a high thermal efficiency. This suggests that the Cu-doped $Ge_8Sb_2Te_{11}$ thin film is a good candidate for PRAM.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.1287-1288
• /
• 2008

In the past work, we showed that $Ge_1Se_1Te_2$ thin films provide a promising alternative for PRAM applications to overcome the problems of conventional $Ge_2Sb_2Te_5$ PRAM devices. However, $Ge_1Se_1Te_2$ thin films were unstable at SET and RESET process. Because of unstable state and its melting temperature, we alloyed As for 5wt%, 10wt% and 15wt% respectively. The phase transition temperature of $Ge_1Se_1Te_2$-only thin film is found to be 213$^{\circ}C$ while As 10wt% alloyed $Ge_1Se_1Te_2$ showed phase transition at 242$^{\circ}C$ with more stability.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2009년도 제38회 동계학술대회 초록집
• /
• pp.155-155
• /
• 2010

Oxygen incorporated $Ge_2Sb_2Te_5$ (GST) films were prepared by an ion beam sputtering deposition (IBSD) method. From the I-V curves, the $V_{th}$ value varies with the oxygen content. Ge-deficient hexagonal phases are responsible for the observed unstability and decrease in $V_h$ values. In the case of a GST film with an elevated oxygen content of 30.8 %, the GST layer melted at 9.02 V due to the instability conferred by the high oxygen content. The formation of Ge-deficient hexagonal phases such as $GeSb_2Te_4$ and $Sb_2Te_3$ appear to be responsible for the $V_{th}$ variation. Impedance analyses indicated that the resistance in GST films with oxygen contentsof 16.7 % and 21.7 % had different origins. Thermal desorption spectroscopy (TDS)data indicate that moisture and hydrocarbons were more readily desorbed at higher oxygen content because the oxygen incorporated GST films are more hydrophilic than undoped GST films.