• Journal of Bio-Environment Control
• /
• v.7 no.1
• /
• pp.63-70
• /
• 1998

This study was carried out to investigate the interaction of selenate and sulfate ion in nutrient solution supplyed with selenate ion. At early growth stage, the growth of Mongolian wormwood was best at 3mM sulfate ion and 2mg/$\ell$Na$_2$SeO$_4$ treatment. As they were grown and matured, at the later growth stage, the effect of antagonism between selenate and sulfate ion on the growth of each plant decreased. At supplying with selenate ion in nutrient solution, the uptake of selenate by plant had negative correlation with sulfate ion concentration in nutrient solution. The higher sulfate ion concentration, the less selenium uptake. However, the effect of antagonistic interaction of selenate and sulfate ion on the selenium uptake increased with plant age. Whereas, the uptake of sulfate ion had positive correlation with sulfate ion concentration in nutrient solution at supplying with selenate ion in nutrient solution. The uptake of sulfate ion increased with increase of sulfate ion concentration in nutrient solution. The effect of this interaction with selenate and sulfate ion increased with growth and maturity of plant. However, at 3mM sulfate ion concentration in nutrient solution, sulfate ion concentration in plant tissue decreased markedly.

• Korean Journal of Materials Research
• /
• v.6 no.7
• /
• pp.700-708
• /
• 1996

Electroless plating technique was utilized to flip chip bonding to improve surface mount characteristics. Each step of plating procedure was studied in terms pf pH, plating temperature and plating time. Al patterned 4 inch Si wafers were used as substrstes and zincate was used as an activation solution. Heat treatment was carried out for all the specimens in the temperature range from room temperature to $400^{\circ}C$ for $30^{\circ}C$ minutes in a vacuum furnace. Homogeneous distribution of Zn particles of size was obtained by the zincate treatment with pH 13 ~ 13.5, solution concentration of 15 ~ 25% at room temperature. The plating rates for both Ni-P and Au electroless plating steps increased with increasing the plating temperature and pH. The main crystallization planes of the plated Au were found to be (111) a pH 7 and (200) and (111) at pH 9 independent of the annealing temperature.

• Applied Biological Chemistry
• /
• v.24 no.4
• /
• pp.224-229
• /
• 1981

Perilla (Perilla frutescens Britton var. Crispa Decasne) cultivated in three geographical areas of Korea, Gwangju, Taegu and Jeju, was analyzed for carbohydrate, lipid, protein, inorganic components and fatty acid composition. Carbohydrate, lipid and protein content of perilla seed ranged from 40 (Taegu) to 44% (Jelu), from 28 (Jeju) to 34% (Taegu) and from 15 (Gwangju) to 16% (Jeju), respectively. The overage contents of potassium, silicate, calcium, phosphate, iron, zinc, magnesium and mangane in the perilla seed varied between $426{\sim}446$, $197{\sim}229$. $124{\sim}136$, $46{\sim}56$, $30{\sim}49$, $42{\sim}45$, $40{\sim}45$, and $30{\sim}36mg%$, respectively and those variations different cultivation areas were not significant except iron. Saponification number, iodine value and acid value of the perilla oil were between $194{\sim}198$, $196{\sim}200$ and $4{\sim}5$, respectively. Those variations among the cultivation areas were not significant. The composition of the perilla oil was observed to be composed of $92{\sim}95%$ of triglyceride, $1.2{\sim}1.3%$ of phospholipid, $1.7{\sim}1.9%$ of unsaponifiables, $0.7{\sim}0.9%$ of free fatty acid, and $1.1{\sim}1.4$ linolenic, linoleic and oleic acid as $55{\sim}56$, $16{\sim}18$ and $16{\sim}20%$ of total fatty acids, but in phospholipid, the content of saturated fatty acids, $12{\sim}24$ of total fatty acid, was higher than that in triglyceride, $8{\sim}19%$ of total fatty acids. The content of saturated fatty acids in sterylester $(14{\sim}19%)$ was higher than that in sterylglycoside ($6{\sim}7%$ of total fatty acids). The variation in fatty acid composition was not significant in the composition of total fatty acid but a significant difference was observed in the composition of phospholipid, in which the content of palmitate ranged from 11.8%(Taegu) to 24%(Gwangju) of total fatty acids. No significant variation was found in the fatty acid composition among the cultivation areas, while a significant difference was observed in phospholipid.

• Journal of Bio-Environment Control
• /
• v.4 no.1
• /
• pp.50-58
• /
• 1995

These studies were carried out to develop a system for non -destructive and continuous measurement of fresh weight and to analyse the growth response of leaf lettuce under the different nutrient solution and light condition with this system. The developed measurement system was consisted of four load cells and a microcomputer. The output from the system was highly positive correlation with the plant fresh weight above the surface of the hydroponic solution. The top fresh weight of plant could be measured within the error $\pm$ 1.0g in the range of 0 - 2000g. The top fresh weight of leaf lettuce increased 44 times at 18th day after transferring to the nutrient solution, and the maximum growth rate was observed at 13th day after transferring. The growth rate was 10.7- 29.6% per day during 18 days. Optimum concentration of the nutrient solution for the growth of lettuce was 1.4 - 2.2 mS/cm of EC level. When the light condition was changed from dark to light, the fresh weight was temporarily decreased, but the fresh weight increased under the opposite condition. Top fresh weight of leaf lettuce in the darkness normally increased within 12 hours after darkness treatment, and then slowly increased until 78 hours under continuous dark condition. After that times, the fresh weight began to decrease.

• Korean Journal of Soil Science and Fertilizer
• /
• v.40 no.5
• /
• pp.418-428
• /
• 2007

Physical and chemical properties of the aggregate by-products including sludge and crushed dust samples collected from the 21 private companies throughout the country were analyzed to evaluate possible usage of the by-products as artificial soil materials for plantation. The pH of the materials ranged from 8.0 to 11.0. The organic matter content was $2.85g\;kg^{-1}$, and the total nitrogen content and available phosphate content were low as 0.7 percents and $12.98mg\;kg^{-1}$, respectively. Exchangeable $Ca^{2+}$, $Mg^{2+}$, $K^+$, and $Na^+$ were 2.29, 0.47, 0.02 and $0.05cmol\;kg^{-1}$, respectively. Heavy metal contents were lower than the limits regulated by environmental law of Korea. Textural analysis showed that most of the materials were silt loam with low water holding capacity ranged from 0.67 to 7.41 percents, and with low hydraulic conductivity ranged from 0.4 to $2.8m\;s^{-1}$. Mineralogical analysis showed that the aggregate by product materials were mostly composed of silicate, alumina and ferric oxides except calcium oxide dominant materials derived from limestones. The primary minerals were quartz, feldspars and dolomites derived from granite and granitic gneiss materials. Some samples derived from limestone material showed calcite and graphite together with the above minerals. According to the result, it can be concluded that the materials could be used as the artificial soil material for plantation after proper improvement of the physico-chemical properties and fertility.

• Korean Journal of Soil Science and Fertilizer
• /
• v.43 no.5
• /
• pp.590-595
• /
• 2010

This study was conducted to investigate form of pollution brought by residual of mine tailing in agricultural land, and get basic information need for environment restoration. Guundong mine was completely restored region by implementation the soil pollution prevention plan. The districts is soils in Guundong mine vicinity the Mahul-ri, Muan-myeon, Miryang city, Gyeongsangnam-do. The nature of soil studied is the Shinra series andesite and mineral deposits which contain brimstone and heavy metals such as gold, silver, copper, lead, and zinc. The residual mine tailing and around agricultural land of heavy metals analyzed with 0.1N HCI solubility. The chemical properties of surface soil in upper part around mining area were pH 4.3-4.4, organic matter 19-21 g $kg^{-1}$, available $P_2O_5$ 85 mg $kg^{-1}$, exchangeable Ca 0.21-0.25 $cmol_c\;kg^{-1}$, exchangeable Mg 0.04 $cmol_c\;kg^{-1}$. The pH, exchangeable Ca, and Mg were increased with soil depth. The contents of 0.1N HCl extractable Cu, Cd, Pb, Cr, and Ni in soil (siteI) which influenced by outflow water from mine tailing were 97, 0.6, 197, 0.28 및 0.12 mg $kg^{-1}$, respectively. The vertical distribution of heavy metals in soil varied considerably among the metals kind. In case of siteI, The content of Cu, Pb, and Cr in soil was highest at surface soil. However, the content of Cd, Zn, Ni, and Mn was high at middle part of soil profile.