• Journal of the Microelectronics and Packaging Society
• /
• v.21 no.1
• /
• pp.19-23
• /
• 2014

For the application of light-emitting diodes (LEDs) for general illumination, the development of high power LEDs chips became more essential. For these reasons, recently, modified vertical LEDs have been developed to meet various requirements such as better heat dissipation, higher light extraction and less cost of production. In this research, we investigate the effect of Size and Array of N-GaN contact on operation voltage with new structured padless vertical LED. We changed the size and array of N-electrodes and investigated how they affect the operation voltage of LEDs. We simulated the current crowding and expected operation voltage for different N-contact structures with commercial LED simulator. Also, we fabricated the padless vertical LED chips and measured the electrical property. From the simulation, we could know that the larger size and denser array of n-electrodes could make operation voltage decrease. These results are well in accordance with those measured values of real padless vertical LED chips.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.134-138
• /
• 2005

In this paper, we have developed a new type of the microwave phase conjugator for the active retrodirective antenna array. The circuit topology is consisted of a 2-port structure to avoid the complexity of LO and RF signal combination and matching, using the cascade connection of two single-ended mixers. The operating frequencies are 4.0 GHz, 2.01 GHz and 1.99 GHz for LO, RF, and IF, respectively. Conversion loss is measured to be -7 dB and 1-dB compression point 15 dBm with the LO power of 9 dBm. For the most important parameter, the isolation between RE leakage and IF signal is as high as 25 dB.

• Nuclear Engineering and Technology
• /
• v.38 no.6
• /
• pp.585-590
• /
• 2006

This paper describes the results of an irradiation test and the specifications of the pneumatic transfer system (PTS) in the NAA #3 irradiation hole at the HANARO research reactor, which was reinstalled after some modifications of the operation mode at the end of 2004. The outer and inner diameters of the PE transfer tube are 34.1 and 27.5 mm, respectively. PE rabbit was used for sample irradiation. The $N_2$ gas pressure of the PTS lines was adjusted to 0.75 bar. The average sending time to the reactor was $8.5{\pm}0.3$ s and the average receiving time back to the receiver was $3.2{\pm}0.2$ s. The internal and external temperature of the irradiation tube was measured in a range of 50 to $80^{\circ}C$ for a 40 s to 80 s irradiation time, respectively. The optimum irradiation time was estimated to be less than 80 s. The thermal, epithermal and fast neutron flux at 30 MW thermal power were $1.42{\pm}0.01{\times}10^{14},\;1.51{\pm}0.04{\times}10^{13}$ and $9.48{\pm}0.69{\times}10^{11} n{\cdot}cm^{-2}{\codt}s^{1-}$, respectively. The cadmium ratio was approximately 9.40. The data obtained will be applied to supplement user information and for reactor management.

• The Bulletin of The Korean Astronomical Society
• /
• v.43 no.1
• /
• pp.66.1-66.1
• /
• 2018

Turbulence is a phenomenon which largely determines the density and velocity fields in molecular clouds. Turbulence can produce density fluctuation which triggers a gravitational collapse, and it can also produce a non-thermal pressure against gravity. Therefore, turbulence controls the mode and tempo of star formation. However, despite many years of study, the properties of turbulence remain poorly understood. As part of the Taeduk Radio Astronomy Observatory (TRAO) Key Science Program (KSP), "apping Turbulent properties In star-forming MolEcular clouds down to the Sonic scale (TIMES; PI: Jeong-Eun Lee)", we have mapped two star-forming clouds, the Orion A and the ${\rho}$ Ophiuchus molecular clouds, in 3 sets of lines (13CO 1-0/C18O 1-0, HCN 1-0/HCO+ 1-0, and CS 2-1/N2H+ 1-0) using the TRAO 14-m telescope. We aim to map entire clouds with a high-velocity resolution (~0.05 km/s) to compare turbulent properties between two different star-forming environments. We will present the preliminary results using a statistical method, Principal Component Analysis (PCA), that is a useful tool to represent turbulent power spectrum.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.962-968
• /
• 2016

The large scaled lead-acid battery is widely used for efficient operation of the photovoltaic system in many islands. However, lithium-ion battery is now being introduced to mitigate the fluctuation of wind power and to replace lead-acid battery. Therefore, hybrid ESS(Energy Storage system) that combines lithium-ion battery with lead-acid battery is being required because lithium-ion battery is costly in present stage. Under this circumstance, this paper presents the optimal algorithm to create composition rate of hybrid ESS by considering fixed and variable costs in order to maximize advantage of each battery. With minimization of total cost including fixed and variable costs, the optimal composition rate can be calculated based on the various scenarios such as load variation, life cycle and cost trend. From simulation results, it is confirmed that the proposed algorithms are an effective tool to produce a optimal composition rate.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.11C
• /
• pp.1139-1151
• /
• 2002

In this paper, we propose the novel module-type optical space switch, employing time division multiplexing (TDM) method and multihop structure, in order to enlarge the capacity of the switching system. And we show that the proposed structure is superior over conventional ones, in terms of power loss, the number of the devices used, and signal to crosstalk (SXR). We also analyze the saturation throughput with the number of module M. As a result, the saturation throughput of the switching system with M modules is M+ 1-√(M$^2$+1), when the number of input port in a module (N) is large. Finally, we confirmed the cell loss rate (CLR) performance with the proposed switch through simulation. For example, when p=0.9, M=8 and N=32, to get the CLR that is less than or equal to 10$\^$-6/, the number of input buffers storage unit is greater than or equal to 6 and output buffers storage unit is greater than or equal to 52.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.8
• /
• pp.1031-1039
• /
• 2018

If large-scale PV systems are continuously interconnected to distribution system, customer voltages could violate the allowable voltage limit($220{\pm}13V$) according to reverse power flow of PV system. In order to solve these problems, this paper proposes flexible adoption evaluation algorithm of PV system in distribution system which estimates proper introduction capacity and location of ESS(energy storage system) for keeping customer voltages within allowable voltage limit based on various operating scenarios related with connecting point and capacity of PV system. And also this paper proposes modeling of ESS, SVR(step voltage regulator) and PV system using PSCAD/EMTDC S/W and analyzes characteristics of customer voltages and the adoption ability of PV system in distribution system. From the simulation results, it is confirmed that proposed algorithm is useful for large-scale adoption of PV system in distribution system to maintain customer voltages within allowable voltage limit.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.40 no.4
• /
• pp.120-128
• /
• 2017

More people travel oversea as the economic size of Korea is getting larger and more new jobs are requested to be created by the society. To respond to these trend and request, Incheon International Airport Corporation (IIAC) is about to expand its processing capability with a new terminal; 54 million passengers to 72 million. IIAC is also introducing new strategies such as open innovation (OI) and creating shared value (CSV). With these changes, IIAC faces new challenges of restructuring its business and organization with new ideas. Most organizations including IIAC are becoming more dependent on external resources to keep their competitive advantages under the turbulence of global business environmental changes. Therefore, they focus on the OI paradigm which is reported as a convincing strategy to improve competitiveness in terms of budget and time-to-market. OI is to quickly react to the rapidly changing business environment and is adopted to support startup incubation. In the previous research with IIAC, three major tasks were defined; utilizing the IIAC brand power for external vendors, building a technology road-map, and introducing a collaboration support system. This paper deals with the collaboration system as proposed in the previous research. We focused on the collaboration process for startup incubation. Cases were studied; the K-startup model by the government, a university model to explore youth startups, and a R&D institute model to study professional startups. Based on the case studies, we defined an IIAC model and proposed issues to take care of. The model is distinguished from the other studied models since IIAC is a prospective customer of new technology.

• Journal of the Korean Society of Safety
• /
• v.29 no.3
• /
• pp.98-106
• /
• 2014

This study proposes severity analysis for pedestrian accidents by improving variables which were used for general severity analysis. The existing variables were collected based on the interviews with policeman or witnesses and evidence of accidents. Therefore, existing variables were subjective and had several measurement errors. In order to improve such problems, this study collected variables from vehicle recorder of taxi which recorded the moment of accidents. As a result, explanatory power of independent variables was enhanced and the complete objective variables could be collected. After collecting variables, ordered probit model was developed by utilizing vehicle recorder database. Fitness of ordered probit model was 0.23. Vehicle speed and pedestrian's eye direction variables were the most critical factors for severity of pedestrian accident. In addition, severity analysis for vulnerable pedestrian was carried out. As a result, it was revealed that vehicle speed, pedestrian's eye direction and safety zone variables affected the severity of pedestrian accidents most. Particularly, vehicle speed variable is the most important factor. Consequently, driver's defensive driving and compliance to the regulations are the priority to reduce severity of pedestrian accidents and prevent pedestrian accident.

• Proceedings of the SAREK Conference
• /
• 2007.11a
• /
• pp.305-309
• /
• 2007

FTL(Fuel Test Loop) is a facility that confirms performance of nuclear fuel at a similar irradiation condition with that of nuclear power plant. FTL construction work began on August, 2006 and ended on March, 2007. During Construction, ensuring the worker's safety was the top priority and installation of the FTL without hampering the integrity of the HANARO was the next one. The installation works were done successfully overcoming the difficulties such as on the limited space, on the radiation hazard inside the reactor pool, and finally on the shortening of the shut down period of the HANARO. The Commissioning of the FTL is to check the function and the performance of the equipment and the overall system as well. The FTL shall start operation with high burn up test fuels in early 2008 if the commissioning and licensing progress on schedule.