• Journal of the Korean Institute of Landscape Architecture
• /
• v.34 no.5 s.118
• /
• pp.52-58
• /
• 2006

Wildlife roadkill is a serious problem for road planners and biologists concerned with traffic safety, species conservation, and animal welfare. The objective of this paper was to analyze the effect of land use on the frequency of mammal roadkills. This study took part in three steps. First, data for 1,279 road kills of nine species were collected by survey over 26 months on 107km of roads near the Mt. Jirisan area. Second, the type of land use near the roadkill points was analyzed, and the area of each land use within loom of the road was calculated using GIS. Finally, the question of whether the land use affects the Sequency of mammal roadkills was analyzed by determining the density of roadkill occurrences for each land-use type. The results of the study were as follows. First, the roadkill density of all species was highest near grasslands, especially natural grasslands. Second, when comparing forests and rice fields, roadkill densities of the Eurasian red squirrel, Siberian chipmunk and Korean hare were higher near the forests, while the densities of the raccoon dog, water deer and leopard cat were higher near rice fields. The results of this study could be an essential information source for mitigating the roadkill problem in Korea.

• Nuclear Engineering and Technology
• /
• v.55 no.4
• /
• pp.1571-1584
• /
• 2023

In this study, a numerical analysis was performed as part of an international joint research project to reproduce a real cable tray fire that occurred in the heater bay area of the turbine building of a nuclear power plant. A sensitivity analysis was performed on various input parameters to derive results consistent with the sprinkler activation time obtained from the fire event analysis. For all sensitive parameters, the normalized sprinkler activation time correlated well with the power function of the normalized sprinkler height. A correlation equation was developed to identify the sprinkler activation time at any location when determining the slope or fire growth rate under the conditions assuming a linear or t-squared heat release rate (HRR) time curve. Various cable fire growth assumptions were used to determine which assumption was better to provide the prediction coincident with the information given from the fire event analysis in terms of the sprinkler activation time and total energy generated from cables damaged by fire. In the comprehensive analysis of all the sensitive parameters, the standard deviation of the input parameters increased as the sprinkler height decreased. Within the range of the sensitivity parameter values given in this study, when considering all sprinkler heights, the standard deviation of the cable model change was the largest and that of the overhang position change was the smallest.

• Korean Journal of Veterinary Research
• /
• v.31 no.3
• /
• pp.295-302
• /
• 1991

From 1988 to 1989, 8 strains of canine parvovirus-2(CPV-2) were isolated from the fecal specimens from the dogs that were clinically diagnosed as canine parvoviral enteritis in the veterinary hospitals located in the regions of Taejeon and Chungbuk province. The biological and physicochemical properties for the isolates were studied. Among 62 fecal samples collected from the dogs with enteric diseases, 24(38.7%) showed the haemagglutinating activity to porcine erythrocyte ranging from 16 to 16,384 of HA titers. In cytopathological studies with CRFK cells, intranuclear inclusion bodies were observed in all of eight specimens with the high HA titer over 1,000, of which three specimens showed cytoplasmic inclusions concurrently with the intranuclear inclusion bodies. It was found that the isolates revealed the highest haemagglutinating activity with porcine erythrocytes and the relatively lower haemagglutination titers with the erythrocytes from cat and rabbit. None of erythrocytes from the other animals reacted with the isolates. By the cross-haemagglutination inhibition test for the isolates with the reference viruses and sera, the isolates were evidently identified as the strains of CPV-2. In physicochemical property test, the isolates were stable in lipid solvent, pH and heat treatment at $56^{\circ}C$ for 30 min, and showed the virus particle size less than 25 nm, containing a DNA genome.

• Journal of Chest Surgery
• /
• v.23 no.5
• /
• pp.833-843
• /
• 1990

Vasomotor areas were identified by stimulating various sites of the medulla electrically in adult cats anesthetized with a-chloralose and their correlation with somatosympathetic pressor or depressor responses was investigated. Followings are the results obtained: 1. Pressor areas were found in the rostral ventrolateral, the caudal ventrolateral and the rostral dorsolateral medulla. 2. Separate depressor areas were found dorsal and ventral to the rostral ventrolateral pressor area. 3. Some areas showed biphasic responses: depressor responses to low frequency[1 \ulcorner2 Hz] and pressor responses to high frequency[20 \ulcorner100 Hz] stimulation 4. Lesions on the rostral ventrolateral pressor areas abolished the somatosympathetic pressor responses to the stimulation of peripheral afferent nerves, while the depressor responses remained. Lesions on the caudal ventrolateral pressor area affected neither the pressor nor depressor responses to the peripheral nerve stimulation. 5. Lesions on the depressor areas resulted in decreased depressor responses to the peripheral nerve stimulation, but to a lesser degree than that resulted from lesions on the pressor areas. 6. A microinjection of glutamate solution to the pressor area resulted in a prolonged pressor response, while glutamate injection to the depressor areas did not elicit depressor responses. From the above results, it is concluded that there are separate pressor and depressor areas in the rostral medulla of cats and each area plays a role in somatosympathetic pressor and depressor responses, respectively.

• Journal of the Korean Chemical Society
• /
• v.3 no.1
• /
• pp.23-27
• /
• 1954

The relation between the height of ascending solvents and its velocity were studied with strips of Toyo No. 50 filter paper. The filter paper strip of 3cm width and cat 30 cm length is hooked down or fixed between two sheets of glass plates inside a cylinder containing the solvent, in which the lower end of the strip is dipped. As the solvents, acetone, hydrochloric acid, water or mixtures of these are used. For short time intervals, Ostwald's folmula $h = Kt^n$ was found to be most suitable to express the relation between the height of the solvent front, h, and time, t. For longer time intervals, results will be discussed in the next paper. The mean values of the constant m in the above formula for pure acetone and pure water were 0.44 and 0.485, respectively, and that of K were 0.05 and 2.4, respectively. The time interval whose the above formula applies, for each solvent was 2 hours for the former, and a half hour for the later, respectively. The movement of solutes, such as $Cu^{++}$ and $Fe^{++}$ showed that the Rf values of solutes become constant values after a long periods; e.g., ca. 6 hours with 10N-HCl-Acetone (1 : 9) solvent.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.10 s.103
• /
• pp.1202-1210
• /
• 2005

This paper develops a computer model for estimating the bump characterisitcs of a cat)over type large-sized truck. The truck is composed of front and rear suspension systems, a frame, a cab, and ten tires. The computer model is developed using MSC.ADAMS. A shock absorber, a rubber bush, and a leaf spring affect a lot on the dynamic characteristic of the vehicle. Their stiffness and damping coefficient are measured and used as input data of the computer model. Leaf springs in the front and rear suspension systems are modeled by dividing them three links and joining them with joints. To improve the reliability of the developed computer model, the frame is considered as a flexible body. Thus, the frame is modeled by finite elements using MSC.PATRAN. A mode analysis is performed with the frame model using MSC.NASTRAN in order to link the frame model to the computer model. To verify the reliability of the developed computer model, a double wheel bump test is performed with an actual vehicle. In the double wheel bump, vortical displacement, velocity, acceleration are measured. Those test results are compared with the simulation results.

• Journal of Information Technology Applications and Management
• /
• v.31 no.4
• /
• pp.149-162
• /
• 2024

This paper explored the characters in spin-off works that are becoming a hot topic not only in Korea but also in the world. I would like to find out whether there are changes in the character in the original and the character's character and behavior in the spin-off work, and if there are changes, for what reason the changes occur. The subjects of the study were "Puss in Boots" and "Minions," which released a number of spin-off works based on the original. As analysis tools, we used the five-step theory of need by Abraham H. Maslow and the behavioral model of Greimas. As a result, in the spin-off work, Minions and Puss have shifted away from the role of facilitator in the original and become subjective characters. According to Maslow's theory of needs, the analysis also confirmed that this appears as an action to satisfy the needs of belonging, love, respect, and self-realization beyond basic physiological and safety needs. This change allowed him to develop a more independent and proactive personality and behavior, and be at the center of the story. This is the result of reflecting the production team's intention and audience expectations to provide audiences with deeper characters and richer stories. is analyzed.