DOI QR코드

DOI QR Code

Experimental Study to analyze Effect of Rail Corrugation Reduction according to Rail Grinding

레일연마에 따른 레일 파상마모 저감 효과 분석을 위한 실험적 연구

  • 최정열 (동양대학교 건설공학과) ;
  • 정천만 (서울교통공사 궤도 2사업소) ;
  • 정지승 (동양대학교 건설공학과)
  • Received : 2021.10.19
  • Accepted : 2021.11.02
  • Published : 2021.11.30

Abstract

Rail corrugation is continuously increasing due to the lack of maintenance regulations for the amount of rail irregularities. Rail corrugation is causing various problems, such as a decrease in ride comfort and an increase in the amount of track maintenance. In this paper, the effect of rail corrugation on the track force was analyzed by measuring the rail irregularities before and after rail grinding and the track measurements (dynamic wheel load, displacement, and acceleration) for the section where the rail corrugation occurred. In addition, it was experimentally proven that the rail grinding performed to reduce the corrugation of the rail was very effective in reducing the additional forces on the track.

레일 파상마모는 레일표면 요철 관리기준의 부재로 인해 지속적으로 증가하는 추세에 있다. 레일파상마모는 승차감 저하와 궤도 유지관리 물량증대 등과 같은 다양한 문제점을 야기 시키고 있다. 본 논문에서는 레일 파상마모 발생구간을 대상으로 레일 연마 전, 후에 대한 레일요철 측정 및 궤도계측(동적 윤중, 변위, 가속도)을 수행하여 레일 파상마모가 궤도부담력에 미치는 영향을 분석하였다. 또한 레일 파상마모 저감을 위해 실시한 레일연마는 레일 파상마모로 인해 발생되는 추가적인 궤도부담력 저감에 매우 효과적이었음을 실험적으로 입증하였다.

Keywords

References

  1. J.Y. Choi, H.S. Gong, J.H. Kim, H.S. Kim, J.S. Chung, "An Experimental Study on Causes Evaluation of Rail Corrugation for Concrete track(STEDEF) in Urban Transit", Journal of the Convergence on Culture Technology(JCCT), Vol. 4, No. 4, pp. 413-418, 2018. https://doi.org/10.17703/JCCT.2018.4.4.413
  2. M.C. Kim, W.H. You, "Rail Corrugation Effects on the Dynamic Behavior of Clips of Rail Fastening System in Operation Environment of Urban Railway", Journal of the Korean Society for Railway, Vol. 19, No. 4, pp. 489-497, 2016. https://doi.org/10.7782/JKSR.2016.19.4.489
  3. S.L. Grassie, "Rail Corrugation: Characteristics, Cause and Treatments", Proceeding IMechE Part F: Journal of Rail and Rapid Transit, Vol. 223, pp. 1-17, 2009. https://doi.org/10.1243/PIME_PROC_1993_207_227_02
  4. P.A. Meehan, W.J.T. Daniel, T. Campey, "Prediction of the Growth of Wear-Type Rail Corrugation", Wear (ELSEVIER), Vol. 258, pp. 1001-1013, 2005. https://doi.org/10.1016/j.wear.2004.03.049
  5. C. Collettea, P. Vanhonacker, R. Bastaits, D. Levy, "Comparison between Time and Frequency Studies of a Corrugated Curve of RER Paris Network", Wear (ELSEVIER), Vol. 265, pp. 1249-1258, 2008. https://doi.org/10.1016/j.wear.2008.01.030
  6. I. Gomez, E.G. Vadillo, "A Linear Model to Explain Short Pitch Corrugation on Rails", Wear (ELSEVIER), Vol. 255, pp. 1127-1142, 2003. https://doi.org/10.1016/S0043-1648(03)00282-5
  7. S.C. Yang, S.Y. Jang, "Investigation of the Maintenance Criteria for the Rail Surface Defects in High-Speed Railways", Journal of the Korean Society for Railway, Vol. 14, No. 6, pp. 535-544, 2011. https://doi.org/10.7782/JKSR.2011.14.6.535
  8. Y.T. Hwang, J.Y. Choi, T.G. Lee, "Study on Force-based Rail Surface Quality Maintenance Method", Journal of the Korean Society for Railway, Vol. 23, No. 5, pp. 451-459, 2020. https://doi.org/10.7782/JKSR.2020.23.5.451
  9. Choi. J., Qualitative Analysis for Dynamic Behavior of Railway Ballasted track, Ph.D. thesis. Technical University of Berlin, GER, 2014.
  10. K.Y. Ha, H.S. Kim. "A Study of Rail Wear by Change of Acceleration and Deceleration", Journal of the Korean Society for Railway, Vol. 10, No. 5, pp. 607-612, 2007. https://doi.org/10.1016/S0043-1648(03)00282-5
  11. J.Y. Choi, H.S. Kim, K.S. Han, C.J. Jang, J.S. Chung, "Damage Evaluation of Track Components for Sleeper Floating Track System in Urban Transit", The Journal of the Convergence on Culture Technology(JCCT), Vol. 5, No. 4, pp. 387-394, 2019. https://doi.org/10.17703/JCCT.2019.5.4.387