DOI QR코드

DOI QR Code

Validation of a New Design of Tellurium Dioxide-Irradiated Target

  • Fllaoui, Aziz (Radiopharmaceutical Production Unit, Life Sciences and Applications Department, Centre National de l'Energie des Sciences et des Techniques Nucleaires) ;
  • Ghamad, Younes (Radiopharmaceutical Production Unit, Life Sciences and Applications Department, Centre National de l'Energie des Sciences et des Techniques Nucleaires) ;
  • Zoubir, Brahim (Radiopharmaceutical Production Unit, Life Sciences and Applications Department, Centre National de l'Energie des Sciences et des Techniques Nucleaires) ;
  • Ayaz, Zinel Abidine (Radiopharmaceutical Production Unit, Life Sciences and Applications Department, Centre National de l'Energie des Sciences et des Techniques Nucleaires) ;
  • Morabiti, Aissam El (Safety Audit Unit, Safety Security Pole, Centre National de l'Energie des Sciences et des Techniques Nucleaires) ;
  • Amayoud, Hafid (Maintenance and Technical Unit, Technical and Logistic Division, Centre National de l'Energie des Sciences et des Techniques Nucleaires) ;
  • Chakir, El Mahjoub (Nuclear Physics Department, University Ibn Toufail)
  • Received : 2015.12.26
  • Accepted : 2016.05.07
  • Published : 2016.10.25

Abstract

Production of iodine-131 by neutron activation of tellurium in tellurium dioxide ($TeO_2$) material requires a target that meets the safety requirements. In a radiopharmaceutical production unit, a new lid for a can was designed, which permits tight sealing of the target by using tungsten inert gaswelding. The leakage rate of all prepared targets was assessed using a helium mass spectrometer. The accepted leakage rate is ${\leq}10^{-4}mbr.L/s$, according to the approved safety report related to iodine-131 production in the TRIGA Mark II research reactor (TRIGA: Training, Research, Isotopes, General Atomics). To confirm the resistance of the new design to the irradiation conditions in the TRIGA Mark II research reactor's central thimble, a study of heat effect on the sealed targets for 7 hours in an oven was conducted and the leakage rates were evaluated. The results show that the tightness of the targets is ensured up to $600^{\circ}C$ with the appearance of deformations on lids beyond $450^{\circ}C$. The study of heat transfer through the target was conducted by adopting a one-dimensional approximation, under consideration of the three transfer modes-convection, conduction, and radiation. The quantities of heat generated by gamma and neutron heating were calculated by a validated computational model for the neutronic simulation of the TRIGA Mark II research reactor using the Monte Carlo N-Particle transport code. Using the heat transfer equations according to the three modes of heat transfer, the thermal study of I-131 production by irradiation of the target in the central thimble showed that the temperatures of materials do not exceed the corresponding melting points. To validate this new design, several targets have been irradiated in the central thimble according to a preplanned irradiation program, going from4 hours of irradiation at a power level of 0.5MWup to 35 hours (7 h/d for 5 days a week) at 1.5MW. The results showthat the irradiated targets are tight because no iodine-131 was released in the atmosphere of the reactor building and in the reactor cooling water of the primary circuit.

Keywords

References

  1. International Atomic Energy Agency (IAEA), Manual for Reactor Produced Radioisotopes, IAEA-TECDOC-1340, IAEA, Vienna, 2003, p. 86.
  2. M. Khalid, A. Mushtaq, Reuse of decayed tellurium dioxide target for production of iodine-131, J. Radioanal. Nucl. Chem. 299 (2014) 591-694. https://doi.org/10.1007/s10967-013-2793-3
  3. Centre d'Etude de l'Energie Nucleaire (CEN), European Atomic Energy Community (EURATOM), groupe d'exploitation du reacteur BR2 et des installations connexes JMB/JMG/RH, BR2 doigt de gant DG 36/01, Rapport de l'incident survenu le 23 fevrier, 1971 [In French].
  4. M.S. Islam, M.M. Haque, M.A. Salam, M.M. Rahman, M.R.I. Khandokar, M.A. Sardar, P.K. Saha, A. Haque, M.A. Malek Sonar, M.M. Uddin, S.M.S. Hossain, M.A. Zulquarnain, Operation experience with the 3 MW TRIGA Mark-II research reactor of Bangladesh, World TRIGA Users Conference, Vienna, Austria, 15-18 September 2004.
  5. B. El Bakkari, Y. Boulaich, C. El Younoussi, B. Nacir, Safety Analysis Report of CENM 2 MW TRIGA Mark-II research reactor, 02 March, 2012.
  6. Isotope Technologie Dresden (ITD), Operating Document, Process Description for Iodine 131, ITD-GmbH, 22.007, ITD, Dresden, Germany, 2010.
  7. International Standard ISO 9978, Radiation Protection, Sealed Radioactive Sources, Leakage Test Methods, 1st ed., 1992.
  8. International Atomic Energy Agency, Training Guidelines in Non-destructive Testing Techniques: Leak Testing at Level 2, Training Course Series No. 52, Austria, Vienna, 2012, p. 46.
  9. Thermo Fisher Scientific, Software Manual, Iodine Monitor FHT 1702 L, Thermo Electron (Erlangen) GmbH, Frauenauracher StraBe 96, 91056 Erlangen,Germany, 2009.