DOI QR코드

DOI QR Code

Investigation of Ne and He Buffer Gases Cooled Ar+ Ion Clouds in a Paul Ion Trap

  • Kiai, S.M. Sadat (Nuclear Science and Technology Research Institute (NSTR), Plasma Physics and Nuclear Fusion Research School, A.E.O.I.) ;
  • Elahi, M. (Nuclear Science and Technology Research Institute (NSTR), Plasma Physics and Nuclear Fusion Research School, A.E.O.I.) ;
  • Adlparvar, S. (Nuclear Science and Technology Research Institute (NSTR), Plasma Physics and Nuclear Fusion Research School, A.E.O.I.) ;
  • Nemati, N. (Nuclear Science and Technology Research Institute (NSTR), Plasma Physics and Nuclear Fusion Research School, A.E.O.I.) ;
  • Shafaei, S.R. (Nuclear Science and Technology Research Institute (NSTR), Plasma Physics and Nuclear Fusion Research School, A.E.O.I.) ;
  • Karimi, Leila (Department of Chemistry, University of Zanjan)
  • Received : 2015.08.15
  • Accepted : 2015.10.05
  • Published : 2015.12.31

Abstract

In this article, we examine the influences of Ne and He buffer gases under confined Ar+ ion cloud in a homemade Paul ion trap in various pressures and confinement times. The trap is of small size (r0 = 1 cm) operating in a radio frequency (rf) voltage only mode, and has limited accuracy of 13 V. The electron impact and ionization process take place inside the trap and a Faraday cup has been used for the detection. Although the experimental results show that the Ar+ ion FWHM with Ne buffer gas is wider than the He buffer gas at the same pressure (1×10-1 mbar) and confinement time is about 1000 μs, nevertheless, a faster cooling was found with He buffer gas with 500 μs. ultimetly, the obtanied results performed an average cloud tempertures reduced from 1777 K to 448.3 K for Ne (1000 μs) and from 1787.9 K to 469.4 K for He (500 μs)

Keywords

Introduction

The confinement of ions in a quadrupole Paul ion traps are well known process and has outstanding applications in sciences and technology.1-4 Since the Paul ion trap was employed as a mass spectrometer, cooling (damping) process has become very important as successful damping improves the sensitivity and resolution of the ion trap performance.5-8 As we deal with the confinement of a non-neutral plasma in a Paul ion trap, buffere gas cooling becomes significant.9

Theoratically, the damping force F is assumed to be proportional to the velocity ν of the confined ion such as F = -mγν, where m denotes the ion mass, and γ depends on the mobility of particular gas and has unit of s-1. In generall, for non-energetic confined ion (up to few eV) the mobility is approximetly constant.10 Under the damping force, the Mathiu differential equations11 should be modified and in the u direction, r or z, may be written;

and the stability parameters au, and qu are defined

and 2ξ=Ωt, where Ω=2πf is radio-frequency (rf). At low buffer gas pressure down to 10-4 mbar, the ratio c=γ/Ω=1 .

The influence of damping force on the ion motion has been studied using two qz values, qz = 0.45 and qz = 0.908; one is near the adiabatic region and other is at the limited of the stability diagram. However, for Ar+ ion of mass m = 40 amu and f = 650 kHz, the corrsponding rf voltages will be Vrf = 77 V, and Vrf = 156 V, respectively. Figure 1 shows the obtanied numerical computations for the initial ion displacement of z(ξ0)=1mm, and a damping time of 200 μs. The Figure shows a very strong shift in the damping time as the qz valeu moves to the stability limits (e.g. 0.908). This can be atributed to the energitic ion.

Figure 1.The confined 40Ar+ ion damping displacement as a function of damping time; (a) qz = 0.45, with Vrf = 77 V, and (b) qz = 0.908, with Vrf = 156 V, and f = 650 kHz. The initial displacement z(ξ0)=1 mm, C = 1, and az = 0.

The existance of the buffer gas in the Paul ion trap caueses the ion cloud to move to the central region of Paul ion trap and increase in the ion signal detections. The purpose of this work is to show experimentally the effect of cooling (damping) ions with buffer gases in a homemade Paul ion trap. All componenets of the trap including the rf generator, the electron gun, trap electrods, the detection system and timing system are made in our Lab.

 

Experimental Methods

The Paul ion trap electrods are made of stainless steel 316, Figure 2. The z0 = 0.707 cm is one-half of the shortest seperation of the endcap electrodes, and r0 = 1 cm is the ring electrode radius. The ring electrode has three meshes of 9 holes, each 0.1 mm in diameter and placed around circle in which 120 degrees are apart for gas entrance. The gas flowed through three small stainless steel tubes, 0.5 mm in diameter, puff through the meshes in to the ionization volume. This situation effectivly provides a better ionization efficency.

Figure 2.A schematic diagram of experimental set up.

The lower and uper end-cap electrodes have 6 small holes, each 0.1 mm in diameter pass the electrons into the ionization volume and then ions get through the detector, respectivly, see Figure 3. The ion trap geometry is stretched hyperbolicly to have higher confinement efficiency. The truncation of the electrodes has been made at 3r0. Therefore, the relationship will be true for 3r0 with 2.8% error.

Figure 3.A ring and two hyperbolic end-cap electrodes of a Paul ion trap up.

The trap is set up in a vacuum chamber of volume 0.0147m3 and pumped with a turbo-pack up to pressure 10-5 mbar. The rf voltage is connected to the ring and end-cap electrodes in the mass-selective instability mode. An electron gun supplied the flow of the electrons is situated below the lower end-cap electrode. The Tungsten filament uses 0.46 A, and 9 V and a constant current circuit generates a constant follow of electrons. The acceleration of electron is made by -110V with respect to lower end-cap electrode. The ejection voltage applied between Faraday-cup and the upper end cap is up to -300 V, choosed in a way that during ejection phase ions sees fairly same voltage.

The variable time delay of the duty cycle depends on the experiments. Here, a delay time of 50-1000 μs is used in the experiments. The rf voltage can produce up to 350 V0→p (zero to pick) with 650 kHz and more. It is important to indicate that the times; electron acceleration time, the time of confinement and the ejection times can be adjusted through a 10 canals circuit with LVTTL controled by Labview program. The output signals from the detector can be visualized and memorized by oscilloscope providing 2500 data on the Excel software can be used for Origin-pro software.

Figure 4. displays a typical Ar+ ion together with rf signals, electron accelerations voltage (grid voltage), and ejection voltage, respectively. The ion signal depends on some parameters including the ejection time and voltage amplitude.

Figure 4.A typical confined Ar+ ions signal with rf voltage, electron acceleration (grid voltage), and extraction voltage.

For a more comprehensive ions signal, one should trigger the ejection voltage, whenever, the rf confinement voltage is nearly stopped, see figure 4.

 

Results and discussion

Shown in Figure 5 is a He buffer gas cooled ion scanned signals; (a) separated Ar+, Kr+ and (b) a mixed Ar+ + Kr+ scanned, respectively. As seen, at separately scanned masses, one easily obtains ion trapping and an acceptable signal. At mixed scanned, one observes a low resolution, caused by Paul ion trap rf voltage accuracy (13 V), which the limit of stability diagram of ions might be missed for ejection.

Figure 5.Buffer gas He cooled Ar+, and Kr+, ion signals, (a) scanned separately, (b) a mixed scanned.

Some experiments with the goals of comparing He and Ne buffer gases cooled Ar+ ions are carried out. Shown in Figure 6 (a) and (b) is a signal from Ar+ cooled by a He buffer gas.

Figure 6.The He buffer gas cooled Ar+ ion signals at dierrent presssures and confinement times (a) 500 μs, and (b) 1000 μs.

At 500 μs time of confinement, one easily obtains fast cooling; while, at higher 1000 μs time of confinement one observes the amplified Ar+ ion signal. These amplifications can be due to Ar+ ion reorganization towards the trap center.

At the pressure of 7.4×10-2 mbar, and a time of confinement of 500 μs, the average Ar+ ion cloud temperture 1787.9 K, using the relationship is calculated, where v is ion velocity, k is Boltzman constant. At the mixted He with Ar+ pressure of 1 × 10-1 mbar, the average ion cloud temperture reduces to 469.4 K.

The same experiment is carried out with Ar+ ions cooling with heaver Ne buffer gas at 1000 μs confinement time. The acquired resluts is depicted in Figure 7 (a) and (b). Here, for Ar+ ions pressure of 7.4×10-2 mbar, the average ion cloud temperture is 1774 K and ulternatively, for the mixed Ar+ + He pressure of 1 × 10-1 mbar, the averge cloud temperture reduces to 448.3 K.

Figure 7.The Ne buffer gas cooled Ar+ ion signals at dierrent presssures and confinement times (a) 500 μs, and (b) 1000 μs.

 

Conclusion

The observation of the results for Ne cooling buffer gas can quentitivly be understand, as Ne has heavier mass than the He buffer gas, a better ions signal is obtained; the longer time of confinement, the higher number of collisions occures, so, a better damping will arise. He is good buffer gas for fast cooling process, tens of μs confinement time, nevertheless, for a good quality signal, one should consider higher confinement time for ions reorganize themselves toward the trap centr. Finally, the experimental results for the mixed gases acquire low resolution due to lower pricision in rf voltage, i.e. a minimum of 13 V. However, a satisfactory results was found for the scanned singls of sample, the damping process can be done susesfully.

References

  1. George Stafford, Jr. J. Am. Soc. Mass Spectrom. 2002, 13, 589. https://doi.org/10.1016/S1044-0305(02)00385-9
  2. Wei, X.; Qingyu, S.; Scott, A. S.; William, J. C.; Zheng, O. J. Am. Soc. Mass Spectrom. 2009, 20, 2144. https://doi.org/10.1016/j.jasms.2009.06.019
  3. Sadat Kiai, S. M.; Andre, J.; Zerega, Y.; Brincourt, G.; Catela, R. Int. J. Mass Spectrom. Ion Process. 1991, 107, 191. https://doi.org/10.1016/0168-1176(91)80058-U
  4. Enders, K.; Stachowska, E.; Marx, G.; Zölch, Ch.; Georg, U.; Dembczynski, J.; Werth, G. Phys. Rev. A 1997, 56, 265. https://doi.org/10.1103/PhysRevA.56.265
  5. Lee, Y. Y.; Lee, W. W.; OH, C. H.; Kim, P. S. J. Korean Phys. Soc. 2001, 39, 902.
  6. Sadat Kiai, S. M.; Seddighi Chaharborj, S.; Abu Bakar, M. R.; Fudziah, I. J. Anal. At. Spectrom. 2011, 26, 2247. https://doi.org/10.1039/c1ja10170f
  7. Wu, H. F.; Brodbelt, J. S. Int. J. Mass Spectrom. Ion Process. 1992, 115, 67. https://doi.org/10.1016/0168-1176(92)85032-U
  8. Leuthner, H.; Werth, G. Appl. Phys. B 2014, 114, 89. https://doi.org/10.1007/s00340-013-5657-1
  9. Bajpai, M.; Lachhvani, L.; Saxena, L. Phys. Status Solidi. 2009, 6, 2456. https://doi.org/10.1002/pssc.200982052
  10. Blaum, K.; Herfurth, F. Trapped Charged Particles and Fundamental Interactions, Springer: Berlin, 2008.
  11. McLachlan, N. W. Theory and application of Mathieu functions, Oxford Press: London, 1951.