Journal of international Conference on Electrical Machines and Systems

Journal of International Conference on Electrical Machines and Systems (대한전기학회 분과)
권호 표지
DOI QR코드

DOI QR Code

Magnetic Characteristic Analysis of Permanent Magnet Motor with Complex E&S Modeling

  • Zeze, Shingo (Dept. of Electrical and Electronic Engineering, Oita University) ;
  • Todaka, Takashi (Dept. of Electrical and Electronic Engineering, Oita University) ;
  • Enokizono, Masato (Dept. of Electrical and Electronic Engineering, Oita University)
  • Received : 2011.06.17
  • Accepted : 2011.10.12
  • Published : 2012.03.01
Download PDF
⟨ Previous Next ⟩

Abstract

This paper presents analyzed results of a permanent magnet motor by using complex E&S modeling. The calculated results are compared with ones from the conventional E&S modeling for verification. Combinations of the numbers of slots and poles are investigated to reduce total iron loss. The results demonstrate that the complex E&S modeling is very useful in design under consideration of rotational magnetic field and magnetic anisotropy.

Keywords

References

  1. T. Todaka, K.Nakanoue and M.Enokizono, "Magnetic field analysis under complex approximation taking account of two-dimensional magnetic properties", The International Journal for Computation and Mathematics in Electrical and Electronic Engineering, Vol. 28, No. 1, pp. 98-108, 2009. https://doi.org/10.1108/03321640910918904
  2. N. Soda and M. Enokizono, "Improvement of T-joint part constructions in three-phase transformer cores by using direct loss analysis with E&S model," IEEE Trans. Magn., vol.MAG-36, pp. 1724-1727, July 2000.
  3. M. Enokizono and N. Soda, "Direct magnetic loss analysis by FEM considering vector magnetic properties," IEEE Trans. Magn., vol.34, pp. 188-195, Sept. 1998.
  4. Y. Maeda, T. Todaka, H. Simoji, M. Enokizono and J. Sievert, "An evaluation method of cross-type H-coil angle for accurate two-dimensional vector magnetic measurement", Journal of Magnetism and Magnetic Materials, Vol. 304, Issue 2, pp.564-567, September 2006. https://doi.org/10.1016/j.jmmm.2006.02.176
  5. Kohsaka.T, Takahashi.N, Nogawa.S, Kuwata.M : "Analysis of magnetic characteristics of three-phase reactor made of grain-oriented silicon steel", IEEE Trans. Magn., Vol.36, No.4, p.1894-1897 (2000) https://doi.org/10.1109/20.877815
  6. Nakano.M, Nishimoto.H, Fujiwara.K, Takahashi.N : "Improvements of single sheet testers for measurement of 2- D magnetic properties up to high flux density", IEEE Trans. Magn., Vol.35, No.5, p.3965-3967 (1999) https://doi.org/10.1109/20.800723
  7. Mori.K, Yanase.S, Okazaki.Y, Hashi.S. : "2-D magnetic rotational loss of electrical steel at high magnetic flux density", IEEE Trans. Magn., Vol.41, No.10, p.3310-3312 (2005) https://doi.org/10.1109/TMAG.2005.854908