Abstract
The wood-concrete composite can be effectively applied for bridge superstructure, and the concept of fully composite action between each member is one of the most important consideration. Until now, related researches have been done mainly in North America and EU countries not enough to cover the fundamental studies. Therefore, this study is planned to perform one of the important issue for using the wood-concrete composite. The objective of this study is evaluation of shear performance with different anchorage length of steel rebar in wood. Prediction of the yield mode and the reference design value was firstly performed as the preliminary investigation. Then, initial stiffness, yield load and maximum load were derived from the shear test due to different anchorage length of the steel rebar (SD30A in Korean Standard) in wood. It was found out from this study that initial stiffness and yield load are not related with the anchorage length over 20 mm of anchorage length while maximum load shows increasing tendency till 60 mm of anchorage length. Pullout strength of inserted steel rebar in wood is considered to be one reason and this was also verified with the x-ray radiography.
목재-콘크리트 하이브리드 부재는 특히 목조 거더교의 상부구조 등으로 유용하게 적용될 수 있으며, 이를 위한 핵심 사항은 상판으로 사용되는 콘크리트 및 거더로 사용되는 목재의 전단성능 부여에 따른 일체화 거동이다. 현재까지 북미 및 유럽 등을 중심으로 관련 연구가 진행되어 왔으나 대부분의 경우 시공성의 담보를 목적으로 한 것으로 목재와 콘크리트의 전단성능을 확보하기 위한 기초적인 연구는 미비한 실정이다. 따라서 본 연구는 목재-콘크리트 하이브리드 구조의 역학적인 거동을 평가하기에 앞서 가장 중요한 사항 중 하나인 부재 간 전단성능을 평가하기 위한 목적으로 수행되었다. 실제 시험에 앞서 EYM을 통해 목재 내 철근의 정착 길이별 항복모드 및 기준허용전단내력 값을 확인하였으며, 사용한 SD30A 철근에 대한 모드 전환이 이루어지는 철근의 정착 길이 등을 확인할 수 있었다. 전단시험을 통해 초기강성 및 항복하중 값은 정착길이 20 mm 이상인 경우 정착 길이에 무관하게 유사한 값을 나타냈으나, 최대하중의 경우에는 철근의 인발 저항과 복합적으로 작용하여 정착 길이 60 mm 이상과 이하에서 다른 거동을 나타냈다. 시험 후 X선 직접촬영법의 적용을 통해 이를 검증할 수 있었다.