Switching Transient Shaping by Application of a Magnetically Coupled PCB Damping Layer

  • Published : 2009.03.20

Abstract

An increasing number of power electronic applications require high power density. Therefore, the switching frequency and switching speed have to be raised considerably. However, the very fast switching transients induce a strong voltage and current ringing. In this work, a novel damping concept is introduced where the parasitic wiring inductances are advantageously magnetically coupled with a damping layer for attenuating these unwanted oscillations. The proposed damping layer can be implemented using standard materials and printed circuit board manufacturing processes. The system behavior is analyzed in detail and design guidelines for a damping layer with optimized RC termination network are given. The effectiveness of the introduced layer is determined by layout parasitics which are calculated by application of the Partial Element Equivalent Circuit (PEEC) simulation method. Finally, simulations and measurements on a laboratory prototype demonstrate the good performance of the proposed damping approach.

Keywords

References

  1. J.A. Rosero, J.A. Ortega, E. Aldabas, L. Romeral, "Moving towards a more electric aircraft", IEEE Alagazine on Aerospace and Electronic Systems, Vol. 22, No.3, pp. 3-9, March 2007 https://doi.org/10.1109/MAES.2007.340500
  2. A. Siebert, A. Troedson, S. Ebner, "AC to DC power conversion now and in the future", IEEE Trans. Industrial Applications, Vol.38, Vo. 4, pp. 934-940, July- Aug. 2002 https://doi.org/10.1109/TIA.2002.800570
  3. J.W. Kolar and F.C. Zach, "A Novel Three-Phase Utility Interface Minimizing Line Current Harmonics of High-Power Telecommunications Rectifier Modules", IEEE Transactions on Industrial Electronics, Vol. 44, No.4, pp. 456-467, August 1997 https://doi.org/10.1109/41.605619
  4. S. Bontemps, A. Calmels, S.D. Round, J.W. Kolar, "Low profile power module combined with state of the art MOSFET switches and SiC diodes allows high frequency and very compact three-phase sinusoidal input rectifiers", Proc. of the Conf. for Power for Power Electronics, Intelligent Motion and Power Nuremberg (Gernlany), 2007
  5. P. C. Todd, "Snubber Circuits: Theory, Design and Application", , http://www.ti.com , 2009
  6. N. Mohan, T. M. Undeland and W. P. Robbins, "Power Electronics - Converters, Applications and Design", 2nd ed. New York: Wiley/Academic, ch. 27, 1995
  7. M. Mardiguian, "EMI Troubleshooting Techniques", McGraw-Hill, ch. 6, 2000
  8. O. Arakawa, T. Yamada, R. Hiramatsu, "Magnetic snubber using amorphous saturable reactor-amorphous beads", Proc. of the 3rd Atmual IEEE Applied Power Electronics Conference and Exposition (APEC '88), pp.334-340, 1-5 Feb. 1988
  9. G. Mantov, K. Wallace, "Diode recovery current suppression circuit", Proc. of the 21st International Teleconmmnications Energy Conference (INTELEC 200), pp.125-129, 2000
  10. J.D. van Wyk Jr., W.A. Cronje, J.D. van Wyk, C.K. Campbell, P.J. Wolmarans, "Power Electronic Interconnects: Skin- and Proximity Effect-Based Frequency Selective Multipath Propagation", IEEE Transactions on Power Electronics, Vol. 20, No.3, pp. 600-609, May 2005 https://doi.org/10.1109/TPEL.2005.846549
  11. K. de Jager, L. Dalessandro, I.W. Hofsajer, W.G. Odendaal, "Wave Analysis of Multilayer Absorptive Low-Pass Interconnects", Proc. of the 38th IEEE Power Electronics Specialists Conference (PESC'07), Orlando (USA), pp. 2121-2127, June 17-21,2007
  12. P.R. Palmer, H.S, Rajamani, "Active Voltage control of IGBTs for high power applications", IEEE Transactions on Power Electronics, Vol.19, No.4, pp. 894-901, July 2004 https://doi.org/10.1109/TPEL.2004.830078
  13. N. Idir, R. Bausiere, J.J. Franchaud, "Active gate voltage control of tum-on di/dt and turn-off dv/dt in insulated gate transistors", IEEE Transactions on Power Electronics, Vol.21, No.4, pp. 849-855, July 2006 https://doi.org/10.1109/TPEL.2007.876895
  14. T. Kjellqvist, S. Ostlund, S. Norrga, "Active Snubber Circuit for Source Commutated Converters Utilizing the IGBT in the Linear Region", IEEE Transactions on Power Rlectronics, Vol.23, No.5, pp.2595-2601, Sept. 2008 https://doi.org/10.1109/TPEL.2008.2002093
  15. M. Hartmann, A. Muesing, J.W. Kolar, "Switching transient shaping of RF power MOSFETs for a 2.5 MHz, three-phase PFC", 7th Internatonal Conference on Power Electronics (TCPE '07), pp. 1160-1166, 22-26 Oct. 2007
  16. W. Teulings, J.L. Schanen, J.Roudet, "MOSFET Switching Behaviour Under Influence of PCB Stray Inductance", Proc. of the 31st lAS Annual Meeting, San Diego (USA), pp.1449-1453, 6-10 October 1996 https://doi.org/10.1109/IAS.1996.559257
  17. S.C. Tang, S.Y. Hui, B.S. Chung, "Coreless Planar Printed-Circuit-Doard (PCB) Transformers A Fundamental Concept for Signal and Energy Transfer", IEEE Transactions on Power Electronics, Vol. I5, No. 5, pp. 931-941, Sept. 2000 https://doi.org/10.1109/63.867683
  18. J. Biela, A. Wirtlunueller, R. Waespe, M.L. Heldwein, J.W. Kolar, E. Waffenschmidt, "Passive and Active Hybrid Integrated EMI Filters", Proc. of the 21 st IEEE Applied Power Electronics Conf. (APEC'06), Dallas (USA), Vol. 2, pp. 1174-1180, March 19-23, 2006
  19. K. Adachi, K. Takao, Y. Hayashi, H. Ohashi, "Study on Intrinsic I,oss of Unipola Power Device due to Main Junction Capacitance", lEEJ Transactions on Industry Applications, Vol. 126, No.7, pp. 941-945, 2006 https://doi.org/10.1541/ieejias.126.941
  20. L. Lorenz, G. Deboy, I. Zverev, "Matched Pair of CoolMOS Transistor With SiC-Schottky Diode - Advantages in Application", IEEE Transactions on Industry Applications, Vol. 40, No.5, pp. 1265-1272, Sept./Oct. 2005 https://doi.org/10.1109/TIA.2004.834017
  21. IXYS-RF, "DE-Series Fast Power MOSFETs - An Introduction", Application Note published at http://www.ixysrf.com. 2007
  22. P. Musznicki, J.L. Schanen, B. Allard and P. Chrzan, "Accurate Modeling of Layout Parasitics to Forecast EMI Emitted from a DC-DC Converter", 35th Annual IEEE Power Electronics Specialists Conference (PESC'04), Vol. 1, Aachen (Germany), pp. 278-283, 2004
  23. A. Musing, M.L. Heldwein, T. Friedli, J.W. Kolar, "Steps Towards Prediction of Conducted Emission Levels of an RB-IGBT Indirect Matrix Converter", Power Conversion Conference (PCC '07), Nagoya (Japan), pp. 1181-1188, 2-5 April 2007
  24. A. Ruehli, G. Antonini, J. Esch, J. Ekman, A. Mayo, A. Orlandi, "Non-Orthogonal PEEC Formulation for Time and Frequency Domain EM and Circuit Modeling", IEEE Transactions on Electromagnetic Compatibility, Vol. 45, No.2, pp. 167-176, May 2003 https://doi.org/10.1109/TEMC.2003.810804
  25. A.E. Ruehli, H. Heeb, "Circuit models for three-dimensional geometries including dielectrics", IEEE Transactions on lvficrowave Theory and Techniques, Vol. 40, No. 7, pp.1507-1516, July 1992 https://doi.org/10.1109/22.146332
  26. Lulea University of Technology and University of L'Aquila, "Partial Element Equivalent Circuit (PEEC) Solver Page", http://www.sm.luth.se/-jekman/PEEC/Program. 2007