Analysis of the Ultrasonic Cavitation Energy in a Large-Scale Sonoreactor

Lrge-Scale 초음파 반응기에서의 내부 초음파 에너지 분포 분석

  • Son, Younggyu (Department of Civil, Environmental and Architectural Engineering, Korea University) ;
  • Lim, Myunghee (Department of Civil, Environmental and Architectural Engineering, Korea University) ;
  • Kim, Wonjang (Saemangeum Project Office, Korea Rural Community & Agriculture Corporation) ;
  • Khim, Jeehyeong (Department of Civil, Environmental and Architectural Engineering, Korea University)
  • 손영규 (고려대학교 건축사회환경공학과) ;
  • 임명희 (고려대학교 건축사회환경공학과) ;
  • 김원장 (한국농촌공사 새만금사업단) ;
  • 김지형 (고려대학교 건축사회환경공학과)
  • Received : 2007.11.19
  • Accepted : 2008.01.08
  • Published : 2008.01.30

Abstract

Ultrasonic cavitational energy distributions were measured in a large-scale sonoreator. In application of 110 and 170 kHz of ultrasound, the cavitational energy was just detected near the transducer module. However 35 and 72 kHz ultrasound made good distributions from the module to the end of the sonoreactor, Especially, 72 kHz ultrasound application showed most stable and highest cavitational energy value through the whole length. In the comparison between input power and cavitational energy, linear relationships were obtained in 35 and 72 kHz and it was anticipated that these results would be used for the optimization of input power for the design of sonoreactors. And three dimensional energy distribution was depicted through the mapping of cavitaional energy. Average energy in the large-scale sonoreactor was estimated as 62.8 W, which was about 40 % of input power.

Keywords

Acknowledgement

Supported by : 환경부

References

  1. Adewuyi, Y. G. (2001). Sonochemistry: Environmental Science and Engineering Applications. Ind. Eng. Chem. Res., 40, pp. 4681-4715 https://doi.org/10.1021/ie010096l
  2. Asakura, Y., Yasuda, K., Kato, D., Kojima, Y. and Koda, S. (2008). Development of a large sonochemical reactor at a high frequency. Chem. Eng. J., in press
  3. Gogate, P. R., Tatake, P. A., Kanthale, P. M. and Pandit, A. B. (2002). Mapping of Sonochemical Reactors: Review, Anlaysis, and Experimental Verification. AIChE Journal, 48(7), pp. 1542-1560 https://doi.org/10.1002/aic.690480717
  4. Gogate, P. R., Mujumdar, S. and Pandit, A. B. (2003). Large scale sonochemical reactors for process intensification: design and experimental validation. J. Chem. Technol. Biotechnol., 78, pp. 685-693 https://doi.org/10.1002/jctb.697
  5. Gogate, P. R. and Pandit, A. B. (2004). Sonophotocatalytic reactors for wastewater treatment: a critical review. AIChE Journal, 50(5), pp 1051-1079 https://doi.org/10.1002/aic.10079
  6. Gogate, P. R. (2007). Appication of cavitational reactors for water disinfection: Current status and path forward. J. Environ. Manage., 85, pp. 801-815 https://doi.org/10.1016/j.jenvman.2007.07.001
  7. Hagenson, L. C. and Doraiswamy, L. K. (1998). Comparison of the Effects of Ultrasound and Mechanical Agitation on a Reacting Solid-Liquid System. Chem. Eng. Sci., 53(1), pp. 131-148 https://doi.org/10.1016/S0009-2509(97)00193-0
  8. Hua, I. and Hoffmann, M. R. (1996). Kinetics and Mechanism of the Sonolytic Degradation of CCl4-Intermediates and Byproducts. Environ. Sci. Technol., 30(3), pp 864-871 https://doi.org/10.1021/es9502942
  9. Hung, H. and Hoffmann, M. R. (1999). Kinetics and Mechanism of the Sonolytic degradation of Chlorinated Hydrocarbons Frequency Effects. J. Phys. Chem., 103(15), pp. 2734- 2739 https://doi.org/10.1021/jp9845930
  10. Kimura, T., Sakamoto, T., Leveque, J. M., Sohmiya, H., Fujita, M., Ikeda, S. and Ando, T. (1996). Standardization of Ultrasonic Power for Sonochemical Reaction. Ultrason. Sonochem., 3, pp. S157-S161 https://doi.org/10.1016/S1350-4177(96)00021-1
  11. Mason, T. J. and Lorimer, J. P. (2002). Applied Sonochemistry- The Uses of Power Ultrasound in Chemistry and Processing, Wiley-VCH Verlag GmbH, Weinheim
  12. Petrier, C. and Francony, A. (1997). Ultrasonic Wastewater Treatment-Incidence of Ultrasoinc Frequency on the Rate of Phenol and Carbon Tetrachloride Degradation. Ultrason. Sonochem., 4, pp. 295-300 https://doi.org/10.1016/S1350-4177(97)00036-9
  13. Pugin, B. (1987). Qualitative Characterization of Ultrasound Reactors for Heterogeneous Sonochemistry. Ultrasonics, 25, pp. 49-55 https://doi.org/10.1016/0041-624X(87)90012-6
  14. Ratoarinoro, N., Contamine, F., Wilhelm, A. M., Berlan, J. and Delmas, H. (1995). Power Measurement in Sonochemistry. Ultrason. Sonochem., 2(1), pp. S43-S47 https://doi.org/10.1016/1350-4177(94)00010-P
  15. Romdhane, M., Gourdon, C. and Casamatta, G. (1995). Local Investigation of Some Ultrasonic Devices by Means of a Thermal Sensor. Ultrasonics, 33, pp. 221-227 https://doi.org/10.1016/0041-624X(94)00023-I
  16. Romdhane, M., Gadri, A., Contamine, F., Gourdon, C. and Casamatta, G. (1997). Experimental Study of the Ultrasound Attenuation in Chemical Reactors. Ultrason. Sonochem., 4, pp. 235-243 https://doi.org/10.1016/S1350-4177(97)00002-3
  17. Thompson, L. H. and Doraiswamy, L. K. (1999). Sonochemistry: Science and Engineering. Ind. Eng. Chem. Res., 38, pp. 1215-1249 https://doi.org/10.1021/ie9804172