DOI QR코드

DOI QR Code

A Study on the Temperature Behavior on Impinging Plate of Diesel Spray with Ultra High Pressure

극초고압 디젤분무의 충돌면 온도거동에 관한 연구

  • Published : 2005.03.01

Abstract

The instantaneous temperature behaviors on impinging plate in case of ultra high pressure have been measured and analyzed by using the instantaneous temperature probe and ultra high pressure injection equipment. The temperature drop was largest at P1 which is center of impinging spray and decreased with propagation of spray to the radius direction. The temperature drop was bigger in case of higher temperature of impinging plate. The temperature drop decreased with increase of injection pressure. But decreasing rate of temperature drop was slight over 2,500 bars. Therefore, it was predicted that the fuel evaporation versus the increase of injection pressure was maximum at around 2,500 bars.

Keywords

References

  1. Enomoto, Yoshiteru, 1985, 'Measurement of Heat-Flux and Heat Transfer Coefficient on Combustion Chamber Wall,' Journal of the Society of Automotive Japan, Vol. 39, No. 11, pp. 1270~1278
  2. Choi, G. H., Choi, K. H., Lee, J. T., Song, Y. S., Ryu, Y. and Cho, J. W., 1997, 'Analysis of Combustion Chamber Temperature and Heat Flux in a DOHC Engine,' SAE, No. 970895, pp. 135~147
  3. Daeyong Jeong and Jongtai Lee, 2003, 'An Anlysis of Impinging Spray Characteristics with Ultra High Pressure to Examine a Limit Pressure,' Spring Conference of KSAE, Vol. 1, pp. 329∼335
  4. Kato, T., Tsujimura, K., Shintani, M., Minami, T. and Yamaguchi, I., 1989, 'Spray Characteristics and Combustion Improvement of a D. I. Diesel Engine with High-Pressure Fuel Injection.' SAE Paper No. 890265
  5. Senda, J., Kanda, T., Kobayashi, M., Iwashita, S. and Fujimoto, H., 1994, 'Modeling of Diesel Spray Impingement on a Flat Wall,' SAE NO. 941894
  6. Shi-Wen Li, Shigeharu Kobori and Takeyuki Kamimoto, 1997, 'Heat Transfer From Impinging Diesel Flames to the Combustion Wall,' SAE Trans., Vol. 106, pp. 1508-1521
  7. Suk Bum Moon and Ja Ye Koo, 1999, 'Characteristics of a Diesel Spray Impinging on the Hot Plate,' SAE, NO. 99370251
  8. Chang, J-C., 1993, 'Diesel Spray Characteristics and Spray/Wall Heat Trandfer,' Ph. D. Thesis, University of London
  9. Daeyong Jeong and Jongtai Lee, 2003, 'A Study on Combustion Characteristics of Diesel-water Emulsion with High Pressure Injection,' Trans. of the KSME(B), Vol. 27, No. 10, pp. 1435-1441 https://doi.org/10.3795/KSME-B.2003.27.10.1435