Abstract
In this paper, method for the determination of removal time of the side forms in high strength concrete are discussed using the estimation model of compressive strength development, the development of bond strength and rebound number of P type Schmidt hammer in order to review the validity of existing regulation as to side form removal and offer effective quality control method. According to the results, as W/B increases by $10\%$, the setting time is shortened by about 2 hours. In the scope of the paper, required time to gain 8MPa of compressive strength is determined about 17 ${\~}$20 hours of age and $21{\~}25^{\circ}D{\cdot}D$ of maturity. Bond strength between form and concrete shows the highest value around final setting time, but decreases drastically after that. Amount of concrete sticking on the form is large before setting completed, but after that, its amount shows decline tendency. The rebound value test with P type schmidt hammer can be started faster by 2${\~}$3 hours than compressive strength test. It is also confirmed that the removal of forms is possible when the rebound value of P type schmidt hammer is more than 32. It is found from the results that existing regulation regarding removal time of the side form of high strength concrete provided in KCI needs no revision because required time to gain the strength provided in KCI has no adverse effect on strength development at early age and surface condition during stripping the side form. Effective procedure to decide the removal time of side form can be performed by applying P type Schmidt hammer.
본 연구에서는 초기재령에서 고강도콘크리트의 압축강도 발현 특성 검토 및 해석 그리고 콘크리트와 거푸집간의 부착강도 특성을 분석하며, P형 슈미트해머를 이용한 반발도와 압축강도간의 상관관계를 검토하므로서 실무의 고강도콘크리트 측면 거푸집 탈형과 연관한 관련규정의 적합성을 재검토하고, 아울러 거푸집제거와 연관한 효율적인 품질관리 방법에 대하여 제안하고자 한다. 연구결과에 따르면, W/B가 증가할수록 응결시간은 감소하는 것으로 나타났으며, 본 연구의 범위에서 로지스틱 모델에 의한 강도증진 해석 결과 압축강도 8MPa를 발휘하는 시간과 적산온도는 17${\~}$20시간, $21{\~}25^{\circ}D{\cdot}D$ 정도로 나타났다. 거푸집과 콘크리트의 부착강도는 종결시점에서 가장 크게 나타났으며 그 이후에는 감소함을 보였고, 거푸집에 부착되어 박리되는 콘크리트의 양은 응결이전에 크게 나타났으며, 그 이후에는 점차적으로 감소하는 경향을 보였다. P형 슈미트해머에 의한 반발도 실험결과 압축강도 발현시점보다 약 2${\~}$3시간 정도 빠르게 측정할 수 있으며, 반발도가 32 이상이면 측면 거푸집을 탈형 할 수 있는 시기로 품질관리가 가능할 것으로 판단되었다.