A Study on the Heat Transport Limitations of a PFC(FC-72) Two-Phase Closed Thermosyphon for Cooling Power Semiconductors

전력변환 반도체 냉각용 PFC(FC-72) 밀폐형 2상 열사이폰의 열전달 한계에 관한 연구

  • 박용주 (성균관대학교 기계공학부 대학원) ;
  • 홍성은 (유한대학교 건축설비과) ;
  • 김철주 (성균관대학교 기계공학부)
  • Published : 2002.09.01

Abstract

In this study, the heat transport limitations of a two-phase closed thermosyphon were investigated. For the test, a two-phase closed thermosyphon ($L_t/: 600 mm,\;L_e:105mm,\;L_a:75mm,\;L_c:420mm,\;D_o:22.2mm,$ container: copper (inner grooved surface), working fluid: PFC ($C_6F_14$) was fabricated with a reservoir that can change the fill charge ratio. The following was imposed as the factors on the heat transport limitations of a two-phase closed thermosyphon. 1) Fill charge ratio of the working fluid. 2) Tilt angle of the longitudinal axis. From tile experimental data, some results were obtained as follows. When the fill charge ratio was relatively small ($\psi$20%), the heat transport limitation occurred about 100W by dry-out limitation. However over 40%, it shelved nearly constant value (500 W) by flooding limitation. The heat transport limitation according to the tilt angle increased smoothly until the tilt angle was $60^{\circ}$,/TEX>, after then decreased slowly.

Keywords

References

  1. Furokawa Review v.12 Power Semiconductor Device Cooliong System Using Electrically Insulated Heat Pipe [POWERKICKER-E] for Rolling Stock Murase, T.;Sasaki, C.;Matsumoto;Kimura, Y.;Kotani, M.;Sotani,J.
  2. 10th IHPC Microscopic Modelling and Test Evaluation of a Capillary Pumped Evaporator Figus, C.;Dunbar, N.;Super, W.
  3. Design and Manufacturing of the Heat Sink Using Heat Pipes Kim, C.J.;Kang, H.K.;Lee, J.S.;Hong, S.E.;Park, Y.J.
  4. The Effect of Fill Charge Ratio on Heat Transfer Performance in PFC Thermosyphon Park, Y.J.
  5. Heat Pipe Science and Technology Faghri, A.
  6. An Introduction to Heat Pipes Peterson, G.P.
  7. 5th IHPC Visual Study of Operating Limit in the Two-Phase Closed Thermosyphon Shiraishi, M.;Yoneya, M.;Yabe, A.
  8. One-Dimensional Two-Phase Flow Wallis, G.B.
  9. Fluid Mechanics Soviet Research v.14 Elements of Hydrodynamics of Gas-Liquid Systems Kutateladze, S.S.
  10. ASME J. of Fluids Engineering no.3 The Hang Film Phenomenon in Vertical Annular Two-Phase Flow Wallis, G.B.;Makkenchery, S.
  11. ASME J. of Heat Transfer v.111 Heat Transfer Characteristics in Two-Phase Closed Conventional and Concentric Annular Thermosyphons Faghri, A.;Chen, M.M.;Morgon, M. https://doi.org/10.1115/1.3250726
  12. 8th IHPC Reflux Condensation Inside a Two-Phase Thermosyphon at Pressures up to the Critical Gross, U.;Hahne, E.
  13. The Tubular Thermosyphon Lock, G.S.H.
  14. A Study on Heat Transfer Limitation for a Perfluorocarbon Heat Pipe v.11 no.3 Kang, H.K.;Kim, J.J.;Kim, C.J.
  15. 3rd IHPC Entrainment Limits in Heat Pipes Tien, C.L.;Chung, K.S.