• Journal of the Society of Naval Architects of Korea
• /
• v.45 no.1
• /
• pp.42-53
• /
• 2008

The two dimensional PIV (particle image velocimetry) measurement technique is applied to water flow in a narrow cavitation tunnel. The nearly homogeneous and isotropic turbulent flows are generated by the honeycomb installed in the tunnel and visualized with a PIV technique. The velocities in the measurement plane at the tunnel centerline 184cm downward from the honeycomb were measured and calculated by an image correlation technique. The turbulent properties are evaluated and each term in the turbulent kinetic energy equation is calculated for the conditions with different internal pressures. Lowering the internal pressure gives an effect on the turbulent flow due to growing bubbles which are resolved in the water. The turbulent kinetic energy in the measurement plane is decayed much slower than those of other research results carried out with wind tunnels. With decreasing the tunnel internal pressures the turbulent intensities are increased about 1.5 times and the anisotropic tendency is also increased.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.23 no.1
• /
• pp.30-41
• /
• 1999

This study was conducted to verify the advantages of Gal-Ot. Gal-Ot is defined the clothings dyed with persimmon juice. Firstly the physical properties of fabrics were examined. Secondly the wear tests were conducted. The wear tests were performed in climatic chamber controlled 3$0^{\circ}C$ air temperature 50$\pm$5% R.H and 0.2m/s air movement. Four women subjects participated in this experiment and 4 times experiments were performed per one subject. The expeimental schedule was planned following 4 steps that is sedentary posture during 30 minutes-walking the 5。slope treadmill by 70m/min during 20 minutes-sedentary posture during 20 minutes-standing posture on toward the blowing wind during 10 minutes. The results obtained is as folows : The insulation of fabric was increased with dyeing with persimmon juice. The air permeability of fabric was remarkably increased with dyeing with persimmon juice. The mean skin temperatures of subjects were apt to be higher in wearing Gal-Ot than undyed clothing. The clothing micro temperature of subjects were slightly inclined to become lower in wearing Gal-Ot than undyed clothing, The clothing micro humidity was decreasee when: the subjects were gal-Ot than wore undyed clothing, And then it brought about more comfortable on wear sensation. The differences of physiological reactions were not consistent between clothing types except for sweat rate on the back. This result may be attributed the to complex experimental schdules consisted of four steps and to a little difference between open type and close type. However I consider that the clothing type of Gal-Ot is suitable for open type because Gal-Ot is summer wear for blocking the sultry heat.

• Journal of the Korean housing association
• /
• v.24 no.1
• /
• pp.21-31
• /
• 2013

This study focuses on the regional characteristics observed in the composition and floor plan of folk houses in the Young-cheon region situated in the Southern East inland of Gyungsangbukdo. According to the typical characteristics of the Korean folk house, Young-cheon region is supposed to be classified as the Young-Nam region. Our study shows that the open inverse 'ㄱ' type composition is the most common among others, which consists the living room, UtChae and one BoosokChae that serves as a living room and a farm shop. The typical floor plan is called 'Young Nam type' 'H$\hat{o}$tjib' composed of four rooms. Young Nam type of house has a wall in front of the room floor with a door to make the space with the room floor as the internal space. This can be explained by the climatic conditions in the Southern region of Gyungsangbukdo, which has a very cold winter and has a harsh spring wind in Young-cheon. The structural feature to which we should pay attention is the Young Nam type house has a gambrel roof. The evolutions of the house in the 70s are observed in the roof during the Saemaeul Movement from a hut to a modernized roof. In the 80s, the replacement of the heating system, expansion of rooms, modernization of kitchen, replacement of paper windows, modernization of roof, and construction of amenities had taken place to change the space, construction and structure following the modern house features.

• Structural Engineering and Mechanics
• /
• v.65 no.3
• /
• pp.303-314
• /
• 2018

Shear walls are a typical member under a complex stress state and have complicated mechanical properties and failure modes. The separated-elements model Genetic Evolutionary Structural Optimization (GESO), which is a combination of an elastic-plastic stress method and an optimization method, has been introduced in the literature for designing such members. Although the separated-elements model GESO method is well recognized due to its stability, feasibility, and economy, its adequacy has not been experimentally verified. This paper seeks to validate the adequacy of the separated-elements model GESO method against experimental data and demonstrate its feasibility and advantages over the traditional elastic stress method. Two types of reinforced concrete shear wall specimens, which had the location of an opening in the middle bottom and the center region, respectively, were utilized for this study. For each type, two specimens were designed using the separated-elements model GESO method and elastic stress method, respectively. All specimens were subjected to a constant vertical load and an incremental lateral load until failure. Test results indicated that the ultimate bearing capacity, failure modes, and main crack types of the shear walls designed using the two methods were similar, but the ductility indexes including the stiffness degradation, deformability, reinforcement yielding, and crack development of the specimens designed using the separated-elements model GESO method were superior to those using the elastic stress method. Additionally, the shear walls designed using the separated-elements model GESO method, had a reinforcement layout which could closely resist the actual critical stress, and thus a reduced amount of steel bars were required for such shear walls.

• Wind and Structures
• /
• v.29 no.6
• /
• pp.457-469
• /
• 2019

In this paper, a numerical solution is presented for supersonic flutter analysis of cantilever non-symmetric functionally graded (FG) sandwich plates. The plate is considered to be composed of two different functionally graded face sheets and an isotropic homogeneous core made of ceramic. Based on the first order shear deformation theory (FSDT) and linear piston theory, the set of governing equations and boundary conditions are derived. Dimensionless form of the governing equations and boundary conditions are derived and solved numerically using generalized differential quadrature method (GDQM) and critical velocity and flutter frequencies are calculated. For various values of the yaw angle, effect of different parameters like aspect ratio, thickness of the plate, power law indices and thickness of the core on the flutter boundaries are investigated. Numerical examples show that wings and tail fins with larger length and shorter width are more stable in supersonic flights. It is concluded for FG sandwich plates made of Al-Al₂O₃ that increase in volume fraction of ceramic (Al₂O₃) increases aeroelastic stability of the plate. Presented study confirms that improvement of aeroelastic behavior and weight of wings and tail fins of aircrafts are not consistent items. It is shown that value of the critical yaw angle depends on aspect ratio of the plate and other parameters including thickness and variation of properties have no considerable effect on it. Results of this paper can be used in design and analysis of wing and tail fin of supersonic airplanes.

• Atmosphere
• /
• v.27 no.1
• /
• pp.1-16
• /
• 2017

In this study, trends of upper jet stream characteristics (intensity, altitude, latitude, and longitude) over the Asia-North Pacific region during the recent 30 (1979~2008) years were analyzed by using four reanalysis datasets (CFSR, ERA-Int., JRA-55, MERRA). We defined the characteristics of upper jet stream as the averages of mass weighted wind speed, mass-flux weighted altitude, latitude and longitude between 400 and 100 hPa. Due to the vertical averaging of jet stream characteristics, our results reveal a weaker spatial variabilities and trends than previous studies. In general, the four reanalysis datasets show similar jet stream properties (intensity, altitude, latitude and longitude) although the magnitude and trends are slightly different among the reanalysis datasets. The altitude of MERRA is slightly higher than that of others for all seasons. The domain averaged intensity shows a weakening trend except for winter and the altitude of jet stream shows an increasing trend for all seasons. Also, the meridional trend of jet core shows a poleward trend for all seasons but it shows a contrasting trend, poleward trend in the continental area but equatorward trend in the Western Pacific region during summer. The zonal trend of jet core is very weak but a relatively strong westward trend in jet core except for spring and winter. The trends of jet stream characteristics found in this study are thermodynamically consistent with the global warming trends observed in the Asia-Pacific region.

• Journal of Korean Medical classics
• /
• v.33 no.3
• /
• pp.91-109
• /
• 2020

Objectives : The aim of this paper is to compare the mechanisms of the OP/LB method and the SSD treatment in 『Piweilun』. Methods : Wenbing texts, articles on the OP/LB method, and the 『Piweilun』 was examined for comparison of treatment mechanisms of SSD. Results : The mechanism of the OP/LB method in treating SSD was to treat the Spleen and Stomach separately, to restore the ascending/descending pattern of qi through simultaneous use of pungent and bitter flavors which raises and lowers, respectively. Moreover, the use of medicinals with contrary properties regulate the other's biased nature, and none of the medicinals create dampness. The pungent and bitter flavors play central roles, where the pungent flavor opens and communicates and the bitter flavor clears and lowers. The treatment method of SSD in the 『Piweilun』 treat the Spleen and Stomach together, with a focus on raising and dispersing through upraising yang and reinforcing qi by means of Wind medicinals with pungent and bitter flavors added to sweet and warm medicinals. Conclusions : Owing to the expansion of the OP/LB method concept by modern-contemporary scholars, the potential for treating SSD as can be seen in the 『Piweilun』 with the OP/LB method has emerged. The similarity between the OP/LB method and treatment of SSD in the 『Piweilun』 is that the objective of the formulas is to lower fire heat and communicate qi to help qi movement. This common objective allows for treatment of SSD within Wenbing and those in 『Piweilun』 with the said formulas through appropriate modification fit for each situation.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.2
• /
• pp.98-105
• /
• 2005

This paper presents the result of the aeroelastic stability test of the small-scaled hingeless hub system with composite paddle blades in hover and forward flight conditions. Excitation tests of hingeless hub system installed in GSRTS(General Small-scale Rotor Test System) at KARI(Korea Aerospace Research Institute) were carried out to get lead-lag damping ratio of blades with flexures as hub flexure. MBA(Moving Block Analysis) technique was used for the estimation of lead-lag damping ratio. First, blades with metal flexures, then with composite flexures of the same dynamic properties of rotor system as metal one were tested. Tests were done on the ground and in the wind tunnel according to the test conditions of hover and forward flight, respectively. Composite flexures were found to have better damping characteristics over metal ones in the non-rotating vibration test, and it was confirmed that the use of composite flexures would give observable improvement in aeroelastic stability compared to metal ones in all test conditions.

• Atmosphere
• /
• v.18 no.2
• /
• pp.97-109
• /
• 2008

The aerosol characteristics in terms of 4 different cases (Asian dust, fog, clear sky and cloud) which had happened at Anmyeon Island in April 2006 were studied using various measurements such as the Micro Pulse Lidar (MPL), sunphotometer, $\beta$-ray $PM_{10}$ Analyzer, anemoscope and anemometer. In addition, synoptic charts, back trajectory analyses and satellite images were also used to help characterize the aerosol events. The aerosol optical properties were featured by the Aerosol Optical Depth (AOD) and ${\AA}ngstr\ddot{o}m$ exponent which were estimated by the sunphotometer. When Anmyeon Island was dominated by the Asian dust, the AOD was sharply increased as seven times as a yearly average of it (0.35). As compared with a yearly average of the ${\AA}ngstr\ddot{o}m$ exponent of 0.97, the ${\AA}ngstr\ddot{o}m$ exponent of a dust day was significantly low (0.099). In addition, $PM_{10}$ mass concentration showed an extremely high record. The maximum concentration reached $1790.5{\mu}gm^{-3}$ on 8 April 2006. The maximum mass concentration was shown with delay when the wind speed of $0ms^{-1}$ was observed. It was also found that a satellite image of the MODIS-RGB had a good agreement with the results of those measurements. It was shown that the MPL was able to describe effectively the vertical distribution of aerosol for all the cases. In particular, the MPL evidently captured the aerosol layer before the cloud observation. The aerosol layer was similarly described by the AOD. On a clear sky day, the AOD had not only a very low value (0.054) but also a feature of homogeneity.

• Geophysics and Geophysical Exploration
• /
• v.20 no.4
• /
• pp.199-206
• /
• 2017

Field data obtained from marine exploration are influenced by various environmental factors such as wind, waves, tidal current and flow velocity of a background medium. Most environmental factors except for the flow velocity are properly corrected in the data processing stage. In this study, the wave equation modeling considering flow velocity is used to generate observation data, and numerical experiments using the observation data were conducted to analyze the effect of flow velocity on waveform inversion. The numerical examples include the results with unrealistic flow velocities. In addition, an algorithm is suggested to numerically extract flow velocity for waveform inversion. The proposed algorithm was applied to the modified Marmousi2 model to obtain the results depending on the flow velocity. The effect of flow velocity on updated physical properties was verified by comparing the inversion results without considering flow velocity and those obtained from the proposed algorithm.