• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.641-644
• /
• 1998

In this paper, wideband MMIC LNA's were designed using low Q matching network. gains of 23.6~25.4dB $(24.5\pm0.9dB),$ noise figures of 0.9~2.8 dB were obtained from the designed wideband MMIC LNA in the frequency ranges of 1.2~2.8㎓. And, P1dB of 10.13 dBm, IP3 of 12.25 dB were obtained at the center frequency of 2 ㎓. A chip size of the designed wideband MMIC LNA is 1.4mm$\times$1.4mm.

• Journal of information and communication convergence engineering
• /
• v.6 no.4
• /
• pp.391-395
• /
• 2008

Wideband terminal and base station is required to serve not only existing 1st and 2nd generation mobile communication systems but also 3rd generation systems. In this paper, we present a feasibility study on coaxial feed compact wideband antenna for UHF RFID reader application. The original antenna was designed for partial discharge detection sensor in high voltage diagnostic system. However, we modified the original prototype to achieve shifted down resonant frequency for wideband wireless communication applications. The experimental result shows good return loss characteristics and radiation patterns except for the total gain at each resonant frequency. The maximum measured gain was 2.45 dBi$\sim$3.18 dBi at 910MHz.

• Journal of information and communication convergence engineering
• /
• v.6 no.2
• /
• pp.164-168
• /
• 2008

Wideband terminal and base station is required to serve not only existing 1st and 2nd generation mobile communication systems but also 3rd generation systems. In this paper, we presents a feasibility study on single feed compact wideband antenna for wireless communication applications including GSM (890-960 MHz), GPS (1575 MHz), DCS (1710-1880 MHz), PCS (1880-1990 MHz), UMTS (1900-2200 MHz), ISM (2400-2480 MHz), IMT2000 and satellite DMB bands. The original antenna was designed for partial discharge detection sensor in high voltage diagnostic system. However, we modified the original prototype to achieve shifted down resonant frequency for wideband wireless communication applications. The experimental result shows good return loss characteristics and radiation patterns except for the total gain at each resonant frequency. The maximum measured gain was 2.45 dBi${\sim}$3.18 dBi at 1710 MHz${\sim}$1880 MHz.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.2
• /
• pp.69-77
• /
• 1996

We analyzed wideband propagation characteristics of a microstrip transmission line based on FR-4 composite substrate using the wideband complex dielectric constant model and the phenomenological loss equivalence method. The loss calculated by constant relative permittivity and loss tangent is greatly overestimatd compared to that calculated by the frequency-dependent complex relative permittivity. This wideband analysis can be helpful to characterize high-speed and high-density transmission lines associated with the wideband dielectric characteristics and shows that the FR-4 composite substrate has high potential of high frequency circuit applications in terms o fthe propagation loss.

• Journal of electromagnetic engineering and science
• /
• v.12 no.2
• /
• pp.155-160
• /
• 2012

A wideband circularly polarized pinwheel-shaped planar monopole antenna fed by a wideband feeding network is presented in this paper. The proposed antenna is formed by four wideband planar monopole antenna elements with aquadruple feeding network in order to improve the performance of circular polarization. Additionally, the antenna, which is introduced here, has a high gain in the z axis direction because of its folded antenna structure. The attractive characteristics of the proposed antenna are the wide impedance bandwidth of 87.3 % (1 GHz to 2.55 GHz), the 3 dB axial ratio (AR) bandwidth of 92.3 % (1.05 GHz to 2.85 GHz), and the maximum gain within the 3 dB AR bandwidth is about 8.24 dBic.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.3
• /
• pp.1199-1212
• /
• 2019

This paper proposes two wideband spectrum sensing approaches: (i) method A, the cumulative sum (CUSUM) algorithm with short-time Fourier transform, taking advantage of the time-frequency analysis for wideband spectrum. (ii)method B, the quickest spectrum sensing with short-time Fourier transform and compressed sensing, shortening the time of perception and improving the speed of spectrum access or exit. Moreover, method B can take advantage of the sparsity of wideband signals, sampling in the sub-Nyquist rate, and it is more suitable for wideband spectrum sensing. Simulation results show that method A significantly outperforms the single serial CUSUM detection for small SNRs, while method B is substantially better than the block detection based spectrum sensing in small probability of the false alarm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.4
• /
• pp.342-350
• /
• 2002

In this paper, aperture coupled U-slot microstrip antenna with wideband stub is investigated. The dielectric constant of the substrate is 2.2 and the hight of the substrate is 62 mil. The impedance bandwidth (VSWR<1.5) of U-slot antenna with wideband stub is about 10 %. The bandwidth characteristic of U-slot antenna wish wideband stub is compared with that of antenna without it. And the results of parameter studies of the wideband stub provides the optimum characteristics of bandwidth and matching.

• ETRI Journal
• /
• v.39 no.5
• /
• pp.756-763
• /
• 2017

A switchable single-wideband (SWB)-to-dual-wideband (DWB) bandpass filter (BPF), which is realized by using lumped switches, is presented in this paper. By alternating the operation modes-ON and OFF-in which the ON mode is achieved by placing the capacitors at the switching spots and the OFF mode is achieved by replacing the capacitors with inductors, DWB-to-SWB BPF can be achieved on the same device. In addition, by changing the capacitor values, the center frequency (CF) of the lower passband of DWB BPF can be easily tuned from 1.69 GHz to 2.22 GHz, while the higher passband stays almost unchanged. As an example, an SWB-to-DWB BPF is designed, fabricated, and measured. This BPF exhibits good performance including wideband, high isolation, compact size, and ability to switch.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2014.05a
• /
• pp.49-50
• /
• 2014

In this paper, a wideband loop antenna for UWB applications is studied. The proposed wideband loop antenna consists of a circular loop and circular sectors. Circular sectors with a ultra-wideband characteristic are used to connect the circular loop and the center feed points. Optimal design parameters are obtained by analyzing the effects of the gap between the circular sectors and the radius of the circular loop on the input reflection coefficient and gain characteristics. The optimized wideband loop antenna is fabricated on an FR4 substrate with a dimension of $41mm{\times}41mm$. Experimental results show that the antenna has a desired UWB characteristic with a frequency band of 3.1-11.0 GHz for a VSWR < 2.25.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.7
• /
• pp.653-659
• /
• 2016

This paper proposes an ultra-wideband Log-Periodic Dipole Array(LPDA) antenna for the feeder of a reflector antenna to be used for airborne spinning direction-finding and detecting wideband signals. To obtain the ultra-wideband characteristics over the 20:1 bandwidth from S to Ka band, the radiation elements of the antenna were printed on a substrate and a wedge-typed dielectric supporter with robust structure was inserted between the substrates. Also, the center portion of the supporter was replaced by a styrofoam material to reduce the supporter weight. The 5-dB return loss of the designed LPDA antenna showed ultra-wideband characteristics, which are 37.57:1(1.09~40.95 GHz) in the simulation and 33.85:1(1.31~44.35 GHz) in the measurement. We achieved the required gains of 5.78 dBi in the simulation and 5.76 dBi in the measurement in the operating band. The proposed robust, light-weight, and ultra-wideband LPDA antenna confirmed that it can be applied for airborne applications.