• Applied Chemistry for Engineering
• /
• v.8 no.3
• /
• pp.357-364
• /
• 1997

The objective of this study was to find optimum nonionic surfactants for clean up of soils contaminated by hydrocarbon oils. PIT(phase inversion temperature) measurements in ternary systems containing pure hydrocarbons, pure nonionic surfactants, and water were carried out and interfacial tensions were measured as a function of time for n-hexadecane oil drops brought into contact with various mixtures of nonionic surfactant and water. Batch surfactant washing experiments were performed based on the measurement, results of PIT and interfacial tension and the results showed that maximum removal of n-hexadecane occurred at the PIT of the system. For the $C_{12}E_5(C_{12}H_{25}O(CH_2CH_2O)_5H)$ system, maximum n-hexadecane removal of 73.4% occurred at the PIT of $52^{\circ}C$. In contrast, n-hexadecane removal at $25^{\circ}C$ and at $60^{\circ}C$, each corresponding to the conditions of below PIT and above PIT of the system, was found to be 57.1% and 57.0% respectively. The maximum removal of a hydrocarbon at the PIT of a system, where the hydrophilic and hydrophobic properties are balanced, was found to be due to the existence of high oil solubilization into a middle-phase microemulsion and ultralow interfacial of the order of $10^{-2}$ to $10^{-3}$ dyne/cm between middle-phase microemulsion and excess oil phase.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.37 no.1
• /
• pp.1-21
• /
• 2011

This review describes several kinds of emulsification methods for nanoemulsions and the application of nanoemulsions. Nanoemulsion droplet sizes fall typically in the range of 20 ~200 nm and show narrow size distributions. Although most of the publications on either oil-in-water (O/W) or water-in-oil (W/O) nanoemulsions have reported their formation by dispersion or high-energy emulsification methods, an increased interest is observed in the study of nano-emulsion formation by condensation or low-energy emulsification methods based on the phase transitions that take place during the emulsification process. Phase behaviour studies have shown that the size of the droplets is governed by the surfactant phase structure (bicontinuous microemulsion or lamellar) at the inversion point induced by either temperature or composition. Studies on nanoemulsion formation by the phase inversion temperature (PIT) method have shown a relation between minimum droplet size and complete solubilization of the oil in a microemulsion bicontinuous phase independently of whether the initial phase equilibrium is single or multiphase. Due to their small droplet size nanoemulsions possess stability against sedimentation or creaming with Ostwald ripening forming the main mechanism of nanoemulsion breakdown. An application of nanoemulsions is the preparation of nanoparticles using a polymerizable monomer as the disperse phase where nanoemulsion droplets act as nanoreactors, cosmetics and controlled drug delivery. In this review, we mainly focus on the cosmetics.

• Membrane and Water Treatment
• /
• v.2 no.1
• /
• pp.25-37
• /
• 2011

PES UF membranes containing silver were prepared to impart antibacterial properties for waste water treatment. Asymmetric membranes for antibacterial application were prepared from polyethersulfone (PES) and silver nitrate ($AgNO_3$) (PES/$AgNO_3$=15/2 by weight) solution in N-Methyl-2-pyrrolidone (NMP) via simple wet phase inversion technique. These membranes were characterized by polyvinylpyrrolidone (PVP) and polyethylene glycol (PEG) of different molecular weights (1000 ppm in water) at room temperature and on operating pressure of 5 bars. It was observed that the water flux of PES-$AgNO_3$ membrane is slightly lower than virgin PES but still increased linearly with the increment of pressure applied. The morphology of the resulting membranes was examined using Field-Emission Scanning Electron Microscope (FESEM) coupled with Energy Dispersive Spectroscopy (EDS). Elemental analysis using EDS proved that silver is successfully loaded on the membrane surfaces. Due to the success of loading silver on membrane surfaces, antibacterial activities were evaluated via agar diffusion method against Escherichia coli (E.coli) and Staphylococcus aureus (S.aureus) culture. By incorporating 2 wt% of silver nitrate, PES-$AgNO_3$ showed significant inhibition ring on both E.coli and S.aureus. Filtration of E.coli solution (OD 0.31) showed satisfactory rejection data with ~100% inhibition growth after 24 hours incubation at $37^{\circ}C$. Resultant membranes also exhibit better tensile strength (compared to virgin PES) up to 71% may be due to the suggested interactions. The residual silver during fabrication was measured using ICP-MS and result showed that the residual silver content of PES-$AgNO_3$ membrane was only ~1% of the original silver added in the polymer solution. These studies have shown that PES-$AgNO_3$ UF membranes are potential in improving the filtration in water treatment.

• Applied Chemistry for Engineering
• /
• v.8 no.6
• /
• pp.945-953
• /
• 1997

Aromatic polyetherimide membranes were prepared by dry/wet phase inversion method and investigated regarding the pervaporation characteristic of water-alcohol mixtures by using the permselective property of imide group and the structure modification of skin layer of the membrane. The membrane selectivity increased with the reaction time of surface-modification, to some extent, and the density of top layer tends to increases with increasing the reaction time. In the case of dense membrane, the separation factor was 160 and 2000 for 90wt% ethanol mixture and 90wt% isopropanol solution, respectively, which implies that aromatic polyetherimide has a high permselectivity. The temperature dependence of permeation flux seems to follow an Arrhenius type at the temperature range of ($40^{\circ}C-70^{\circ}C$).

• The Korean Journal of Pharmacology
• /
• v.19 no.1
• /
• pp.61-69
• /
• 1983

Hypothermia is an essential preparatory procedure for cardiac surgery, which lows the metabolic rate and myocardial oxygen demand. However, hypothermia itself is a stress enough to change the tonus of sympathoadrenal system, especially the cardiovascular responses to the catecholamines. It is reported that the positive chronotropic and inotropic response of catecholamines is exaggerated during hypothermia because of decreased norepinephrine uptake at the junctional cleft or decreased catecholamine metabolism. On the other hand, there are evidences of diminished catecholamines responses in low temperature ana further, interconversion of adrenergic receptors is also suggested. Present investigation was planned to observe the cardiovascular changes and its responses to catecholamines during surface hypothermia in cat. Healthy mongrel cats, weighing $2{\sim}3\;kg$, anesthetized with secobarbital(30 mg/kg), were permitted to hypothermia by external cooling technic. Esophageal temperature, ECG (lead II), heart rate, left ventricular pressure with dP/dt, carotid artery pressure and left ventricular contractile force were monitored with Polygragh (Model 7, Grass), and the respiration was maintained with artificial respirator (V 5 KG, Narco). Followings are summarized results. 1) Surface cooling caused progressive decrease of body temperature and reached $l8.8{\pm}0.8^{\circ}C$ and $16.9{\pm}0.6^{\circ}C$ in 120 and 150 min respectively, after immersion into ice water, and ventricular fibrillation was developed at $20.4{\pm}0.65^{\circ}C$. 2) Heart rate, blood pressure and myocardial contractility were decreased after initial increase as the body temperature falls. 3) Systolic and diastolicdd P/dt of left ventricular pressure were decreased and that the decrement of diastolic dP/dt was more marked. 4) On ECG, ST depression, Twave inversion and prolongation of PR interval were prominent in hypothermia, and moreover, the prolongation of PR interval was marked just prior to the development of ventricular fibrillation. 5) The cardiovascular responses to catecholamines, especially to isoproterenol, were suppressed under hypothermia.

• Journal of Environmental Science International
• /
• v.15 no.7
• /
• pp.623-634
• /
• 2006

In this study, characteristics of fog at Mokpo as the west coastal area of Jeonnam were investigated, using statistical analysis of observed fog and meteorological data. Higher frequency of the fog occurrence at Mokpo was showed in spring(32%) and summer(34%) due to the seasonal high atmospheric pressure. Regional characteristics as radiation cooling, advection of fog and water vapor from surrounding sea and Yeongsan lake, and frontal fog had major effect on the coastal fog at Mokpo on the meteorological conditions of north-west/south wind and calm($0{\sim}2m/s$). Also, as the results of analyzing data of before and after the construction of Yeongsan dam, the frequency of annual mean fog days increased 41 %, specially increased 178% in autumn. The increase of fog days mainly resulted from evaporation during colder seasons and from temperature inversion during warmer seasons over the water surface of Yeongsan lake. The construction of Yeongsan dam had a little effect on the meteorological conditions concerning fog occurrence, because Yeongsan dam which only supplies the water for use do not always carry out outlet of the cold water. In addition, the sea fog at Heuksando located in offshore had not effect on the occurrence of fog at Mokpo.

• Applied Chemistry for Engineering
• /
• v.10 no.2
• /
• pp.319-323
• /
• 1999

Asymmetric polyetherimide membranes were prepared by phase inversion method. In the modification of the skin layers of polyetherimide membranes, the effects of NaOH concentration on the morphology and pervaporation separation of water-isopropanol mixtures were investigated. With increasing concentration of NaOH solution, polyamicacid structure was formed by the hydrolysis of imide group of polyetherimide, and the thickness of dense layer of the asymmetric membrane increased. In the pervaporation separation of water-isopropanol mixtures the overall permeation rate decreased and the separation factor increased with increasing concentration of NaOH solution. However, when the concentration of NaOH solution was very high, the permeation rate increased but separation factor decreased. From these results, it was found that the permeation behaviors of asymmetric polyetherimide membranes depended upon the concentration of NaOH solution. These modified membranes showed that both the permeation rate and separation factor increased as the operating temperature increased.

• Membrane Journal
• /
• v.19 no.2
• /
• pp.104-112
• /
• 2009

Ultrafiltration membranes (UF) were manufactured by the conventional phase inversion method using an additives with N-methyl-2-pyrrolidinone as a solvent. Characteristics of performance could be controlled by the preparation conditions and the operating methods. The fouling resistance was observed by the relative ratio of permeate flux $(J_t)$/pure water flux $(J_o)$. Compared with the anion charged membranes and its original polyamide membrane, fouling resistance to the protein was increasing in proportion to the ion exchange capacity. The relative flux for the bovin serum albumin (BSA) solution increased as pH value further away from isoelectric point of BSA. The hydrophilicity of a membrane, the pH condition, and the operating temperature played the important role in the membrane permeations.

• Applied Chemistry for Engineering
• /
• v.9 no.3
• /
• pp.413-418
• /
• 1998

Methoxy polyoxyethylene dodecanoates are a kind of nonionic surfactants obtainable from reaction of fatty acid methyl ester with ethylene oxide utilizing a solid catalyst. Methoxy polyoxyethylene dodecanoates have economical advantage compared with polyoxyethylene dodecyl ethers using fatty alcohol. In this work, the solubilizing capacity concerned with phase behavior of ternary systems composed of nonionic surfactant/water/oil, interfacial tension and detergency at the phase inversion temperature(PIT) were investigated and compared with those of polyoxyethylene dodecyl ethers in order to confirm the applicability of methoxy polyoxyethylene dodecanoates in the detergents. Methoxy polyoxyethylene dodecanoates showed the solubilizing capacity of 10~18% for hexadecane which were about 6% higher than polyoxyethylene dodecyl ethers. At the PIT condition, methoxy polyoxyethylene dodecanoates' interfacial tension were 0.0124~0.0176 dyne/cm while polyoxyethylene dodecyl ethers have the value of 0.013~0.0163 dyne/cm and methoxy polyoxyethylene dodecanoates showed higher detergency of 82.1~83.2% than polyoxyethylene dodecyl ethers of 76.5~77.3%. The good detergency performance of methoxy polyoxyethylene dodecanoates would be due to the higher oil solubilizing power and lower interfacial tension than polyoxyethylene dodecyl ethers at the PIT condition.

• Journal of Environmental Science International
• /
• v.22 no.6
• /
• pp.745-759
• /
• 2013

The characteristics of meteorological conditions and air pollution were investigated in a valley city (Yangsan) on bad visibility days (from 05:00 to 09:00 LST) of the cold half year (November 2008 to April 2009). This analysis was performed using the hourly observed data of meteorological variables (temperature, wind speed and direction, relative humidity, and 2 m and 10 m temperature) and air pollutants ($NO_2$, $SO_2$, $PM_{10}$, and $O_3$). In addition, visibility data based on visual measurements and a visibility meter were used. The bad visibility days were classified into four types: fog, mist, haze, and the mixture (mist+haze). The results showed that the bad visibility days of the four types in the valley city were observed to be more frequently (about 50% of the total study period (99 days except for missing data)) than (27%) those near coastal metropolitan city (Busan). The misty days (39%) in the valley city were the most dominant followed by the hazy (37%), mixture (14%), and foggy days (10%). The visibility degradation on the misty days in Yangsan was closely related to the combined effect of high-level relative humidity due to the accumulation of water vapor from various sources (e.g. river, stream, and vegetation) and strong inversion due to the development of surface radiative cooling within the valley. On the hazy days, the visibility was mainly reduced by the increase in air pollutant (except for $O_3$) concentrations from the dense emission sources under local conditions of weaker winds from the day before and stronger inversion than the misty days. The concentrations of $NO_2$, $PM_{10}$, and $SO_2$ (up to +36 ppb, $+25{\mu}g/m^3$, and +7 ppb) on the hazy days were a factor of 1.4-2.3 higher than those (+25 ppb, $+14{\mu}g/m^3$, and +3 ppb) on the misty days.