• 대한기계학회논문집
• /
• 제19권9호
• /
• pp.2399-2411
• /
• 1995

Crane operation for transporting heavy loads inherently causes swinging motion at the loads due to crane's acceleration or deceleration. This motion not only lowers the handling safety but also slows down the handling process. To complement such a problem, Korea Atomic Energy Research Institute(KAERI) has designed several anti-swing controllers using open loop and closed loop approaches. They are namely a pre-programmed feedback controller and a fuzzy controller. These controllers are implemented on a 1-ton crane system at KAERI and their control performances are compared. Test operations show that the new controllers are superior to that of conventional cranes in terms of robustness to the disturbances and adaptation capability to the change of rope length.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2003년도 춘계학술대회 논문집
• /
• pp.1012-1017
• /
• 2003

The development of a fast, accurate, and inexpensive position-controlled pneumatic actuator that may be applied to a variety of practical positioning applications with various external loads is described in this paper. A novel modified pulso width modulation (MPWM) valve pulsing algorithm allows on/off solenoid valves to be used in place of costly servo valves. A comparison between the system response of standard PWM technique and that of the novel modified PWM technique shows that the control performance is significantly increased. A state feedback controller with position, velocity and acceleration feedback is successfully implemented as the continuous controller. Switching algorithm of control parameter using learning vector quantization neural network (LVQNN) is newly proposed. which estimates the external loads of the pneumatic actuator. The effectiveness of the proposed control algorithms are demonstrated through experiments with various loads.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 B
• /
• pp.696-698
• /
• 1997

The marine diesel engine have been widely applied with a mechanical hydraulic governor to control the ship speed for long time. But it was recently very difficult for the mechanical hydraulic governor to control the speed of engine under the condition of low speed and low load because of jiggling by rough fluctuation of rotating torque and hunting by dead time of diesel engine. In order to analyze the speed control system the transfer function was converted from z to w transformation. The author proposed velocity control system with feedback loop by PID controller in order to stabilize for unstable area. The influence of dead time was discussed by Nichols chart and unit step response curve. It was confirmed through computer simulation that the performance improvement of a mechanical hydraulic governor can be obtained by PID controller.

• 대한물리의학회지
• /
• 제10권4호
• /
• pp.49-57
• /
• 2015

PURPOSE: This study aimed to investigate the effect of emphasized initial contact gait training on balance and gait ability in hemiplegia patients. METHODS: Twenty-four hemiplegic patients were randomly allocated to an experimental group or control group. All participants received 30-min neurodevelopmental treatment. Furthermore, the experimental group received initial contact-emphasized auditory feedback gait training, whereas the control group received gait training without auditory feedback. The intervention was performed 3 times per week, 20 min per each time, for a total of 6 weeks. Balance was assessed using the center of pressure path length, center of pressure velocity, and limitation of stability path length, whereas gait ability was assessed using the 10-m walking test and functional gait assessment. RESULTS: In both groups, center of pressure path length and center of pressure velocity significantly decreased after training. Compared to the control group, the experimental group showed a 10% significant improvement (p<.05). In the limitation of stability path length of both sides, the experimental group showed a significant increase compared to that before intervention. Compared to the control group, the experimental group showed a 7% significant improvement in results of the 10-m walking test and functional gait assessment (p<.05). CONCLUSION: Emphasized Initial contact gait training is considered an effective treatment for improving gait ability and balance ability in stroke patients.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 B
• /
• pp.859-862
• /
• 1995

In this paper, an adaptive nonlinear observer using new Off-line algorithm is proposed to reduce the computing time. The estimated velocity data obtained from the control scheme is more accurate than that by the normal interpolation method when the velocity to be estimated is at the low speed or the fast speed. It is also shown that the adaptive controller based on AC100/C30 is useful for implementing the real-time controller.

• 한국정밀공학회지
• /
• 제20권4호
• /
• pp.59-67
• /
• 2003

This paper presents a new approach for the use of smart materials, piezoelectric materials of PVDF and PZT, for vibration attenuation of a planar parallel manipulator. Since lightweight linkages of parallel manipulators deform under high acceleration/deceleration, an active damper is needed to attenuate vibration due to structural flexibility of linkages. Based on the dynamic model of a planar parallel manipulator, an active damping controller is developed, which consists of a PD feedback control scheme, applied to linear electrical motors, and a linear velocity feedback (L-type) scheme applied to either PVDF layer or PZT actuator(5). Simulation results show that piezoelectric materials yield good damping performance, resulting in precise manipulations of a planar parallel manipulator.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2006년도 International Symposium on GPS/GNSS Vol.1
• /
• pp.271-275
• /
• 2006

This paper describes the design and realization of full attitude system based on MEMS IMU and GPS carrier phase. The work can be divided into two parts: First, initial heading is determined by using two GPS receivers. And this paper discusses the usage of space geometry conditions to reduce the range of ambiguity search. The method presented in this paper was tested on the static. On the static condition, an accuracy better than 0.06 degrees for heading for 3.48m long baseline has been achieved. Integration of GPS and low cost MEMS IMU are used to realize the real-time heading attitude system. Second, level attitude (pitch and roll) is determined using the method of frequency-velocity for the feedback control. At the same time, the method using the attitude based on MEMS IMU to help determination of the range of ambiguity search is proposed. The results done on the sea show that an alternative means to provide real-time, cost-effective, accurate and reliable attitude information for attitude surveys. Though motivated by a big ships application, the design can be applied to other vehicles.

• Journal of Mechanical Science and Technology
• /
• 제17권3호
• /
• pp.380-390
• /
• 2003

This paper addresses the problem of the modeling and vibration control of tapered rotating blade modeled as thin-walled beams and incorporating damping capabilities. The blade model incorporates non-classical features such as anisotropy, transverse shear, secondary warping and includes the centrifugal and Coriolis force fields. For the rotating blade system, a thorough validation and assessment. of a number of non-classical features including the taper characteristics is accomplished. The damping capabilities are provided by a system of piezoactuators bonded or embedded into the structure and spread over the entire span of the beam. Based on the converse piezoelectric effect, the piezoactuators produce a localized strain field in response to a voltage and consequently, a change of the dynamic response characteristics is induced. A velocity feedback control law relating the piezoelectrically induced transversal bending moment at the beam tip with the appropriately selected kinematical response quantity is used and thebeneficial effects upon the closed-loop dynamic characteristics of the blade are highlighted.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1993년도 한국자동제어학술회의논문집(국제학술편); Seoul National University, Seoul; 20-22 Oct. 1993
• /
• pp.197-201
• /
• 1993

A method for the closedloop control of the torsional tip motion of a piezo-polymer actuator is presented. The application of Lyapunov's direct, method to the problem is explored. A feedback control of the torsional tip motion of tile piezopolymer actuator is derived by considering tile time rate of change of the total energy of the system. If the angular velocity of the tip of the actuator is known, all the modes of tile actuator can be controlled simultaneously. This approach has tile advantage over the conventional methods in the respect that it allows one to directly with tile system's partial differential equations without resorting to approximations.

• 대한조선학회논문집
• /
• 제45권5호
• /
• pp.469-476
• /
• 2008

In this paper, it is shown that an input-output (I/O) feedback linearized controller can be designed rationally by utilizing the time-scale properties of heave and pitch for an underwater vehicle. It is assumed that the dynamics of the vehicle is restricted to the vertical plane. An output-feedback control is designed, which stabilizes steady cruising paths. It is shown that the vehicle dynamics with acceleration as output becomes minimum phase. The dynamics can be transformed into a reduced system through a kind of partial linearization and singular perturbation technique. The reduced system is not only minimum phase but also exactly I/O linearizable via feedback. The I/O dynamic characteristics of the heave and pitch modes can be made linear and decoupled. Furthermore it becomes independent of cruising condition such as vehicle velocity. This study may help for designing autopilot systems for underwater vehicles.