• 조명전기설비학회논문지
• /
• 제26권1호
• /
• pp.1-7
• /
• 2012

As the standard lighting required in the threshold zone of a road tunnel is determined by the enough contrast. Lighting design, therefore, must be determined by the calculation method of threshold luminance based on the adaptation luminance of the driver approaching the tunnel. The veiling luminance and the luminance in the access zone were measured at different time and in different weather using the veiling luminance method, a kind of perceived contrast methods, and the L20 method when the range of vision was 20 degrees. On the basis of the measured data each threshold luminance was calculated and its results were analyzed.

• 한국자동차공학회논문집
• /
• 제10권6호
• /
• pp.90-99
• /
• 2002

The main purpose of this study lies on the development of micro dilution tunnel based on the Sierra Dilution chamber model. As a primary examination, characteristics of flow and temperature distributions during the steady dilution process in dilution chamber are observed with numerical analysis. The penetration of dilution air through porous tube as well as wall temperature and temperature gradient inside porous tube are examined. The thermophoretic velocity in terms of temperature behavior inside porous tube are defined and examined. Based on the ratio of penetration and thermophoretic velocities, all part of porous tube are shown to be safe from the particulate depositions. However, The inlet portion of porous tube in addition to the portion of impinging of dilution air are marginally safe from the particulate depositions. Generally the safer design against particulate deposition is required in provision f3r steady dilution process and for transient process as well.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 추계학술대회논문집
• /
• pp.49-52
• /
• 2004

High-speed trains with the maximum speed of 300 km/h have started revenue services since April 2004. A large portion of the 'Kyung-Bu' line is comprised of tunnels or bridges, which may cause excessive noise in a vehicle. The vibration generated by the trains propagates into the structure of the tunnel and the vehicle and it can be radiated as noise inside the vehicle interior. This noise can usually be heard as low frequency structure-borne noise. Measurement of the noise and vibration inside the KTX vehicle confirmed that the noise comprises of frequencies below 250 Hz with a couple of broad peaks.

• ETRI Journal
• /
• 제45권4호
• /
• pp.557-569
• /
• 2023

Traditional deterministic channel modeling is accurate in prediction, but due to its complexity, improving computational efficiency remains a challenge. In an alternative approach, we investigated a multilayer artificial neural network (ANN) to predict large-scale and small-scale channel characteristics in metro tunnels. Simulated high-precision training datasets were obtained by combining measurement campaign with a ray tracing (RT) method in a metro tunnel. Performance on the training data was used to determine the number of hidden layers and neurons of the multilayer ANN. The proposed multilayer ANN performed efficiently (10 s for training; 0.19 ms for prediction), and accurately, with better approximation of the RT data than the single-layer ANN. The root mean square errors (RMSE) of path loss (2.82 dB), root mean square delay spread (0.61 ns), azimuth angle spread (3.06°), and elevation angle spread (1.22°) were impressive. These results demonstrate the superior computing efficiency and model complexity of ANNs.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2016년도 제50회 동계 정기학술대회 초록집
• /
• pp.308-309
• /
• 2016

Reducing surface recombination is a critical factor for high efficiency silicon solar cells. The passivation process is for reducing dangling bonds which are carrier. Tunnel oxide layer is one of main issues to achieve a good passivation between silicon wafer and emitter layer. Many research use wet-chemical oxidation or thermally grown which the highest conversion efficiencies have been reported so far. In this study, we deposit ultra-thin tunnel oxide layer by PECVD (Plasma Enhanced Chemical Vapor Deposition) using $N_2O$ plasma. Both side deposit tunnel oxide layer in different RF-power and phosphorus doped a-Si:H layer. After deposit, samples are annealed at $850^{\circ}C$ for 1 hour in $N_2$ gas atmosphere. After annealing, samples are measured lifetime and implied Voc (iVoc) by QSSPC (Quasi-Steady-State Photo Conductance). After measure, samples are annealed at $400^{\circ}C$ for 30 minute in $Ar/H_2$ gas atmosphere and then measure again lifetime and implied VOC. The lifetime is increase after all process also implied VOC. The highest results are lifetime $762{\mu}s$, implied Voc 733 mV at RF-power 200 W. The results of C-V measurement shows that Dit is increase when RF-power increase. Using this optimized tunnel oxide layer is attributed to increase iVoc. As a consequence, the cell efficiency is increased such as tunnel mechanism based solar cell application.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2006년도 공동학술대회 논문집
• /
• pp.239-244
• /
• 2006

현재 건설중인 한국원자력 연구소 내의 지하 처분 연구시설에서 발파에 의한 터널 굴착 중 발생하는 손상대를 모니터링 하기 위해 시추공 레이다 반사법 탐사를 수행하였다. 60m 길이의 진입 터널이 완성되고 끝단에 쉘터가 만들어진 뒤 쉘터로부터 길이 35 m의 수평 시추공을 뚫어 터널 굴착에 따른 손상대 모니터링을 위한 관측공으로 사용하였다. 시추공은 굴착터널로부터 5.5 m 떨어져 있으며, $2{\sim}4$일 간격으로 5회 실험을 실시하였다. 터널의 굴착에 따른 터널면에서의 반사가 가장 강력한 반사면으로 작용하였으며, 서로 다른 날짜의 자료의 비교를 통해 터널 굴착면에 인접한 반사면의 변화를 감지 하였으며 이는 균열대의 생성과 암반 강도의 저하에 의한 것으로 여겨 졌으며 손상대로 평가되었다.

• 한국재난정보학회 논문집
• /
• 제16권1호
• /
• pp.10-20
• /
• 2020

연구목적: 터널구조물 유지관리계측의 현장점검 결과를 분석하여 개선방안을 제시한다. 연구방법: 도심지에서 건설되고 있는 서울지하철◯호선 14개 공구의 터널구조물을 대상으로 유지관리계측에 대한 다양한 항목의 문제점을 조사하고 분석을 실시하였다. 연구결과: 유지관리 계측 항목과 계측수량 및 설치위치는 개착터널과 굴착터널로 구분하여 개선방안을 제시하였다. 계측기기의 내구연한은 각종 기준을 검토하였고, 내구성 확인방법은 계측센서의 승인 및 검수, 검사 및 시험, 검정 및 교정 등의 개선방안을 제시하였다. 결론: 터널구조물 유지관리계측의 개선방안을 건설현장에 적용하면 유지관리계측의 효율성이 증대되고 건설계측 기술발전에 기여할 것이다.

• 지질공학
• /
• 제25권3호
• /
• pp.395-401
• /
• 2015

터널 시공 중 획득되는 굴진면 조사와 계측자료 등은 암판정의 기초자료로 터널 안정성 및 경제성과 밀접한 관련이 있다. 하지만 국내에서는 이러한 자료에 대한 체계적 관리가 부족한 실정이며 자료의 효율적 활용 및 관련 전문가의 수도 부족하다. 따라서 자료의 체계적 관리 및 효율적 활용, 한정된 전문가를 효과적으로 활용할 수 있는 방안 마련이 필요한 실정이다. 이에 본 연구에서는 BIM기반 데이터 시각화를 통해 터널 설계 및 시공관련 정보를 온라인 상에서 효율적으로 제공하기 위한 연구를 수행하였으며 그 결과로 통합 3D 터널모델 생성 모듈과 웹뷰어 모듈을 개발하였다. 개발 기술은 국내 ○○터널 설계 및 시공 자료를 통해 구현성능을 검증하였으며 향후 연구방향 및 시스템 개선방안을 도출하였다.

• 한국건축시공학회지
• /
• 제4권1호
• /
• pp.97-103
• /
• 2004

In case of a fire in road or railway tunnel it is always necessary to keep the escape condition as good as possible. Most of the victims of major fires in tunnels are because they couldn't leave the tunnel in time and were trapped by smoke, or rescue teams couldn't reach the place of the accident due to low visibility and high temperature. In spring 2003 a comprehensive field experiment was undertaken in a large scaled tunnel in Youngin City to test the effectiveness of a new water spray curtain system, designed to the air qualify inside of a tunnel in case of fire during passenger's escape to safe routes, In order to control the smoke propagation, fixed water sprayed nozzles were used to make water curtain system, which can be installed or hanging water piping line below ceiling. The experiment was accompanied by an extensive measurement campaign in order to measure temperature dropping effect and flow conditions as well as CO concentration for various water sprayed curtains produced by sprinkler heads or water spray nozzle. Eventually comparison analysis were undertaken to investigate the performance of water curtains under fixed water pressure. Therefore most effective water curtain system was presented on the basis of water droplet size in long tunnel.

• Geomechanics and Engineering
• /
• 제34권1호
• /
• pp.17-27
• /
• 2023

Taking a subway shield tunnel in a certain section of Zhengzhou Metro Line 5 as an example, the field tests of shield cutting cement-soil monopile composite foundation were carried out. The load and internal force of the tunnel lining under the action of composite foundation were tested on-site and the distribution characteristics and variation laws of earth pressure around the tunnel under the load holding state of the composite foundation were analyzed. Five different load combinations (i.e., overburden load theory + q₀, Terzaghi's theory + q₀, Bierbaumer's theory + q₀, Xie's theory + q₀, and the proposed method (the combination of compound weight method and Terzaghi's theory) + q₀) were used to calculate the internal force of the tunnel structure and the obtained results were compared with the measured internal force results. The action mode of earth pressure on the tunnel lining structure was evaluated. Research results show that the earth pressure obtained by the calculation method proposed in this paper was more consistent with the measured value and the deviation between the two was within 5%. The distribution of the calculated internal force of the tunnel structure was more in line with the distribution law of field test data and the deviation between the calculated and measured values was small. This effectively verified the rationality and applicability of the proposed calculation method. Research results provided references for the design and evaluation of shield tunnels under the action of composite foundations.