• 대한전기학회논문지:전력기술부문A
• /
• 제53권8호
• /
• pp.432-437
• /
• 2004

Since the characteristic frequency is decreased in proportion to the fault distance, the characteristic frequency component may be insufficiently eliminated by a low-pass filter on a long transmission line. In order to set a standard for the cut-off frequency of the low-pass filter, this paper proposes a method for obtaining the characteristic frequencies due to line faults. The application results of the proposed method are presented for line to ground (LG) faults and line to line (LL) faults on a 345 kV 200 km overhead transmission line. The EMTP is used to generate fault signals under different fault locations and fault inception angles. By comparison between the characteristic frequencies obtained from the proposed method and the EMTP simulation, it is shown that the proposed method accurately obtains the characteristic frequency.

• 환경영향평가
• /
• 제23권5호
• /
• pp.353-363
• /
• 2014

본 연구의 목적은 가공송전선 인접 258개 시설과 120개의 고압 가공송전선, 17개의 지중화 송전선에서 자기장 방출량을 조사하였다. 또한 시뮬레이션을 이용하여 이격거리에 따른 ELF-MF 저감률을 파악하였다. 120개 고압 가공송전선의 전압 형태에 따라 자기장 방출량 조사한 결과, 154kV 고압송전선은 최소 60m, 345kV는 최소 80m, 765kV는 최소 100m 이격거리를 설정해야 고압송전선에서 발생하는 자기장 노출의 위해요인을 사전에 예방할 수 있을 것으로 나타났다. 극저주파 자기장의 방출량 시뮬레이션을 실시한 결과, 154kV의 경우 최대 부하가 걸린 시점에서 40m 이상, 345kV의 경우 60m 이격된 거리에서 4mG 이하로 나타났다. 환경영향평가학적 측면을 감안한 최악의 조건과 앞으로 증가될 전력 부하량을 감안하여 본 연구에서는 고압송전선로 최소 적정 이격거리는 70m 이상이 타당할 것이라 판단된다. 70m 내에 녹지대나 완충구역을 설정하여 수용체가 노출되지 않는 환경을 조성해야 차후 발생할 수 있는 극저주파 자기장 인체 위해성 관련 불안 요인을 제거할 수 있을 것으로 사료된다.

• International Journal of Contents
• /
• 제10권4호
• /
• pp.69-74
• /
• 2014

General location aware systems are only applied to indoor and outdoor environments using more than three transmitters to estimate a fixed object location. Those kinds of systems have environmental restrictions that require an already established infrastructure. To solve this problem, an Object Location Estimation (OLE) algorithm based on PTP (Point To Point) communication has been proposed. However, the problem with this method is that deduction of performance parameters is not enough and location estimation is very difficult because of unknown restriction conditions. From experimental tests in this research, we determined that the performance parameters for restriction conditions are a maximum transmission distance of CSS communication and an optimum moving distance interval between personal locations. In this paper, a system applied OLE algorithm based on PTP communication is implemented using a CSS (Chirp Spread Spectrum) communication module. A maximum transmission distance for CSS communication and an optimum moving distance interval between personal locations are then deducted and studied to estimate a fixed object location for generalization.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1990년도 하계학술대회 논문집
• /
• pp.121-124
• /
• 1990

Distance relaying is one of the most commonly used protection schemes in the high voltage transmission systems. In this scheme, coordination between the primary and backup relays is very critical for the power system security. This paper reports an rule-based methodology for checking and correction of miscoordination problems in the distance relaying. Diagnosis rules achieving an accurate but simple checking have been developed through the geometric analysis of the impedance characteristics of the distance relays. Heuristic rules having the pratical power for miscoordination correction are suggested. The proposed method has proved very effective through the several case studies on the actual systems.

• 전기학회논문지
• /
• 제56권11호
• /
• pp.1885-1891
• /
• 2007

This paper presents a distance relaying algorithm for phase-to-ground faults in transmission lines under Multi-Agent protection environment. In normal condition, a distance relay agent stores the latest states, e.g., voltage of source side, voltage of the opposite side and the loading conditions, etc., through communication between the agents. Once a fault occurs, the relay calculates the fault location using the knowledge about the states just before the fault happens. This stand-alone operation is to improve reliability under the fault condition at which the accuracy or time required for communication may not be guaranteed. The mathematical expression of fault location is derived through loop analysis, before hand, in the manner that both fault current from the opposite end and fault resistance are included implicitly so that their effects are minimized. The suggested algorithm is applied to a typical transmission system with two power sources on both ends to show its effectiveness.

• 대한전기학회논문지:전력기술부문A
• /
• 제50권1호
• /
• pp.38-44
• /
• 2001

For double-circuit transmission line systems, an accurate digital distance relaying algorithm immune to the reactance effect is proposed. The apparent impedance calculated by the distance relay is influenced by the combined reactance effect of the fault resistance and the load current as well as the mutual coupling effect caused by the zero-sequence current of the adjacent parallel circuit. To compensate the magnitude and phase of the estimated impedance, this algorithm uses phase angle difference between the zero(positive) sequence of the both side of the system seperated by the fault point. The impedance measuring algorithm presented used a current distribution factor to compensate mutual coupling effect instead of the collected zero-sequence current of the adjacent parallel circuit.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 추계종합학술대회 논문집(2)
• /
• pp.309-312
• /
• 2000

In this paper, The Influence of chromatic fiber dispersion on the transmission distance of MMW(millimeter-wave) link is analyzed and discussed. It is shown that dispersion significantly limits the transmission distance in intensity modulated direct detection and heterodyne links operating in the above 20㎓ frequency region by inducing a carrier to noise penalty on the transmitted signal. We analyze and discuss the influence of dispersion induced CNR(Carrier to Noise Ratio) penalty for direct detection and heterodyne method from simulation.

• 한국산업정보학회논문지
• /
• 제7권3호
• /
• pp.54-61
• /
• 2002

원격 영상전송 장치는 안전상의 문제가 있거나 사람이 갈 수 없는 곳을 관찰하기 위해 로봇 기술과 영상전송 기술을 결합한 것이다. 최근 원격 제어를 위해 웹서버와 로봇간 유선 및 RF를 이용한 제어 장치들이 개발되고 있지만, 작동 거리 및 인터넷 라인을 설치해야 하는 제한점이 있으며, 무선 방식의 통신장비를 이용할 경우 무선 라우터의 가격이 고가라는 문제가 있다. 본 연구에서는 이러한 문제점을 해결하기 위해 CDMA 셀룰러 폰 통신망을 이용하여 영상전송 및 영상전송 장치를 원격으로 제어할 수 있는 시스템을 개발하였으며, 개발된 시스템은 기존의 무선동신(RF)을 이용한 영상 전송시의 단점인 거리 제한 문제와 인터넷을 이용한 영상전송시의 문제를 해결할 수 있었고, 현재의 통신망을 비롯한 제한된 조건하에서 최적의 영상 및 음성을 전송할 수 있었다.

• 전기학회논문지
• /
• 제64권2호
• /
• pp.353-356
• /
• 2015

Due to high oil prices, environmental pollution, the study of electric vehicles have been actively promoted. Charger for the electric vehicle is being developed using wireless rather than cable options. In this paper, we got more efficiency from using a superconducting transmission coil compared to using a normal coil. We implemented a wireless power transmission system using a magnetic induction at a frequency of 63.1 kHz. For comparison, a transmitter was designed using a superconducting coil and a normal coil. In addition, a receiver used a normal coil to apply for electric vehicles. The applied voltage and current were12 V and 5 A. Efficiency at a distance of 40 ~ 80 mm was measured. As a result, the superconducting transmission coil had a higher efficiency than the normal transmission coil. However, the receiving coil should be normal conductor for stable operation considering that it was put in moving electric vehicle. The efficiency was increased to 44 % at a distance of 40 mm when the diameter of normal receiving coil was 120 mm.

• 대한전자공학회논문지SD
• /
• 제41권4호
• /
• pp.29-40
• /
• 2004

본 논문에서는 유한 차분 시간 영역(FDTD, Finite Differential Time Domain)법과 완전 정합층(PML, Perfectly Matched Layer) 방법을 이용하여 반도체 다층 배선이 평행하게 인접하거나, 교차하면서 인접하는 구조뿐 아니라. 평행하게 인접하면서 다른 평면상에 두 배선이 존재하는 3차원 다층 배선 구조에 대한 컴퓨터 수치 분석 방법을 보고한다. 평행한 인접 배선 구조에서는 수평 거리를 변화시키면서 출력 결과를 비교하였으며, 교차한 인접 배선 구조에서는 수직 거리를 변수로 하여 시간 영역과 주파수 영역에서의 출력 결과를 정량적으로 비교하였다. 또한, 평행하게 인접하면서 다른 평면상에 두 배선이 존재하는 3차원 다층 배선 구조에 대해서는 수평 거리와 수직 거리를 각각 변화시켜 가면서 출력되는 누화 특성을 측정하고 비교하였다.