• Journal of Sensor Science and Technology
• /
• v.27 no.5
• /
• pp.306-310
• /
• 2018

In order to develop a highly sensitive infrared sensor, it is necessary to develop techniques for decreasing the rate of heat absorption and the transition of the absorption wavelength to a longer wavelength, both of which can be induced by decreasing the pixel size of the bolometer. Therefore, in this study, $1{\mu}m$ hole-arrays with a subwavelength smaller than the incident infrared wavelength were formed on the amorphous silicon-based microbolometer pixels in the absorber, which consisted of a TiN absorption layer, an a-Si resistance layer and a SiNx membrane support layer. We demonstrated that it is possible to reduce the thermal time constant by 16% relative to the hole-patternless bolometer, and that it is possible to shift the absorption peak to a shorter wavelength as well as increase absorption in the $4-8{\mu}m$ band to compensate for the infrared long-wavelength transition. These results demonstrate the potential for a new approach to improve the performance of high-resolution microbolometers.

• The Journal of the Korea Contents Association
• /
• v.5 no.3
• /
• pp.167-173
• /
• 2005

In a speech coding system using excitation source of voiced and unvoiced, it would be involved a distortion of speech quality in case coexist with a voiced and unvoiced consonants in a frame. So, I propose TSIUVC(Transition Segment Including Unvoiced Consonant) extraction method by using pitch pulses and Zero Crossing Rate in order to unexistent with a voiced and unvoiced consonants in a frame. And this paper present a TSIUVC approximate-synthesis method by using frequency band division. As a result, this method obtains a high quality approximation-synthesis waveform within TSIUVC by using frequency information of 0.547kHz below and 2.813kHz above. And the TSIUVC extraction rate was $91\%$ for female voice and $96.2\%$ for male voice respectively This method has the capability of being applied to a new speech coding of Voiced/Silence/TSIUVC, speech analysis, and speech synthesis.

• Korean Journal of Optics and Photonics
• /
• v.6 no.1
• /
• pp.33-38
• /
• 1995

We have measured the excited state absorption in $Ce:YAlO_{3}$, crystals for the first time and assigned it for a 5d$\rightarrow$conduction band transition. Two broad absorption bands were observed at 555 nm and 465 nm fowllowing the 308 nm XeCl laser excitation and their cross sections and oscillator strengths were calculated. We have also measured the fluorescence lifetimes in between 300 K and 700 K to study the nonradiative relaxation from the lowest 5d state of $Ce^{3+}$ ions and explained ESA and the transition process from the state in terms of a configurational coordinate.dinate.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.4 s.107
• /
• pp.324-329
• /
• 2006

In this paper, a resonator with the substrate integrated waveguide(SIW) structure at the satellite communication band is presented. The SIW structure is realized by via-holes on the dielectric substrate and has an advantage of integration with other circuits. For the measurement, a designed back-to-back transition has the insertion loss of 0.4 dB at 18 GHz. Also, the quality factor of the resonator with the SIW structure including back-to-back transition is obtained to be 222. The high-Q resonator with the SIW structure can be used in filter, oscillator, and voltage controlled oscillator.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.23 no.4
• /
• pp.29-34
• /
• 2023

A clear and efficient design method for a microstrip-to-waveguide inline transition, which is based on an analytical model, is presented. The transition consists of three parts: a microstrip-to-SIW transition, a dielectric-loaded waveguide with substrate-height, and a stepped-height waveguide. The shape of the transitional structure is formed for impedance matching. Two equivalent type0s of dielectric-loaded transitional structures are proposed. The design method is applicable to any size of the waveguide, but a design method of two Ka-band transitions is demonstrated. The proposed transitions, in a back-to-back configuration, have less than 1.2 dB insertion loss and more than 15 dB return loss from 29.8 GHz to 38.2 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.12
• /
• pp.1435-1444
• /
• 2008

In this paper, we designed a reduced height waveguide(WG) to microstrip mode converter with a short transition length. The mode converter is composed of a mode converter using E-plane probe and a modified impedance transformer. The mode converter was designed using a probe shorted to top of a 50 ohm ridge WG. The modified impedance transformer was designed to connect the mode converter to the reduced height WG. For wide bandwidth operation, the coupling of the two parts was tuned. The structure of the mode converter was optimized for low loss and wide bandwidth, and the optimized mode converter was fabricated. The performance of the mode converter was extracted using the thru and line S-parameters for back-to-back connections, and the connector loss was calibrated. The mode converter has a right angle structure and short transition length, 7.2 mm. The mode converter shows excellent performances; the insertion loss of 0.12 dB at 15 GHz, and the return loss above 10 dB for the full Ku-band.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.5
• /
• pp.447-453
• /
• 1999

Congruent $LiNbO_3$ crystals with doped Mg and codoped with Mn or Fe were grown by the Czochralski method. It is known that the physical properties of $LiNbO_3$ depend strongly on the addition of Mg and transition metals. This is established by studying the following properties; XRD patterns, the phase transition temperature, energy of the fundamental absorption edge, the shape of the absorption band of the $OH^-$ vibration and lines of the ESR of $Fe^{3+},\; Mn^{2+}$. The position of the UV absorption edge and the shape and peak point of the absorption band of the $OH^-$ vibrational band changed monotonously up to a critical concentration of $Mg^{2+}$ ions. The mechanism of the incorporation of Mg ions changes at this concentration. The transition temperature was estimated by measuring the dielectric temperature behavior up to $1230^{\circ}C$ in a frequency range of 100Hz to 10MHz. EPR of $Mn^{2+}\;and\; Fe^{3+}$ ions were employed to investigated the Mg doping effects in the $LiNbO_3$ crystal. The increase of linewidths and the asymmetry of signals were observed in all crystals. New signals of $Fe^{3+}$ arising from the new centers were observed I the heavily Mg-doped crystals.

• Bulletin of the Korean Chemical Society
• /
• v.27 no.3
• /
• pp.363-367
• /
• 2006

The structure-property relations of ternary copper chalcogenides, $TlCu_{3-x}S_2$ and $\alpha-BaCu_{2-x}S_2$ are examined. The density of states, band dispersions, and Fermi surfaces of these compounds are investigated to verify the reason of the metal-insulator transitions by extended Huckel tight-binding band calculations. The origin of the metalinsulator transitions of non-stoichiometric $TlCu_{3-x}S_2$ and $\alpha-BaCu_{2-x}S_2$ is thought to be the electronic instability induced by their Fermi surface nesting.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.297-302
• /
• 2005

Right hand circularly polarized Ka band microstrip patch array antenna was designed, manufacture and measurement were carried out. In order to lower axial ratio performance sequential rotation array technique was used. With mono-pulse feed There are sum and delta channel. Waveguide to microstrip transition was used. The 512 array antenna was performed which axial ratio is about 1.ldB in the half power beam width and also 1.ldB at the normal direction. Directivity gain of designed antenna is 32dB.

• 한국생물공학회:학술대회논문집
• /
• 2003.04a
• /
• pp.539-542
• /
• 2003

Fusion gene of GFPuv and Cytochrome c-552 was inserted into the pTrcHis B vector and transferred to E. coli. A fusion protein of GFPuv and Cytochrome c-552 was expressed in BL21. This fusion protein was composed of a His-tag for purification using an immobilized metal affinity chromatography(IMAC). IMAC constitutes a rather facile means of unravelling the principles of recognition and, in particular, of identifying the counterligands on the protein surface, which interact with the ligated and immobilized metal ions. Histidine when present on the surface of a protein molecule under a favorable solvent condition, may serve as electron donors in coordination with the immobilized chelates of some transition metal ions$(Ni^{2+})$.