• Economic and Environmental Geology
• /
• v.28 no.5
• /
• pp.469-480
• /
• 1995

Gravity and magnetic surveys were carried out to investigate the three-dimensional configuration and characteristics of the landfills at Nanjido waste disposal site. For terrain correction and three-dimensional density inversion of gravity data an algorithm, which calculates the gravity effect of a three-dimensional body by using the solid angle method, is developed. This algorithm has been proved to give more accurate terrain correction values for the small survey area having varied topography like Nanjido site as compared with widely used methods such as Hammer's method and multiquadric equation method. Density inversion of gravity anomaly data gives very useful information about the lateral and vertical variation of the landfills, which can be used to discriminate the kinds of wastes. The average density of filled materials appears to be $1.7\;g/cm^3$ which is much higher than the value $(0.8\;g/cm^3)$ estimated by Seoul City. The lateral variation of density shows high correlation with the pattern of ongoing depression of the landfills. The northern region of the landfill no. 1, which shows low density and high depression, is closely associated with the industrial waste and sludge filled area. The magnetic anomaly data provide information about relative concentration of magnetic materials, which is also very useful to investigate characteristics of the fills. Several high positive anomaly regions on the reduced-to-pole magnetic anomaly map are appeared to be associated with the industrial waste fills, but certain industrial waste fills show low negative anomalies. This kind of magnetic information can be used in selecting drilling locations over landfills away from buried metal products during the stabilization process.

• Journal of the korean society of oceanography
• /
• v.33 no.3
• /
• pp.41-52
• /
• 1998

A seasonal circulation pattern in the eastern Yellow Sea (EYS) is suggested from the water mass analysis and geostrophic calculation using the hydrographic data collected by National Fisheries Research and Development Institute during the years of 1970 to 1990. This research focuses on the presence of inflow of warm (and saline) waters into EYS in summer. EYS is divided into two regions in this paper: the west coast of Korea (WCK) and the central Yellow Sea (CYS). In CYS, waters are linked with warm waters near Cheju Island in winter, but with cold waters from the north in summer (in the lower layer). It is not simple to say about WCK because of the influences of freshwater input and tidal mixing. Nevertheless, water mass analysis reveals that along WCK, waters have the major mixing ratios (40-60%) of warm waters in summer, while the dominant mixing ratios (50-90%) of cold waters in winter. Such a seasonal change of water mass distribution can be explained only by seasonal circulation. In winter, warm waters flow northward into CYS and cold waters flow southward along WCK. In summer, warm waters flow northward along WCK and cold waters flow southward into CYS. This circulation pattern is supported by both statistical analysis and dynamic depth topography. Accordingly, Yellow Sea Warm Current may be defined as the inflow of warm waters to CYS in winter and to WCK in summer.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.31 no.2
• /
• pp.174-180
• /
• 2011

Nondestructive surface imaging of elastic characteristic and mechanical property has been studied on nanoscale surface with ultrasonic AFM. Resonance frequency variation of cantilever is theoretically analyzed with respect to contact mechanics as well as experimentally measured. The contact resonance frequency is calculated theoretically using the spring-mass and Herzian model in accordance with the resonance frequency of UAFM cantilever measured experimentally. Consequently, the topography and amplitude images could be obtained successfully and the elastic characteristic at the nanoscale surface was evaluated qualitatively by amplitude signals.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.6
• /
• pp.1279-1284
• /
• 2012

This study is about the change of coastline through using ASTER images. ASTER image is a sensor loaded in earth resources satellite shoot in Japan on Dec. 1999. It has 15m, 30m, 90m coastline, three sensors of VNIR, TIR and WIR, therefore it's possible to obtain more information on the Earth than the existing satellite images cause it contains various a wavelength range in spite of relatively economic image. The coastline is changed according to topography shape because it's strongly localized. Besides, it's one of the most important factors in MGIS(Marine Geographic Information System). Therefore, this study is accomplished by analysing variation after abstraction the coastline automatically by Vector Line from ASTER satellite images. The study result will be used as an important basic data when analysis the change of e coastline hereafter.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2004.04a
• /
• pp.241-246
• /
• 2004

We studied field observation and countermeasure about the effluent of sediment and nutrient materials on the Okinawa Ishigaki Coast according rainy season. though this observation, we found out the analysis of outflow topography, intensity of rainfall and effects on the tide, the property of effluent materials etc. The sediment and nutrient concentration of the Okinawa Ishigaki coast are different on the regional sites according to vary with time variation of intensity of rainfall and the ebb and flow. We could confirm to vary with utilized waterways land area and distribution of surrounding vegetation.

• Journal of Navigation and Port Research
• /
• v.29 no.1 s.97
• /
• pp.113-118
• /
• 2005

We studied field observation and countermeasure about the effluent of sediment and nutrient materials on the Okinawa Ishigaki Coast according rainy season though this observation, we found out the analysis of outflow topography, intensity of rainfall and effects on the tide, the property of effluent materials ete. The sediment and nutrient concentration of the Okinawa Ishigaki coast are different on the regional sites according to vary with time variation of intensity of rainfall and the ebb and flow. We could confirm to vary with utilized waterways land area and distribution of surrounding vegetation.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.634-639
• /
• 2003

It has been studied the flow near a rotating disk with surface topography. The system Ekman number is assumed very small, i.e., $E[{\equiv}\frac{\nu}{{\Omega}^{\ast}L^{\ast2}}]<<1$ in which $L^{\ast}$ denotes a disk radius, ${\nu}$ kinematic viscosity of the fluid and ${\Omega}^{\ast}$ angular velocity of the basic state. Disk surface has a sinusoidal topographic variation along radial coordinate, i.e., $z={\delta}cos(2{\pi}{\omega}r)$, where ${\delta}$ and ${\omega}$ are, respectively, nondimensional amplitude and wave number of the disk surface. Analytic solutions, being useful over the parametric ranges of ${\delta}{\sim}O$( $E^{1/2}$ ) and ${\omega}{\leq}O$ ( $E^{1/2}$ ), are secured in a series-function form of Fourier-Bessel type. An asymptotic behavior, when $E{\rightarrow}0$, is clarified as : for a disk with surface roughness, in contrast to the case of a flat disk, the azimuthal velocity increases in magnitude, together with the thickening boundary layer. The radial velocity, however, decreases in magnitude as the amplitude of surface waviness increases. Consequently, the overall Ekman pumping at the edge of the boundary layer remains unchanged, maintaining the constant value equal to that of the flat disk.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2017.05a
• /
• pp.3-23
• /
• 2017

The achievement of tissue engineering can be highly depending on the capability to generate complicated, cell seeded three dimensional (3D) micro/nano-structures. So, various fabrication techniques that can be used to precisely design the architecture and topography of scaffolding materials will signify a key aspect of multi-functional tissue engineering. Previous methods for obtaining scaffolds based on top-down are often not satisfactory to produce complex micro/nano-structures due to the lack of control on scaffold architecture, porosity, and cellular interactions. However, a bioprinting method can be used to design sophisticated 3D tissue scaffolds that can be engineered to mimic the tissue architecture using computer aided approach. Also, in recent, the method has been modified and optimized to fabricate scaffolds using various natural biopolymers (collagen, alginate, and chitosan etc.). Variation of the topological structure and polymer concentration allowed tailoring the physical and biological properties of the scaffolds. In this presentation, the 3D bioprinting supplemented with a newly designed plasma treatment for attaining highly bioactive and functional scaffolds for tissue engineering applications will be introduced. Moreover, various in vivo and in vitro results will show that the fabricated scaffolds can carry out their structural and biological functionality.

• Water Engineering Research
• /
• v.3 no.1
• /
• pp.31-44
• /
• 2002

The effect of diurnal cycle, intermittent visit of observation satellite, sensor installation, partial coverage of remote sensing, heterogeneity of soil properties and precipitation to the soil moisture estimation error were analyzed to present the global sampling strategy of soil moisture. Three models, the theoretical soil moisture model, WGR model proposed Waymire of at. (1984) to generate rainfall, and Turning Band Method to generate two dimensional soil porosity, active soil depth and loss coefficient field were used to construct sufficient two-dimensional soil moisture data based on different scenarios. The sampling error is dominated by sampling interval and design scheme. The effect of heterogeneity of soil properties and rainfall to sampling error is smaller than that of temporal gap and spatial gap. Selecting a small sampling interval can dramatically reduce the sampling error generated by other factors such as heterogeneity of rainfall, soil properties, topography, and climatic conditions. If the annual mean of coverage portion is about 90%, the effect of partial coverage to sampling error can be disregarded. The water retention capacity of fields is very important in the sampling error. The smaller the water retention capacity of the field (small soil porosity and thin active soil depth), the greater the sampling error. These results indicate that the sampling error is very sensitive to water retention capacity. Block random installation gets more accurate data than random installation of soil moisture gages. The Walnut Gulch soil moisture data show that the diurnal variation of soil moisture causes sampling error between 1 and 4 % in daily estimation.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.145-148
• /
• 2008

ICESat launched in Jan. 2003 has a capability to monitor polar regions with its inclination of 94 degree. ICESat carries GLAS (Geosciences Laser Altimetry System) to measure Earth's topography in unprecedented accuracy, and thus it can be applied for glacier variation due to recent climate changes. Here we present a new method to estimate velocity structure of Amery Ice-Shelf using ICESat altimtery data. ICESat data shows horizontal displacement of Amery Ice-Shelf, which can be directly used for velocity estimation. This method is expected to extend to other ice-shelves in Antarctica.