• Korean Membrane Journal
• /
• 제1권1호
• /
• pp.100-105
• /
• 1999

A novel system to thicken the concentrated colloidal solution from membrane water treat-ment processes was developed. A hollow-fiber microfilter(hydrophilic polyethylene nominal pore size 0.1 ${\mu}$m total surface area 0.42 m2) was installed in an acrylic housing that has an aeration port 5 cm below the membrane and a clarifier in the bottom. The concentrate was uniformly supplied from the top of the housing. Bacuum filtration caused downward flow of concentrate and as a result thickening interface. The addition of poly-aluminum chloride (PAC) resulted in rapid increase of trans-membrane pressure (TMP) and in no improvement of the filtered water turbidity and thickening process. Two types of con-centrate and concentrate turbidity had little effect on the increase of TMP and concentrate thickening. It was observed that for the same height of membrane housing membrane surface area to housing volume (A/V) ratio had significant effect on the increase of TMP. When the housing volume was increased ten times the increasing rate of TMP was three times faster as compared to the original housing. A hydraulic model successfully simulated the formation and sedimentation of thickening interface.

• 한국조리학회지
• /
• 제13권1호
• /
• pp.112-118
• /
• 2007

This study was carried out to investigate the quality characteristics of snow crab cream soup in order to seek the possibility of using fresh yams and potatoes instead of roux as thickening agents. The highest crude lipid(p<.05) and moisture(p<.001) were examined for the snow crab cream soup with yams and with potatoes as thickening agents($S_1$),($S_2$). The highest pH levels of $S_2(5.75)$ for the snow crab cream soup with yams and with potatoes were 75% and 25%. respectively. The highest lightness of 71.51(L value) was found in the 100% potato as a thickening agent($S_5$)(p<.001). The redness(a value) and yellowness(b value) were increased by adding potatoes to the snow crab soup(a=p<.001), (b=p<.01). Viscosity was increased by potato contents, and highest for the snow crab cream soup($S_5$) (p<.001). In sensory evaluation, the highest sensory scores for flavor and texture(p<.001) of mean 5.11 and 5.05, respectively, were obtained from the snow crab cream soup with yams(75%) and with potatoes(25%)($S_4$). The highest overall acceptability of mean 5.11 was found in the snow crab cream soup with yams(50%) and with potatoes(50%) as thickening agents($S_3$)(p<.001).

• 한국물환경학회지
• /
• 제22권1호
• /
• pp.97-103
• /
• 2006

Excess sludge treatment and disposal currently represent a rising challenge for domestic or wastewater treatment plants due to economic, environmental and regulation factors. Conventional gravity sedimentation process has been widely used in sludge thickening. The operation method of the process is very simple, but the process requires long detention time for sludge thickening, uses polymers, and shows low sludge thickening efficiency. To solve the problems, we studied on DAF (Dissolved Air Flotation) system. We use bulking sludge of a paper manufacturing plant. The effects of parameters such as SVI (Sludge Volume Index), storage time, initial concentration and wet density of excess sludge were examined. The results showed that the more SVI was low, the more sludge was thickened. As storage time goes by, SVI was increased and thickening performance was deteriorated. In order to improve flotation performance at high concentration, high recycling ratio and pressure did not increase the concentration due to thickening limitation. The addition of 0.8 g/L of loess was increased flotation efficiency of 1.41 times.

• 상하수도학회지
• /
• 제24권5호
• /
• pp.527-536
• /
• 2010

Although the bubble-floc agglomerate floated and formed the float layer on the surface of the water in the DAF process, after inducing in the thickening tank a part of the bubble-floc agglomerate come up again to the surface and the other is settled at the bottom of the tank. The bubble-floc agglomerate divided into two group as the scum on the surface and the sludge of the bottom gives rise to operational troubles for the thickening process. In order to find out the cause of break-up and the effective thickening method for sludge from the DAF process, the composition of the bubble-floc agglomerate was investigated and a series of flotation experiments carried out. There was no difference of composition between the scum on the surface and the sludge of the bottom in the thickening tank. The coagulation was not effective to improve the trouble that the bubble-floc agglomerate divided into the scum and the sludge. It was estimated that for the bubble-floc agglomerate of thickening tank the trouble was caused by not the change or the difference of chemical composition but whether the bubble-floc agglomerate hold bubbles. Furthermore, for the effective thickening of sludge from the DAF process, it is required an additional flotation applied the AS ratio depending upon the solid concentration of sludge as the operation parameter.

• 대한핵의학회지
• /
• 제34권6호
• /
• pp.487-496
• /
• 2000

목적: 국소 심근 벽 운동과 수축기 심근두꺼워짐에 대한 자동정량화 소프트웨어의 재현성을 알아보고자 하였다. 대상 및 방법: 31명의 무작위 추출한 관상동맥질 환자에서 부하 게이트 Tc-99m-MIBI SPECT를 시행하는 중에, 게이트 심근 SPECT를 1회 시행한 이후 바로 이어 한번 더 게이트 SPECT를 시행하였다. 얻어진 영상으로부터 AutoQUANT 소프트웨어를 이용하여 분절별, 심근벽별로 심근벽 운동과 수축기 심근두꺼워짐의 자동정량값을 얻어, 1회째 값과 2회째 값 사이의 상관계수를 계산하고 Bland-Altman 도표를 통해 변이의 범위를 보았다. 또 각 값들을 등급화한 수치 간에 kappa 값을 구해보았다. 결과: 재현성 분석에서 1회와 2회 시행간의 상관계수는 각각 0.948, 0.878이었으며, weighted kappa 값은 0.807, 0.708로 아주 좋은 일치도를 보였다. Bland-Altman 분석에서 변이의 2 표준편차 범위는 각각 ${\pm}2.0mm,\;{\pm}20.2%$였다. 각각의 재현성은 분절영역, 성별, 관류의 수준에 따라 차이를 보이지 않았다. 결론: 이 연구에서 우리는, 심근 벽 운동과 수축기 심근두꺼워짐의 자동정량화 소프트웨어가 좋은 재현성을 가지고 있음을 알았으며, 또한 추적 검사나 치료효과 판정시 심근 벽 운동과 수축기 심근두꺼워짐의 변화 판정 기준을 마련하였다.

• Journal of the Korean Wood Science and Technology
• /
• 제22권3호
• /
• pp.39-44
• /
• 1994

This study was carried out to investigate features pertaining to spiral thickenings, which was considered one of the most important diagnostic values, for wood identification. Species, kind of cells with spiral thickening, and ridge numbers of spiral thickening per axial mm were recorded in 71 families, 144 genera, 316 species of Korean hardwoods. Spiral thickening was observed in 128 of 316 species, about 40.5 % of all the investigated, and classified into 6 types on the basis of distributional patterns and morphological features as follows: 1. Type 1, present throughout all vessel element, which was found in 14 families, 19 genera, 43 species. 2. Type 2, present only in small vessel element, which was found in 18 families, 29 genera, 41 species. 3. Type 3, present both in small vessel element and wood fibers, which was found in 8 families, 17 genera, 29 species. 4. Type 4, present in wood fibers, which was found in 1 family, 1 genus, 1 species. 5. Type 5, present only in tail of vessel element, which was found in 4 families, 5 genera, 9 species. 6. Type 6, being present in vessel element faintly or partially, which was found in 2 families, 3 genera, 5 species.

• 멤브레인
• /
• 제1권1호
• /
• pp.100-100
• /
• 1991

A novel system to thicken the concentrated colloidal solution from membrane water treat-ment processes was developed. A hollow-fiber microfilter(hydrophilic polyethylene nominal pore size 0.1 μm total surface area 0.42 m2) was installed in an acrylic housing that has an aeration port 5 cm below the membrane and a clarifier in the bottom. The concentrate was uniformly supplied from the top of the housing. Bacuum filtration caused downward flow of concentrate and as a result thickening interface. The addition of poly-aluminum chloride (PAC) resulted in rapid increase of trans-membrane pressure (TMP) and in no improvement of the filtered water turbidity and thickening process. Two types of con-centrate and concentrate turbidity had little effect on the increase of TMP and concentrate thickening. It was observed that for the same height of membrane housing membrane surface area to housing volume (A/V) ratio had significant effect on the increase of TMP. When the housing volume was increased ten times the increasing rate of TMP was three times faster as compared to the original housing. A hydraulic model successfully simulated the formation and sedimentation of thickening interface.

• 상하수도학회지
• /
• 제20권5호
• /
• pp.747-753
• /
• 2006

Air flotation is a solid-liquid separation process that utilizes up-flow microbubbles to thicken activated sludge and enhance clarification efficiency. Continuous air flotation experiments were performed to investigate the effect of operation parameters such as initial MLSS (mixed liquor suspended solid) concentration, air pressure, surface loading rate, air to solid (A/S) ratio, and flotation time on thickening efficiency. An initial activated sludge concentration ranged from 3,000 to 12,000mgSS/L and thickened sludge concentration varied from 6,400 to 28,100mgSS/L. The result showed that the thickening efficiency was mainly dependent on surface loading rate, A/S ratio, and flotation time. The pressure did not affect the thickening efficiency when it kept in the range of 1.6 to 1.8 bar. Experimental results showed that the thickening efficiency of activated sludge was increased only when the feed sludge concentration exceeded 5,000mgSS/L and the thickened concentration was over 20,000mgSS/L. At this time, SS concentration in the clarified liquid was ranged from 5 to 10mg/L.

• 한국주조공학회지
• /
• 제30권6호
• /
• pp.241-246
• /
• 2010

The viscosity of foam metal is necessary to get the pores, but it is difficult to manufacture net-shape foam, because the fluidity decreases by increasing viscosity. In this study, the A356 alloy which has good fluidity and less defect was selected and fabricated to foam metal. To understand about effect of thickening agent on foaming and mechanical properties, quantity of thickening agent was changed. The pore size, porosity and distribution of foam metal were measured by i-solution program. And compression test were performed by UTM. In case of 3.0wt% Ca in thickening agent, it is found that most of foam consist of homogeneous shape, and the growth height had the highest value of 204 mm in the all fabricated foams. The porosity was 93% and compressive strength was 3.1 MPa. In the microstructure, the $Al_2Si_2Ca$ intermetallic compound and Ti were observed. The vickers hardness value rose with increasing viscosity value.

• 한국환경보건학회지
• /
• 제33권1호
• /
• pp.68-74
• /
• 2007

The objective of this study is to examine the effect of the coagulation and homogenization in bulking sludge thickening of paper manufacturing plant using DAF(Dissolved Air Flotation) and gravitational sedimentation. The effects of parameters such as dosage of coagulant and homogenization time were examined. The results showed that DAF and sedimentation was affected aluminum sulfate and anion polymer coagulant differently. At the optimum dosage of aluminum sulfate, thickening efficiency of DAF and sedimentation process were increase 1.25 time and 2.02 time, respectively. At the optimum dosage of anion polymer coagulant, thickening efficiency of DAF process was increase 1.35 time, but thickening efficiency at sedimentation was 1.06 time. When anion polymer coagulant of 0.5 mg/l was added in DAF process, water content of sludge was decreased from 96.6% to 90.7% in dewatering process using Buchner funnel test device. After homogenization(20500 rpm, 10 min), Sauter mean diameter of sludge floc was decreased from 631 ${\mu}m$ to 427 ${\mu}m$, however increase of flotation efficiency by DAF was only 1.09 time.