• Analytical Science and Technology
• /
• v.32 no.4
• /
• pp.131-138
• /
• 2019

This paper reports results on the physical properties of a powder type of $Al_2O_3:C$ commonly used as a luminescence dosimeter using the LM-OSL technique. On the analysis with the general order kinetics model, the LM-OSL signal measured appeared to be composed of three components (fast, medium, slow) showing the largest area in the medium component. The photoionization cross sections of three components were distributed between $10^{-19}{\sim}10^{-21}cm^2$. The values of the thermal assistance energy were evaluated the largest in slow component and the smallest in fast component, which indicates the electrons trapped in defects attributed to slow component should be the most sensitive to thermal vibration among three components. In illumination to blue light, the fast component showed a rapid linear decay and completely disappeared after light exposure time of about 5 s. The medium component decayed with two exponential elements but the slow component did not observed any noticeable change until light exposure time of 40 s. In a dose response study, all components exhibited a linear behaviour up to approximately 10 Gy.

• KIEAE Journal
• /
• v.14 no.4
• /
• pp.111-117
• /
• 2014

In South Korea, the government has recently enforced regulations associated with buildings. Temperature restriction in indoor environment is one of the common ways of energy reduction in order not to dissipate heating and cooling energy; however the people who are in restricted temperature feels uncomfortable. Furthermore, occupants cannot feel the same thermal sensation even they are in the same place. For the reason, occupants should express their thermal sensation and HVAC system should be able to apply their demand. It is proved by an adaptive principle. The adaptive model means that people react in ways which tend to restore their comfort, when change occurs such as to produce discomfort. In order to design HVAC control strategies based on adaptive model, we designated an existing office building as a reference building to gather data from actual field. Furthermore, we gathered occupants' thermal sensation and clothing insulation in real-time. We filtered the data with Kalman's filter method. The data was reasonable when there is an alarm messages for asking questionnaire. The response ratio were different in occupants' thermal condition. In conclusion, the filtered occupants' thermal sensation can be used as a real time HVAC control and input value of HVAC control.

• Analytical Science and Technology
• /
• v.31 no.1
• /
• pp.7-13
• /
• 2018

In this study, we measured the time-resolved optically stimulated luminescence (TR-OSL) of Paleolithic paleosol quartz and evaluated its lifetime. Considering the lifetime dependence on the preheating applied after irradiation, the radiation exposure, and the optical pulse stimulation, we found that the optimum measurement condition for determining the lifetime of paleosol quartz was the optical pulse stimulation at a dwelling time of $250{\mu}s$, pulse width of $10{\mu}s$, and sweep number of 100,000, without preheating after 100 Gy of irradiation. Based on the dependence of the lifetime on the reading temperature, the thermal quenching activation energy ${\Delta}E$ and thermal assistance activation energy $E_a$ were evaluated as $0.60{\pm}0.14eV$ and $0.053{\pm}0.029eV$, respectively. These values were in good agreement with those reported in the literature. Therefore, we concluded that the resulting kinetic parameters for paleosol quartz are quite reliable.

• KIEAE Journal
• /
• v.14 no.3
• /
• pp.39-45
• /
• 2014

Energy poverty has been defined as low-income households who paid energy cost more than 10% of their ordinary income. Therefore, there are various subsidy programs focused on house remodeling for low-income households and one of them is the Home Energy Efficiency Assistance Program which have done by Korea Energy Foundation since 2007. The aim of the program is to improve the thermal performance of dilapidated dwellings and analyzed the detached house for the low-income households to develop the building typology. The database contained approximately 3,061 households which was obtained from the program in 2013 and the results of the study were like this; 1) For the shape of residential houses, the number of rectangular shaped building was higher than non-rectangular shaped ones. 2) For the orientation of buildings, the south layout of the detached housing was dominant to gain heating energy into buildings. 3) For the floor area, the average floor area was $44.2m^2$, although its size varied wide variations, which range from $6.3m^2$ to $107.1m^2$. 4) For the windows and doors, the south-facing window was larger than the other side. Finally it would be possible to determine the characteristics of residential houses for low-income families. A future study could establish typology of low-income housing that it would estimate the performance of each model building before and after the retrofit to improve the energy performance.

• Nuclear Engineering and Technology
• /
• v.52 no.8
• /
• pp.1611-1625
• /
• 2020

We propose a scaled-down experimental model of vertical air-natural convection channels by applying the modified Ishii-Kataoka scaling method with the assistance of numerical analyses to the Reactor Vault Cooling System (RVCS) of the Proto-type Gen-IV Sodium-cooled fast reactor (PGSFR) being developed in Korea. Two major non-dimensional numbers (modified Richardson and Friction number) from the momentum equation and Stanton number from the energy balance equation were identified to design the scaled-down experimental model to assimilate thermal-hydraulic behaviors of the natural convective air-cooling channel of RVCS. The ratios of the design parameters in the PGSFR RVCS between the prototype and the scaled-down model were determined by setting Richardson and Stanton number to be unity. The friction number which cannot be determined by the Ishii-Kataoka method was estimated by numerical analyses using the MARS-KS system code. The numerical analyses showed that the friction number with the form loss coefficient of 2.0 in the scale-down model would result in an acceptable prediction of the thermal-hydraulic behavior in RVCS. We also performed experimental benchmarking using the scaled-down model with the MARS-KS simulations to verify the appropriateness of the scale-down model, which demonstrated that the temperature rises and the average air flow velocity measured in the scale-down model.

• Nuclear Engineering and Technology
• /
• v.49 no.8
• /
• pp.1654-1659
• /
• 2017

The boundary layer of a two-dimensional forced convective flow along a persistent moving horizontal needle in an electrically conducting magnetohydrodynamic dissipative nanofluid was numerically investigated. The energy equation was constructed with Joule heating, viscous dissipation, uneven heat source/sink, and thermal radiation effects. We analyzed the boundary layer behavior of a continuously moving needle in Blasius (moving fluid) and Sakiadis (quiescent fluid) flows. We considered Cu nanoparticles embedded in methanol. The reduced system of governing Partial differential equations (PDEs) was solved by employing the Runge-Kutta-based shooting process. Computational outcomes of the rate of heat transfer and friction factors were tabulated and discussed. Velocity and temperature descriptions were examined with the assistance of graphical illustrations. Increasing the needle size did not have a significant influence on the Blasius flow. The heat transfer rate in the Sakiadis flow was high compared with that in the Blasius flow.

• Geomechanics and Engineering
• /
• v.16 no.4
• /
• pp.363-373
• /
• 2018

The evaluation of Thermo-Hydro-Mechanical (THM) coupling behavior is important for the development of underground space for various purposes. For a high-level radioactive waste repository excavated in a deep underground rock mass, the accurate prediction of the complex THM behavior is essential for the long-term safety and stability assessment. In order to develop reliable THM analysis techniques effectively, an international cooperation project, Development of Coupled models and their Validation against Experiments (DECOVALEX), was carried out. In DECOVALEX-2015 Task B2, the in situ THM experiment that was conducted at Horonobe Underground Research Laboratory(URL) by Japan Atomic Energy Agency (JAEA), was modeled by the research teams from the participating countries. In this study, a THM coupling technique that combined TOUGH2 and FLAC3D was developed and applied to the THM analysis for the in situ experiment, in which rock, buffer, backfill, sand, and heater were installed. With the assistance of an artificial neural network, the boundary conditions for the experiment could be adequately implemented in the modeling. The thermal, hydraulic, and mechanical results from the modeling were compared with the measurements from the in situ THM experiment. The predicted buffer temperature from the THM modelling was about $10^{\circ}C$ higher than measurement near by the overpack. At the other locations far from the overpack, modelling predicted slightly lower temperature than measurement. Even though the magnitude of pressure from the modeling was different from the measurements, the general trends of the variation with time were found to be similar.

• Journal of Energy Engineering
• /
• v.24 no.4
• /
• pp.192-199
• /
• 2015

Under the economic banner of "self-reliance," North Korea has focused on hydro and thermal power as its main energy supply sources. However, in the face of extreme energy penury caused by machinery and material supply instability in the wake of the collapse of the former communist block as well as equipment aging and deterioration due to floods and other disasters, North Korea and international aid organizations are increasingly turning their attention toward energy source diversification. In particular, renewable energy is recognized as the best strategic energy source for North Korea and it is a decentralized energy option that is suitable in light of North Korea's power distribution networks and its pursuit of self-reliance. Biogas can contribute to improving the human rights situation of North Koreans in conjunction with an increase in food production. For this reason, renewable energy is the most promising option for an energy source that is likely to secure humanitarian aid from international organizations such as the Food and Agricultural Organization (FAO) and the World Food Programme (WFP). However, the implementation of such humanitarian aid has been hampered by rising concerns about the diversion of provided energy materials for military purposes and the disguised introduction of dual use items strategic materials as well as UN Security Council resolutions and sanctions of the international community against North Korea's military provocation, including nuclear tests and missile launches. This paper explores the possibility of solving this dilemma and proceeding with the humanitarian aid to North Korea by evaluating the potential for sanction and the risk of diversion of the possible products for biogas-related aid on the basis of the list of UN-sanctioned items.