• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제45회 하계 정기학술대회 초록집
• /
• pp.190.2-190.2
• /
• 2013

Vanadium dioxide ($VO_2$) has been widely attracted for academic research and industrial applications due to its metal-insulator transition (MIT) temperature close to room temperature. We synthesized VOx film on (0001) sapphire substrate with vanadium target (purity: 99.9%) using DC magnetron sputtering in Ar ambience at a pressure of $10^{-3}$ Torr at $400{\sim}700^{\circ}C$. The VOx film subsequently was annealed at difference temperatures in ambience of Ar and $O_2$ gas mixture at $60{\sim}800^{\circ}C$. The structural properties of the films were investigated using scanning electron microscopic (SEM), x-ray diffraction (XRD) and x-ray absorption fine structure (XAFS) measurements. SEM reveal that small grains formed on the substrates with a roughness surface. XRD shows oriented $VO_2$(020) crystals was deposited on the $Al_2O_3$(006) substrate. From I-V measurements, the electric resistance near its MIT temperature were dramatically changed by ${\sim}10^4$ during heating and cooling the films. We will also discuss the temperature-dependent local structural changes around vanadium atoms using XAFS measurements.

• Bulletin of the Korean Chemical Society
• /
• 제22권7호
• /
• pp.703-708
• /
• 2001

K2NiF4-type organic-based perovskites of the (C4H9NH3)2FexPb1-xCl4 (x=0.00, 0.25, 0.50, and 0.75) system have been synthesized using a low-temperatu re solution method under a flowing argon gas. When stoichiometric butylamine, iron chloride, and lead chloride are mixed, a yellow solution are obtained from slow cooling of 90 to -10 $^{\circ}C.$ The final product is a plate-like yellow crystal. The X-ray crystallographic analysis has been carried out using XRD in the range of $5^{\circ}{\leq}$ 2${\theta}$ ${\leq}80^{\circ}.$ The local symmetry around the absorbing Pb atom of the samples has been determined by the EXAFS spectroscopic study. The crystals assign to orthorhombic system by the XRD analysis. The FT-IR spectra are analyzed in the range of 600 to 3300 cm-1 . DSC and TGA are measured to detect thermal stability between 30 and 300 $^{\circ}C.$ Two endothermic peaks are detected in all samples. The electrical conductivity has been measured using the four-probes technique for the (C4H9NH3)2FexPb1-xCl4 system in 300-460 K. Photoluminescence phenomenon was also investigated at room-temperature.

• 한국추진공학회지
• /
• 제23권5호
• /
• pp.53-59
• /
• 2019

고체연료는 추진제 연소 시 산화제와 반응하여 추진제 성능을 증가시키는 역할을 한다. 대표적인 고체연료는 Al, RDX, HMX 등이 있다. 이들 물질은 연소 시 수분과 만나 흰색 연기를 발생시키고, 일산화탄소, 이산화탄소, 메탄가스 등의 환경유해 물질을 다량 발생시킨다. 이러한 문제를 해결하기 위해 본 연구에서는 고체 연료로 사용 가능한 고질소 에너지 물질인 hydrazinium 5-aminotetrazolate(HAT)를 제조하였다. 분광분석(NMR)을 통해 HAT의 구조를 분석하였으며, DSC를 이용하여 열특성 분석을 하였다. 또한, EXPLO5 프로그램을 이용하여 비추력, 가스발생량 등을 계산하였다.

• 반도체디스플레이기술학회지
• /
• 제9권2호
• /
• pp.1-6
• /
• 2010

Star-like ZnO nanostructures were grown on SI(100) substrates with carbon(C) catalyst by employing vapor-solid(VS) mechanism. The morphologies and structure of ZnO nanostructures were investigated by Field emission scanning electron microscopy (FESEM), X-ray diffraction (XRD) and Raman spectrum, Photoluminescence spectrum. The results demonstrated that the as-synthesized products consisted of star-like ZnO nanostructure with hexagonal wurtzite phase. Nanostructures grown at 1100 were mainly star-like in structure with diameters of 500 nm. The legs of the star-like nanostructures were preferentially grown up along the [0001] direction. A vapor.solid (VS) growth mechanism was proposed to explain the formation of the star-like structures. Photoluminescence spectrum exhibited a narrow emission band peak around 380 nm and a broad one around 491 nm. Raman spectrum of the ZnO nanostructures showed oxygen defects in ZnO nanostructures due to the existence of Ar gas during the growth process, leading to the dominant green band peak in the PL spectrum.

• Nuclear Engineering and Technology
• /
• 제51권3호
• /
• pp.792-799
• /
• 2019

The present study aims to investigate the fluorination of thorium oxide ($ThO_2$) by ammonium hydrogen difluoride ($NH_4HF_2$). Fluorination was performed at room temperature by mixing $ThO_2$ and $NH_4HF_2$ at different molar ratios, which was then left to react for 20 days. Next, the mixtures were analyzed using X-ray diffraction (XRD) at the intervals of 5, 10, 15, and 20 days, followed by the heating of the mixtures at $450-750^{\circ}C$ with argon gas flow. The characterization of $ThF_4$ was established using X-ray diffraction (XRD) and scanning electron microscopy-dispersion X-ray spectroscopy (SEM-EDX). In this study, ammonium thorium fluoride was synthesized through the fluorination of $ThO_2$ at room temperature. The optimum molar ratio in synthesizing ammonium thorium fluoride was 1.0:5.5 ($ThO_2:NH_4HF_2$) with 5 days reaction time. In addition, the heating of ammonium thorium fluoride at $450^{\circ}C$ was sufficient to produce $ThF_4$. Overall, this study proved that $NH_4HF_2$ is one of the fluorination agents that is capable of synthesizing $ThF_4$.

• Elastomers and Composites
• /
• 제55권4호
• /
• pp.321-328
• /
• 2020

Zinc nitrate hexahydrate (Zn(NO3)2·6H2O) and sodium hydroxide (NaOH) were dissolved in distilled water and stirred for 30 min. The resulting solution was sonicated by an ultrasonic wave for 45 min. This solution was washed with distilled water and ethanol after centrifugation; next, it was placed in an electric furnace at 200℃ for 1 h under the flow of Ar gas to obtain zinc oxide nanoparticle. A zinc oxide nanoparticle-(C60) fullerene nanowhisker composite was synthesized using the zinc oxide nanoparticle solution, C60-saturated toluene, and isopropyl alcohol via the liquid-liquid interfacial precipitation method. The zinc oxide nanoparticle and zinc oxide nanoparticle-(C60) fullerene nanowhisker composite were characterized using X-ray diffraction, scanning electron microscopy, and Raman spectroscopy, and they were used for the catalytic degradation of methyl orange (MO) under ultraviolet (at 254 and 365 nm) and ultrasonic irradiation. In addition, the catalytic degradation of MO over the zinc oxide nanoparticle and zinc oxide nanoparticle-(C60) fullerene nanowhisker composite was evaluated using ultraviolet-visible spectroscopy.

• 산업기술연구
• /
• 제42권1호
• /
• pp.7-12
• /
• 2022

High nickel layered oxide cathodes are gaining increasing attention for lithium-ion batteries due to their higher energy density and lower cost compared to LiCoO₂. However, they suffer from the formation of residual lithium on the surface in the form of LiOH and Li₂CO₃ on exposure to ambient air. The residual lithium causes notorious issues, such as slurry gelation during electrode preparation and gas evolution during cell cycling. In this review, we investigate the residual lithium issues through its impact on cathode slurry instability based on deformed polyvinylidene fluoride (PVdF) as well as its formation and reduction mechanism in terms of inherently off-stoichiometric synthesis of high nickel cathodes. Additionally, new analysis method with anhydrous methanol was introduced to exclude Li⁺/H⁺ exchange effect during sample preparation with distilled water. We hope that this review would contribute to encouraging the academic efforts to consider practical aspects and mitigation in global high-energy-density lithium-ion battery manufacturers.

• 한국근적외분광분석학회:학술대회논문집
• /
• 한국근적외분광분석학회 2001년도 NIR-2001
• /
• pp.3114-3114
• /
• 2001

During the last years phytochemistry and phytopharmaceutical applications have developed rapidly and so there exists a high demand for faster and more efficient analysis techniques. Therefore we have established a near infrared transflectance spectroscopy (NIRS) method that allows a qualitative and quantitative determination of new polyphenolic pharmacological active leading compounds within a few seconds. As the NIR spectrometer has to be calibrated the compound of interest has at first to be characterized by using one or other a combination of chromatographic or electrophoretic separation techniques such as thin layer chromatography (TLC), high performance liquid chromatography (HPLC), capillary electrophoresis (CE), gas chromatography (GC) and capillary electrochromatography (CEC). Both structural elucidation and quantitative analysis of the phenolic compound is possible by direct coupling of the mentioned separation methods with a mass spectrometer (GC-MS, LC-MS/MS, CE-MS, CEC-MS) and a NMR spectrometer (LC-NMR). Furthermore the compound has to be isolated (NPLC, MPLC, prep. TLC, prep. HPLC) and its structure elucidated by spectroscopic techniques (UV, IR, HR-MS, NMR) and chemical synthesis. After that HPLC can be used to provide the reference data for the calibration step of the near infrared spectrometer. The NIRS calibration step is time consuming, which is compensated by short analysis times. After validation of the established NIRS method it is possible to determine the polyphenolic compound within seconds which allows to raise the efficiency in quality control and to reduce costs especially in the phytopharmaceutical industry.

• 한국분말재료학회지
• /
• 제30권1호
• /
• pp.41-46
• /
• 2023

In this study, an Al₈₂Ni₇Co₃Y₈ (at%) bulk metallic glass is fabricated using gas-atomized Al₈₂Ni₇Co₃Y₈ metallic glass powder and subsequent spark plasma sintering (SPS). The effect of powder size on the consolidation of bulk metallic glass is considered by dividing it into 5 ㎛ or less and 20-45 ㎛. The sintered Al₈₂Ni₇Co₃Y₈ bulk metallic glasses exhibit crystallization behavior and crystallization enthalpy similar to those of the Al₈₂Ni₇Co₃Y₈ powder with 5 ㎛ or less and it is confirmed that no crystallization occurred during the sintering process. From these results, we conclude that the Z-position-controlled spark plasma sintering process, using superplastic deformation by viscous flow in the supercooled liquid-phase region of amorphous powder, is an effective process for manufacturing bulk metallic glass.

• 한국표면공학회지
• /
• 제56권1호
• /
• pp.55-61
• /
• 2023

As a preliminary study to produce functional nanocomposites in a heat dissipation device, we performed the direct synthesis of carbon nanotubes (CNTs) on the surface of alumina (Al₂O₃) powders. A thermal chemical vapor deposition (TCVD) system was used to grow CNTs directly on the Al₂O₃ surface. In order to investigate the growth behavior of CNTs, we varied both furnace temperature of the TCVD ranging from 700 to 850 ℃ and concentration of the ferritin-dissolved DI solution from 0.1 to 2.0 mg/mL. From the previous results, the gas composition and duration time for CNT growth were fixed as C₂H₄ : H₂ = 30 : 500 (vol. %) and 10 min, respectively. Based on the analysis results, the optimized growth temperature and ferritin concentration were found to be 825 ℃ and 0.5 mg/mL, respectively. The obtained results could be adopted to achieve mass production of nanocomposites with heat dissipation functionality.