• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.15 no.1
• /
• pp.33-38
• /
• 2003

Turbidity meter calibrations were conducted using bottom sediment and suspended material collected with a vertical array of sediment traps at the coastal water off Gaduk Island. Compared to the bottom sediment comprising sand fraction of approximately 6％, trapped suspended material was composed entirely of silt and clay fractions and showed a tendency to get finer as elevation from the sea-bed increases. Slope parameter of linear regression due to bottom sediment was of minimum value and values of those due to suspended material increased gradually as the height of sediment trap increases (i.e., sediment size decreases). This result shows that turbidity meter calibration using bottom sediment can cause an overestimation error in the calculation of suspended sediment concentration and that the error can reach up to 25% in case of this study. Therefore, it is suggested that the use of a corrected calibration curve based on grain size distribution of suspended material instead of bottom sediment may reduce the measurement error of suspended sediment concentration.

• Korean Journal of Materials Research
• /
• v.28 no.11
• /
• pp.627-632
• /
• 2018

Two dimensional(2D) crystals, composed of a single layer or a few atomic layers extracted from layered materials are attracting researchers' interest due to promising applications in the nanoelectromechanical systems. Worldwide researchers are preparing devices with suspended 2D materials to study their physical and electrical properties. However, during the fabrication process of 2D flakes on a target substrate, contamination occurs, which makes the measurement data less reliable. We propose a dry transfer method using poly-methyl methacrylate(PMMA) for the 2D flakes to transfer onto the targeted substrate. The PMMA is then removed from the device by an N-Methyl-2-pyrrolidone solution and a critical point dryer, which makes the suspended 2D flakes residue free. Our method provides a clean, reliable and controllable way of fabricating micrometer-sized suspended 2D nanosheets.

• Journal of Ocean Engineering and Technology
• /
• v.24 no.1
• /
• pp.99-105
• /
• 2010

The concentration and size analysis of in-situ suspended particulate material were measured using an optical instrument, LISST-100, in the bottom layer at the three inlets of the Seomjin River Estuary, mouth of Gwangyang bay, and Gwangyang bay-side of the Namhae Bridge. In the Seomjin river estuary and mouth of Gwangyang bay-side of the Namhae Bridge, the in-situ mean grain size of the suspended material changed from a uni-modal distribution with a dominant peak at a coarse fraction to a bi-modal distribution with a secondary peak at the finer particles. Seomjin River. The interactions between suspended particulate concentration and beam attenuation coefficient of suspended particulate matters depended on the supply of finer and coarser particles in the mouth of Gwangyang Bay and Seomjin River. So, interactions reflected difference of the concentration, mean size and sorting of suspended particulate matters. The difference of interaction showed dynamic behaviors to the resuspension and deflocculation processes increased river discharge. This showed that it may be possible to use the interactions between the suspended particle concentration and beam attenuation coefficient to monitor the temporal and spatial distributions of in-situ particles.

• Journal of Convergence for Information Technology
• /
• v.10 no.12
• /
• pp.236-244
• /
• 2020

In this research a suspended solid transport experiment was conducted in the river experiment center to find the characteristics and dispersion of the material. Modeling by the particle dispersion model was also executed to reproduce the suspended solid transport. The suspended solid was consisted of a mixture of silica and water using a mixing equipment, which was then introduced into a real-scale flume and measured with the laser-diffraction based particle size analyzer(LISST) to find the concentration of the material. The comparison between the measured suspended solid concentration using drone images and particle size analyzers, with the model showed a good match overall, which proved the applicability of the model. Along with finding the model applicability, the research showed the potential for suspended solid estimation in high flow situations with high rainfall.

• 한국해양학회지
• /
• v.29 no.3
• /
• pp.269-277
• /
• 1994

Process of resuspension and accumulation well explaines the characteristics of surface sediment size distribution and suspended material in Deukryang Bay. Most of the surface sediments of the bay show asymmetric unimodal size distribution, which is found also in sediments from western part of the inner shelf mud area between Keomundo and Yokchido islands. Investigation of the size curves indicates that surface sediment in Deukryang Bay is a deposit of suspended coastal sediment transported east along southern coast of Korea. The distribution pattern of coarse sit fraction content in the surface sediment is very similar to that of computed current velocity (Lee, 1994), suggesting that fine sediment on the bed may reassumed and accumulate repeatedly due to shallow depth and strong tidal current in Deukryang Bay. The process of repeated resuspension and accumulate repeatedly due to shallow depth and strong tidal current in Deukryang Bay. The process of repeated resuspension and accumulation seems to be responsible not only to the asymmetric size distribution of the surface sediment, but also to the amount of suspended material in the bay. The difference of suspended material concentration between surface and near bottom water in summer is two times as large as that the in winter. This seems to derive from the fact that stratification of water mass prevails in summer, while total water mass is vertically mixed in winter. It was found that the most important factors to decide distribution of suspended material in Deukryang Bay are the physical properties of water mass such as current velocity and stratification, and water depth, in part with the supply of suspended sediment by rivers.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.06a
• /
• pp.87-88
• /
• 2006

It is needed several large reservoirs and long time in order to remove suspended solid like steel fines and iron oxide at steel making factory. If removing rate of suspended solid in rolling coolant is improved, the productivity of working process can be increased and the area of reservoir can be reduced. Pre-treatment to add extra magnetization of suspended solid was studied Iron hydroxide and electrolytic dissociation were used for pretreatment. High gradient magnetic separation (HGMS) system was used for removing of magnetized suspended solid. Removing ratio showed over than 99% in the coolant containing magnetic fines. Magnetic properties of suspended solid were investigated after mixed with Al2(SO2)3 and organic flocculant by using electrochemical treatment.

• Journal of the korean society of oceanography
• /
• v.37 no.3
• /
• pp.178-186
• /
• 2002

The mud deposit located to the south of Cheju Island, the East China Sea, is characterized by an upwelling system or, on occasions, a combined upwelling-downwelling system. The water mass here is associated with relatively high suspended matter concentrations. In the present study, a vertical I-D model is used to undertake numerical experiments for evaluating the upwelling and downwelling effects on the suspended particulate matter distribution patterns within the water column. The results show that: (1) because the upwelling or downwelling velocity tends to be of the same order of magnitude as the settling velocity of suspended particles, a number of different patterns of suspended matter concentration distribution are possible, depending on the relative importance of the velocities; (2) the presence of upwelling can enhance the suspended particulate matter concentration; and (3) in an upwelling-downwelling system, maximum concentrations may or may not lie in the middle of the water column, depending on, once again, the interrelationships between the opwelling/downwelling velocities and the settling velocity. Hence, the physical processes associated with upwelling/downwelling appear to be relevant to the suspended material distribution over shelf mud areas.

• Journal of Korean Port Research
• /
• v.14 no.4
• /
• pp.451-461
• /
• 2000

The design and maintenance of navigation channel and water facilities of an harbor which is located at the mouth of river or at the estuary area are difficult due to the complexity of estuarial water and sediment circulation. Effects of deepening navigable waterways, of changing coastline configurations, or of discharging dredged material to the open sea are necessary to be investigated and predicted in terms of water quality and possible physical changes to the coastal environment. A borad analysis of the transport mechanism in the estuary area was made in terms of sediment property, falling velocity, concentration and flow characteristics. In order to simulate the transport processes, a two-dimensional finite element model is developed, which includes erosion, transport and deposition mechanism of suspended sediments. Galerkin’s weighted residual method is used to solve the transient convection-diffusion equation. The fluid domain is subdivided into a series of triangular elements in which a quadratic approximation is made for suspended sediment concentration. Model could deal with a continuous aggregation by stipulating the settling velocity of the flocs in each element. The model provides suspended sediment concentration, bed shear stress, erosion versus deposition rate and bed profile at the given time step.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.52 no.1
• /
• pp.74-80
• /
• 2019

Nonylphenol is an endocrine-disrupting chemical that is the degradation product of the nonionic surfactants nonylphenol ethoxylates. To understand the contamination and behavioral characteristics of nonylphenol, we measured the nonylphenol concentrations in surface water in the lower reaches of the Suyeong River, Korea. The results were used to estimate the material balance. The target area was divided into three regions to estimate the material balance of nonylphenol. In region 1, in flux of the dissolved nonylphenol was 282.3 g/day and the nonylphenol influx in particulate suspended solids was 1,582.8 g/day. The dissolved nonylphenol outflow discharged toward region 2 was 192.5 g/day, while the adsorption to particulate suspended solids was 89.8 g/day. Within the particulate suspended solids, the outflow to region 2 was 1,250.0 g/day, while the estimated amount settling in the sediments was 422.7 g/day. The adsorption of dissolved nonylphenol to the particulate suspended solids in regions 1 and 2 was 31.8% and 54.9%, respectively. In region 3, the desorption rate was 8.8%.

• Journal of Environmental Science International
• /
• v.20 no.12
• /
• pp.1533-1540
• /
• 2011

This study was conducted to identify the sedimentation quantity and settling velocity, sediment fundamental data that an important position of water quality management of Seston, POC, PP and PN in Nakdong river basin using a sediment traps to collect suspended material pollutants. Nakdong river basin is that average sedimentation quantity of seston, POC, PP and PN were 124~1,125 g/$m^2$/d, 2,963~25,072, 26~347, 445~2,184 mg/$m^2$/d, respectively. Settling velocity of Seston, POC, PP and PN were 17.0, 35.5, 8.7, 2.4 m/d. It was appeared that various results according to the river flow, weather and other environmental factors. There was no significant correlation, each suspended material pollutants. Sedimentation rates are likely to be overestimated because the flow is not considered to resuspended materials. Therefore diversification through continued monitoring is needed to be analyzed.