• Ocean Systems Engineering
• /
• v.7 no.3
• /
• pp.179-193
• /
• 2017

Dynamic response analysis of offshore triceratops with stiffened buoyant legs under impact and non-impact waves is presented. Triceratops is relatively new-generation complaint platform being explored in the recent past for its suitability in ultra-deep waters. Buoyant legs support the deck through ball joints, which partially isolate the deck by not transferring rotation from legs to the deck. Buoyant legs are interconnected using equally spaced stiffeners, inducing more integral action in dispersing the encountered wave loads. Two typical nonlinear waves under very high sea state are used to simulate impact and non-impact waves. Parameters of JONSWAP spectrum are chosen to produce waves with high vertical and horizontal asymmetries. Impact waves are simulated by steep, front asymmetric waves while non-impact waves are simulated using Stokes nonlinear irregular waves. Based on the numerical analyses presented, it is seen that the platform experiences both steady state (springing) and transient response (ringing) of high amplitudes. Response of the deck shows significant reduction in rotational degrees-of-freedom due to isolation offered by ball joints. Weak-asymmetric waves, resulting in non-impact waves cause steady state response. Beat phenomenon is noticed in almost all degrees-of-freedom but values in sway, roll and yaw are considerably low as angle of incidence is zero degrees. Impact waves cause response in higher frequencies; bursting nature of pitch response is a clear manifestation of the effect of impact waves on buoyant legs. Non-impact waves cause response similar to that of a beating phenomenon in all active degrees-of-freedom, which otherwise would not be present under normal loading. Power spectral density plots show energy content of response for a wide bandwidth of frequencies, indicating an alarming behaviour apart from being highly nonlinear. Heave, being one of the stiff degrees-of-freedom is triggered under non-impact waves, which resulted in tether tension variation under non-impact waves as well. Reduced deck response aids functional requirements of triceratops even under impact and non-impact waves. Stiffened group of buoyant legs enable a monolithic behaviour, enhancing stiffness in vertical plane.

• Computers and Concrete
• /
• v.22 no.3
• /
• pp.279-289
• /
• 2018

Shear walls are one of the important structural elements for bearing loads imposed on buildings due to winds and earthquakes. Composite shear walls with high lateral resistance, and high energy dissipation capacity are considered as a lateral load system in such buildings. In this paper, a composite shear wall consisting of steel faceplates, infill concrete and tie bars which tied steel faceplates together, and concrete filled steel tubular (CFST) as boundary columns, was modeled numerically. Test results were compared with the existing experimental results in order to validate the proposed numerical model. Then, the effects of some parameters on the behavior of the composite shear wall were studied; so, the diameter and spacing of tie bars, thickness and compressive strength of infill concrete, thickness of steel faceplates, and the effect of strengthening the bottom region of the wall were considered. The seismic behavior of the modeled composite shear wall was evaluated in terms of stiffness, ductility, lateral strength, and energy dissipation capacity. The results of the study showed that the diameter of tie bars had a trivial effect on the performance of the composite shear wall, but increasing the tie bars spacing decreased ductility. Studying the effect of infill concrete thickness, concrete compressive strength, and thickness of steel faceplates also showed that the main role of infill concrete was to prevent buckling of steel faceplates. Also, by strengthening the bottom region of the wall, as long as the strengthened part did not provide a support performance for the upper part, the behavior of the composite shear wall was improved; otherwise, ductility of the wall could be reduced severely.

• Asian-Australasian Journal of Animal Sciences
• /
• v.25 no.7
• /
• pp.994-1002
• /
• 2012

An experiment was carried out to determine the effect of age and caponization on the development blood and bone characteristics development in male country chickens in Taiwan. A total of two hundred 8-wk-old LRI native chicken cockerels, Taishi meat No.13 from LRI-COA, were used as experimental animals. Cockerels were surgically caponized at 8 wks of age. Twelve birds in each group were bled and dressed from 8 wks to 35 wks of age at 1 to 5 wk intervals. The results indicated that the plasma testosterone concentration was significantly (p<0.05) lower in capons after 12 wks of age (caponized treatment after 4 wks) than that of the intact males. The relative tibia weight, bone breaking strength, cortical thickness, bone ash, bone calcium, bone phosphorus and bone magnesium contents were significantly (p<0.05) higher in intact males, while capons had higher (p<0.05) plasma ionized calcium, inorganic phosphorus and alkaline phosphatase concentration. The plasma testosterone concentration, relative tibia weight, tibia length, breaking strength, cortical thickness, bone ash, calcium, and phosphorus contents of intact males chickens increased significantly (p<0.05) with the advance of age. In addition, the relative tibia weight of capons peaked at 18 wks of age, and declined at 35 wks of age. The bone ash, calcium and phosphorus content increased most after 14 wks of age in male native chickens in Taiwan. Also, tibia length and cortical thickness peaked at 22 wks of age. However, the peak of bone strength was found at 26 wks of age. These findings support the assertion that androgens can directly influence bone composition fluxes in male chickens. Caponization caused a significant increase in bone loss at 4 wks post treatment, which reflected bone cell damage, and demonstrated reductions in the relative tibia weight, breaking strength, cortical thickness, bone ash, calcium, phosphorus and magnesium contents, and increases in plasma ionized calcium, inorganic phosphorus and alkaline phosphatase concentration.

• Asian Pacific Journal of Cancer Prevention
• /
• v.14 no.12
• /
• pp.7629-7634
• /
• 2013

Background: Cylin D1(CCDN1) is an important regulator of the cell cycle whose alterations are thought to be involved in cancer development. There have been many studies indicating CCDN1 amplification or over-expression in a variety of cancer types. In addition to gene amplification, the G870A polymorphism may be related with altered CCDN1 activity, and therefore with cancer development. This hypothesis has been tested in different cancer types but results have been contradictory. We therefore aimed to investigate any relationship between CCDN1 A870G genotypes and laryngeal squamous cell cancer development and progression. Materials and Methods: A total of 68 Turkish patients with primary laryngeal squamous cell cancer and 133 healthy controls were enrolled. Polymerase chain reaction-restriction fragment length polymorphism analysis was used to determine the CCDN1 genotypes. Results: No significant association was detected between CCDN1 genotypes and laryngeal squamous cell cancer (LxSCCa) development. Similarly CCDN1 genotypes were not related to clinical parameters of Lx SCCa. However, there was a very significant association between CCDN1 G allele and presence of perineural invasion (p=0.003; OR: 1.464; CI% 1.073-1.999). CCDN1 G allele frequency was significantly higher in the individuals with perineural invasion (85.7%) when compared to those without (58.5%). The 2 patients who died of disease were both found to possess the GG genotype. Conclusions: These results pose a controversy in suggesting a protective role of the G allele against LxSCCa development and support the association of CCDN1 gene GG genotype with mortality in patients with LxSCCa.

• Nutrition Research and Practice
• /
• v.7 no.5
• /
• pp.393-399
• /
• 2013

Asian populations are thought to receive significant health benefits from traditional diets rich in soybeans due to high isoflavone contents. However, available epidemiologic data only weakly support this hypothesis. The present study was carried out to assess the pharmacokinetics of isoflavones in South Korean women after ingestion of soy-based foods. Twenty-six healthy female volunteers (20-30 y old) consumed three different soy products (i.e., isogen, soymilk, and fermented soybeans) with different aglycone/glucoside ratios. Plasma and urine isoflavone concentrations were measured by high-performance liquid chromatography (HPLC) after ingestion of one of the soy products. Pharmacokinetic parameters were determined using the WinNonlin program. The area under the curve (AUC) for plasma daidzein levels of the soymilk group ($2,101{\pm}352ng{\cdot}h/mL$) was significantly smaller than those of the isogen ($2,628{\pm}573ng{\cdot}h/mL$) and fermented soybean ($2,593{\pm}465ng{\cdot}h/mL$) groups. The maximum plasma concentration ($C_{max}$) of daidzein for the soymilk group ($231{\pm}44$ ng/mL) was significantly higher than those of the isogen ($160{\pm}32$ ng/mL) and fermented soybean ($195{\pm}35$ ng/mL) groups. The half-lives of daidzein and genistein in the soymilk group (5.9 and 5.6 h, respectively) were significantly shorter than those in the individuals given isogen (9.6 and 8.5 h, respectively) or fermented soybean (9.5 and 8.2 h, respectively). The urinary recovery rates of daidzein and genistein were 42% and 17% for the isogen group, 46% and 23% for the fermented soybean group, and 33% and 22% for the soymilk group. In conclusion, our data indicated that soy products containing high levels of isoflavone aglycone are more effective for maintaining plasma isoflavone concentrations. Additional dose-response, durational, and interventional studies are required to evaluate the ability of soy-based foods to increase the bioavailability of isoflavones that positively affect human health.

• Journal of Korean Neurosurgical Society
• /
• v.59 no.3
• /
• pp.269-275
• /
• 2016

Objective : Although middle cerebral artery (MCA) aneurysms are less amenable to coil embolization, an increasing number of studies support favorable endovascular treatment for them. The purpose of this study is to compare the outcomes of two different treatments (surgery versus coiling) and evaluate the benefits of surgical clipping for MCA aneurysms. Methods : Here we retrospectively analyzed the outcomes of 178 ruptured and unruptured MCA aneurysms treated in patients between September 2008 and April 2012. Parameters assessing treatment outcomes include degree of aneurysm occlusion, presence of regrowth, clinical status, and complications. Results : Among 178 MCA aneurysms, 153 were treated surgically. After a mean follow-up of 12 months, the surgery group showed a clinically significant complete occlusion rate (98%) compared with the coiling group (56%) (p<0.001). Follow-up radiologic evaluation showed a higher regrowth rate (four of 16 cases) in the coiling group than in the surgery group (one of 49 cases) (p=0.003). There was no statistically significant difference in favorable clinical outcome rate between the two groups. The procedure-related permanent morbidity and mortality rates were 2% (three of 153 cases) in the surgery group and 0% (0 of 25 cases) in the coiling group. Conclusion : Compared to endovascular treatment, surgical neck clipping for both ruptured and unruptured MCA aneurysms results in a significantly higher complete obliteration rate and less regrowth. Therefore, even in this endovascular era, we still recommend surgical clipping as the primary treatment option for MCA aneurysms rather than coil embolization.

• Journal of the Korean Society of Safety
• /
• v.30 no.5
• /
• pp.37-43
• /
• 2015

This study examined the effects of the minimum horizontal load on the structural behaviors and safety of system supports. The minimum horizontal load was frequently ignored in the design of system supports even though the level of that load was specified in the code and guide in Korea such as 'Standard Specification in Temporary Construction' and 'Guide to Installation of Shores for a Concrete Bridge'. To examine the effects of considering the minimum horizontal load, the finite element analysis were performed for various system supports. By varying installing parameters of system supports such as the vertical member spacing, the installation height, and the thickness of slab, the maximum combined stress ratios were estimated to investigate the structural safety of system supports. The results showed similar axial stress in vertical members but an increase in bending stress with a consideration of the horizontal load. The combines stress ratios are remarkably increased due to the consideration of the horizontal load. Consequently, the system supports, which were initially estimated to be safe when only the vertical loads were considered, were changed to be unsafe in most cases by the effects of the both the vertical and horizontal stresses. Therefore, the minimum horizontal load following the code and the guide is an essential load that could control the structural safety of system supports.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.7A
• /
• pp.493-502
• /
• 2003

In this paper, to solve some problems of the Mobile IP and local registration strategy we propose a method that can effectively support real-time traffics sensitive to delay time and packet loss. The proposed method reduces the registration time after a Mobile Node's movement between networks by carrying out the pre-registration for the domain which it will move into the network information of the link layer of cdma2000 system, at the boundary cell's handoff zone. Through the cost analysis and simulation it is shown that the proposed scheme yield a better performance compared with the Mobile IP and local registration strategies in terms of packet loss for parameters; variation of the velocity of a Mobile Node, and a distance between the Mobile Node and home networks, etc.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.11B
• /
• pp.1373-1382
• /
• 2011

Zigbee is communication technology most ideal because Zigbee support low power communication and wide expansion in wireless home network. However, Zigbee is not popular, because of Zigbee always has Hidden Node Problem and Transit Delay Problem. We propose new Beacon Frame structure to solve the two problem in Zigbee. New Beacon Frame structure reduces a Super Frame Duration and add a same space of a Control Frame Duration. We expect to solved method of Hidden Node Problem that exchange terminal information to using RTS/CTS. Also, We expect to solved method of Transit Delay Problem that put Beacon between Control Frame Duration and Super Frame Duration for synchronization. We confirm new Beacon Frame to solved two problem in OPNET simulation at Zigbee QoS Parameters. We measure Delay(sec) for solution degree of Transit Delay Problem, and measure Throughput(bits/sec) and Load (bits/sec) for solution degree of Hidden Node Problem.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.9B
• /
• pp.745-750
• /
• 2008

In a cognitive radio based system, quality of service (QoS) for the secondary user must be maintained as much as possible even while that of the primary user is protected all he time. In particular, switching wireless links for the secondary user during the transmission of multimedia data causes delay and information loss, and QoS degradations occur inevitably. The efficient resource management scheme is necessary to support the seamless multimedia service to the secondary user. This paper proposes a novel frequency selection method based on Multi-Criteria Decision Making (MCDM), in which uncertain parameters such as received signal strength, cell load, data rate, and available bandwidth are considered during the decision process for the frequency selection with the fuzzy set theory. Through simulation, we show that our proposed frequency selection method provides a better performance than the conventional methods which consider the received signal strength only.