• Korean Journal of Environmental Agriculture
• /
• v.16 no.3
• /
• pp.212-215
• /
• 1997

Parent isolates and $first-generation(F_1)$ progenies from single-sporangium of Phytophthora infestans were investigated for the acqusition of metalaxyl and streptomycin sulfate(SM) resistance. The parent isolates, KM10, U6, CDB6 showed resistance to metalaxyl, and F817, DNC303, DN107 to SM. Especially, the average mycelial growth of $F_1$ progenies of F817, CDB6, JD1 was more than 51% than parent isolates on 25ppm metalaxyl added V-8 juice agar, whereas those of KM10, U6, JD1 were extended more than 51% similar on 200ppm SM treatment. They acquired resistance on the basis of the standard in this experiment. There were positive correlations between parent isolates and $F_1$colonies in resistance. The $F_1$ colonies obtained from parent isolates showing above interinediate resistance on metalaxyl amended agar acquired much resistance.

• Journal of the Korea Concrete Institute
• /
• v.21 no.5
• /
• pp.611-617
• /
• 2009

This paper reports an experimental study on the damage mechanism and resistance of Type I portland cement mortar and paste samples exposed to 5% sodium sulfate solution with different solution temperatures; namely, $4^{\circ}C$, $10^{\circ}C$ and $20^{\circ}C$. The resistance of mortar samples was evaluated using expansion, compressive strength and flexural strength measurements. Some microstructural observations such as x-ray diffraction, differential scanning calorimetry and scanning electron microscopy were also introduced to elucidate reactants formed by sulfate attack, especially in a low temperature condition. From the results, it was found that the degree of damage in the mortar samples was significantly associated with the temperature of sulfate solution. Low temperature of the sulfate solution led to the formation of thaumasite in mortar and paste samples, and subsequently a poor resistance to sulfate attack. Thus, it is noted that when concrete structures are exposed to sulfate media in the condition of a cold region or whether, special care should be taken.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.508-513
• /
• 2001

Recently, ground granulated blast-furnace slag (GGBFS) has been increasingly used as additive for concrete. Many researchers reported that concrete using GGBFS had a better resistance under severe environments, such as marine or sulfate-rich soils, than Portland type cement concrete. The aim, therefore, of this study is to evaluate on the effectiveness of concrete using GGBFS when the concrete exposes to sulfate-rich environment. The detailed items for experiments show 2 series consisted of sulfate immersion test with mortar and sulfate diffusion test with concrete. The sulfate immersion test was performed for 400 days and contained reduction of compressive strength, length change and XRD analysis. For sulfate diffusion test, sulfate ions diffusivity was calculated on tile consideration of electrochemical theory by the diffusion cell test. As the results of this study, it was found that the concrete using GGBFS as additive was superior to portland type cement concrete. Consequently, the use of concrete with GGBFS for recycling may expect the durable and economical benefits.

• Computers and Concrete
• /
• v.29 no.5
• /
• pp.335-346
• /
• 2022

Geopolymers are an important alternative material supporting recycling, sustainability, and waste management. Durability properties are among the most critical parameters to be investigated; in this study, the durability of manufactured geopolymer samples under the attack of 10% magnesium sulfate and 10% sodium sulfate solution was investigated. 180 cycles of freezing and thawing were also tested. The experimentally obtained results investigate the durability of geopolymer mortar prepared with fly ash (class F) and alkali activator. Three different quarry dust wastes replaced the river sand aggregate: limestone, marble, and basalt powder as fine filler aggregate in three different replacement ratios of 25%, 50%, and 75% to produce ten series of geopolymer composites. The geopolymer samples' visual appearance, weight changes, UPV, and strength properties were studied for up to 12 months at different time intervals of exposure to sulfate solutions to investigate sulfate resistance. In addition, Scanning Electron Microscopy (SEM), EDS, and XRD were used to study the microstructure of the samples. It was beneficial to include quarry waste as a filler aggregate in durability and mechanical properties. The compact matrix was demonstrated by microstructural analysis of the manufactured specimens. The geopolymer mortars immersed in sodium sulfate showed less strength reduction and deterioration than magnesium sulfate, indicating that magnesium sulfate is more aggressive than sodium sulfate. Therefore, it is concluded that using waste dust interrogation with partial replacement of river sand with fly ash-based geopolymers has satisfactory results in terms of durability properties of freeze-thaw and sulfate resistance.

• Journal of the Korea Furniture Society
• /
• v.19 no.1
• /
• pp.83-90
• /
• 2008

Gypsum-wood composites were made by introducing inorganic substances into wood using calcium chloride, first treating solution, and sodium sulfate, secondary treating solution, by double diffusion process under atmospheric pressure at room temperature. The process conducted as follows: water saturated specimens were soaked in calcium chloride solutions at several concentration. Then the specimens were soaked further in saturated sodium sulfate solution, and they were leached in flowing tap water for 24h. To attain sufficient weight percent gain (WPG) values, the suitable concentration of calcium chloride and soaking time in saturated sodium sulfate solution were 20% and 48h, respectively. Inorganic substances were produced mainly in the lumina of tracheides. It was made sure that these substances were dihydrate gypsum($CaSO_4$ $2H_2O$) by X -ray microanalysis (SEM-EDX). The composites had good fire resistance due to low heat transfer rate of gypsum formed in wood. However, the composites had little decay resistances, because they showed high weight losses by test fungi attacks.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1997.04a
• /
• pp.163-169
• /
• 1997

The sea water resistance of cement and concrete must be considered when it is used for construction on the seashore of in the ocean. The concrete specimens using seven type of cements such as ordinary Portland cement, moderate heat Portland cement, sulfate resistance Portland cement, type A. B. C Portland blastfurnace slag cement and Portland flyash cement were immersed for 10 years in seawater in Kunsan. This study proved that moderate heat Portland cement, sulfate resistance Portland cement, type A Portland blastfurnace slag cement had higher resistance for seawater.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.5A
• /
• pp.757-764
• /
• 2008

This paper was conducted to evaluate the durability of cement mortars exposed to varying concentrations of sodium sulfate for up to 540 days. Three types of cement mortars, namely OPC, SRC and SGC, were exposed to four sodium sulfate solutions with concentrations of 4225, 8450, 16900 and 33800 ppm of ${SO_4}^{2-}$ ions at ambient temperature. The sulfate deterioration was evaluated by measuring compressive strength and linear expansion of mortar specimens. Experimental results indicated that the maximum deterioration was noted in OPC mortar specimens in highly concentrated sulfate solution. In particular, the $C_3A$ content in cements plays a critical role in resisting expansion due to sodium sulfate attack. Additionally, the beneficial effect of GGBS was clearly observed showing a superior resistance against sodium sulfate attack, because of its lower permeability. Another important observation was that the parameters for the evaluation of deterioration degree are greatly dependent on the products formed by sulfate attack.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2022.11a
• /
• pp.179-180
• /
• 2022

In this study, analyzed the effect of using CGS before and after the pre-treatment process as fine aggregate on the resistance to sulfate attack in concrete. As a result of the analysis, Although it showed a similar tendency to Plain (CS100), it is judged that it is necessary to analyze the resistance to sulfate attack due to the increase in immersion periods such as 180 days and 365 days.

• Journal of the Korea Concrete Institute
• /
• v.16 no.3 s.81
• /
• pp.433-440
• /
• 2004

In order to improve the performance of concrete, generally, modern cements often incorporate several mineral admixtures. In this study, the experimental included the flow value, air content of mortar containing limestone powder and length change and compressive strength of mortar specimen immersed in sulfate solutions. From the experimental results, the limestone powder cement matrices improved the physical properties and sulfate resistance of cement matrices at $10\%$ replacement ratio of limestone powder. The $30\%$ replacement ratio of limestone powder was significantly deteriorated in sodium sulfate solution. Irrespective of fineness levels of limestone powder, length change and SDF of mortar specimens with only $10\%$ replacement was much superior to the other replacements.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2002.05a
• /
• pp.379-384
• /
• 2002

The deterioration of concrete due to sulfate ions in various sulfate environments such as groundwater, soil and seawater is one of important factors degrading the durability of concrete structure. The aim of this paper is to evaluate on the magnesium sulfate alttack resistance of mortars with silica fume. In this study, compressive strength loss and length change of prismatic mortars, containing silica fume, immersed in 5% magnesium sulfate solution for 270 days were investigated. Additionally, paste powders with same binder were used to observe reactants of cement matrices through the instrumental analysis such as XRD, SEM and MIP. Results obtained from this study indicate that the greater damaging effects of the magnesium soulution are due to the decomposition of the C-S-H gel to M-C-S-H.