• Journal of the Korean Ceramic Society
• /
• v.32 no.5
• /
• pp.601-607
• /
• 1995

The bond strength between the low-firing-substrate and Cu conductor depended on the softening point and the amount of frit added to the metal paste. The addition of 3 wt% frit (softening point: 68$0^{\circ}C$) to the metal paste resulted in the improvement of bond strength, which was approximately 3 times higher (3kg/$\textrm{mm}^2$) than that of non frit condition. It was also found that fracture surface shifted to the ceramic substrate in the interface region. These phenomena were attributed to the frit migration into the metal-ceramic interface. It was thought that the migration of glass frit occurred extensively when the softening point of glass firt was 68$0^{\circ}C$. The sheet resistance of Cu conductor remained constant by the addition of 4 wt% frit regardless of softening point of frit. For all samples with more than 4 wt% frit, the sheet resistance increased abruptly.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.688-692
• /
• 2004

In this paper, zinc oxide (ZnO) films with c-axis (002) orientation have been successfully deposited on the Al/Si substrate by rf magnetron sputtering method. The deposited films were characterized by substate temperature. Physical and structural properties of the deposited films were investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM) and atomic force microscopy (AFM) measurement. Electrical Properties of the deposited films were investigated by 4-poing probe and LCR meter measurement. The optimal condition in this experimental result was found at foot of the substrate temperature and shown good film quality for FBAR application.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.4
• /
• pp.498-505
• /
• 1986

In2O3: Sn(ITO) transparent conducting films were fabricated by the electron beam evaporation method. The dependence of their electrical and optical properties on deposition conditions were examined. The optimum evaporation conditions were such that the deposition rate was 5-10\ulcornersec, oxygen partial pressure was 4x10**_4 torr, substate temperatudre was above 300\ulcorner, and SnO2 doping rate was 10 mol%. The values of sheet resistance and transmittance of the films in visible region fabricated under these optimum conditins were 12\ulcorner/ and 87-99%, respecively. And the energy conversion efficiency of the SIS solar cell fabricated using ITO was 9.16%. It is shown that the transparent conducting films can be applied to the TV camear pick-up tube and solar cell.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.6
• /
• pp.1045-1052
• /
• 2019

In this paper, the slot-coupled microstrip antenna structure with reflector is used for broadband. The reflector of this structure is designed to reduce the radiation emitted from the slot and minimize the influence of external electromagnetic environment while reducing the overall antenna height. Experimental results show that the antenna is very well matched with VSWR below 1.4 at 1.942.17GHz, and the maximum gain of the antenna in this band was measured 9.21dBi. The measured results shows that it can be used in the wireless communication field or IoT field of other frequency band in the future.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.32 no.3
• /
• pp.102-115
• /
• 1990

Importance of anaerobic digestion as an energy generating device has been increased as fuel shortage becomes serieous. Several modification methods on the conventional digesters including Powdered Activated Carbon (PAC) addition and two-phase digestion were studied to enhance the gas production. This study investigated the effects of PAC on anaerobic digestion of chicken manure in terms of gas production and sludge stabilization. As a first experiment, an optimum PAC dose for efficient gas production was determined in a batch test. In semi-continuous experiments, an optimum Sludge Retention Time (SRT) at that PAC concentration and an overall substate utilization rate coefficient were investigated. A portion of gas increased by PAC addition was estimated using a substrate utilization rate coefficient of microorganisms attached on PAC. This test was performed in batch experiments using acetic acid as a substrate. The digesters for all experiments were kept 35${\pm}$ 1˚C in a heated water bath. Mixing was performed manually once a day and the produced gas was collected for daily reading. The following conclusions were made for this study. 1. Cptimum PAC concentration was 5% total solids, where gas production rate was increased by 20 percents. 2. Optimum SRT was 7.5 days. 3. Substrate utilization rate coefficient of microorganisms attached on PAC was about twice as much as that of suspended ones.

• Proceedings of the KIEE Conference
• /
• 1999.11a
• /
• pp.31-34
• /
• 1999

In the present study, we fabricated stoichiometric $(Ba_{1-x}Sr_x)TiO_3$ thin films at various substrate temperature and contents using of magnetron sputtering method on optimized Pt-based electrodes (Pt/TiN/$SiO_2$/Si). The substate temperature deposited at 200[ $^{\circ}C$], 400[$^{\circ}C$] and 600[$^{\circ}C$] and crystalline BST thin films show above 400[$^{\circ}C$]. Also, the composition of $(Ba_{1-x}Sr_x)TiO_3$ thin films deposited on Si wafer substrate at 400[$^{\circ}C$] were closed to stoichiometry($1.015{\sim}1.093$ in A/B ratio), but compositional deviation from a stoichiometry is larger as $SrCO_3$ is added. The drastic decrease of dielectric constant and increase of dielectric loss in $(Ba_{1-x}Sr_x)TiO_3$thin films is observed above 100[kHz]. V-I characteristics of $(Ba_{1-x}Sr_x)TiO_3$ thin films show the decrease of leakage current with the increase of $SrCO_3$ contents.

• The Korean Journal of Food And Nutrition
• /
• v.12 no.5
• /
• pp.455-461
• /
• 1999

The possibility of wine making from soft and dried persimmon and the effects of treatment for persimmon on the quality of wine have been investigated. Soft persimmon was pretreated by two method of heat and hydrochloric acid treatment. Fermentation mash was composed of 12% persimmon and 15% of sucrose and was fermented at 17$^{\circ}C$ for 36 days. The fermentation using persimmons which were untreated and treated by acid was not successful because of contamination caused by lactic acid and acetic acid bacteria. Acidity of the fermented broth produced from boiled dried acid treated and untreated persimmon was 4,4, 5.0, 5,8 and 13.5ml(0.1N NaOH/10ml broth) respectively. Ethanol concentration of the fermented broth produced from boiled dried acid treated and untreated persimmon was 11.2, 10.0, 9.4 and 6.1% v/v respectively. The wine fermented for 28day's fermentation using boiled persimmon as substate had the best quality and stability. After 36day's fermentation using boild persimon following composition was obtained: 4.65% of total sugar 3.65% of reducing sugar 0.03mg/ml of protin 0.17$\mu$/ml of amino acid and 13.02 $\mu$g/ml of pectin. The pH and yeast cell of the boiled persimmon broth were 3.4 and 5.75 logCFU/ml. Fermented wine using dried persimmon had aslo good quality but the fermentation rate was slow.

• Journal of Surface Science and Engineering
• /
• v.23 no.2
• /
• pp.24-29
• /
• 1990

The TiN filmms were deposited on the stainless steel substrates by BARE techinique in order to investigate the effects of process parameters such as source-to-substate distance (15-35cm), N2 pressure(4$\times$10-10 -1$\times$10-3mb)and bias voltage(O-2000V), on the deposition rate, the concentration ratio [N/Ti] and the surface color of the films. The deposition rate was deduced from the weight measurement, the [N/ti] ratio by ESCA. The deposition rate decreased with a relationship of=40.2/D2 where D was source-to-substrate distance. The effect of the bias voltage and the N2pressure on the deposition rate, however, appeared negligble. The [N/Ti] ratio was in the narrow range of 0.7 tp 0.8 It increased slightly with the N2 partial pressure and deceased with the source-to-substrate distance. It was confired by ESCA that a significant amount of oxygen and carbon was contaminated after deposition in the top surface of TiN films. The surface color of TiN film was changed from light gold yellow to reddish gold yellow with increasing [N/Ti] ratio.

• Journal of Aquaculture
• /
• v.11 no.2
• /
• pp.261-269
• /
• 1998

The harpacticoid copepod, Tigriopus japonicus is one of the important zooplankton as a live food the production of marine fish fry. This reserch was carried out to investigate the culturing method and dietary value of T. japonicus. The reproduction of this copepod was analysed in the culturing systems (tne opened and the closed systems) and the surface area of the substate plates for the mass culture. Survival rate of the mature female and the number of nauplii produced per female for two day was higher in the open culturing system than in the close system. However, the result of survival rate of the nauplius was reversed. Larger surface area of the culturing vessel accommodated higher density of this bentic copepod. In polyculture of T. japonicus and rotifer (B. plicatilis), growth of T. japonicus seems to be dependent on the rotifer density. But rotifer seems to be independent on the copepod. With regard to dietary value, this copepod is better than Artemia nauplius for the larvae of red sea bream and tiger puffer which feed by picking. However, it is inadequate for bottom fish larvae as flounder.

• Archives of Pharmacal Research
• /
• v.3 no.1
• /
• pp.7-12
• /
• 1980

Ampliciline was synthesized from 6-amino-pencillanic acid (6-APA) and D-.alpha. phenylglycine methyl ester by using amplicilin synthesizing enzyme from Peudomonas melanogenum (IAM 1655). The whole cell enzyme was immobilized by entrapping it in the polyacrylamide gel lattices. The polymer used in the enzyme entrapment was made from 150 mg per ml of acrylamide monomer and 8 mg per ml of N, N'-methylenebisacrylamide. About 200 mg/whole cell enzyme was mixed in the polymer for entrapment. The maximal activity retention after immobilization was 56%. The optimal pH values for the whole cell enzyme and the immobilized whole cell enzyme were 6.0 and 5.9, respectively. The optimal temperature for the enzyme activity were the same for both type of preparations. The enzyme stabilities against pH and heat increased for immobilized whole cell enzyme. Immobilized cell was more stable especially in the acidic condition while both type were found to be very suceptible to thermal inactivation at a temperature above 4.deg.C. The kinetic constants obtained from Lineweaver-Burk plot based on two substate reaction mechanism showed somewhat higher value for immobilized whole cell enzyme as compared to the whole cell enzyme : the Km value for 6-APA were 7.0 mM and 12.5 mM while Km values for phenylglycine methyl ester were 4.5 mM and 8.2 mM, respectively. Using the immobilized whole cell enzyme packed in a column reactor, the productivity of ampiciline was studied by varying the flow rate of substrate solution. At the space velocity, SV, 0.14 hr$^{-1}$ the conversion was 45%. Operational stability found in terms of half life was 30 hr at SV = 0.2 hr.