• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.3
• /
• pp.1-9
• /
• 2005

The interaction between hypersonic free stream and side jet flow at high altitudes is investigated by using the direct simulation Monte Carlo (DSMC) method. In order to alleviate the difficulty associated with the large density difference between the free stream and the side jet flow and to simulate the two flows simultaneously, a weighting factor technique is applied. For validation, the corner flow over a pair of plates perpendicularly attached is calculated with and without a side jet, and the results are compared with experiment. For a more realistic configuration, the flow past a blunted cone cylinder shape is solved. The leeward or windward jet is injected into the free stream and the effect on the aerodynamic force and moment is observed at various flow angles. The lambda shock effect and the wake structure are studied in terms of the surface pressure differential. A higher interaction between the free stream and the side jet flow is observed when the side jet is injected in the windward direction.

• The KSFM Journal of Fluid Machinery
• /
• v.19 no.6
• /
• pp.5-13
• /
• 2016

Three-dimensional unsteady numerical analysis has been performed to observe aerodynamic characteristics of a H-rotor. Generally, the structure of the H-rotor is simple but the aerodynamic characteristics are exceptionably complicated since the angle of attacks and incident velocities to a blade are considerably varied according to the azimuth angles and solidities. The blade in the upwind revolution between 0 to 180 degree obtains aerodynamic energy from the free stream but the blade in the downwind revolution between 180 to 360 degree does not. When the rotating speed increases, the blade in the downwind revolution accelerates the air around the blade like a fan and it consumes the energy and shows negative torque in the area. On the other hand, the direction of the free stream is bent because of the interaction between blade the free stream. Therefore, the operation point (highest power coefficient) appears at a lower tip-speed-ratio what it is expected.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.35 no.3
• /
• pp.22-36
• /
• 2007

The direction of this study lies in exploring a schematic proposal for a historical walk over an area called 'West Village' located inside the old city wall of Seoul. The case study area is comparable to the historic 'North Village,' including historical assets such as the Kyunghi Royal Palace and Sajik-dan. Moreover, it has spectacular scenic spots surrounding Mt. Inwang and Baegundong Stream, although this has now been paved over for use as a road. This village maintained its fame as a hub of art through the early 20th century. The comprehensive approach of this study ranges from the historical and cultural to the ecological and visual. The results of this study can be summarized as follows. A themed walk would commemorate the great leader of national independence, Baegbeom Kim Ku, as well as the famous Korean style realistic landscape painting school under the leadership of Kyumjae Jeong Seon, a great artist of the Josun Dynasty. In addition, a scenic streamside walk would accentuate the surrounding panoramic vistas which were drawn by Kyumjae, while at the same time allowing the ecological system of Baegundong Stream to be uncovered and restored.

• Journal of ILASS-Korea
• /
• v.1 no.2
• /
• pp.66-73
• /
• 1996

The present study investigates experimentally the characteristics of liquid jet, which is, the spray flow in the normal direction of the air stream under the flow conditions of air velocity $110\sim125m/s$. The present study adopts with the flow visualization technique using a short duration light bulb and the image processing analyse with CCD camera. Two types of injector were used: one is a flat plate type, and the other is backward facing step type, which height are 5, 8, 10mm. Dispersion of liquid jet can be represented by gray level of CCD camera. In the upstream of liquid jet, the backward facing step shows better liquid jet penetration. However, in the downstream. mean droplet size for backward facing step injector is smaller than that for flat plate injector

• The KSFM Journal of Fluid Machinery
• /
• v.17 no.1
• /
• pp.47-53
• /
• 2014

This paper aims to present the design and performance evaluation of a counter-rotating tidal turbine using CFD and to compare its performance with single rotor. The device scale is 10kW and the rotating part consists of two rotors which rotate in opposite direction. Compared with conventional single rotor, the counter-rotating system shows higher power efficiency at high stream velocity but lower efficiency at low stream velocity. The added counter-rotated rotor together helps improve the energy absorption capacity but has influence on the upstream rotor that reduces its performance. In terms of power capture, the designed counter-rotating tidal turbine is more advantageous in high speed tidal condition.

• Journal of the Semiconductor & Display Technology
• /
• v.8 no.1
• /
• pp.19-25
• /
• 2009

Abstract JPEG2000 achieve quality scalability through the rate control method used in the encoding process, which embeds quality layers to the code-stream. This architecture might raise two drawbacks. First, when the coding process finishes, the number and bit-rates of quality layers are fixed, causing a lack of quality scalability to code-stream encoded with a single or few quality layers. Second, in Post compression rate distortion (PCRD) the bit streams after the truncation points discarded. Therefore, computational power for the discarded bit streams is wasted. For solving of problem, through bit rate control, there are many researches. Each proposed algorithms have specially target feature that is improved performance like reducing computational power. Research results have strength and weakness. For the mean time, research contents are reviewed and compared, so we proposed research direction in the future.

• Journal of Environmental Impact Assessment
• /
• v.30 no.3
• /
• pp.141-154
• /
• 2021

In this study, the effect of the restoration of Yaksa stream and the construction of an apartment complex by the urban renewal project in the Yaksa district of Chuncheon on air quality in the surrounding area was evaluated using computational fluid dynamics (CFD) model simulations. In orderto compare the impact of the project, wind and pollutant concentration fields were simulated using topographic data in 2011 and 2017, which stand for the periods before and after the urban renewal project, respectively. In the numerical experiments, the scenarios were set to analyze the effect of the construction of the apartment complex and the effect of stream restoration. Wind direction and wind speed data obtained from the Chuncheon Automated Synoptic Observing System (ASOS) were used as the inflow boundary conditions, and the simulation results were weighted according to the frequencies of the eight-directional inflow wind directions. The changes in wind speed and NO_X concentration distribution according to the changes in building and terrain between scenarios were compared. As a result, the concentration of NO_X emitted from the surrounding roads increased by the construction of the apartment complex, and the magnitude of the increase was reduced as the result of including the effect of stream restoration. The concentration of NO_X decreased around the restored stream, while the concentration increased significantly around the constructed apartment complex. The increase in the concentration of NO_X around the apartment complex was more pronounced in the place located in the rear of the wind direction to the apartment complex, and the effect remains up to the height of the building. In conclusion, it was confirmed that the relative arrangement of apartment complex construction and stream restoration in relation to the main wind direction of the target area was one of the major factors in determining the surrounding air quality.

• Journal of the Korean association of regional geographers
• /
• v.3 no.2
• /
• pp.19-35
• /
• 1997

The purpose of this study is to find out the characteristics of landform in Geoje-Do using GIS and DTED data. The characteristics of landform in Geoje-Do are as follows; First, the height-range of Geoje-Do is $0{\sim}580m$, and the average elevation of it is 124m. Volcanic and granite region is mainly appeared at high elevation-region. But, we can't find out outstanding difference of elevation, according to its geology. The second. the slope-range of Geoje-Do is $0{\sim}52$ degree, and the average slope of it is 17.6 degree. The slope of volcanic and granite area is more steeper than any other region. But the results of analysis of the geology in Geojo-Do, don't show outstanding difference of the slope. The third, the area-rate of the aspect of Geoje-Do is almost same in all direction. And the area-rate of south-west direction is the highest. According to the geology of Geoje-Do, granite is distributed the most widely, and the area of volcanic and granite occupy 60% of entire island's area. According to analysis of influence of geology with elevation, geology has little relationship with elevation. According to analysis of geology and drainage network, streams are inclined to be developed well in Alluvium area. Drainage network is well developed throughout the entire island, except southeast area. The highest order of stream is 4 in 1:25,000 topographic map. The density of stream in Geoje-Do is very high, such as 1.6. The bifurcation-ratio of stream is also higher than 4 in all order. The length-ratio of stream is ranged from 1.24 to 3.25. According to the relationship between order and elevation. order is the greater, elevation is the lower. According to the relationship between order and slope, order is the greater, slope is the gentler. In this study, we use DTED Data, and compare it with topographic map data. According to the comparison, there is a little difference between DTED data and topographic map data. Therefore, to use DTED data in landform analysis, it is required coordinate matching process. This process is very important, and take very long time. Thus, if you use DTED in landform analysis, some processes are required. DTED data can be taken very easily, but its using is not simple. Because coordinate adjust is very hard work.

• Journal of Digital Contents Society
• /
• v.16 no.1
• /
• pp.13-24
• /
• 2015

Online design education, started with the establishment of cyber universities in Korea in 2001, has been operated with the development of online classes for various subjects until present and is predicted to be expanded both quantitatively and qualitatively as the concept of remote education is gradually generalized along with the growth of cyber universities and the development of digital technologies. However, regardless of such quantitative growth and possibility of development, the current online design classes are operating curriculum that is not much different from that of design department at the existing offline universities, while the concepts and roles of design and designer are changing according to the stream of digital times. Moreover, although complex elements are required to be considered since online design education is influenced by digital technological trend as being a form in which digital technology, contents, and design are all combined and advantages and features of online are required to be reflected to the maximum, the reality is different from what has been expected due to many circumstances. Online design education needs to be changed in accordance with the stream of digital times and new online design curriculum suitable for the current of future digital times and online environment are required to be developed and prepared at this moment. Accordingly, this research aims to look into the concepts and roles of design and designer changing in accordance with the stream of digital times by researching the existing literatures as well as the advantages and features of online class and to analyze the current state of curriculum of digital design and related departments at cyber universities in Korea to suggest an improvement direction of curriculum of online design class suitable for the future digital times.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.3 no.2
• /
• pp.66-74
• /
• 2000

This study was carried out to introduce current status and development strategy for an environmental restoration of stream side in Japan, and to consider a methodology which could be effectively applied for the environmental restoration of stream side in Korea. The strategy prospects of environmental restoration in Japan were summarized as follows: 1. We should establish a new paradigm of forest road, forest conservation and erosion control which can emphasize the restoration of the streamside ecosystem and reduce the effects of soil movement change in the areas. And we should maintain the biotic habitats to conserve native biotic community when we practice forest road, forest conservation and erosion control works. 2. In the point of view ecological conservation aspects, we should evaluate the effects of new forest conservation and erosion control methods which is emphasized on the restoration of the streamside ecosystem to apply desirable methodology to the environmental restoration of the streamside area. 3. In the past, the objective of forest conservation and erosion control was to fix a soil by construction of permanent structures. Whereas, the direction of future's forest conservation and erosion control needs to change new forest conservation and erosion control technology to prevent large scale soil movement but allow small scale soil movement to conserve sound ecosystem and biotic habitats. 4. The restoration of the streamside ecosystem should provide continuity of the streamside environment which allows desirable biological habitats, and environmentally sound facilities to harmonize the environment.